Semih Ener
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Semih Ener has a total of 158 co-authors. Here are the top co-authors by number of shared publications:
- Konstantin P. Skokov
Technical University of Darmstadt
18 shared publications Oliver Gutfleisch
13 shared publications- Oliver Gutfleisch
Institute of Materials Science, Technical University of Darmstadt, Darmstadt, Germany
12 shared publications - Fernando Maccari
Technical University of Darmstadt
5 shared publications - Maximilian Fries
Institute of Materials Science, Technische Universität Darmstadt 2 , Peter-Grünberg-Str. 16, 64287 Darmstadt, Germany
4 shared publications O. Gutfleisch
Tech Univ Darmstadt, Funct Mat, Peter Grunberg Str 16, D-64287 Darmstadt, Germany
4 shared publications
Latest Publications
- Open Access
- 24 December 2024
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 10 (1) , 683-691
Comprehensive Study of τ-Phase Mn–Al–C Magnets: Corrosion Resistance, Structural Integrity, and Magnetic Properties
This study investigates the chemical, physical, and magnetic properties of Mn-Al-C type magnets, focusing on their corrosion resistance. The hot compaction process is used for densification, producing isotropic magnets. Microstructural analysis reveals undesirable features, such as phase decomposition and deformation. Although these consolidated magnets do not have ideal microstructural and magnetic properties, they would serve as a good basis for corrosion experiments and provide a relative comparison of the effect on the magnetic properties. Voltammetry measurements compare the corrosion behavior of consolidated magnets and bulk cast material, revealing a potential difference of about 400 mV. The higher potential in bulk material likely results from reduced porosity and secondary phases. The formation of the β-phase is observed during the hot compaction process. The structural analysis of the corroded samples shows no substantial phase change up to 4 weeks of exposure under different conditions. The magnetic characterization of the corroded samples also shows no significant differences compared with the initial hot densified state. Microstructural analysis of the hot-compacted τ-phase Mn-Al-C magnets shows noticeable surface pitting and increased roughness under alkaline conditions, but no evidence of selective corrosion is observed. These results suggest that Mn-Al-C alloys are promising candidates for applications in which corrosion resistance is critical.
- 24 December 2024
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 10 (1) , 683-691
Open AccessComprehensive Study of τ-Phase Mn–Al–C Magnets: Corrosion Resistance, Structural Integrity, and Magnetic Properties
This study investigates the chemical, physical, and magnetic properties of Mn-Al-C type magnets, focusing on their corrosion resistance. The hot compaction process is used for densification, producing isotropic magnets. Microstructural analysis reveals undesirable features, such as phase decomposition and deformation. Although these consolidated magnets do not have ideal microstructural and magnetic properties, they would serve as a good basis for corrosion experiments and provide a relative comparison of the effect on the magnetic properties. Voltammetry measurements compare the corrosion behavior of consolidated magnets and bulk cast material, revealing a potential difference of about 400 mV. The higher potential in bulk material likely results from reduced porosity and secondary phases. The formation of the β-phase is observed during the hot compaction process. The structural analysis of the corroded samples shows no substantial phase change up to 4 weeks of exposure under different conditions. The magnetic characterization of the corroded samples also shows no significant differences compared with the initial hot densified state. Microstructural analysis of the hot-compacted τ-phase Mn-Al-C magnets shows noticeable surface pitting and increased roughness under alkaline conditions, but no evidence of selective corrosion is observed. These results suggest that Mn-Al-C alloys are promising candidates for applications in which corrosion resistance is critical.
- Open Access
- 8 October 2024
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 610
Structural and magnetic properties of rapidly solidified and Bi-bonded hot compacted MnAl45C1.7Ti magnets- 8 October 2024
- Published by Elsevier in Journal of Magnetism and Magnetic Materials
- Vol. 610
Open AccessStructural and magnetic properties of rapidly solidified and Bi-bonded hot compacted MnAl45C1.7Ti magnets - 15 May 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Grain Boundary Engineering of Nd-based ThMn12 Magnets and Their Nitrides
Grain boundaries in rare earth (RE) permanent magnets are of major importance for magnetically decoupling and sintering densification. In this work, we investigate the grain boundary engineering of the Nd-based ThMn 12 magnets and their nitrides. First, we demonstrate the possibility to form a RE-rich grain boundary by adding excess Nd $(\text{Nd}_{\mathrm{x}}\text{Fe}_{10.5}\text{Mo}_{1.5}$ with $\mathrm{x}=1.2$ and 1.4) in micro- and nanostructured samples. We show that the grain boundary phase is dhcp-Nd and is paramagnetic, being beneficial for magnetically decoupling the grains and optimizing the coercivity. In addition, this phase promotes the liquid-phase sintering process, and we successfully obtained a bulk $\text{Nd}_{1.2}(\text{Pe}_{2}\text{Mo})_{12}$ sample with a relative density of 95 % using Spark Plasma Sintering (SPS). With adding small amounts of Cu or Ga elements, we were able to tune the grain boundary phase properties in lowering its melting point by forming eutectic phase. Next, we focus on the effect of grain boundary in nitrides. We show that during the nitrogenation process, the dhcp-Nd grain boundary phase reacts with nitrogen to form NdN grain boundary phase, which is paramagnetic at room temperature. However, magnetic characterization suggests that the NdN grain boundary does not influence the magnetic coupling of grains resulting in no further improvement of the coercivity. In addition, NdN inhibits liquid-phase sintering of the nitrided compounds, due to its high melting point $(> 1500^{\circ}\mathrm{C})$ , limiting the relative density to 65% after SPS.- 15 May 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-2
Grain Boundary Engineering of Nd-based ThMn12 Magnets and Their Nitrides
Grain boundaries in rare earth (RE) permanent magnets are of major importance for magnetically decoupling and sintering densification. In this work, we investigate the grain boundary engineering of the Nd-based ThMn 12 magnets and their nitrides. First, we demonstrate the possibility to form a RE-rich grain boundary by adding excess Nd $(\text{Nd}_{\mathrm{x}}\text{Fe}_{10.5}\text{Mo}_{1.5}$ with $\mathrm{x}=1.2$ and 1.4) in micro- and nanostructured samples. We show that the grain boundary phase is dhcp-Nd and is paramagnetic, being beneficial for magnetically decoupling the grains and optimizing the coercivity. In addition, this phase promotes the liquid-phase sintering process, and we successfully obtained a bulk $\text{Nd}_{1.2}(\text{Pe}_{2}\text{Mo})_{12}$ sample with a relative density of 95 % using Spark Plasma Sintering (SPS). With adding small amounts of Cu or Ga elements, we were able to tune the grain boundary phase properties in lowering its melting point by forming eutectic phase. Next, we focus on the effect of grain boundary in nitrides. We show that during the nitrogenation process, the dhcp-Nd grain boundary phase reacts with nitrogen to form NdN grain boundary phase, which is paramagnetic at room temperature. However, magnetic characterization suggests that the NdN grain boundary does not influence the magnetic coupling of grains resulting in no further improvement of the coercivity. In addition, NdN inhibits liquid-phase sintering of the nitrided compounds, due to its high melting point $(> 1500^{\circ}\mathrm{C})$ , limiting the relative density to 65% after SPS.- Open Access
- 24 January 2023
- Published by American Physical Society (APS) in Physical Review Materials
- Vol. 7 (1) , 014410
Combined ab initio and experimental screening of phase stabilities in the Ce-Fe-Ti- system ( and metals)One of the main challenges for the synthesis and application of the promising hard-magnetic compound is the formation of Laves phases that are detrimental for their thermodynamic stability and magnetic properties. In this paper, we present an ab initio based approach to modify the stability of these phases in the Ce-Fe-Ti system by additions of and elements. We combine highly accurate free-energy calculations with an efficient screening technique to determine the critical annealing temperature for the formation of . The central findings are the dominant role of the formation enthalpy at K on chemical trends and the major relevance of partial chemical decompositions. Based on these insights, promising transition metals to promote the stability of the hard-magnetic phase, such as Zn and Tc, were predicted. The comparison with suction casting and reactive crucible melting experiments for Ce-Fe-Ti-X (X = Cu, Ga, Co, and Cr) highlights the relevance of additional phases and quaternary elements.- 24 January 2023
- Published by American Physical Society (APS) in Physical Review Materials
- Vol. 7 (1) , 014410
Open AccessCombined ab initio and experimental screening of phase stabilities in the Ce-Fe-Ti- system ( and metals)One of the main challenges for the synthesis and application of the promising hard-magnetic compound is the formation of Laves phases that are detrimental for their thermodynamic stability and magnetic properties. In this paper, we present an ab initio based approach to modify the stability of these phases in the Ce-Fe-Ti system by additions of and elements. We combine highly accurate free-energy calculations with an efficient screening technique to determine the critical annealing temperature for the formation of . The central findings are the dominant role of the formation enthalpy at K on chemical trends and the major relevance of partial chemical decompositions. Based on these insights, promising transition metals to promote the stability of the hard-magnetic phase, such as Zn and Tc, were predicted. The comparison with suction casting and reactive crucible melting experiments for Ce-Fe-Ti-X (X = Cu, Ga, Co, and Cr) highlights the relevance of additional phases and quaternary elements. - Open Access
- 27 October 2022
- Published by Elsevier in Acta Materialia
- Vol. 242
Magnetic properties of NdFe 11 Ti and YFe 11 Ti, from experiment and theory
- 27 October 2022
- Published by Elsevier in Acta Materialia
- Vol. 242
Open AccessMagnetic properties of NdFe 11 Ti and YFe 11 Ti, from experiment and theory
- 1 September 2021
- Published by Elsevier in Acta Materialia
- Vol. 217
Influence of microstructure on the application of Ni-Mn-In Heusler compounds for multicaloric cooling using magnetic field and uniaxial stress
- 1 September 2021
- Published by Elsevier in Acta Materialia
- Vol. 217
Influence of microstructure on the application of Ni-Mn-In Heusler compounds for multicaloric cooling using magnetic field and uniaxial stress
- 1 August 2021
- Published by Elsevier in Acta Materialia
- Vol. 214
Twins – A weak link in the magnetic hardening of ThMn12-type permanent magnets
- 1 August 2021
- Published by Elsevier in Acta Materialia
- Vol. 214
Twins – A weak link in the magnetic hardening of ThMn12-type permanent magnets
- 10 March 2021
- Published by American Physical Society (APS) in Physical Review Materials
- Vol. 5 (3) , 034407
Neutron study of magnetic correlations in rare-earth-free Mn-Bi magnets
We report the results of an unpolarized small-angle neutron scattering (SANS) study on Mn-Bi-based rare-earth-free permanent magnets. The magnetic SANS cross section is dominated by long-wavelength transversal magnetization fluctuations, and has been analyzed in terms of the Guinier-Porod model and the distance distribution function. This provides the radius of gyration which, in the remanent state, ranges between about for the three different alloy compositions investigated. Moreover, computation of the distance distribution function, in conjunction with results for the so-called parameter obtained from the Guinier-Porod model, indicates that the magnetic scattering of a sample has its origin in slightly shape-anisotropic structures.- 10 March 2021
- Published by American Physical Society (APS) in Physical Review Materials
- Vol. 5 (3) , 034407
Neutron study of magnetic correlations in rare-earth-free Mn-Bi magnets
We report the results of an unpolarized small-angle neutron scattering (SANS) study on Mn-Bi-based rare-earth-free permanent magnets. The magnetic SANS cross section is dominated by long-wavelength transversal magnetization fluctuations, and has been analyzed in terms of the Guinier-Porod model and the distance distribution function. This provides the radius of gyration which, in the remanent state, ranges between about for the three different alloy compositions investigated. Moreover, computation of the distance distribution function, in conjunction with results for the so-called parameter obtained from the Guinier-Porod model, indicates that the magnetic scattering of a sample has its origin in slightly shape-anisotropic structures.