Clément Tronche
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Clément Tronche has a total of 28 co-authors. Here are the top co-authors by number of shared publications:
- Julien Perchoux
LAAS-CNRS, Université de Toulouse, CNRS, INP, UPS, F-31400 Toulouse, France
5 shared publications - Evelio Esteban Ramírez Miquet
Ctr. de Aplicaciones Tecnológicas y Desarrollo Nuclear (Cuba)
2 shared publications A. Luna-Arriaga
LAAS-CNRS, Université de Toulouse, CNRS, INP, F-31400 Toulouse, France
1 shared publicationA. Quotb
LAAS-CNRS, Université de Toulouse, CNRS, INP, F-31400 Toulouse, France
1 shared publicationAdam Quotb
CNRS, LAAS, 7 Avenue du Colonel Roche, F-31077 Toulouse Cedex 4, France
1 shared publication- Aleksandar D. Rakic
School of Electrical Engineering and Computer Science, The University of Queensland, Brisbane, QLD, Australia
1 shared publication
Latest Publications
- Open Access
- 1 July 2024
- Published by IOP Publishing in New Journal of Physics
- Vol. 26 (7) , 073021
Collimated beam formation in 3D acoustic sonic crystals
We demonstrate strongly collimated beam formation, at audible frequencies, in a three-dimensional acoustic phononic crystal where the wavelength is commensurate with the crystal elements; the crystal is a seemingly simple rectangular cuboid constructed from closely-spaced spheres, and yet demonstrates rich wave phenomena acting as a canonical three-dimensional metamaterial. We employ theory, numerical simulation and experiments to design and interpret this collimated beam phenomenon and use a crystal consisting of a finite rectangular cuboid array of 4 × 10 × 10 polymer spheres 1.38 cm in diameter in air, arranged in a primitive cubic cell with the centre-to-centre spacing of the spheres, i.e. the pitch, as 1.5 cm. Collimation effects are observed in the time domain for chirps with central frequencies at 14.2 kHz and 18 kHz, and we deployed a laser feedback interferometer or Self-Mixing Interferometer – a recently proposed technique to observe complex acoustic fields—that enables experimental visualisation of the pressure field both within the crystal and outside of the crystal. Numerical exploration using a higher-order multi-scale finite element method designed for the rapid and detailed simulation of 3D wave physics further confirms these collimation effects and cross-validates with the experiments. Interpretation follows using High Frequency Homogenization and Bloch analysis whereby the different origin of the collimation at these two frequencies is revealed by markedly different isofrequency surfaces of the sonic crystal.
- 1 July 2024
- Published by IOP Publishing in New Journal of Physics
- Vol. 26 (7) , 073021
Open AccessCollimated beam formation in 3D acoustic sonic crystals
We demonstrate strongly collimated beam formation, at audible frequencies, in a three-dimensional acoustic phononic crystal where the wavelength is commensurate with the crystal elements; the crystal is a seemingly simple rectangular cuboid constructed from closely-spaced spheres, and yet demonstrates rich wave phenomena acting as a canonical three-dimensional metamaterial. We employ theory, numerical simulation and experiments to design and interpret this collimated beam phenomenon and use a crystal consisting of a finite rectangular cuboid array of 4 × 10 × 10 polymer spheres 1.38 cm in diameter in air, arranged in a primitive cubic cell with the centre-to-centre spacing of the spheres, i.e. the pitch, as 1.5 cm. Collimation effects are observed in the time domain for chirps with central frequencies at 14.2 kHz and 18 kHz, and we deployed a laser feedback interferometer or Self-Mixing Interferometer – a recently proposed technique to observe complex acoustic fields—that enables experimental visualisation of the pressure field both within the crystal and outside of the crystal. Numerical exploration using a higher-order multi-scale finite element method designed for the rapid and detailed simulation of 3D wave physics further confirms these collimation effects and cross-validates with the experiments. Interpretation follows using High Frequency Homogenization and Bloch analysis whereby the different origin of the collimation at these two frequencies is revealed by markedly different isofrequency surfaces of the sonic crystal.
- Open Access
Demonstration of Pressure Wave Observation by Acousto-Optic Sensing Using a Self-Mixing Interferometer
In this paper, we demonstrate that a compact and inexpensive interferometric sensor based on the self-mixing effect in the laser cavity can be used for the characterization of shock waves. The sensor measures the changes in the refractive index induced by the shock wave. It is based on the self-mixing interferometry scheme. We describe the architecture of the dynamic sensor and the design of the experimental setup used for the characterization that involves a shock tube. Thus, we detail the experimental measurements for shock wave pressure amplitude of 5 bar and address their interpretation with regard to the most admitted models for acousto-optics.
Open AccessDemonstration of Pressure Wave Observation by Acousto-Optic Sensing Using a Self-Mixing Interferometer
In this paper, we demonstrate that a compact and inexpensive interferometric sensor based on the self-mixing effect in the laser cavity can be used for the characterization of shock waves. The sensor measures the changes in the refractive index induced by the shock wave. It is based on the self-mixing interferometry scheme. We describe the architecture of the dynamic sensor and the design of the experimental setup used for the characterization that involves a shock tube. Thus, we detail the experimental measurements for shock wave pressure amplitude of 5 bar and address their interpretation with regard to the most admitted models for acousto-optics.
- 1 October 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 22, 1-3
An embedded 2D imager for microscale flowmetry based on optical feedback interferometry
We present a compact and embedded imager based on the Optical Feedback Interferometry (OFI) sensing scheme that gives quantitative information about the velocity in fluids at micro-scale through the Doppler-Fizeau effect. This sensor can reach a spatial imaging resolution up to 5 μm in 2D scanning using a MEMS 2 axis beam-steering mirror. As an illustration of the imager performances, a 500 μm circular channel flow profile is measured. An image (300×50 pixels) of a 100 μm square section channel is successfully obtained thus validating the device.
- 1 October 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 22, 1-3
An embedded 2D imager for microscale flowmetry based on optical feedback interferometry
We present a compact and embedded imager based on the Optical Feedback Interferometry (OFI) sensing scheme that gives quantitative information about the velocity in fluids at micro-scale through the Doppler-Fizeau effect. This sensor can reach a spatial imaging resolution up to 5 μm in 2D scanning using a MEMS 2 axis beam-steering mirror. As an illustration of the imager performances, a 500 μm circular channel flow profile is measured. An image (300×50 pixels) of a 100 μm square section channel is successfully obtained thus validating the device.
- Open Access
Optical Feedback Interferometry for Velocity Measurement of Parallel Liquid-Liquid Flows in a Microchannel
Optical feedback interferometry (OFI) is a compact sensing technique with recent implementation for flow measurements in microchannels. We propose implementing OFI for the analysis at the microscale of multiphase flows starting with the case of parallel flows of two immiscible fluids. The velocity profiles in each phase were measured and the interface location estimated for several operating conditions. To the authors knowledge, this sensing technique is applied here for the first time to multiphase flows. Theoretical profiles issued from a model based on the Couette viscous flow approximation reproduce fairly well the experimental results. The sensing system and the analysis presented here provide a new tool for studying more complex interactions between immiscible fluids (such as liquid droplets flowing in a microchannel).
Open AccessOptical Feedback Interferometry for Velocity Measurement of Parallel Liquid-Liquid Flows in a Microchannel
Optical feedback interferometry (OFI) is a compact sensing technique with recent implementation for flow measurements in microchannels. We propose implementing OFI for the analysis at the microscale of multiphase flows starting with the case of parallel flows of two immiscible fluids. The velocity profiles in each phase were measured and the interface location estimated for several operating conditions. To the authors knowledge, this sensing technique is applied here for the first time to multiphase flows. Theoretical profiles issued from a model based on the Couette viscous flow approximation reproduce fairly well the experimental results. The sensing system and the analysis presented here provide a new tool for studying more complex interactions between immiscible fluids (such as liquid droplets flowing in a microchannel).
- 1 November 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19300395,p. 362-365
Optical Feedback Interferometry sensor for flow characterization inside ex-vivo vessel
Pressure myograph systems allow the study of pharmacological effects of drugs and other vasoactive compounds on small isolated vessels by image processing. In this work, we present a new pressure myograph system based on Optical Feedback Interferometry (OFI) sensor that gives information about local velocity in fluids and enables reconstruction of a velocity profile inside a vessel. OFI is a self-aligned interferometric technique that uses the laser as both the light source and the receiver thus offering high sensitivity, fast response, and a simple and compact optical design. The local Doppler flow velocity is directly measured inside ex-vivo rat vessel with a step of 100 μm thus avoiding the need to use complex image processing and models based profile calculation for extracting flow velocity. This technique will be useful to investigate hemodynamics in microcirculation by measuring unsteady irregular blood.
- 1 November 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19300395,p. 362-365
Optical Feedback Interferometry sensor for flow characterization inside ex-vivo vessel
Pressure myograph systems allow the study of pharmacological effects of drugs and other vasoactive compounds on small isolated vessels by image processing. In this work, we present a new pressure myograph system based on Optical Feedback Interferometry (OFI) sensor that gives information about local velocity in fluids and enables reconstruction of a velocity profile inside a vessel. OFI is a self-aligned interferometric technique that uses the laser as both the light source and the receiver thus offering high sensitivity, fast response, and a simple and compact optical design. The local Doppler flow velocity is directly measured inside ex-vivo rat vessel with a step of 100 μm thus avoiding the need to use complex image processing and models based profile calculation for extracting flow velocity. This technique will be useful to investigate hemodynamics in microcirculation by measuring unsteady irregular blood.