KTKoki Takanashi

Koki Takanashi

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Koki Takanashi has a total of 353 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Induction of large in-plane uniaxial magnetic anisotropy for Co–Fe–B–Pt thin films by magnetic field annealing

    by Takumi Yamazaki, Yugo Ishitani, Katsuyuki Nakada, Tomoyuki Sasaki, Yasushi Endo, Koki Takanashi, Takeshi Seki

    We report the induction of large in-plane uniaxial magnetic anisotropy for the CoFeB-based thin films by post-annealing under the magnetic field application. The comprehensive study reveals the influence of CoFeB composition and Pt addition to CoFeB on the induced magnetic anisotropy by magnetic field annealing. The addition of Pt to a CoFeB film significantly enhances the effect of magnetic field annealing, and as a result, the CoFeB–Pt films exhibit the in-plane uniaxial magnetic anisotropy energies that are one order of magnitude larger than the pristine CoFeB films. In order to understand the mechanism of magnetic anisotropy induction by post-annealing, we carried out the magnetostriction measurement for the CoFeB-based thin films. The correlation between the induced magnetic anisotropy and magnetoelastic properties is discussed.


  • Fe contribution to the magnetic anisotropy of L10-ordered FePt thin films studied by angle-dependent x-ray magnetic circular dichroism

    by Goro Shibata, Keisuke Ikeda, Takeshi Seki, Shoya Sakamoto, Yosuke Nonaka, Zhendong Chi, Yuxuan Wan, Masahiro Suzuki, Tsuneharu Koide, Hiroki Wadati, et al.

    Among magnetic thin films with perpendicular magnetic anisotropy (PMA), L10-ordered FePt has attracted significant attention because of its exceptionally strong PMA. However, the microscopic origin of its strong PMA has not been elucidated experimentally. We have investigated the contribution of the Fe 3d electrons to its magnetic anisotropy energy by angle-dependent x-ray magnetic circular dichroism at the Fe L2,3 edge. By this technique, one can deduce the magnetic dipole moment mT, which represents the anisotropic spatial distribution of spin-polarized electrons, and the orbital moment anisotropy (OMA) of Fe 3d electrons. Detected finite mT indicates that the spin-polarized Fe 3d electrons are distributed preferentially in the out-of-plane direction of the films. This mT of Fe overwhelms the positive contribution of OMA to PMA and reduces the PMA of L10-ordered FePt thin films, consistent with a previous first-principles calculation. The present result implies that a large positive contribution of the non-magnetic element Pt rather than Fe governs the PMA of L10-ordered FePt thin films.

  • Open Access

    Effect of heavy element on magneto-transport properties in magnetic FeCoNiCuPd high-entropy alloy thin films

    by Kazuya Z. Suzuki, Takahide Kubota, Koki Takanashi

    The structural, magnetic, and magneto-transport properties of ferromagnetic FeCoNiCuPd high-entropy alloy (HEA) thin films were investigated to assess the role of the heavy element Pd in magneto-transport. FeCoNiCuPd films with varying composition ratios of Cu and Pd were fabricated by a co-sputtering process at ambient temperature, and the resulting films exhibited a face-centered cubic structure with a homogeneous single phase. All films exhibited ferromagnetic hysteresis curves with soft magnetic behavior at room temperature. The dependence of the anisotropic magnetoresistance effect and anomalous Hall effect on Pd suggests that heavy metals with large spin–orbit interactions play an important role in the magneto-transport of magnetic HEAs. This finding will facilitate the understanding of the magneto-transport phenomenon in magnetic HEAs for future spintronic materials.


  • Magnetoelastic coupling for Fe–Ga thin films epitaxially grown on different substrates

    by Hao Ding, Keita Ito, Yasushi Endo, Koki Takanashi, Takeshi Seki

    This paper reports the systematic study on the structure, magnetic properties and magnetoelastic properties for the Fe100−x Ga x (001) thin films epitaxially grown on the different substrates of GaAs(001) and MgO(001) using the sputtering technique. The alloy composition dependence of effective magnetoelastic coupling coefficient B eff along the FeGa [110] direction indicated that the largest magnetoelastic coupling was obtained for the Fe–Ga layer with x = 30 grown on the MgO substrate, which was evaluated to be B eff = − 9.4 × 107 erg cm−3. Considering the results of structural analysis and magnetization measurement, the different crystallite sizes depending on the kind of substrate may give rise to the different magnetoelastic coupling strengths between the Fe–Ga layers on the MgO and the GaAs. The magnetostriction along the Fe–Ga [111] direction λ 111 was also estimated with the assumption of plausible elastic property of Fe–Ga, and showed the values comparable to the reported value of bulk Fe–Ga. This means the large magnetostriction can be obtained even for the Fe–Ga thin films epitaxially grown not only on the GaAs(001) but also on the MgO(001). The findings in this work will give a guideline for designing spintronic applications with a Fe–Ga layer exhibiting a large magnetoelastic coupling.


  • Spin caloritronics in metallic superlattices

    by T Seki, K Uchida, K Takanashi

    Spin caloritronics, a research field studying on the interconversion between a charge current ( J c ) and a heat current ( J q ) mediated by a spin current ( J s ) and/or magnetization (M), has attracted much attention not only for academic interest but also for practical applications. Newly discovered spin-caloritronic phenomena such as the spin Seebeck effect (SSE) have stimulated the renewed interest in the thermoelectric phenomena of a magnet, which have been known for a long time, e.g. the anomalous Nernst effect (ANE). These spin-caloritronic phenomena involving the SSE and the ANE have provided with a new direction for thermoelectric conversion exploiting J s and/or M. Importantly, the symmetry of ANE allows the thermoelectric conversion in the transverse configuration between J q and J c . Although the transverse configuration is totally different from the conventional longitudinal configuration based on the Seebeck effect and has many advantages, we are still facing several issues that need to be solved before developing practical applications. The primal issue is the improvement of conversion efficiency. In the case of ANE-based applications, a material with a large anomalous Nernst coefficient ( S ANE ) is the key for solving the issue. This review article introduces the increase of S ANE can be achieved by forming superlattice structures, which has been demonstrated for several kinds of materials combinations. The overall picture of studies on spin caloritronics is first surveyed. Then, we mention the pioneering work on the transverse thermoelectric conversion in superlattice structures, which was performed using Fe-based metallic superlattices, and show the recent studies for the Ni-based metallic superlattices and the ordered alloy-based metallic superlattices.


  • Negative anomalous Nernst coefficient in a MnAlGe film and its enhancement in a (Mn-Cr)AlGe film

    by Keita Ito, Takahide Kubota, Koki Takanashi

    Topological ferromagnets with remarkable transverse-transport properties, low saturation magnetization (Ms), and high uniaxial magnetic anisotropy energy (Ku) are attracting attention for application in spintronic devices. In this study, the anomalous Nernst effect (ANE) in MnAlGe and (Mn-Cr)AlGe films with a pseudo-two-dimensional structure consisting of Mn (Mn-Cr) and Al-Ge layers were investigated. The MnAlGe and (Mn-Cr)AlGe films with low Ms and high Ku were grown epitaxially on single-crystal MgO(001) substrates using sputtering. The relatively large anomalous Hall angles of approximately 0.02 were obtained in both films at 300 K, which is attributed to layered topological nodal lines in these materials. Anomalous Nernst coefficients (SANE) were −0.13 µV/K for the MnAlGe film and −0.50 µV/K for the (Mn-Cr)AlGe film at 300 K. The enhancement of the negative SANE by substituting some Mn with Cr is caused by the enhancement of the positive Seebeck coefficient and the sign change of the transverse thermoelectric conductivity from positive to negative. These materials with low Ms, high Ku, and negative SANE are suitable for application in thermoelectric conversion devices using an ANE-based thermopile structure.


  • Quantitative measurement of figure of merit for transverse thermoelectric conversion in Fe/Pt metallic multilayers

    by Takumi Yamazaki, Takamasa Hirai, Takashi Yagi, Yuichiro Yamashita, Ken-Ichi Uchida, Takeshi Seki, Koki Takanashi

    This study presents a measurement method for determining the figure of merit for transverse thermoelectric conversion (zTT) in thin-film forms. Leveraging the proposed methodology, we comprehensively investigate the transverse thermoelectric coefficient ($S_{\rm T}$), in-plane electrical conductivity (σyy), and out-of-plane thermal conductivity (κxx) in epitaxial and polycrystalline Fe/Pt metallic multilayers. Multilayers with a number of stacking repetitions (N) of 200 have κxx values that are lower than those of FePt alloy films, indicating that the multilayer structure effectively contributes to the suppression of κxx. zTT is found to increase with increasing N, which remarkably reflects the N-dependent enhancement of the ST values. Notably, ST and σyy are significantly larger in the epitaxial multilayers than in the polycrystalline counterparts, whereas negligible differences in κxx are observed between the epitaxial and polycrystalline multilayers. The present measurement technique reveals the transverse thermoelectric properties inherent to multilayers.


  • Open Access

    Influence of epitaxial growth on spin current transmission of NiO films

    by Takumi Yamazaki, Takeshi Seki, Takahide Kubota, Koki Takanashi

    This letter reports the effect of the epitaxial growth of NiO films on its spin current transmission. Two sample series of Pt/NiO/CoFeB, including epitaxial and polycrystalline NiO, were prepared using different deposition conditions. The spin current transmission of NiO is evaluated using the thermo-spin effects in the trilayers. Epitaxial NiO exhibits a non-monotonic behavior in the NiO thickness dependence of spin current transmission, while this behavior is smeared out in polycrystalline NiO. The non-monotonic behavior implies the presence of multiple spin transport mechanisms, which becomes apparent with epitaxial growth.


  • Perpendicular Magnetic Anisotropy of an Ultrathin Fe Layer Grown on NiO(001)

    by Soki Kobayashi, Hiroki Koizumi, Hideto Yanagihara, Jun Okabayashi, Takahiro Kondo, Takahide Kubota, Koki Takanashi, Yoshiaki Sonobe

    The magnetic anisotropy and magnetic interactions at the interface between Fe and NiO(001) were investigated. Depending on the growth conditions of the NiO(001) layers and the postannealing temperature, the preferential magnetization direction of the ultrathin Fe layer grown on a NiO(001) layer changed from the in-plane direction to a direction perpendicular to the film plane. The lattice constant of the NiO(001) layers parallel to the growth direction increased with O2 flow rate, while that parallel to the in-plane direction were locked onto the MgO(001) substrate regardless of the growth conditions of the NiO layers. Moreover, perpendicular magnetization was observed only when the NiO layer was grown with O2 flow rates higher than 2.0 sccm corresponding to oxygen-rich NiO. X-ray magnetic circular dichroism measurements revealed an enhancement in anisotropic orbital magnetic moments similar to the origin of perpendicular magnetic anisotropy at the Fe/MgO(001) interface. The interfacial magnetic anisotropy energies were 0.93 and 1.02mJ/m2 at room temperature and at 100 K, respectively, indicating less temperature dependence. In contrast, the coercivity Hc exhibited a significant temperature dependence. Although no signature of exchange bias or unidirectional loop shift was observed, Hc was strongly dependent on the NiO layer thickness, indicating that the exchange interaction at the interface between the ferromagnetic and antiferromagnetic layers was not negligible, despite the NiO(001) being a spin-compensated surface.


  • Open Access

    Magnetization switching process by dual spin–orbit torque in interlayer exchange-coupled systems

    by Hiroto Masuda, Yuta Yamane, Takeshi Seki, Klaus Raab, Takaaki Dohi, Rajkumar Modak, Ken-Ichi Uchida, Jun'IChi Ieda, Mathias Kläui, Koki Takanashi

    We report current-induced magnetization switching in Pt/Co/Ir/Co/Pt multilayers with different Ir layer thicknesses (tIr), where the perpendicularly magnetized Co layers are coupled ferromagnetically or antiferromagnetically through an interlayer exchange coupling and are sandwiched by the Pt spin Hall layers. The domain structures formed during switching vary depending on the magnetization alignment, i.e., a ferromagnetically coupled or antiferromagnetically coupled configuration. These results clarify the macroscopic picture of switching process for interlayer exchange-coupled systems. The local picture of the switching process is also examined by a numerical calculation based on a macrospin model, which reveals the switching dynamics triggered by dual spin–orbit torques for both antiferromagnetically and ferromagnetically coupled cases. The numerical calculation shows that the dual spin–orbit torques from the two Pt layers effectively act on the two Co layers not only for the antiferromagnetically coupled case but also for the ferromagnetically coupled one. Our findings deepen the understanding of the switching mechanism in a magnetic multilayer and provide an avenue to design spintronic devices with more efficient spin–orbit torque switching.