FJFranziska Jach

Franziska Jach

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Franziska Jach has a total of 57 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Optimization of the Cathode Composition for Aluminum Graphite Dual Ion Batteries

    by Ngoc Tram Nguyen, Martin Eckert, Ulrike Wunderwald, Gero Frisch, Franziska Jach

    Li‐free aluminum graphite dual ion batteries (AGDIB) have attracted attention due to abundant raw materials and low costs. AGDIB uses Al foils as anode material, natural graphite flakes as cathode, and AlCl 3 /[EMIm]Cl as electrolyte. To allow future upscaling, a significant increase of the cathode loading and optimization of cathode composition are inevitable. This is systematically investigated by varying graphite loading, water‐soluble binders, such as sodium alginate and sodium carboxymethyl cellulose (CMC), as well as conductive additive content (Super C65, SC). The cathode loading was successfully increased to 10 mg cm −2 achieving a specific capacity of 62.2 mAh g −1 and a Coulombic efficiency of 97.5% at 1 C employing 700 kDa CMC and 5 wt% SC. At high currents, capacities fade more drastically when employing high‐loading electrodes—mainly caused by increasing anodic overpotentials and only minimally by the cathode. GITT measurements revealed increasing apparent diffusion coefficients ( D app ) for high C‐rates indicating pseudocapacitive kinetics and highlighting high‐power capabilities of AGDIB. Binder and electrode stability in the corrosive IL electrolyte is emphasized by a long‐term cycle stability >700 cycles (1 C). The optimized cathode recipe yields ~61% gain in absolute cell capacity providing a foundation for future scale‐up of AGDIBs.

  • Open Access

    Sodium Tetraazidoaurate(III)—From Na[AuCl 4 ]·2H 2 O to Na[Au(N 3 ) 4 ] and Beyond One Step at a Time

    by Mehmet Somer, Joannis Psilitelis, Raul Cardoso‐Gil, Thomas Doert, Franziska Jach, Ayberk Yılmaz, Alexander Ovchinnikov, Yurii Prots, Helge Rosner, Marcus P. Schmidt, et al.

    The novel sodium tetrachlorido‐/azidoaurate(III) dihydrates Na[AuCl 4– x (N 3 ) x ]·2H 2 O ( x = 0, 1, 2, 3, 4) provide the first example of a complete series of gradual substitution on square planar complex anions to be described. Transparent yellow to dark orange single crystals of these phases were synthesized by reaction of NaN 3 and AuCl 3 or HAuCl 4 in different molar ratios from aqueous solution. Controlled dehydration of Na[Au(N 3 ) 4 ]·2H 2 O led to Na[Au(N 3 ) 4 ]·H 2 O and Na[Au(N 3 ) 4 ] in form of orange microcrystalline powders, the latter being a highly explosive material. Predominant structural features of all phases are discrete anions [AuCl 4– x (N 3 ) x ] – with gold in an ordered square planar coordination of azide/chloride anions. Vibrational spectra show good agreement with other known azidoaurates(III).

  • On the Challenge of Developing Scalable and Sustainable Aluminum-Ion Batteries: From Active to Passive Materials

    by Martin Eckert, Ngoc-Tram Nguyen, Max Bamberg, Fatjon Maxharraj, Peter Marcinkowski, Jacob Klink, Jana Gatz, Granit Jashari, Kristian Nikolowski, Ralf Benger, et al.

    As a result of the ongoing energy revolution, the development of new battery types with new cell chemistries gained a lot of attention in the last five to ten years. This evolution is on one side triggered due to the gap between demand and supply of required resources like lithium, nickel, and cobalt. This gap led to a huge cost-rally of the raw materials, e.g. the price of lithium was very volatile within the last 5 years.1, 2 The search for other cheap, reusable, and above all, safe sustainable cell chemistries led. among other things, to the development of rechargeable sodium-ion batteries (SIBs). Other cell chemistries that show promising properties are zinc-ion batteries (ZIBs) and potassium-ion batteries (KIBs) but these are not commercialized yet. One of the raising stars that gained attention in the last few years is the so-called aluminum-graphite-dual-ion battery (AGDIB). The active materials are aluminum as inexpensive anode and natural graphite as cathode material. During charging, chloroaluminate anions intercalate into the graphite host-matrix, while at the anode, metallic aluminum from the electrolyte is deposited. Typical electrolytes, which are in research focus, are the so-called ionic liquids made of 1-ethyl-3-methyl-imidazoliumchloride [EMIm]Cl and AlCl3 or triethylamine hydrochloride [TEA]Cl and AlCl3.3, 4 Other electrolytes belong to the group of so-called deep-eutectic solvents e.g., a mixture of urea and AlCl3.5 Thus, less toxic than common electrolytes in other chemistries. Beside the mentioned advantages (cheap raw materials and urea-based electrolytes), the AGDIB can be operated with extraordinary high-power densities up to as shown in laboratory-scaled battery cells.6 Thus, together with an extraordinary long cycle-life >25.000 cycles in lab test cells, the AGDIB might be a game-changer for high-power applications. To push the technical-readiness-level (TRL), we focused on upscaling processes aiming at higher loadings & multilayered pouch cells. This involved optimization of selected pouch cell casing materials as well as a detailed study on adjusting the effective graphite loading, evaluating binders and slurry recipes together with a controlled porosity of the prepared electrodes. We increased the active graphite loading from to employing a sodium alginate binder, while the prepared electrodes showed a mean capacity up to 80-100 mAh for a 2-layered cell. The results are supported by in-depth electrochemical characterization like cyclic voltammetry (CV), U/I-curves and electrochemical impedance spectroscopy (EIS). To allow further upscaling, the specifics of cells in the ampere-hour range have been determined. To enhance the kinetics of electrochemical Al-plating and stripping mechanism, as suggested by other groups7, we analyzed commercially available Al-alloys by CV, chronopotentiometry (CP) and EIS to push the high-power properties of the developed AGDIB. Those new pouch cells show an extraordinary cycling stability above 3,000 cycles at 10C while increasing the energy efficiency and rate capability. For the first time the AGDIB is also tested with a typical power-profile for grid-stabilization. In addition, the AGDIB was evaluated for a potential application that matches the performance characteristics - the provision of instantaneous reserve. This profile consists of short, highly dynamic pulse loads over several hours and has been used at 20 °C and 30 °C and scaled to 1 and 5C. Simulation of these tests with a parameterized model completed the evaluation The results confirm the applicability of AGDIB for dynamic grid-stabilization and thus their possible contribution in providing a stable energy supply employing renewable, yet fluctuating energy sources. The data obtained are of fundamental importance for increasing the TRL and represent the first step towards a possible commercially usable rechargeable AGDIB.

  • Open Access

    Nitridochromate(iv) fluoride – LiCa8[CrN3]2N2F

    by Natalia Gloriozova, Yurii Prots, Mitja Krnel, Ulrich Burkhardt, Marcus Schmidt, Alim Ormeci, Franziska Jach, Peter Höhn, Yuri Grin

    LiCa8[CrIVN3]2N2F is a nitridochromate fluoride featuring trigonal planar [CrN3]5− anions with tetravalent chromium and highly polar covalent Cr–N bonds. The compound exhibits diamagnetic and semiconducting behavior.


  • Open Access

    Nitridochromate(IV): LiSr2[CrN3]

    by Natalia Gloriozova, Yurii Prots, Franziska Jach, Mitja Krnel, Matej Bobnar, Alim Ormeci, Yuri Grin, Peter Höhn

    The quaternary nitridochromate(IV) LiSr2[CrN3] crystallizes in a new structure type with the non-centrosymmetric space group P21 (no. 4) with a = 5.5685(7) Å, b = 5.3828(8) Å, c = 7.5381(1) Å, and β = 92.291(8)°. Predominant structural features of the compound are slightly nonplanar trigonal units [CrN3]5-, which are connected by three-fold coordinated lithium to form slabs in the (001) plane. Shorter Cr-N bond lengths in comparison with reported nitridochromates(III), as well as diamagnetic behavior and vibrational spectroscopy data indicate Cr(IV), which is in a good agreement with the charge balance. According to electronic structure calculations, the compound is a semiconductor with a band gap of 1.19 eV.


  • Open Access

    Reactivity of Rare-Earth Oxides in Anhydrous Imidazolium Acetate Ionic Liquids

    by Sameera Shah, Tobias Pietsch, Maria Annette Herz, Franziska Jach, Michael Ruck

    Rare-earth metal sesquioxides (RE2O3) are stable compounds that require high activation energies in solid-state reactions or strong acids for dissolution in aqueous media. Alternatively, dissolution and downstream chemistry of RE2O3 have been achieved with ionic liquids (ILs), but typically with additional water. In contrast, the anhydrous IL 1-butyl-3-methylimidazolium acetate [BMIm][OAc] dissolves RE2O3 for RE = La–Ho and forms homoleptic dinuclear metal complexes that crystallize as [BMIm]2[RE2(OAc)8] salts. Chloride ions promote the dissolution without being included in the compounds. Since the lattice energy of RE2O3 increases with decreasing size of the RE3+ cation, Ho2O3 dissolves very slowly, while the sesquioxides with even smaller cations appear to be inert under the applied conditions. The Sm and Eu complex salts show blue and red photoluminescence and Van Vleck paramagnetism. The proton source for the dissolution is the imidazolium cation. Abstraction of the acidic proton at the C2-atom yields an N-heterocyclic carbene (imidazole-2-ylidene). The IL can be regenerated by subsequent reaction with acetic acid. In the overall process, RE2O3 is dissolved by anhydrous acetic acid, a reaction that does not proceed directly.


  • Cover Feature: The First Alkaline‐Earth Azidoaurate(III), Ba[Au(N3)4]2 ⋅ 4 H2O (Chem. Eur. J. 11/2023)

    by Yaprak Subaşı, Elif Sena Tekin, Yurii Prots, Franziska Jach, Mehmet Somer, Semih Afyon, Peter Höhn

  • Open Access

    The First Alkaline‐Earth Azidoaurate(III), Ba[Au(N3)4]2 ⋅ 4 H2O

    by Yaprak Subaşı, Elif Sena Tekin, Yurii Prots, Franziska Jach, Mehmet Somer, Semih Afyon, Peter Höhn

    Transparent, dark orange Ba[Au(N3)4]2 ⋅ 4 H2O was synthesized by reaction of Ba(N3)2 and AuCl3 or HAuCl4 in aqueous solution. The novel barium tetraazidoaurate(III) tetrahydrate crystallizes in the monoclinic space group Cc (no. 9) with a=1813.68(17) pm, b=1737.95(11) pm, c=682.04(8) pm and β=108.849(4)°. The predominant structural features of Ba[Au(N3)4]2 ⋅ 4 H2O are two crystallographically independent discrete anions [Au(N3)4]− with gold in a tetragonal planar coordination by nitrogen. Vibrational spectra show good agreement with those of other azidoaurates(III). Upon drying, this salt was shown to be a highly explosive material.


  • Open Access

    Non-innocent cyanido ligands: tetracyanidoferrate(–ii) as carbonyl copycat

    by Franziska Jach, Theresa Block, Yurii Prots, Marcus Schmidt, Matej Bobnar, Rainer Pöttgen, Michael Ruck, Peter Hoehn

    Electron-rich [Fe(CN)4]6− features a π-backbonding scheme with non-innocent CN-ligands exhibiting weak C–N bonds and a d10 configuration on iron.


  • Open Access

    Formation of Tetraselenodiarsenate(II) Anions in Ultra‐alkaline Medium

    by Ralf Albrecht, Franziska Jach, Michael Ruck

    SeO2 and As2O3 were reacted at 200 °C in in a potassium hydroxide hydroflux with a molar water‐base ratio n(H2O) : n(KOH)=1.8. Arsenate(III) disproportionates under these conditions into arsenate(V) and elemental arsenic. The reduction also yielded tetraselenodiarsenate(II) anions, which turned the solution yellow and precipitated at room temperature as plate‐shaped crystals of K4(As2Se4) ⋅ 2H2O. The unexpected redox reaction as well as the formation of a hygroscopic compound in an aqueous solution are attributed to a strongly reduced activity of water in ultra‐alkaline media. K4(As2Se4) ⋅ 2H2O crystallizes in the orthorhombic space group Cmce with lattice parameters a=784.78(3), b=1027.76(4) and c=1750.63(7) pm at 100 K. The (As2Se4)4− anion has C2h symmetry and an As−As bond length of 245.3(1) pm. The water molecules are part of infinite zig‐zag chains [K(H2O)2/2]+ and form hydrogen bonds to neighboring selenium atoms.