Richard Saldanha
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Richard Saldanha has a total of 1000 co-authors. Here are the top co-authors by number of shared publications:
A. Pocar
56 shared publications- Albert Sotnikov
Joint Institute for Nuclear Research
56 shared publications - Oleg Smirnov
Department of Physics and Electronics Centre for Radio Astronomy Techniques and Technologies (RATT) Rhodes University 6140 Makhanda South Africa
56 shared publications - Alexander Derbin
St. Petersburg Nuclear Physics Institute NRC Kurchatov Institute
55 shared publications - Davide Franco
Université de Paris Cité
55 shared publications - Marco Pallavicini
Istituto Nazionale di Fisica Nucleare Sezione di Genova
54 shared publications
Latest Publications
- 4 March 2026
- Published by American Physical Society (APS) in Physical Review D
- Vol. 113 (5)
Scintillation of liquid nitrogen
- 4 March 2026
- Published by American Physical Society (APS) in Physical Review D
- Vol. 113 (5)
Scintillation of liquid nitrogen
- 9 January 2026
- Published by American Physical Society (APS) in Physical Review C
- Vol. 113 (1)
Enhanced sensitivity to trace U 238 impurity of sapphire via coincidence neutron activation analysis
- 9 January 2026
- Published by American Physical Society (APS) in Physical Review C
- Vol. 113 (1)
Enhanced sensitivity to trace U 238 impurity of sapphire via coincidence neutron activation analysis
- Open Access
Scintillation of liquid nitrogen
Liquid nitrogen is commonly used in cryogenic applications and is a promising medium for the direct immersion cooling of sensors used for nuclear and particle physics experiments. The scintillation properties of gaseous nitrogen are well-documented, but little is known about the scintillation of liquid nitrogen. If present, scintillation light from interactions of ambient radioactivity could produce backgrounds for rare event searches such as the direct detection of dark matter. Using a coincidence-tagged alpha decay, we demonstrate that liquid nitrogen exhibits measurable, albeit very faint, scintillation. Assuming the same scintillation wavelength spectrum as gaseous nitrogen, we estimate a relative scintillation yield of $Y_{\text{LN}}/Y^{\text{STP}}_{\text{GN}} = 0.0142 \pm 0.0005\text{(stat)} \pm 0.0030\text{(sys)}$ with respect to gaseous nitrogen at standard temperature and pressure. Considering the average scintillation yield from alpha decays in gaseous nitrogen, this implies a scintillation yield for alpha decays in liquid nitrogen of $Y_{\text{LN}} = 2.39 \pm 0.56$ photons per MeV. To our knowledge this is the first measurement of scintillation in liquid nitrogen.Open AccessScintillation of liquid nitrogen
Liquid nitrogen is commonly used in cryogenic applications and is a promising medium for the direct immersion cooling of sensors used for nuclear and particle physics experiments. The scintillation properties of gaseous nitrogen are well-documented, but little is known about the scintillation of liquid nitrogen. If present, scintillation light from interactions of ambient radioactivity could produce backgrounds for rare event searches such as the direct detection of dark matter. Using a coincidence-tagged alpha decay, we demonstrate that liquid nitrogen exhibits measurable, albeit very faint, scintillation. Assuming the same scintillation wavelength spectrum as gaseous nitrogen, we estimate a relative scintillation yield of $Y_{\text{LN}}/Y^{\text{STP}}_{\text{GN}} = 0.0142 \pm 0.0005\text{(stat)} \pm 0.0030\text{(sys)}$ with respect to gaseous nitrogen at standard temperature and pressure. Considering the average scintillation yield from alpha decays in gaseous nitrogen, this implies a scintillation yield for alpha decays in liquid nitrogen of $Y_{\text{LN}} = 2.39 \pm 0.56$ photons per MeV. To our knowledge this is the first measurement of scintillation in liquid nitrogen. - 26 September 2025
- Published by American Physical Society (APS) in Physical Review D
- Vol. 112 (5)
Removal of spallation-induced tritium from silicon through diffusion
- 26 September 2025
- Published by American Physical Society (APS) in Physical Review D
- Vol. 112 (5)
Removal of spallation-induced tritium from silicon through diffusion
- Open Access
Ultra-pure Nickel for Structural Components of Low-Radioactivity Instruments
The next generation of rare-event search experiments in nuclear and particle physics demand structural materials combining exceptional mechanical strength with ultra-low levels of radioactive contamination. This study evaluates chemical vapor deposition (CVD) nickel as a candidate structural material for such applications. Manufacturer-supplied CVD Ni grown on aluminum substrates underwent tensile testing before and after welding alongside standard Ni samples. CVD Ni exhibited a planar tensile strength of ~600 MPa, significantly surpassing standard nickel. However, welding and heat treatment were found to reduce the tensile strength to levels comparable to standard Ni, with observed porosity in the welds likely contributing to this reduction. Material assay via inductively coupled plasma mass spectrometry (ICP-MS) employing isotope-dilution produced measured bulk concentration of 232-Th, 238-U, and nat-K at the levels of ~70 ppq, <100 ppq, and ~900 ppt, respectively, which is the lowest reported in nickel. Surface-etch profiling uncovered higher concentrations of these contaminants extending ~10 micrometer beneath the surface, likely associated with the aluminum growth substrate. The results reported are compared to the one other well documented usage of CVD Ni in a low radioactive background physics research experiment and a discussion is provided on how the currently reported results may arise from changes in CVD fabrication or testing process. These results establish CVD Ni as a promising low-radioactivity structural material, while outlining the need for further development in welding and surface cleaning techniques to fully realize its potential in large-scale, low radioactive background rare-event search experiments.
Open AccessUltra-pure Nickel for Structural Components of Low-Radioactivity Instruments
The next generation of rare-event search experiments in nuclear and particle physics demand structural materials combining exceptional mechanical strength with ultra-low levels of radioactive contamination. This study evaluates chemical vapor deposition (CVD) nickel as a candidate structural material for such applications. Manufacturer-supplied CVD Ni grown on aluminum substrates underwent tensile testing before and after welding alongside standard Ni samples. CVD Ni exhibited a planar tensile strength of ~600 MPa, significantly surpassing standard nickel. However, welding and heat treatment were found to reduce the tensile strength to levels comparable to standard Ni, with observed porosity in the welds likely contributing to this reduction. Material assay via inductively coupled plasma mass spectrometry (ICP-MS) employing isotope-dilution produced measured bulk concentration of 232-Th, 238-U, and nat-K at the levels of ~70 ppq, <100 ppq, and ~900 ppt, respectively, which is the lowest reported in nickel. Surface-etch profiling uncovered higher concentrations of these contaminants extending ~10 micrometer beneath the surface, likely associated with the aluminum growth substrate. The results reported are compared to the one other well documented usage of CVD Ni in a low radioactive background physics research experiment and a discussion is provided on how the currently reported results may arise from changes in CVD fabrication or testing process. These results establish CVD Ni as a promising low-radioactivity structural material, while outlining the need for further development in welding and surface cleaning techniques to fully realize its potential in large-scale, low radioactive background rare-event search experiments.
- 30 October 2024
- Published by American Physical Society (APS) in Physical Review D
- Vol. 110 (8)
Subsurface cosmogenic and radiogenic production of- 30 October 2024
- Published by American Physical Society (APS) in Physical Review D
- Vol. 110 (8)
Subsurface cosmogenic and radiogenic production of- Open Access
- 19 September 2023
- Published by Springer Nature in EPJ Techniques and Instrumentation
- Vol. 10 (1) , 1-17
Ultra-low radioactivity flexible printed cables
Flexible printed cables and circuitry based on copper-polyimide materials are widely used in experiments looking for rare events due to their unique electrical and mechanical characteristics. However, past studies have found copper-polyimide flexible cables to contain 400-4700 pg 238U/g, 16-3700 pg 232Th/g, and 170-2100 ng natK/g, which can be a significant source of radioactive background for many current and next-generation ultralow background detectors. This study presents a comprehensive investigation into the fabrication process of copper-polyimide flexible cables and the development of custom low radioactivity cables for use in rare-event physics applications. A methodical step-by-step approach was developed and informed by ultrasensitive assay to determine the radiopurity in the starting materials and identify the contaminating production steps in the cable fabrication process. Radiopure material alternatives were identified, and cleaner production processes and treatments were developed to significantly reduce the imparted contamination. Through the newly developed radiopure fabrication process, fully-functioning cables were produced with radiocontaminant concentrations of 20-31 pg 238U/g, 12-13 pg 232Th/g, and 40-550 ng natK/g, which is significantly cleaner than cables from previous work and sufficiently radiopure for current and next-generation detectors. This approach, employing witness samples to investigate each step of the fabrication process, can hopefully serve as a template for investigating radiocontaminants in other material production processes.
- 19 September 2023
- Published by Springer Nature in EPJ Techniques and Instrumentation
- Vol. 10 (1) , 1-17
Open AccessUltra-low radioactivity flexible printed cables
Flexible printed cables and circuitry based on copper-polyimide materials are widely used in experiments looking for rare events due to their unique electrical and mechanical characteristics. However, past studies have found copper-polyimide flexible cables to contain 400-4700 pg 238U/g, 16-3700 pg 232Th/g, and 170-2100 ng natK/g, which can be a significant source of radioactive background for many current and next-generation ultralow background detectors. This study presents a comprehensive investigation into the fabrication process of copper-polyimide flexible cables and the development of custom low radioactivity cables for use in rare-event physics applications. A methodical step-by-step approach was developed and informed by ultrasensitive assay to determine the radiopurity in the starting materials and identify the contaminating production steps in the cable fabrication process. Radiopure material alternatives were identified, and cleaner production processes and treatments were developed to significantly reduce the imparted contamination. Through the newly developed radiopure fabrication process, fully-functioning cables were produced with radiocontaminant concentrations of 20-31 pg 238U/g, 12-13 pg 232Th/g, and 40-550 ng natK/g, which is significantly cleaner than cables from previous work and sufficiently radiopure for current and next-generation detectors. This approach, employing witness samples to investigate each step of the fabrication process, can hopefully serve as a template for investigating radiocontaminants in other material production processes.
- Open Access
- 17 January 2023
- Published by American Physical Society (APS) in Physical Review D
- Vol. 107 (2) , 022006
Cosmogenic activation of sodium iodide
The production of radioactive isotopes by interactions of cosmic-ray particles with sodium iodide (NaI) crystals can produce radioactive backgrounds in detectors used to search for rare events. Through controlled irradiation of NaI crystals with a neutron beam that matches the cosmic-ray neutron spectrum, followed by direct counting and fitting the resulting spectrum across a broad range of energies, we determined the integrated production rate of several long-lived radioisotopes. The measurements were then extrapolated to determine the sea-level cosmogenic neutron activation rate, including the first experimental determination of the tritium production rate: . These results will help constrain background estimates and determine the maximum time that NaI-based detectors can remain unshielded above ground before cosmogenic backgrounds impact the sensitivity of next-generation experiments.- 17 January 2023
- Published by American Physical Society (APS) in Physical Review D
- Vol. 107 (2) , 022006
Open AccessCosmogenic activation of sodium iodide
The production of radioactive isotopes by interactions of cosmic-ray particles with sodium iodide (NaI) crystals can produce radioactive backgrounds in detectors used to search for rare events. Through controlled irradiation of NaI crystals with a neutron beam that matches the cosmic-ray neutron spectrum, followed by direct counting and fitting the resulting spectrum across a broad range of energies, we determined the integrated production rate of several long-lived radioisotopes. The measurements were then extrapolated to determine the sea-level cosmogenic neutron activation rate, including the first experimental determination of the tritium production rate: . These results will help constrain background estimates and determine the maximum time that NaI-based detectors can remain unshielded above ground before cosmogenic backgrounds impact the sensitivity of next-generation experiments.