MMMorten Bo Madsen

Morten Bo Madsen

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Morten Bo Madsen has a total of 877 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Top Cited Papers
    Open Access

    Depositional and Diagenetic Sulfates of Hogwallow Flats and Yori Pass, Jezero Crater: Evaluating Preservation Potential of Environmental Indicators and Possible Biosignatures From Past Martian Surface Waters and Groundwaters

    by Kathleen C. Benison, Karena K. Gill, Sunanda Sharma, Sandra Siljeström, Mike Zawaski, Tanja Bosak, Adrian Broz, Benton C. Clark, Edward Cloutis, Andrew D. Czaja, et al.

    The Mars 2020 Perseverance rover has examined and sampled sulfate‐rich clastic rocks from the Hogwallow Flats member at Hawksbill Gap and the Yori Pass member at Cape Nukshak. Both strata are located on the Jezero crater western fan front, are lithologically and stratigraphically similar, and have been assigned to the Shenandoah formation. In situ analyses demonstrate that these are fine‐grained sandstones composed of phyllosilicates, hematite, Ca‐sulfates, Fe‐Mg‐sulfates, ferric sulfates, and possibly chloride salts. Sulfate minerals are found both as depositional grains and diagenetic features, including intergranular cement and vein‐ and vug‐cements. Here, we describe the possibility of various sulfate phases to preserve potential biosignatures and the record of paleoenvironmental conditions in fluid and solid inclusions, based on findings from analog sulfate‐rich rocks on Earth. The samples collected from these outcrops, Hazeltop and Bearwallow from Hogwallow Flats, and Kukaklek from Yori Pass, should be examined for such potential biosignatures and environmental indicators upon return to Earth.


  • Open Access

    The Mastcam‐Z Radiometric Calibration Targets on NASA's Perseverance Rover: Derived Irradiance Time‐Series, Dust Deposition, and Performance Over the First 350 Sols on Mars

    by M. Merusi, K. B. Kinch, M. B. Madsen, J. F. Bell, J. N. Maki, A. G. Hayes, J. Joseph, J. R. Johnson, M. Rice, E. A. Cloutis, et al.

    The Mastcam‐Z radiometric calibration targets mounted on the NASA's Perseverance rover proved to be effective in the calibration of Mastcam‐Z images to reflectance (I/F) over the first 350 sols on Mars. Mastcam‐Z imaged the calibration targets regularly to perform reflectance calibration on multispectral image sets of targets on the Martian surface. For each calibration target image, mean radiance values were extracted for 41 distinct regions of the targets, including patches of color and grayscale materials. Eight strong permanent magnets, placed under the primary target, attracted magnetic dust and repelled it from central surfaces, allowing the extraction of radiance values from eight regions relatively clean from dust. These radiances were combined with reflectances obtained from laboratory measurements, a one‐term linear fit model was applied, and the slopes of the fits were retrieved as estimates of the solar irradiance and used to convert Mastcam‐Z images from radiance to reflectance. Derived irradiance time series are smoothly varying in line with expectations based on the changing Mars‐Sun distance, being only perturbed by a few significant dust events. The deposition of dust on the calibration targets was largely concentrated on the magnets, ensuring a minimal influence of dust on the calibration process. The fraction of sunlight directly hitting the calibration targets was negatively correlated with the atmospheric optical depth, as expected. Further investigation will aim at explaining the origin of a small offset observed in the fit model employed for calibration, and the causes of a yellowing effect affecting one of the calibration targets materials.


  • Open Access

    Geological, multispectral, and meteorological imaging results from the Mars 2020 Perseverance rover in Jezero crater

    by James F. Bell, Justin N. Maki, Sanna Alwmark, Bethany L. Ehlmann, Sarah A. Fagents, John P. Grotzinger, Sanjeev Gupta, Alexander Hayes, Ken E. Herkenhoff, Briony H. N. Horgan, et al.

    Perseverance’s Mastcam-Z instrument provides high-resolution stereo and multispectral images with a unique combination of spatial resolution, spatial coverage, and wavelength coverage along the rover’s traverse in Jezero crater, Mars. Images reveal rocks consistent with an igneous (including volcanic and/or volcaniclastic) and/or impactite origin and limited aqueous alteration, including polygonally fractured rocks with weathered coatings; massive boulder-forming bedrock consisting of mafic silicates, ferric oxides, and/or iron-bearing alteration minerals; and coarsely layered outcrops dominated by olivine. Pyroxene dominates the iron-bearing mineralogy in the fine-grained regolith, while olivine dominates the coarse-grained regolith. Solar and atmospheric imaging observations show significant intra- and intersol variations in dust optical depth and water ice clouds, as well as unique examples of boundary layer vortex action from both natural (dust devil) and Ingenuity helicopter–induced dust lifting. High-resolution stereo imaging also provides geologic context for rover operations, other instrument observations, and sample selection, characterization, and confirmation.


  • Open Access

    The Mastcam-Z Radiometric Calibration Targets on NASA’s Perseverance Rover: Derived Irradiance Time-Series, Dust Deposition, and Performance over the First 350 Sols on Mars.

    by Marco Merusi, Kjartan Münster Kinch, Morten Bo Madsen, James F. Bell Iii, Justin N. Maki, Alexander G. Hayes, Jonathan Joseph, Jeffrey R. Johnson, Meiissa Rice, Edward Cloutis, et al.

    The Mastcam-Z radiometric calibration targets mounted on the NASA’s Perseverance rover proved to be effective in the calibration of Mastcam-Z images to reflectance (I/F) over the first 350 sols on Mars. Mastcam-Z imaged the calibration targets regularly to perform reflectance calibration on multispectral image sets of targets on the Martian surface. For each calibration target image, mean radiance values were extracted for 41 distinct regions of the targets, including patches of color and grayscale materials. Eight strong permanent magnets, placed under the primary target, attracted magnetic dust and repelled it from central surfaces, allowing the extraction of radiance values from eight regions relatively clean from dust. These radiances were combined with reflectances obtained from laboratory measurements, a one-term linear fit model was applied, and the slopes of the fits were retrieved as estimates of the solar irradiance and used to convert Mastcam-Z images from radiance to reflectance. Derived irradiance time series are smoothly varying in line with expectations based on the changing Mars-Sun distance, being only perturbed by a few significant dust events. The deposition of dust on the calibration targets was largely concentrated on the magnets, ensuring a minimal influence of dust on the calibration process. The fraction of sunlight directly hitting the calibration targets was negatively correlated with the atmospheric optical depth, as expected. Further investigation will aim at explaining the origin of a small offset observed in the fit model employed for calibration, and the causes of a yellowing effect affecting one of the calibration targets materials.

  • Open Access

    Mars Oxygen ISRU Experiment (MOXIE)—Preparing for human Mars exploration

    by Jeffrey A. Hoffman, Michael H. Hecht, Donald Rapp, Joseph J. Hartvigsen, Jason G. SooHoo, Asad M. Aboobaker, John B. McClean, Andrew M. Liu, Eric D. Hinterman, Maya Nasr, et al.

    MOXIE [Mars Oxygen In Situ Resource Utilization (ISRU) Experiment] is the first demonstration of ISRU on another planet, producing oxygen by solid oxide electrolysis of carbon dioxide in the martian atmosphere. A scaled-up MOXIE would contribute to sustainable human exploration of Mars by producing on-site the tens of tons of oxygen required for a rocket to transport astronauts off the surface of Mars, instead of having to launch hundreds of tons of material from Earth’s surface to transport the required oxygen to Mars. MOXIE has produced oxygen seven times between landing in February 2021 and the end of 2021 and will continue to demonstrate oxygen production during night and day throughout all martian seasons. This paper reviews what MOXIE has accomplished and the implications for larger-scale oxygen-producing systems.


  • Open Access

    The Mastcam-Z Radiometric Calibration Targets on NASA’s Perseverance Rover: Derived Irradiance Time-Series, Dust Deposition, and Performance over the First 350 Sols on Mars.

    by Marco Merusi, Kjartan Münster Kinch, Morten Bo Madsen, James F. Bell Iii, Justin N. Maki, Alexander G. Hayes, Jonathan Joseph, Jeffrey R. Johnson, Meiissa Rice, Edward Cloutis, et al.

    The Mastcam-Z radiometric calibration targets mounted on the NASA Perseverance rover proved to be effective in the calibration of Mastcam-Z images to reflectance (I/F) over the first 350 sols on Mars. Mastcam-Z imaged the calibration targets regularly to perform reflectance calibration on multispectral image sets of targets on the Martian surface. For each calibration target image, mean radiance values were extracted for 41 distinct regions of the targets, including patches of color and grayscale materials. Eight strong permanent magnets, placed under the primary target, attracted magnetic dust and repelled it from central surfaces, allowing the extraction of radiance values from eight regions relatively clean from dust. These radiances were combined with reflectances obtained from laboratory measurements, a one-term linear fit model was applied, and the slopes of the fits were retrieved as estimates of the solar irradiance and used to convert Mastcam-Z images from radiance to reflectance. Derived irradiance time series are smoothly varying in line with expectations based on the changing Mars-Sun distance, being only perturbed by a few significant dust events. The deposition of dust on the calibration targets was largely concentrated on the magnets, ensuring a minimal influence of dust on the calibration process. The fraction of sunlight directly hitting the calibration targets was negatively correlated with the atmospheric optical depth, as expected. Further investigation will aim at explaining the origin of a small offset observed in the fit model employed for calibration, and the causes of a yellowing effect affecting one of the calibration targets materials.

  • Open Access

    Homogeneity assessment of the SuperCam calibration targets onboard rover perseverance

    by J.M. Madariaga, J. Aramendia, G. Arana, K. Castro, L. Gómez-Nubla, S. Fdez-Ortiz de Vallejuelo, C. Garcia-Florentino, M. Maguregui, J.A. Manrique, G. Lopez-Reyes, et al.


  • Open Access

    Photometric characterization of Lucideon and Avian Technologies color standards including application for calibration of the Mastcam-Z instrument on the Mars 2020 rover

    by Jennifer Buz, Bethany L. Ehlmann, Kjartan Kinch, Morten Bo Madsen, Jeffrey R. Johnson, Melissa S. Rice, Justin Maki, James F. Bell

    Calibration targets are essential in many applications for accurate radiometric calibration of data. Here, we describe the spectral and photometric properties of color standards from Lucideon and Avian Technologies, which we characterized prior to use on the Mars-2020 (M2020) rover mission. M2020 includes the Mastcam-Z (MCZ) instrument, which consists of a pair of multispectral, visible/near-infrared [VNIR, adjustable-zoom (focusable)] cameras. The science goals of the MCZ instrument, in brief, are to characterize the geomorphology and geology at the rover field site, assess current atmospheric and astronomical phenomena, and provide operational support and scientific context for the M2020 rover.1


  • Open Access

    An Instrument Anomaly in the Mars Exploration Rover Pancam 1,009‐nm Filter (R7): Characterization, Simulation, Correction, and Preliminary Verification

    by Simone J. Jakobsen, Kjartan M. Kinch, Morten Bo Madsen, James F. Bell, Danika Wellington, Lorinda Dajose, Khaled Alizai

  • Open Access

    Martian Eolian Dust Probed by ChemCam

    by J. Lasue, A. Cousin, P.‐Y. Meslin, N. Mangold, R. C. Wiens, G. Berger, E. Dehouck, O. Forni, W. Goetz, O. Gasnault, et al.

    The ubiquitous eolian dust on Mars plays important roles in the current sedimentary and atmospheric processes of the planet. The ChemCam instrument retrieves a consistent eolian dust composition at the submillimeter scale from every first laser shot on Mars targets. Its composition presents significant differences with the Aeolis Palus soils and the Bagnold dunes as it contains lower CaO and higher SiO2. The dust FeO and TiO2 contents are also higher, probably associated with nanophase oxide components. The dust spectra show the presence of volatile elements (S and Cl), and the hydrogen content is similar to Bagnold sands but lower than Aeolis Palus soils. Consequently, the dust may be a contributor to the amorphous component of soils, but differences in composition indicate that the two materials are not equivalent.