Edmundo Gomes de Azevedo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Edmundo Gomes de Azevedo has a total of 56 co-authors. Here are the top co-authors by number of shared publications:
- Henrique A. Matos
Centro de Recursos Naturais e Ambiente, Departamento de Engenharia Química, Instituto Superior Técnico, Universidade de Lisboa, Av. Rovisco Pais 1, 1049-001 Lisboa, Portugal
24 shared publications - Miguel A. Rodrigues
Centro de Química Estrutural, Department of Chemical Engineering, Instituto Superior Técnico, Universidade de Lisboa, Lisboa, Portugal
18 shared publications - Manuel Nunes da Ponte
LAQV, REQUIMTE, Departamento de Química, Faculdade de Ciências e Tecnologia, Universidade Nova de Lisboa, 2829-516 Caparica, Portugal
13 shared publications - Luis Padrela
SSPC, The Research Ireland Centre for Pharmaceuticals, Limerick, Ireland; Department of Chemical Sciences, Bernal Institute, University of Limerick, Limerick, Ireland
10 shared publications Jun Li
Department of Chemical and Biological Engineering, Instituto Superior Técnico, Av. Rovisco Pais, Lisboa, Portugal
7 shared publications- António José Almeida
Research Institute for Medicines (iMed.ULisboa), Faculty of Pharmacy, Universidade de Lisboa, Av. Professor Gama Pinto, 1649-003 Lisbon, Portugal
6 shared publications
Latest Publications
- 21 September 2016
- Published by American Chemical Society (ACS) in Crystal Growth & Design
- Vol. 16 (11) , 6222-6229
Polymorphism in Pharmaceutical Drugs by Supercritical CO2 Processing: Clarifying the Role of the Antisolvent Effect and Atomization Enhancement
- 21 September 2016
- Published by American Chemical Society (ACS) in Crystal Growth & Design
- Vol. 16 (11) , 6222-6229
Polymorphism in Pharmaceutical Drugs by Supercritical CO2 Processing: Clarifying the Role of the Antisolvent Effect and Atomization Enhancement
- 29 May 2015
- Published by American Chemical Society (ACS) in Crystal Growth & Design
- Vol. 15 (7) , 3175-3181
Insight into the Mechanisms of Cocrystallization of Pharmaceuticals in Supercritical Solvents
- 29 May 2015
- Published by American Chemical Society (ACS) in Crystal Growth & Design
- Vol. 15 (7) , 3175-3181
Insight into the Mechanisms of Cocrystallization of Pharmaceuticals in Supercritical Solvents
- 20 May 2014
- Published by Springer Nature in Pharmaceutical Research
- Vol. 31 (11) , 3136-3149
New Thermoresistant Polymorph from CO2 Recrystallization of Minocycline Hydrochloride
Purpose To prepare and thoroughly characterize a new polymorph of the broad-spectrum antibiotic minocycline from its hydrochloride dehydrate salts. Methods The new minocycline hydrochloride polymorph was prepared by means of the antisolvent effect caused by carbon dioxide. Minocycline recrystallized as a red crystalline hydrochloride salt, starting from solutions or suspensions containing CO2 and ethanol under defined conditions of temperature, pressure and composition. Results This novel polymorph (β-minocycline) revealed characteristic PXRD and FTIR patterns and a high melting point (of 247 ºC) compared to the initial minocycline hydrochloride hydrates (α-minocycline). Upon dissolution the new polymorph showed full anti-microbial activity. Solid-state NMR and DSC studies evidenced the higher chemical stability and crystalline homogeneity of β-minocycline compared to the commercial chlorohydrate powders. Molecular structures of both minocyclines present relevant differences as shown by multinuclear solid-state NMR. Conclusions This work describes a new crystalline structure of minocycline and evidences the ability of ethanol-CO2 system in removing water molecules from the crystalline structure of this API, at modest pressure, temperature and relatively short time (2 h), while controlling the crystal habit. This process has therefore the potential to become a consistent alternative towards the control of the solid form of APIs.
- 20 May 2014
- Published by Springer Nature in Pharmaceutical Research
- Vol. 31 (11) , 3136-3149
New Thermoresistant Polymorph from CO2 Recrystallization of Minocycline Hydrochloride
Purpose To prepare and thoroughly characterize a new polymorph of the broad-spectrum antibiotic minocycline from its hydrochloride dehydrate salts. Methods The new minocycline hydrochloride polymorph was prepared by means of the antisolvent effect caused by carbon dioxide. Minocycline recrystallized as a red crystalline hydrochloride salt, starting from solutions or suspensions containing CO2 and ethanol under defined conditions of temperature, pressure and composition. Results This novel polymorph (β-minocycline) revealed characteristic PXRD and FTIR patterns and a high melting point (of 247 ºC) compared to the initial minocycline hydrochloride hydrates (α-minocycline). Upon dissolution the new polymorph showed full anti-microbial activity. Solid-state NMR and DSC studies evidenced the higher chemical stability and crystalline homogeneity of β-minocycline compared to the commercial chlorohydrate powders. Molecular structures of both minocyclines present relevant differences as shown by multinuclear solid-state NMR. Conclusions This work describes a new crystalline structure of minocycline and evidences the ability of ethanol-CO2 system in removing water molecules from the crystalline structure of this API, at modest pressure, temperature and relatively short time (2 h), while controlling the crystal habit. This process has therefore the potential to become a consistent alternative towards the control of the solid form of APIs.
- 1 February 2014
- Published by Elsevier in The Journal of Supercritical Fluids
- Vol. 86, 129-136
Tuning physicochemical properties of theophylline by cocrystallization using the supercritical fluid enhanced atomization technique
- 1 February 2014
- Published by Elsevier in The Journal of Supercritical Fluids
- Vol. 86, 129-136
Tuning physicochemical properties of theophylline by cocrystallization using the supercritical fluid enhanced atomization technique
- 14 October 2013
- Published by American Chemical Society (ACS) in Crystal Growth & Design
- Vol. 13 (11) , 4940-4947
Single-Step Co-Crystallization and Lipid Dispersion by Supercritical Enhanced Atomization
- 14 October 2013
- Published by American Chemical Society (ACS) in Crystal Growth & Design
- Vol. 13 (11) , 4940-4947
Single-Step Co-Crystallization and Lipid Dispersion by Supercritical Enhanced Atomization
- 27 June 2013
- Published by Wiley in Biotechnology Progress
- Vol. 29 (5) , 1212-1221
The importance of heat flow direction for reproducible and homogeneous freezing of bulk protein solutions
Freezing is an important operation in biotherapeutics industry. However, water crystallization in solution, containing electrolytes, sugars and proteins, is difficult to control and usually leads to substantial spatial solute heterogeneity. Herein, we address the influence of the geometry of freezing direction (axial or radial) on the heterogeneity of the frozen matrix, in terms of local concentration of solutes and thermal history. Solutions of hemoglobin were frozen radially and axially using small‐scale and pilot‐scale freezing systems. Concentration of hemoglobin, sucrose and pH values were measured by ice‐core sampling and temperature profiles were measured at several locations. The results showed that natural convection is the major source for the cryoconcentration heterogeneity of solutes over the geometry of the container. A significant improvement in this spatial heterogeneity was observed when the freezing geometry was nonconvective, i.e., the freezing front progression was unidirectional from bottom to top. Using this geometry, less than 10% variation in solutes concentration was obtained throughout the frozen solutions. This result was reproducible, even when the volume was increased by two orders of magnitude (from 30 mL to 3 L). The temperature profiles obtained for the nonconvective freezing geometry were predicted using a relatively simple computational fluid dynamics model. The reproducible solutes distribution, predictable temperature profiles, and scalability demonstrate that the bottom to top freezing geometry enables an extended control over the freezing process. This geometry has therefore shown the potential to contribute to a better understanding and control of the risks inherent to frozen storage. © 2013 American Institute of Chemical Engineers Biotechnol. Prog., 29:1212–1221, 2013
- 27 June 2013
- Published by Wiley in Biotechnology Progress
- Vol. 29 (5) , 1212-1221
The importance of heat flow direction for reproducible and homogeneous freezing of bulk protein solutions
Freezing is an important operation in biotherapeutics industry. However, water crystallization in solution, containing electrolytes, sugars and proteins, is difficult to control and usually leads to substantial spatial solute heterogeneity. Herein, we address the influence of the geometry of freezing direction (axial or radial) on the heterogeneity of the frozen matrix, in terms of local concentration of solutes and thermal history. Solutions of hemoglobin were frozen radially and axially using small‐scale and pilot‐scale freezing systems. Concentration of hemoglobin, sucrose and pH values were measured by ice‐core sampling and temperature profiles were measured at several locations. The results showed that natural convection is the major source for the cryoconcentration heterogeneity of solutes over the geometry of the container. A significant improvement in this spatial heterogeneity was observed when the freezing geometry was nonconvective, i.e., the freezing front progression was unidirectional from bottom to top. Using this geometry, less than 10% variation in solutes concentration was obtained throughout the frozen solutions. This result was reproducible, even when the volume was increased by two orders of magnitude (from 30 mL to 3 L). The temperature profiles obtained for the nonconvective freezing geometry were predicted using a relatively simple computational fluid dynamics model. The reproducible solutes distribution, predictable temperature profiles, and scalability demonstrate that the bottom to top freezing geometry enables an extended control over the freezing process. This geometry has therefore shown the potential to contribute to a better understanding and control of the risks inherent to frozen storage. © 2013 American Institute of Chemical Engineers Biotechnol. Prog., 29:1212–1221, 2013
- 18 November 2011
- Published by Taylor & Francis in Drug Development and Industrial Pharmacy
- Vol. 38 (8) , 923-929
Powder X-ray diffraction method for the quantification of cocrystals in the crystallization mixture
Context: The solid state purity of cocrystals critically affects their performance. Thus, it is important to accurately quantify the purity of cocrystals in the final crystallization product. Objective: The aim of this study was to develop a powder X-ray diffraction (PXRD) quantification method for investigating the purity of cocrystals. The method developed was employed to study the formation of indomethacin-saccharin (IND-SAC) cocrystals by mechanochemical methods. Materials and methods: Pure IND-SAC cocrystals were geometrically mixed with 1:1 w/w mixture of indomethacin/saccharin in various proportions. An accurately measured amount (550 mg) of the mixture was used for the PXRD measurements. The most intense, non-overlapping, characteristic diffraction peak of IND-SAC was used to construct the calibration curve in the range 0–100% (w/w). This calibration model was validated and used to monitor the formation of IND-SAC cocrystals by liquid-assisted grinding (LAG). Results: The IND-SAC cocrystal calibration curve showed excellent linearity (R2 = 0.9996) over the entire concentration range, displaying limit of detection (LOD) and limit of quantification (LOQ) values of 1.23% (w/w) and 3.74% (w/w), respectively. Validation results showed excellent correlations between actual and predicted concentrations of IND-SAC cocrystals (R2 = 0.9981). Discussion: The accuracy and reliability of the PXRD quantification method depend on the methods of sample preparation and handling. The crystallinity of the IND-SAC cocrystals was higher when larger amounts of methanol were used in the LAG method. Conclusion: The PXRD quantification method is suitable and reliable for verifying the purity of cocrystals in the final crystallization product.
- 18 November 2011
- Published by Taylor & Francis in Drug Development and Industrial Pharmacy
- Vol. 38 (8) , 923-929
Powder X-ray diffraction method for the quantification of cocrystals in the crystallization mixture
Context: The solid state purity of cocrystals critically affects their performance. Thus, it is important to accurately quantify the purity of cocrystals in the final crystallization product. Objective: The aim of this study was to develop a powder X-ray diffraction (PXRD) quantification method for investigating the purity of cocrystals. The method developed was employed to study the formation of indomethacin-saccharin (IND-SAC) cocrystals by mechanochemical methods. Materials and methods: Pure IND-SAC cocrystals were geometrically mixed with 1:1 w/w mixture of indomethacin/saccharin in various proportions. An accurately measured amount (550 mg) of the mixture was used for the PXRD measurements. The most intense, non-overlapping, characteristic diffraction peak of IND-SAC was used to construct the calibration curve in the range 0–100% (w/w). This calibration model was validated and used to monitor the formation of IND-SAC cocrystals by liquid-assisted grinding (LAG). Results: The IND-SAC cocrystal calibration curve showed excellent linearity (R2 = 0.9996) over the entire concentration range, displaying limit of detection (LOD) and limit of quantification (LOQ) values of 1.23% (w/w) and 3.74% (w/w), respectively. Validation results showed excellent correlations between actual and predicted concentrations of IND-SAC cocrystals (R2 = 0.9981). Discussion: The accuracy and reliability of the PXRD quantification method depend on the methods of sample preparation and handling. The crystallinity of the IND-SAC cocrystals was higher when larger amounts of methanol were used in the LAG method. Conclusion: The PXRD quantification method is suitable and reliable for verifying the purity of cocrystals in the final crystallization product.
- 1 September 2011
- Published by Elsevier in The Journal of Supercritical Fluids
- Vol. 58 (2) , 303-312
Theophylline polymorphs by atomization of supercritical antisolvent induced suspensions
- 1 September 2011
- Published by Elsevier in The Journal of Supercritical Fluids
- Vol. 58 (2) , 303-312
Theophylline polymorphs by atomization of supercritical antisolvent induced suspensions
- 1 June 2010
- Published by Elsevier in The Journal of Supercritical Fluids
- Vol. 53 (1-3) , 156-164
Screening for pharmaceutical cocrystals using the supercritical fluid enhanced atomization process
- 1 June 2010
- Published by Elsevier in The Journal of Supercritical Fluids
- Vol. 53 (1-3) , 156-164
Screening for pharmaceutical cocrystals using the supercritical fluid enhanced atomization process