Mohammad Shareef Ghanim
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Mohammad Shareef Ghanim has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Khaled Shaaban
Department of Civil and Environmental Engineering, Florida Polytechnic University, Lakeland, FL 33805, USA
5 shared publications - Ali Hamdi
Computer Science, October University for Modern Sciences and Arts
1 shared publication Amjad Issa
1 shared publicationDeepti Muley
Qatar Transportation and Traffic Safety Center, Department of Civil Engineering, Qatar University, P.O. Box 2713, Doha, Qatar
1 shared publicationFrancois Dion
Partners for Advanced Transportation TecHnologies (PATH), University of California, Berkeley, 2105 Bancroft Way, Suite 300, Berkeley, CA 94720-3830, USA
1 shared publicationGhassan Abu-Lebdeh
American University of Sharjah, Civil Engineering Department, PO Box 26666, Sharjah, United Arab Emirates
1 shared publication
Latest Publications
- 1 May 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Effect of Through Movement Flow Rate on Left-Turn Lane Utilization at Signalized Intersections
Heavy left-turn volumes can increase the delay at any signalized intersection. This study aims to investigate the interaction between through movement and left-turning movement at signalized intersections. A microsimulation approach is employed to simulate real traffic conditions at a signalized intersection in the city of Doha, Qatar. Different scenarios with different traffic needs, left-turn bay designs, and traffic control parameters were used. For each scenario, the left-turn throughput, average delay, and average queue are recorded. The results indicated that the approach volume is influencing the level of utilization of left-turn lanes, regardless of the number of lanes or the storage length. The results also reveal that high delay at left-turn lanes is experienced as the through movements reach capacity. In regards to left-turn queues, while increasing the number of left-turn lanes has reduced the queue length, the associated high delays indicate that the storage bay is not fully utilized, and many of the left-turn vehicles are not allowed to enter the left-turn bay due to the through movement demand. The results indicate that through movement flow rate should be considered when deciding the number and length of left-turn lanes needed instead of focusing only on the left turn demand. The results also suggest that the use of microsimulation can provide more accurate results when determining the length and number of left-turn lanes.
- 1 May 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Effect of Through Movement Flow Rate on Left-Turn Lane Utilization at Signalized Intersections
Heavy left-turn volumes can increase the delay at any signalized intersection. This study aims to investigate the interaction between through movement and left-turning movement at signalized intersections. A microsimulation approach is employed to simulate real traffic conditions at a signalized intersection in the city of Doha, Qatar. Different scenarios with different traffic needs, left-turn bay designs, and traffic control parameters were used. For each scenario, the left-turn throughput, average delay, and average queue are recorded. The results indicated that the approach volume is influencing the level of utilization of left-turn lanes, regardless of the number of lanes or the storage length. The results also reveal that high delay at left-turn lanes is experienced as the through movements reach capacity. In regards to left-turn queues, while increasing the number of left-turn lanes has reduced the queue length, the associated high delays indicate that the storage bay is not fully utilized, and many of the left-turn vehicles are not allowed to enter the left-turn bay due to the through movement demand. The results indicate that through movement flow rate should be considered when deciding the number and length of left-turn lanes needed instead of focusing only on the left turn demand. The results also suggest that the use of microsimulation can provide more accurate results when determining the length and number of left-turn lanes.
- Open Access
- 16 March 2022
- Published by Elsevier in International Journal of Transportation Science and Technology
- Vol. 12 (1) , 245-257
Machine learning-based multi-target regression to effectively predict turning movements at signalized intersections
- 16 March 2022
- Published by Elsevier in International Journal of Transportation Science and Technology
- Vol. 12 (1) , 245-257
Open AccessMachine learning-based multi-target regression to effectively predict turning movements at signalized intersections
- 10 March 2022
- Published by Elsevier in Sustainable Cities and Society
- Vol. 81, 103830
ANN-Based traffic volume prediction models in response to COVID-19 imposed measures
- 10 March 2022
- Published by Elsevier in Sustainable Cities and Society
- Vol. 81, 103830
ANN-Based traffic volume prediction models in response to COVID-19 imposed measures
- Open Access
- 1 January 2022
- Published by Elsevier in Ain Shams Engineering Journal
- Vol. 13 (1) , 101490
Predicting pavement condition index using artificial neural networks approach
- 1 January 2022
- Published by Elsevier in Ain Shams Engineering Journal
- Vol. 13 (1) , 101490
Open AccessPredicting pavement condition index using artificial neural networks approach
- Open Access
- 17 May 2019
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 44 (10) , 8905-8913
A Strategy for Emergency Vehicle Preemption and Route Selection
- 17 May 2019
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 44 (10) , 8905-8913
Open AccessA Strategy for Emergency Vehicle Preemption and Route Selection
- Open Access
- 4 January 2019
- Published by Institution of Engineering and Technology (IET) in IET Intelligent Transport Systems
- Vol. 13 (4) , 661-669
Projected state‐wide traffic forecast parameters using artificial neural networks
Design‐hour volume (DHV) and directional DHV (DDHV) are important traffic forecast parameters for both planning and operational studies. They are used for roads and intersection design and operational analysis. Estimating these two parameters requires a record of hourly volumes for every hour in a year. Therefore, permanent traffic counters are usually used to keep a record of those hourly volumes. The use of permanent counters faces several challenges because of adjacent construction activities and hardware or communication failure. These challenges result in the missing part of the collected data. Moreover, estimating DHV and DDHV based on short‐term traffic counts is often needed. In this research, an artificial intelligence approach is used to estimate DHV and DDHV for roadways with different functional classifications. An artificial neural network model, which utilises historical records of annual average daily traffic along with other road characteristics, such as number of lanes and functional classification, is developed. Results show that the model was able to achieve a highly accurate and reliable DHV and DDHV estimates.
- 4 January 2019
- Published by Institution of Engineering and Technology (IET) in IET Intelligent Transport Systems
- Vol. 13 (4) , 661-669
Open AccessProjected state‐wide traffic forecast parameters using artificial neural networks
Design‐hour volume (DHV) and directional DHV (DDHV) are important traffic forecast parameters for both planning and operational studies. They are used for roads and intersection design and operational analysis. Estimating these two parameters requires a record of hourly volumes for every hour in a year. Therefore, permanent traffic counters are usually used to keep a record of those hourly volumes. The use of permanent counters faces several challenges because of adjacent construction activities and hardware or communication failure. These challenges result in the missing part of the collected data. Moreover, estimating DHV and DDHV based on short‐term traffic counts is often needed. In this research, an artificial intelligence approach is used to estimate DHV and DDHV for roadways with different functional classifications. An artificial neural network model, which utilises historical records of annual average daily traffic along with other road characteristics, such as number of lanes and functional classification, is developed. Results show that the model was able to achieve a highly accurate and reliable DHV and DDHV estimates.
- 14 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Intelligent Transportation Systems
- Vol. 20 (5) , 1828-1836
Estimating Turning Movements at Signalized Intersections Using Artificial Neural Networks
Intersection turning movements' counts are critical input data for traffic studies, analysis, and forecasting. These types of counts are often used to analyze operational performance of signalized intersections under different traffic conditions and peak hours. There are several methods to collect these movements, such as manual counts and video image processing. Traffic studies require turning movement counts although they may not be readily available, especially in the case of traffic forecasting or when seasonal adjustment factors are applied. In these cases, only approach volumes might be available and turning movements are assumed using different techniques to balance the inbound and outbound traffic. Nonetheless, these techniques require initial conditions, and their outcomes are highly sensitive to the initial assumptions. In this paper, a robust and practical method is developed. The turning movement counts at 691 four-leg, and 156 three-leg signalized intersections are analyzed to develop an accurate and reliable turning movement estimation model. A total of 4,175 hours of turning movement counts are used. An artificial neural networks (ANN) model is trained to analyze the relationship between the approach volumes and the corresponding turning movements. The results show that the developed ANN model can be utilized to predict turning movements at a high level of accuracy.
- 14 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Intelligent Transportation Systems
- Vol. 20 (5) , 1828-1836
Estimating Turning Movements at Signalized Intersections Using Artificial Neural Networks
Intersection turning movements' counts are critical input data for traffic studies, analysis, and forecasting. These types of counts are often used to analyze operational performance of signalized intersections under different traffic conditions and peak hours. There are several methods to collect these movements, such as manual counts and video image processing. Traffic studies require turning movement counts although they may not be readily available, especially in the case of traffic forecasting or when seasonal adjustment factors are applied. In these cases, only approach volumes might be available and turning movements are assumed using different techniques to balance the inbound and outbound traffic. Nonetheless, these techniques require initial conditions, and their outcomes are highly sensitive to the initial assumptions. In this paper, a robust and practical method is developed. The turning movement counts at 691 four-leg, and 156 three-leg signalized intersections are analyzed to develop an accurate and reliable turning movement estimation model. A total of 4,175 hours of turning movement counts are used. An artificial neural networks (ANN) model is trained to analyze the relationship between the approach volumes and the corresponding turning movements. The results show that the developed ANN model can be utilized to predict turning movements at a high level of accuracy.
- 9 June 2018
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 44 (5) , 4225-4231
A Case Study for Surrogate Safety Assessment Model in Predicting Real-Life Conflicts
- 9 June 2018
- Published by Springer Nature in Arabian Journal for Science and Engineering
- Vol. 44 (5) , 4225-4231
A Case Study for Surrogate Safety Assessment Model in Predicting Real-Life Conflicts
- 1 February 2014
- Published by Canadian Science Publishing in Canadian Journal of Civil Engineering
- Vol. 41 (2) , 154-163
The impact of dwell time variability on transit signal priority performance
Transit signal priority (TSP) is an operational control strategy that provides preferential treatments for transit vehicles at signalized intersections. Many transit agencies are currently considering the implementation of priority systems providing buses with preferential treatments at signalized intersections. While studies have demonstrated potential bus delay reductions, none has attempted to identify the problems posed by variable dwell times at bus stops. This study identifies the impacts of variable dwell times on the efficiency of transit signal priority systems. Results also show that, in general, variable dwell times negatively affect the TSP performance. However, and contrary to expectations, a number of scenarios with variable dwell times resulted in lower average bus delays than scenarios with fixed dwell times. These results are attributed to changes in progression and bus arrival patterns under variable dwell times resulting in an increasing number of buses arriving close enough to benefit from preferential treatments.
- 1 February 2014
- Published by Canadian Science Publishing in Canadian Journal of Civil Engineering
- Vol. 41 (2) , 154-163
The impact of dwell time variability on transit signal priority performance
Transit signal priority (TSP) is an operational control strategy that provides preferential treatments for transit vehicles at signalized intersections. Many transit agencies are currently considering the implementation of priority systems providing buses with preferential treatments at signalized intersections. While studies have demonstrated potential bus delay reductions, none has attempted to identify the problems posed by variable dwell times at bus stops. This study identifies the impacts of variable dwell times on the efficiency of transit signal priority systems. Results also show that, in general, variable dwell times negatively affect the TSP performance. However, and contrary to expectations, a number of scenarios with variable dwell times resulted in lower average bus delays than scenarios with fixed dwell times. These results are attributed to changes in progression and bus arrival patterns under variable dwell times resulting in an increasing number of buses arriving close enough to benefit from preferential treatments.