MCMatteo Cargnello

Matteo Cargnello

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Matteo Cargnello has a total of 487 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • High Temperature Stable Pt Nanoclusters Formation in Alumina-Encapsulated Pt Catalysts

    by Gennaro Liccardo, Shyama C. Mandal, Jacob Smith, Tomás Vergara, Arik Beck, Miaofang Chi, Frank Abild-Pedersen, Stacey F. Bent, Matteo Cargnello

    Metal nanoparticle sintering in high-temperature oxidizing atmospheres remains a primary deactivation pathway for platinum-group metal catalysts on alumina supports. Here, atomic layer deposition (ALD) was used to deposit alumina on supported Pt catalysts and develop alumina-encapsulated Pt/Al2O3 catalysts that were aged at 800 °C under different atmospheres and characterized by time-resolved high-angle annular dark-field scanning transmission electron microscopy (HAADF-STEM), CO-probe diffuse reflectance infrared Fourier transform spectroscopy (CO-DRIFTS), and propene combustion kinetics. Within the alumina-encapsulated system, a sub-2 nm Pt cluster population formed under all oxidizing atmospheres tested but not under inert atmosphere, and this population persisted for at least 12 h at 800 °C under propene complete combustion (PCC) conditions. Unencapsulated Pt/Al2O3 controls, by contrast, developed only a transient sub-2 nm population, detected within 1 min of aging in air at 800 °C and no longer present afterward, consistent with the rapid disappearance of small particles predicted by Ostwald ripening theory. CO-DRIFTS confirmed the presence of undercoordinated Pt surface sites in all oxidatively aged samples, with no detectable signal when the sample was aged under inert atmosphere. Propene combustion rates measured after aging for an alumina-encapsulated catalyst were approximately two and five times higher than the fresh encapsulated catalyst for catalysts aged under inert atmosphere and under oxygen and steam, respectively. DFT calculations of Pt diffusion through defective Al2O3 identified kinetically accessible diffusion pathways at 800 °C, with activation barriers as low as 0.76 eV. Furthermore, Pt surface binding was calculated to be favored in the presence of O2. These results identify oxygen-driven surface segregation, mediated by defect-assisted diffusion through the ALD overcoat, as a possible mechanism responsible for nanocluster formation in this system. The persistence of the sub-2 nm cluster population for at least 12 h at 800 °C under PCC conditions demonstrates the thermal stability of these sites within the encapsulated architecture.

  • Open Access

    Enhancing selectivity and yield in polyethylene hydrogenolysis using goal-aware Bayesian algorithm execution

    by Makenna L. Pennel, Akash Ramdas, Sean Gasiorowski, Sathya R. Chitturi, Willie Neiswanger, Nicholas D. Broadbent, Mike Dunne, Felipe H. da Jornada, Daniel Ratner, Christopher Tassone, et al.

    An AI-driven sequential design approach coupled with human intuition to maximize the expected information gain about a complex multi-objective user goal in the field of polyolefin hydrogenolysis.

  • Boosting Ethanol Production via Strategic CO Co-Feeding in CO2 Hydrogenation over Rh-Based Catalysts

    by Pin-Hung Chung, Jinwon Oh, Roel S. Sánchez-Carrera, Carlos Lizandara-Pueyo, Yuejin Li, Matteo Cargnello

    The catalytic hydrogenation of carbon dioxide (CO2) to ethanol is a highly promising reaction for carbon utilization and the production of renewable fuels and chemicals. Achieving high ethanol selectivity remains the biggest challenge in the field. Ethanol formation on rhodium (Rh)-based catalysts from CO2 hydrogenation relies on the carbon monoxide (CO) insertion pathway that is kinetically limited compared to the competing hydrogenation of methyl intermediates to methane. In this study, we demonstrate that adding CO to the CO2 hydrogenation reaction stream over colloidally synthesized Rh/Fe/Li–TiO2 catalysts can effectively overcome this limitation. This direct co-feeding strategy promotes C–C coupling and suppresses methanation, increasing ethanol selectivity 5-fold to 24% and boosting the space-time yield 6-fold with only a 15% CO cofeed (CO/(CO + CO2)). Under optimized, hydrogen-deficient conditions (H2/(CO + CO2)), the ethanol selectivity further increases to 32%. Our findings present an efficient, simplified pathway for upgrading CO2-rich streams into higher-value chemicals.

  • Autothermal methane pyrolysis: Scalable heat integration for hydrogen and graphite production

    by Henry Moise, Sebastian Moll, Shailesh Pathak, Joshua Martinez-Navarro, Sai Varanasi, Kun Xu, Eric McFarland, Arun Majumdar, Matteo Cargnello

    Methane pyrolysis (MP) offers a compelling opportunity to meet low-carbon hydrogen demand using existing energy infrastructure. A key limitation in scaling MP is the efficient delivery of high-temperature heat into the reactor. We show that hydrogen-fueled autothermal operation overcomes this limitation, enabling an increase of several orders of magnitude in the reactor throughput for commercially relevant bed diameters. It also yields a carbon coproduct of 96.0% degrees of graphitization, meeting graphite precursor specifications and enabling domestic graphite production from natural gas using low-cost iron oxide catalysts. We further demonstrate a strategy to suppress the direct emissions inherent to autothermal operation, reducing them to near zero. A process-level life cycle assessment estimates that carbon intensities for autothermal methane pyrolysis can be as low as 1.9 to 4.5 kilograms (kg) of CO 2,eq per kg H 2 .

  • Synthesizing Colloidal Bimetallic Nanoparticles in Water Using a Dual‐Ligand Strategy

    by Pin‐Hung Chung, Alex M. Fontani Herreros, Jinwon Oh, Roel S. Sánchez‐Carrera, Carlos Lizandara‐Pueyo, Yuejin Li, Matteo Cargnello

    Controlled aqueous synthesis of bimetallic nanoparticles below 5 nm remains challenging due to reduction potential mismatches between noble and base metals, which often causes uncontrolled aggregation. Here, we propose a dual‐ligand strategy to assist the commonly used seed‐mediated method in aqueous phase to demonstrate fine control for the formation of uniform bimetallic nanoparticles. To decouple reduction kinetics and colloidal stabilization, polyvinylpyrrolidone (PVP) was used as a steric stabilizer for the preparation of the seeds, and polyethyleneimine (PEI) as a strong chelating agent to strictly regulate base metal reduction on the surface of seeds. This strategy allows controlled deposition and pairing of noble metal seeds (e.g., Pt, Pd, and Rh) with base metals (e.g., Cu, Ni, Co, and Fe) with a tunable atomic ratio from 3:1 to 1:2. Furthermore, we demonstrate that this synthetic platform can be extended to trimetallic compositions (such as Pt/Cu/Co and Pt/Cu/Ni). To demonstrate the utility of uniform nanoparticles prepared with this strategy, several bimetallic nanoparticle combinations were evaluated for the catalytic hydrogenation of carbon dioxide (CO 2 ). Optimizing the metal composition and support materials maximized active Rh sites and Rh─Fe interfaces to enhance ethanol production. This work presents a robust synthetic platform for synthesizing bimetallic nanoparticle catalysts.


  • Synthesizing Colloidal Bimetallic Nanoparticles in Water Using a Dual‐Ligand Strategy

    by Pin‐Hung Chung, Alex M. Fontani Herreros, Jinwon Oh, Roel S. Sánchez‐Carrera, Carlos Lizandara‐Pueyo, Yuejin Li, Matteo Cargnello

    Controlled aqueous synthesis of bimetallic nanoparticles below 5 nm remains challenging due to reduction potential mismatches between noble and base metals, which often causes uncontrolled aggregation. Here, we propose a dual‐ligand strategy to assist the commonly used seed‐mediated method in aqueous phase to demonstrate fine control for the formation of uniform bimetallic nanoparticles. To decouple reduction kinetics and colloidal stabilization, polyvinylpyrrolidone (PVP) was used as a steric stabilizer for the preparation of the seeds, and polyethyleneimine (PEI) as a strong chelating agent to strictly regulate base metal reduction on the surface of seeds. This strategy allows controlled deposition and pairing of noble metal seeds (e.g., Pt, Pd, and Rh) with base metals (e.g., Cu, Ni, Co, and Fe) with a tunable atomic ratio from 3:1 to 1:2. Furthermore, we demonstrate that this synthetic platform can be extended to trimetallic compositions (such as Pt/Cu/Co and Pt/Cu/Ni). To demonstrate the utility of uniform nanoparticles prepared with this strategy, several bimetallic nanoparticle combinations were evaluated for the catalytic hydrogenation of carbon dioxide (CO 2 ). Optimizing the metal composition and support materials maximized active Rh sites and Rh─Fe interfaces to enhance ethanol production. This work presents a robust synthetic platform for synthesizing bimetallic nanoparticle catalysts.

  • Data as the Backbone of Artificial Intelligence: Insights from Heterogeneous Catalysis

    by Dongjae Shin, Ruchika Mahajan, Zan Lian, Jake Heinlein, Matteo Cargnello, Christopher J. Tassone, Kirsten T. Winther

    Machine learning (ML) and artificial intelligence (AI) are changing how catalysis science is performed, with the prospect of accelerating the discovery of catalysis knowledge. Despite the substantial efforts and resources invested in the development and application of AI/ML approaches, their performance still exhibits clear limitations due to the lack of usable data. Although decades of work have produced an abundance of catalysis data, much of it was generated without sufficient understanding of AI/ML or community-wide consensus on terminology and reporting standards. As a result, not all of this data is suitable for training models. It is therefore essential to define what constitutes AI-ready data and understand the efforts required to obtain it, in order to prepare for the era of AI-driven catalysis. In this perspective, we define the essential properties of AI-ready data that enable the construction of robust catalysis AI/ML models. Then, we discuss current practices in computational and experimental catalysis through the lens of data readiness for AI/ML applications. Lastly, we discuss community-level efforts needed to establish large-scale datasets ready for AI-driven catalysis research.

  • Quantifying uncertainty in catalyst activity and deactivation during CO2 hydrogenation via round-robin testing for data-driven modelling

    by Selin Bac, Dongjae Shin, Seunghwa Hong, Jake Heinlein, Anastassiya Khan, Greg Barber, Zhihengyu Chen, Michael M. Albrechtsen, Christopher Tassone, Robert M. Rioux, et al.


  • Enhancing CO Oxidation Rate via Electronic Tuning of CO Binding on Bimetallic Nanoparticle Catalysts

    by Pin-Hung Chung, Shaohua Xie, Xiaodi Li, Shyama Charan Mandal, Zisheng Zhang, Jinwon Oh, Fudong Liu, Frank Abild-Pedersen, Roel S. Sánchez-Carrera, Carlos Lizandara-Pueyo, et al.

  • Tailored Rh–Al 2 O 3 –ZrO 2 Interfaces: Insights into Rh Aluminate Formation and Enhanced Stability

    by Gennaro Liccardo, Bang T. Nhan, Pin-Hung Chung, Daniel Hutton, Giulio D’ACunto, Shyama C. Mandal, Jacob Smith, Sydney Richardson, Miaofang Chi, Frank Abild-Pedersen, et al.