Paul Brandl
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Paul Brandl has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Horst Zimmermann
Institute of Electrodynamics, Microwave and Circuit Engineering, Technische Universitt Wien, Vienna, Austria
5 shared publications Alexander Weiss
Institute of Electrodynamics, Microwave and Circuit Engineering, Vienna University of Technology, Gusshausstrasse 25, 1040 Vienna, Austria
1 shared publication- Bernhard Steindl
Institute of Electrodynamics, Microwave and Circuit Engineering, Vienna University of Technology, Vienna, Austria
1 shared publication Kerstin Schneider-Hornstein
Institute of Electrodynamics, Microwave and Circuit Engineering, Vienna University of Technology, Vienna, Austria
1 shared publication- Michael Hofbauer
Technische Universität Wien
1 shared publication R. Enne
Institute of Electrodynamics, Microwave and Circuit Engineering Vienna University of Technology Gusshausstrasse 25/354 1040 Vienna Austria
1 shared publication
Latest Publications
- 24 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Selected Topics in Quantum Electronics
- Vol. 24 (2) , 1-8
Single-Photon Avalanche Photodiode Based Fiber Optic Receiver for Up to 200 Mb/s
The first fully integrated receiver based on single-photon avalanche diodes (SPADs) for data rates of up to 200 Mb/s is reported . An array of four SPADs in combination with quenching circuits and a short dead time of 3.5 ns is fabricated in a 0.35 μm CMOS process. The responses of the SPADs are combined using an integrated digital latch-type processing circuit to create a single output data stream. In addition, the output of each quenching circuit is recorded and the bit error rates are extracted by postprocessing in MATLAB. Using a 635-nm single-mode laser source, the bit error rate at different optical power is measured at 50, 100, 150, and 200 Mb/s. The integrated digital circuit achieved the best sensitivity at –46.3 dBm (BER = 2·10 –3 ) for 100 Mb/s. Using the MATLAB postprocessing, a sensitivity of –43.8 dBm at 200 Mb/s (BER = 6.5·10 –3 ) is reached.
- 24 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Selected Topics in Quantum Electronics
- Vol. 24 (2) , 1-8
Single-Photon Avalanche Photodiode Based Fiber Optic Receiver for Up to 200 Mb/s
The first fully integrated receiver based on single-photon avalanche diodes (SPADs) for data rates of up to 200 Mb/s is reported . An array of four SPADs in combination with quenching circuits and a short dead time of 3.5 ns is fabricated in a 0.35 μm CMOS process. The responses of the SPADs are combined using an integrated digital latch-type processing circuit to create a single output data stream. In addition, the output of each quenching circuit is recorded and the bit error rates are extracted by postprocessing in MATLAB. Using a 635-nm single-mode laser source, the bit error rate at different optical power is measured at 50, 100, 150, and 200 Mb/s. The integrated digital circuit achieved the best sensitivity at –46.3 dBm (BER = 2·10 –3 ) for 100 Mb/s. Using the MATLAB postprocessing, a sensitivity of –43.8 dBm at 200 Mb/s (BER = 6.5·10 –3 ) is reached.
- Open Access
- 1 October 2014
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 50 (21) , 1541-1543
Monolithically integrated optical receiver with large‐area avalanche photodiode in high‐voltage CMOS technology
A novel monolithically integrated optoelectronic receiver with a 200 µm diameter, high responsivity avalanche photodiode (PD) is presented. The whole receiver was developed in a high‐voltage 0.35 µm CMOS technology. This permits high PD bias voltages and the implementation of the receiver circuitry in a single chip. With a PD bias voltage of 65 V, a high responsivity of 30 A/W has been reached at a wavelength of 675 nm. Together with a folded‐cascode transimpedance amplifier, the complete receiver achieves a sensitivity of −31.8 dBm at a data rate of 1 Gbit/s with a bit error rate of 10 −9 and a pseudorandom binary sequence of 2 31 –1.
- 1 October 2014
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 50 (21) , 1541-1543
Open AccessMonolithically integrated optical receiver with large‐area avalanche photodiode in high‐voltage CMOS technology
A novel monolithically integrated optoelectronic receiver with a 200 µm diameter, high responsivity avalanche photodiode (PD) is presented. The whole receiver was developed in a high‐voltage 0.35 µm CMOS technology. This permits high PD bias voltages and the implementation of the receiver circuitry in a single chip. With a PD bias voltage of 65 V, a high responsivity of 30 A/W has been reached at a wavelength of 675 nm. Together with a folded‐cascode transimpedance amplifier, the complete receiver achieves a sensitivity of −31.8 dBm at a data rate of 1 Gbit/s with a bit error rate of 10 −9 and a pseudorandom binary sequence of 2 31 –1.
- 30 June 2014
- Published by Optica Publishing Group in Optics Letters
- Vol. 39 (13) , 4045-4048
Automated alignment system for optical wireless communication systems using image recognition
In this Letter, we describe the realization of a tracked line-of-sight optical wireless communication system for indoor data distribution. We built a laser-based transmitter with adaptive focus and ray steering by a microelectromechanical systems mirror. To execute the alignment procedure, we used a CMOS image sensor at the transmitter side and developed an algorithm for image recognition to localize the receiver’s position. The receiver is based on a self-developed optoelectronic integrated chip with low requirements on the receiver optics to make the system economically attractive. With this system, we were able to set up the communication link automatically without any back channel and to perform error-free (bit error rate ) data transmission over a distance of 3.5 m with a data rate of 3 Gbit/s.- 30 June 2014
- Published by Optica Publishing Group in Optics Letters
- Vol. 39 (13) , 4045-4048
Automated alignment system for optical wireless communication systems using image recognition
In this Letter, we describe the realization of a tracked line-of-sight optical wireless communication system for indoor data distribution. We built a laser-based transmitter with adaptive focus and ray steering by a microelectromechanical systems mirror. To execute the alignment procedure, we used a CMOS image sensor at the transmitter side and developed an algorithm for image recognition to localize the receiver’s position. The receiver is based on a self-developed optoelectronic integrated chip with low requirements on the receiver optics to make the system economically attractive. With this system, we were able to set up the communication link automatically without any back channel and to perform error-free (bit error rate ) data transmission over a distance of 3.5 m with a data rate of 3 Gbit/s.- 15 January 2014
- Published by Wiley in Transactions on Emerging Telecommunications Technologies
- Vol. 25 (6) , 629-637
Development of an optoelectronic integrated circuit for indoor optical wireless communication systems
Indoor optical wireless communication systems use in most cases discrete built receivers. The analogue part of receivers consists of a photodetector and an amplifier. In this paper, we present a fully integrated optoelectronic integrated circuit that combines a photodetector and an amplifier into one single receiver chip. We show the evolution of such receivers and examine the benefits of their production as standard semiconductor chip. We developed a fully integrated receiver for a 3Gbit/s communication in standard BiCMOS technology. We expanded the receiver by additional photodetectors to have the possibility of implementing an automatic alignment system. To demonstrate the performance of this receiver, we built a complete indoor optical wireless communication system. We increased the working area of the system by applying two strategies at the transmitter side. First, we used an adaptive optical system to influence the laser spot diameter. Second, to steer the laser beam, we included a micro‐electro‐mechanical system. Copyright © 2014 John Wiley & Sons, Ltd.
- 15 January 2014
- Published by Wiley in Transactions on Emerging Telecommunications Technologies
- Vol. 25 (6) , 629-637
Development of an optoelectronic integrated circuit for indoor optical wireless communication systems
Indoor optical wireless communication systems use in most cases discrete built receivers. The analogue part of receivers consists of a photodetector and an amplifier. In this paper, we present a fully integrated optoelectronic integrated circuit that combines a photodetector and an amplifier into one single receiver chip. We show the evolution of such receivers and examine the benefits of their production as standard semiconductor chip. We developed a fully integrated receiver for a 3Gbit/s communication in standard BiCMOS technology. We expanded the receiver by additional photodetectors to have the possibility of implementing an automatic alignment system. To demonstrate the performance of this receiver, we built a complete indoor optical wireless communication system. We increased the working area of the system by applying two strategies at the transmitter side. First, we used an adaptive optical system to influence the laser spot diameter. Second, to steer the laser beam, we included a micro‐electro‐mechanical system. Copyright © 2014 John Wiley & Sons, Ltd.
- Open Access
- 1 April 2013
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 49 (8) , 552-554
3 Gbit/s optical receiver IC with high sensitivity and large integrated pin photodiode
An optoelectronic integrated circuit in a 0.35 µm BiCMOS technology containing a 200 µm diameter pin photodiode for optical wireless communication systems is presented. The design consists of a highly efficient integrated Si pin photodiode, a transimpedance amplifier and 50 Ω output driver. The overall transimpedance of the whole receiver is 86.6 dBΩ. At a data rate of 3 Gbit/s with a pseudorandom bit sequence of 2 31 − 1 a sensitivity of − 23.4 dBm is achieved (BER = 10 − 9 , λ = 675 nm).
- 1 April 2013
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 49 (8) , 552-554
Open Access3 Gbit/s optical receiver IC with high sensitivity and large integrated pin photodiode
An optoelectronic integrated circuit in a 0.35 µm BiCMOS technology containing a 200 µm diameter pin photodiode for optical wireless communication systems is presented. The design consists of a highly efficient integrated Si pin photodiode, a transimpedance amplifier and 50 Ω output driver. The overall transimpedance of the whole receiver is 86.6 dBΩ. At a data rate of 3 Gbit/s with a pseudorandom bit sequence of 2 31 − 1 a sensitivity of − 23.4 dBm is achieved (BER = 10 − 9 , λ = 675 nm).