PMParisa Mirbod

Parisa Mirbod

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Parisa Mirbod has a total of 55 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Linear stability analysis of particle-laden Couette–Poiseuille flows: effect of porous walls

    by Ananthapadmanabhan Ramesh, Abbas Moradi Bilondi, Mohammadreza Mahmoudian, Parisa Mirbod

    The current study presents a three-dimensional linear stability analysis of particle-laden Couette-Poiseuille flow (CPF) suspended in a Newtonian fluid between two parallel plates, with the lower plate coated by a porous medium. The influence of suspended particles is examined using a two-domain formulation in which particles are confined to the fluid layer and do not penetrate the porous substrate. The particle-laden suspension is modelled using the dusty gas framework, while the flow within the porous layer is described by the volume-averaged Navier–Stokes equations. In particle-laden flows over impermeable walls, particle inertia may either stabilise or destabilise the flow depending on the governing parameters. In contrast, the presence of a porous layer introduces an additional permeability-dependent destabilising mechanism that fundamentally modifies these classical trends. Consequently, particle loading can reduce the critical Reynolds number at sufficiently high permeability, even in parameter regimes where particles stabilise the corresponding rigid-wall flow. The coupled formulation also introduces additional disturbance branches associated with fluid–particle coupling near the permeable interface. Although these modes remain stable throughout the parameter space investigated, they modify the eigenspectrum and influence the dominant instability through altered coupling pathways. Furthermore, unlike impermeable-wall CPF, where increasing the Couette component generally stabilises the flow, the porous-wall configuration exhibits a monotonic decrease in the critical Reynolds number over the range examined. These results demonstrate that porous boundaries can fundamentally alter established stability behaviour in particle-laden shear flows through permeability-dependent coupling between the suspension and the porous substrate.


  • Open Access

    Route to instability in viscoelastic flows via porous interfaces

    by Parisa Mirbod, Elmira Taheri

    We identify an instability mechanism in pressure-driven viscoelastic channel flows bounded by porous walls. Unlike the elastoinertial center mode in impermeable channels or the classical porous-wall mode in Newtonian flows, the instability uncovered here is wall localized and arises from the coupling of polymeric stress transport with interfacial momentum leakage. Elastic normal stresses concentrate disturbances at the fluid-porous interface, while permeability simultaneously enables slip-driven stress amplification and dissipative leakage, producing a wall-confined elastoinertial mode. The resulting instability occurs at Reynolds and Weissenberg numbers well below classical thresholds and exhibits a nonmonotonic dependence on permeability. In the strongly elastic limit, the onset is governed by interfacial stress localization rather than inertial amplification, rendering inertia nonessential. These findings show that permeability not only shifts stability boundaries but also reorganizes the instability mechanism itself, establishing a boundary-driven route to transition in porous-bounded viscoelastic flows.

  • Open Access

    Linear stability analysis of viscoelastic flows overlying permeable surfaces

    by Elmira Taheri, Parisa Mirbod

    We present a linear stability analysis of plane Poiseuille flow of an Oldroyd-B fluid confined between rigid, isotropic porous layers at the upper and lower boundaries. The study aims to investigate the interplay between elasticity, inertia and wall permeability on the onset of flow instability. The system is characterized by four dimensionless parameters: the Reynolds number ( $ \textit{Re}$ ), Weissenberg number ( $ \textit{Wi}$ ), permeability parameter ( $\alpha$ ) and solvent viscosity ratio ( $\beta$ ), with porosity held fixed at $\epsilon = 0.6$ . We focus on the low-permeability regime, where inertial effects within the porous layers are negligible. The governing equations are formulated using a modified Darcy–Brinkman–Oldroyd-B model, following the framework of Tan & Masuoka (2005 Phys . Fluids , vol. 17, p. 023101), and are coupled across the fluid–porous interfaces using appropriate interfacial conditions. The formulation recovers the classical results for impermeable viscoelastic channels and Newtonian flows with porous surfaces in the appropriate limits. At low $ \textit{Wi}$ , the dominant mode resembles a viscoelastic Tollmien–Schlichting instability, but porous boundaries significantly alter the spectrum, introducing concentric eigenvalue rings and modal shifts. At higher $ \textit{Wi}$ , an elastic wall mode emerges near the interfaces and dominates at low $ \textit{Re}$ . The critical Reynolds number $ \textit{Re}_{\textit{cr}}$ depends on $ \textit{Wi}$ and $\beta$ , with a secondary instability branch appearing at large $ \textit{Wi}$ . For highly permeable walls ( $\alpha =50$ ), $ \textit{Re}_{\textit{cr}}$ varies in a non-uniform trend with $\beta$ , in contrast to impermeable cases.


  • From sedimentation to suspension: Critical strain as a predictor of particle resuspension thresholds

    by Mohammadreza Mahmoudian, Simon A. Rogers, Parisa Mirbod

    Viscous resuspension, the process by which sedimented particles are re-entrained into a fluid under flow, is central to numerous natural and industrial systems, including environmental contaminant transport, riverbed erosion, and biogeochemical cycling. Despite its importance, predicting when and how resuspension occurs remains challenging, particularly under oscillatory shear, where particle interactions are nonlinear, collective, and time-dependent. Here, we examine the resuspension dynamics of dense, non-Brownian suspensions under both steady and oscillatory shear using bulk rheometry and in situ rheo-microscopy over a broad range of particle volume fractions (ϕ=0.30–0.55). We show that resuspension cannot be described by the shear rate alone; rather, particle motion requires a critical stress condition (ShieldsNumber≈1), while the extent of resuspension is governed by the accumulated strain. This strain-driven evolution is mediated by effective interparticle collisions and collective particle motion. We develop a predictive model that captures the observed strain thresholds as a function of volume fraction, allowing for the construction of a state diagram delineating sedimentation, resuspension, and full suspension regimes. These findings indicate that, under the conditions investigated, strain governs the progression of resuspension once the stress threshold is exceeded and provide a framework for describing suspension behavior across steady and oscillatory flows. This framework offers mechanistic insight into particle resuspension and inform the understanding of related transport phenomena in more complex systems.

  • Open Access

    Turbulent convection in emulsions: the Rayleigh–Bénard configuration

    by Abbas Moradi Bilondi, Nicolò Scapin, Luca Brandt, Parisa Mirbod

    This study explores heat and turbulent modulation in three-dimensional multiphase Rayleigh–Bénard convection using direct numerical simulations. Two immiscible fluids with identical reference density undergo systematic variations in dispersed-phase volume fractions, $0.0 \leq \varPhi \leq 0.5$ , and ratios of dynamic viscosity, $\lambda _{\mu }$ , and thermal diffusivity, $\lambda _{\alpha }$ , within the range $[0.1\unicode{x2013}10]$ . The Rayleigh, Prandtl, Weber and Froude numbers are held constant at $10^8$ , $4$ , $6000$ and $1$ , respectively. Initially, when both fluids share the same properties, a 10 % Nusselt number increase is observed at the highest volume fractions. In this case, despite a reduction in turbulent kinetic energy, droplets enhance energy transfer to smaller scales, smaller than those of single-phase flow, promoting local mixing. By varying viscosity ratios, while maintaining a constant Rayleigh number based on the average mixture properties, the global heat transfer rises by approximately 25 % at $\varPhi =0.2$ and $\lambda _{\mu }=10$ . This is attributed to increased small-scale mixing and turbulence in the less viscous carrier phase. In addition, a dispersed phase with higher thermal diffusivity results in a 50 % reduction in the Nusselt number compared with the single-phase counterpart, owing to faster heat conduction and reduced droplet presence near walls. The study also addresses droplet-size distributions, confirming two distinct ranges dominated by coalescence and breakup with different scaling laws.


  • Open Access

    Turbulent convection in emulsions: the Rayleigh-Bénard configuration

    by Abbas Moradi Bilondi, Nicolò Scapin, Luca Brandt, Parisa Mirbod

    This study explores heat and turbulent modulation in three-dimensional multiphase Rayleigh-Bénard convection using direct numerical simulations. Two immiscible fluids with identical reference density undergo systematic variations in dispersed-phase volume fractions, $0.0 \leq \Upphi \leq 0.5$, and ratios of dynamic viscosity, $λ_μ$, and thermal diffusivity, $λ_α$, within the range $[0.1-10]$. The Rayleigh, Prandtl, Weber, and Froude numbers are held constant at $10^8$, $4$, $6000$, and $1$, respectively. Initially, when both fluids share the same properties, a 10\% Nusselt number increase is observed at the highest volume fractions. In this case, despite a reduction in turbulent kinetic energy, droplets enhance energy transfer to smaller scales, smaller than those of single-phase flow, promoting local mixing. By varying viscosity ratios, while maintaining a constant Rayleigh number based on the average mixture properties, the global heat transfer rises by approximately 25\% at $\Upphi=0.2$ and $λ_μ=10$. This is attributed to increased small-scale mixing and turbulence in the less viscous carrier phase. In addition, a dispersed phase with higher thermal diffusivity results in a 50\% reduction in the Nusselt number compared to the single-phase counterpart, owing to faster heat conduction and reduced droplet presence near walls. The study also addresses droplet-size distributions, confirming two distinct ranges dominated by coalescence and breakup with different scaling laws.

  • Open Access

    On the instability of particle-laden flows in channels with porous walls

    by P. Mirbod, S. Hooshyar, E. Taheri, H. N. Yoshikawa

    We investigate the stability of flows with low particle volume fractions in channels featuring porous walls. The particles, which are neutrally buoyant, interact with the carrier fluid through the Stokes drag force. Our study explores stability concerning particle relaxation time and mass fraction, employing different porous walls with varying permeabilities while maintaining a fixed porosity of 0.6. Our results reveal that in highly permeable porous walls, flow stability is mainly governed by the porous structure. The particle volume fraction and relaxation time exert relatively minor destabilizing and stabilizing effects, respectively. However, as porous wall permeability decreases, flow behavior becomes more sensitive to the particle volume fraction. In such cases, higher particle volume fractions and longer relaxation times contribute to stabilization. This suggests that particles and porous walls can effectively control flow, either maintaining laminar flow or inducing a transition to turbulence. We also analyze the impact of the momentum transfer coefficient at the porous surface, τ, on flow stability. Finally, we compare marginal stability curves obtained for various commonly used porous materials to conclude our study.


  • Hysteresis and ribbons in Taylor-Couette flow of a semidilute noncolloidal suspension

    by Changwoo Kang, Michael F. Schatz, Parisa Mirbod

    In this study, we numerically investigate hysteretic behaviors of secondary bifurcations in the Taylor-Couette flow of a semidilute, neutrally buoyant, and noncolloidal suspension. We consider a suspension with a bulk particle volume fraction ϕb=0.1, radius ratio η(=ri/ro)=0.877, and particle size ε(=d/a)=60, where d is the gap width between two cylinders, a is the radius of the suspended particles, and ri and ro are the radii of the inner and outer cylinders, respectively. The suspension balance model is introduced for numerical simulations to model the dynamics of particles undergoing shear-induced particle migration with rheological constitutive laws. The suspension flow transitions from circular Couette flow via ribbons (RIB), spiral vortex flow (SVF), and wavy spiral vortex flow (WSVF) to wavy vortex flow (WVF) with the increase of suspension Reynolds number (Res). The primary transition arises very slowly with an oscillatory critical mode and appears through a supercritical (or nonhysteretic) bifurcation. However, we find hysteretic behaviors in subsequent bifurcations [spiral vortex flow (SVF) ↔ wavy spiral vortex flow (WSVF) and WSVF ↔ wavy vortex flow (WVF)] during increasing-Re and decreasing-Re procedures with a rapid step change near the transition boundaries. The WSVF and WVF states are more sustained below the transition boundaries, when the Reynolds number is rapidly decreased in stages. However, the SVF and WSVF become WSVF and WVF more sharply with increasing Re, respectively. To conclude this study, we also examine in detail a standing wave of weak counter-rotating vortices that occurs as the primary instability and analyze the wave that oscillates in time but is stationary in space in the RIB state.


  • Open Access

    Hysteresis and ribbons in Taylor-Couette flow of a semidilute non-colloidal suspension

    by Changwoo Kang, Michael F. Schatz, Parisa Mirbod

    In this study, we numerically investigate hysteretic behaviors of secondary bifurcations in the Taylor-Couette flow of a semidilute, neutrally buoyant, and noncolloidal suspension. We consider a suspension with a bulk particle volume fraction of 0.1, a radius ratio of 0.877, and a particle size of 60. The suspension balance model (SBM) is introduced for numerical simulations to model the dynamics of particles undergoing shear-induced particle migration with rheological constitutive laws. The suspension flow transitions from circular Couette flow (CCF) via ribbons (RIB), spiral vortex flow (SVF), and wavy spiral vortex flow (WSVF) to wavy vortex flow (WVF) with the increase of suspension Reynolds number. The primary transition arises very slowly with an oscillatory critical mode and appears through a supercritical (or non-hysteretic) bifurcation. However, we find hysteretic behaviors in subsequent bifurcations (spiral vortex flow (SVF) to wavy spiral vortex flow (WSVF) and WSVF to wavy vortex flow (WVF)) during increasing-Re and decreasing-Re procedures with a rapid-step change near the transition boundaries. The WSVF and WVF states are more sustained below the transition boundaries when the Reynolds number is rapidly decreased in stages. However, the SVF and WSVF become WSVF and WVF more sharply with increasing Re, respectively. To conclude this study, we also examine in detail, a standing wave of weak counter-rotating vortices that occurs as the primary instability and analyze the wave that oscillates in time but is stationary in space in the RIB state.