Alexander F. Pal
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Alexander F. Pal has a total of 157 co-authors. Here are the top co-authors by number of shared publications:
A. N. Starostin
SRC RF Troitsk Institute for Innovation and Fusion Research, 142190 Troitsk, Moscow, Russia
35 shared publicationsA. V. Filippov
Troitsk Institute for Innovation and Fusion Research
16 shared publications- Anatoly V. Filippov
Troitsk Institute of Innovative and Thermonuclear Research, Moscow, Russia
15 shared publications V. E. Fortov
Russian Research Centre “Kurchatov Institute,
14 shared publications- Alexander O. Serov
Skobeltsyn Institute for Nuclear Physics of the Lomonosov Moscow State University, Leninskiye Gory 1, Moscow 119899, Russia
11 shared publications A. N. Ryabinkin
Moscow State University
8 shared publications
Latest Publications
- 1 July 2020
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 46 (7) , 725-728
The Influence of Magnetron Sputtering Conditions on the Structure of Zr–Pd Coatings
Using the method of DC magnetron sputtering, nonstructured amorphous metal coatings of Zr75Pd25 composition were obtained with an average deposition rate of 1.3 nm/s at a substrate temperature of 40°C, while crystalline coatings were formed at a higher substrate temperature. A crystalline coating with equilibrium phase composition was obtained at 350°C. Coatings deposited at intermediate temperatures contained predominantly a PdZr phase, in contrast to the equilibrium PdZr2 phase. The surface roughness of amorphous coatings was on a level of 0.2–0.5 nm, which was about ten times lower than the mean roughness of crystalline coatings with the same composition.
- 1 July 2020
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 46 (7) , 725-728
The Influence of Magnetron Sputtering Conditions on the Structure of Zr–Pd Coatings
Using the method of DC magnetron sputtering, nonstructured amorphous metal coatings of Zr75Pd25 composition were obtained with an average deposition rate of 1.3 nm/s at a substrate temperature of 40°C, while crystalline coatings were formed at a higher substrate temperature. A crystalline coating with equilibrium phase composition was obtained at 350°C. Coatings deposited at intermediate temperatures contained predominantly a PdZr phase, in contrast to the equilibrium PdZr2 phase. The surface roughness of amorphous coatings was on a level of 0.2–0.5 nm, which was about ten times lower than the mean roughness of crystalline coatings with the same composition.
- 28 September 2016
- Published by Pleiades Publishing Ltd in Instruments and Experimental Techniques
- Vol. 59 (5) , 698-702
A diamond-based photovoltaic cell
- 28 September 2016
- Published by Pleiades Publishing Ltd in Instruments and Experimental Techniques
- Vol. 59 (5) , 698-702
A diamond-based photovoltaic cell
- 24 February 2016
- Published by Wiley in Contributions to Plasma Physics
- Vol. 56 (3-4) , 286-295
A Dusty Plasma in a Non‐Self‐Sustained Gas Discharge at Atmospheric Pressure
- 24 February 2016
- Published by Wiley in Contributions to Plasma Physics
- Vol. 56 (3-4) , 286-295
A Dusty Plasma in a Non‐Self‐Sustained Gas Discharge at Atmospheric Pressure
- Open Access
- 11 November 2015
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 653 (1) , 012128
Structure and properties of the ceramics based on quasicrystal powders processed by plasma coating method
Homogeneous incorporation of a small amount of binding material or modifying agent in the batch consisting of micron size particles is a problem of a composite material production process. In this work the problem is solved by deposition of a thin coating consisting of binding material on the initial powder particles by means of high-rate magnetron sputtering. The confinement of dusty particles in plasma was used in fine powder processing procedure. Composite powders based on the Al-Cu-Fe quasicrystalline particles with nickel coating were obtained. Their investigation showed that the method provides uniform incorporation of small quantities of additives (at concentration of about 3 wt. %) to fine powders. The powders were pressed at room temperature under quasi-hydrostatic conditions at high pressures. After pressing the samples were sintered in hydrogen at normal pressure. Structure and mechanical properties of the sintered samples were studied. The conditions of sintering the composite powder, which provide producing compacts with improved performance data, were established.
- 11 November 2015
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 653 (1) , 012128
Open AccessStructure and properties of the ceramics based on quasicrystal powders processed by plasma coating method
Homogeneous incorporation of a small amount of binding material or modifying agent in the batch consisting of micron size particles is a problem of a composite material production process. In this work the problem is solved by deposition of a thin coating consisting of binding material on the initial powder particles by means of high-rate magnetron sputtering. The confinement of dusty particles in plasma was used in fine powder processing procedure. Composite powders based on the Al-Cu-Fe quasicrystalline particles with nickel coating were obtained. Their investigation showed that the method provides uniform incorporation of small quantities of additives (at concentration of about 3 wt. %) to fine powders. The powders were pressed at room temperature under quasi-hydrostatic conditions at high pressures. After pressing the samples were sintered in hydrogen at normal pressure. Structure and mechanical properties of the sintered samples were studied. The conditions of sintering the composite powder, which provide producing compacts with improved performance data, were established.
- Open Access
- 11 November 2015
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 653 (1) , 012127
Current-pressure characteristics of dc magnetron discharge for high-rate sputtering
The current-pressure (I-P) characteristics of axially symmetric dc discharge of planar magnetron sputter were studied. The characteristics in argon and krypton gases for copper and aluminum cathodes and the spatial distributions of the plasma glow at different pressures are obtained. The sequence of local maximum and minimum is observed on current- pressure characteristics under defined conditions. The necessity of taking into account the gas heating by sputtered atoms for explaining the observed features of I-P characteristics is shown. Numerical simulation has allowed explaining the observed significant difference between the values of the discharge current density in argon and krypton.
- 11 November 2015
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 653 (1) , 012127
Open AccessCurrent-pressure characteristics of dc magnetron discharge for high-rate sputtering
The current-pressure (I-P) characteristics of axially symmetric dc discharge of planar magnetron sputter were studied. The characteristics in argon and krypton gases for copper and aluminum cathodes and the spatial distributions of the plasma glow at different pressures are obtained. The sequence of local maximum and minimum is observed on current- pressure characteristics under defined conditions. The necessity of taking into account the gas heating by sputtered atoms for explaining the observed features of I-P characteristics is shown. Numerical simulation has allowed explaining the observed significant difference between the values of the discharge current density in argon and krypton.
- 4 November 2015
- Published by Pleiades Publishing Ltd in Plasma Physics Reports
- Vol. 41 (11) , 895-904
Dust trap formation in a non-self-sustained discharge with external gas ionization
- 4 November 2015
- Published by Pleiades Publishing Ltd in Plasma Physics Reports
- Vol. 41 (11) , 895-904
Dust trap formation in a non-self-sustained discharge with external gas ionization
- 1 November 2015
- Published by Pleiades Publishing Ltd in Journal of Experimental and Theoretical Physics
- Vol. 121 (5) , 909-923
Electrostatic interaction of two charged macroparticles in an equilibrium plasma
- 1 November 2015
- Published by Pleiades Publishing Ltd in Journal of Experimental and Theoretical Physics
- Vol. 121 (5) , 909-923
Electrostatic interaction of two charged macroparticles in an equilibrium plasma
- 1 October 2015
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 41 (10) , 974-976
Magnetic porous composite material: Synthesis and properties
A new method of obtaining magnetic porous composite materials is described, which is based on the self-propagating high-temperature synthesis (SHS) in the form of solid-phase combustion. The SHS...
- 1 October 2015
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 41 (10) , 974-976
Magnetic porous composite material: Synthesis and properties
A new method of obtaining magnetic porous composite materials is described, which is based on the self-propagating high-temperature synthesis (SHS) in the form of solid-phase combustion. The SHS...
- 1 May 2015
- Published by Pleiades Publishing Ltd in Russian Journal of General Chemistry
- Vol. 85 (5) , 1270-1283
Application of dusty plasma for production of disperse composite materials
Objectives and achievements of the production of disperse composite materials (DCMs) which consist of particles with a metal coating are represented. The prospects of the DCM production by the dusty...
- 1 May 2015
- Published by Pleiades Publishing Ltd in Russian Journal of General Chemistry
- Vol. 85 (5) , 1270-1283
Application of dusty plasma for production of disperse composite materials
Objectives and achievements of the production of disperse composite materials (DCMs) which consist of particles with a metal coating are represented. The prospects of the DCM production by the dusty...
- 1 December 2014
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 40 (12) , 1142-1145
Neutral gas rotation in magnetron discharge
We have experimentally established the existence and determined the velocity of motion of the neutral component of plasma in a planar magnetron discharge, which takes place in the direction of drift...
- 1 December 2014
- Published by Pleiades Publishing Ltd in Technical Physics Letters
- Vol. 40 (12) , 1142-1145
Neutral gas rotation in magnetron discharge
We have experimentally established the existence and determined the velocity of motion of the neutral component of plasma in a planar magnetron discharge, which takes place in the direction of drift...