Norman J. Dovichi

Capillary zone electrophoresis (CZE) is a powerful tool for high resolution chemical separations. Applying CZE to microbial samples may facilitate a deeper understanding of bacterial physiology and behavior. However, the study of complex microbial samples has been limited by the uncontrolled hetero-aggregation of bacterial cells under an applied electric field. We tested a wide range of sample buffers and buffer additives for the optimization of bacterial CZE separations using a 20 mM Tris–HCl background electrolyte. By modifying the sample buffer, but not the background electrolyte, we retain constant separation conditions, which aids in the comparison of the sample buffer additives. We report optimized methods for automated CZE separation and simultaneous fractionation of Escherichia coli B, which is one of the two most widely used wild-type strains. A modified sample buffer containing neutral salts and the addition of glycerol produced a 20-fold increase in loading capacity and a reduction in peak width/broadening of 86% in comparison to previously reported work. In addition, the glycerol-modified sample buffer appears to reduce the persistent aggregation and adhesion to the capillary walls during electrophoretic separations of complex environmental microbiota.

We report an integrated platform that enabled a seamlessly coupling miniaturized filter-aided sample preparation (MICROFASP) method to high-pH reversed phase (RP) or strong cation exchange (SCX) microreactors for low-loss sample preparation and fractionation of 1 μg of cell lysates prior to LC-ESI-MS/MS analysis. Due to the reduced size of the microreactor, only 5 μL of buffer volume is required to generate each fraction, which speeds both elution and lyophilization. The fraction was directly eluted into an autosampler insert vial for LC-MS analysis to reduce sample transfer steps and minimize sample loss as well as contamination. The flow-through sample generated during the loading step was also collected and analyzed. The integrated platform generated 48,890 unique peptides and 4723 protein groups from 1 μg of a K562 cell lysate using MICROFASP and C18 microreactor-based high-pH RP fractionation methods, which are comparable with the state-of-the-art result using in-StageTip sample preparation and nanoflow RPLC-based fractionation methods but with a significant reduction in cost and time. Both pH gradient elution and salt gradient elution approaches provide high reproducibility for the SCX microreactor-based fractionation method. This integrated platform has significant potential in deep proteomics analysis of mass-limited samples with reduced time and equipment requirements.

A robust and compact injection system for capillary electrophoresis that can be rapidly manufactured using 3-D printing technology.

We report both the design of a high-throughput MICROFASP (a miniaturized filter aided sample preparation) system and its use for the comprehensive proteomic analysis of single blastomeres isolated from 50-cell stage Xenopus laevis embryos (∼200 ng of yolk-free protein/blastomere). A single run of the MICROFASP system was used to process 146 of these blastomeres in parallel. Three samples failed to generate signals presumably due to membrane clogging. Two cells were lost due to operator error. Of the surviving samples, 32 were analyzed using a Q Exactive HF mass spectrometer in survey experiments (data not included). The 109 remaining blastomeres were analyzed using a capillary LC-ESI-MS/MS system coupled to an Orbitrap Fusion Lumos mass spectrometer, which identified a total of 4189 protein groups and 40,998 unique peptides. On average, 3468 ± 229 protein groups and 14,525 ± 2437 unique peptides were identified from each blastomere, which is the highest throughput and deepest proteome coverage to date of single blastomeres at this stage of development. We also compared two dissociation buffers, Newport and calcium–magnesium-free (CMFM) buffers; the two buffers generated similar numbers of protein identifications (3615 total protein IDs from use of the Newport dissociation buffer and 3671 total protein IDs from use of the CMFM buffer).

The processing of sexual assault kits (SAKs) relies on the genetic analysis of material extracted from swabs collected from the assault victim. A vital step in producing an identifiable DNA profile of the perpetrator is the effective separation of perpetrator (sperm) and victim (epithelial) DNA that have been isolated from the collected evidence. We report the use of capillary zone electrophoresis for the separation of intact sperm from whole and lysed epithelial cells in SAKs. The separated components are deposited into wells of a microtiter plate using a computer‐controlled fraction collector, and quantitative PCR is used to verify the collection of sperm cells by targeted amplification of male DNA. We present results from simulated sexual assault samples that have been aged for up to 18 months, as well as vaginal swabs from authentic forensic kits. Components extracted from the vaginal swabs from the SAK co‐migrated with an aged semen sample at 6.25 ± 0.25 minutes. Epithelial cells migrated from 10–12 minutes, producing baseline resolution of the components. Sperm cells were collected in a microtiter plate for downstream analysis. This article is protected by copyright. All rights reserved

Stable heavy‐isotope labeling is commonly used in quantitative proteomics. Several common techniques incorporate deuterium (²H) as the heavy isotopic label using reductive amination with formaldehyde. Compared with alternatives, dimethyl labeling reagents are inexpensive and the labeling chemistry is simple and rapid. However, the substitution of hydrogen by deuterium can introduce subtle changes in peptides’ polarities, leading to a shift in chromatographic retention times between deuterated and nondeuterated peptides that can lead to quantification deviations. Capillary zone electrophoresis has emerged as a complementary separation for ESI–MS‐based proteomics, including targeted and quantitative approaches. The extent to which the deuterium isotope effect impacts CZE‐based proteomics, which separates peptides based on their S/N ratios, has not been investigated. To address this issue, CZE was used to analyze dimethyl labeled E. coli tryptic digests in 100 min single‐shot analyses. The median migration time shift was 0.1 s for light versus heavy labeled peptides, which is 2.5% of the peak width. For comparison, nUHPLC–ESI–MS/MS was used to analyze the same sample. In UPLC, deuterated peptides tended to elute earlier than nondeuterated peptides, with a retention shift of 3 s for light versus heavy labeled peptides, which is roughly half the peak width. This shift in separation time did not have a significant effect on quantitation for either method for equal mixing ratios of the light‐intermediate‐heavy isotope labeled samples.

We report a miniaturized Filter Aided Sample Preparation method (micro-FASP) for low-loss preparation of submicrogram proteomic samples. The method employs a filter with ~0.1 mm2 surface area, reduces the total volume of reagents to < 10 μL, and requires only two sample transfer steps. The method was used to generate 25,883 unique peptides and 3,069 protein groups from 1,000 MCF-7 cells (~100 ng protein content), and 13,367 peptides and 1,895 protein groups were identified from 100 MCF-7 cells (~10 ng protein content). Single blastomeres from Xenopus laevis embryos at the 50-cell stage (~200 ng yolk free protein/blastomere) generated 20,943 unique peptides and 2,597 protein groups; the proteomic profile clearly differentiated left and right blastomeres and provides strong support for models in which this asymmetry is established early in the embryo. The parallel processing of 12 samples demonstrates reproducible label free quantitation of 1-μg protein homogenates.

Glycans are known to be involved in many biological processes, while little is known about the expression of N-glycans during vertebrate development. We now report the first quantitative studies of both the expression of N-linked glycans at six early development stages and the expression of N-glycosylated peptides at two early development stages in Xenopus laevis, the African clawed frog. N-Glycans were labeled with isobaric tandem mass tags, pooled, separated by capillary electrophoresis, and characterized using tandem mass spectrometry. We quantified 110 N-glycan compositions that spanned four orders of magnitude in abundance. Capillary electrophoresis was particularly useful in identifying charged glycans; over 40% of the observed glycan compositions were sialylated. The glycan expression was relatively constant until the gastrula–neurula transition (developmental stage 13), followed by massive reprogramming. An increase in oligomannosidic and a decrease in the paucimannosidic and phosphorylated oligomannosidic glycans were observed at the late tailbud stage (developmental stage 41). Two notable and opposing regulation events were detected for sialylated glycans. LacdiNAc and Lewis antigen features distinguished down-regulated sialylation from up-regulated species. The level of Lewis antigen decreased at later stages, which was validated by Aleuria aurantia lectin (AAL) and Ulex europaeus lectin (UEA-I) blots. We also used HPLC coupled with tandem mass spectrometry to identify 611 N-glycosylation sites on 350 N-glycoproteins at the early stage developmental stage 1 (fertilized egg), and 1682 N-glycosylation sites on 1023 N-glycoproteins at stage 41 (late tailbud stage). Over two thirds of the N-glycoproteins identified in the late tailbud stage are associated with neuron projection morphogenesis, suggesting a vital role of the N-glycome in neuronal development.