Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Ratnesh Kumar Pandey has a total of 119 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Tailoring surface and structural properties of WO3 thin films via mixed-gas plasma deposition for optimized H2 gas sensing performance

    by Santosh Kumar, Archana Singh Kharb, Shristi Bist, Hritik Yadav, Amit Kumar Chawla, Shikha Awasthi, Amol Singh, Ratnesh K. Pandey

    Detecting hydrogen at low concentration is essential for the early identification of leaks in hydrogen storage and transportation systems, thereby improving operational safety. In this work, thin films of tungsten trioxide (WO 3 ), a well-known hydrogen-sensing material, were deposited via DC reactive magnetron sputtering under systematically varied gas environments to elucidate the role of deposition conditions in tailoring film morphology and sensing performance. Introducing mixed Ar/O 2 , Ar/He/O 2 , and He/O 2 sputtering atmospheres with varying gas flow rates at a substrate temperature of 400 °C produced a marked reduction in grain size and film thickness compared with films grown in an equal flow-rate Ar/O 2 plasma. The film synthesized in the Ar/O 2 environment exhibited superior resistance modulation upon H 2 exposure and significantly enhanced sensitivity compared with the other films. Gas sensing characteristics toward H 2 were evaluated at operating temperatures of 100, 150, and 200 °C, and the optimized film was further investigated for low H 2 concentrations down to 25 ppm. These findings demonstrate a strong correlation between microstructure and sensing response and highlight the critical influence of the deposition environment on the morphological and electronic properties of WO 3 thin films, providing a viable strategy for developing next-generation high-performance hydrogen gas sensors.

  • Open Access

    Yielding Enhanced Gas Sensing in WO3 Thin Films via p-n Heterojunction Formation

    by Santosh Kumar, Archana Singh Kharb, Amit Kumar Chawla, Amol Singh, Subrata Ghosh, Ratnesh K Pandey

    Semiconductor nanostructures have attracted considerable attention for developing high-performance gas sensors for the high-level detection of highly flammable and toxic gases. Herein, the present work integrates n-type WO3 with p-type Ag2O to form a p-n heterojunction by DC reactive magnetron co-sputtering technique. The CH4 sensing performance of the p-n heterojunction with Ag content is correlated with the crystalline structure, surface morphology, elemental composition, optical band gap, and chemical states of the thin film. The p-n heterojunction thin film with 3.63 at. % Ag exhibits a maximum CH4 sensitivity of 70.61 % towards 25 ppm at a low operating temperature of 75 °C. The optimised CH4 sensor also demonstrates a fast response/recovery time of 28 s/106 s with a low detection limit of 1 ppm, excellent repeatability, and long-term stability. The effectiveness of the p-n heterojunction is validated by comparing the sensing performance with that of pristine n-type WO3. Moreover, the utilisation of our optimised p-n heterojunction thin-film-based sensor is further extended towards CO, H2S, H2 and NH3 gas detection, with a detection limit of 25 ppm. This easily implementable approach to designing p-n heterojunctions could pave the way for advanced next-generation sensing technology.

  • Open Access

    Modification of Surface Properties in Ruthenium Thin Films through Nitrogen Ion Irradiation

    by Anmol Sharma, Arnab Tripathy, Rajeev Gupta, Raj Kumar, Harsh Vardhan, Ratnesh Kumar Pandey, Atul Thakur, Shalendra Kumar, Ranjeet Kumar Brajpuriya, Vishakha Kaushik, et al.

    Surface modification is an important strategy for tailoring the physical and chemical properties of materials for advanced technological applications. In thin films, changes in surface structure, roughness, and composition can strongly influence their functional behavior. In this work, we studied the effect of N+-ion irradiation at 20 keV energy on Ru thin films of two different thicknesses, 100 Å and 1000 Å, over a fluence range of ~1014 to 1017 ions/cm2. The main objective of this study is to investigate the evolution of the structural and wettability properties of Ru thin films of different thicknesses under increasing ion fluence. Overall, the results reveal that increasing ion fluence promotes surface roughening in both film thicknesses, which is correlated with an increase in contact angle. This indicates a clear transition from hydrophilic to hydrophobic behaviour, with the highest contact angle of ~95.54° observed at a fluence of 1017 ions/cm2. TRIM simulations reveal that for the 100 Å film, the projected ion range exceeds the film thickness, allowing interaction with the bottom substrate, whereas in the 1000 Å film, ion penetration remains largely confined within the Ru layer. GIXRD confirms fluence-dependent structural modification, including peak broadening with preferred orientation changes from Ru (101) to (002). Overall, this study demonstrates that N+-ion irradiation serves as an effective route for tuning both the surface morphology and wettability of Ru thin films, enabling controlled enhancement of hydrophobicity.

  • Open Access

    Enhanced erosion resistance and radiation stability of WC–WO 3 nanocomposite films under 100 keV Kr + ion irradiation

    by Shristi Bist, Parswajit Kalita, Ratnesh K Pandey, Sejal Shah, Richa Krishna, Umapathy G. R., Sunil Ojha, Devesh K Avasthi

    Plasma-facing components (PFCs) in fusion reactors are exposed to extreme radiation and thermal environments, leading to material degradation processes such as sputtering erosion and amorphization. This study investigates and compares the erosion behaviour of tungsten (W) in potential ceramic-based PFC materials, specifically tungsten carbide (WC) thin films and their nanocomposite counterpart, WC–WO 3 , under 100 keV Kr + ion irradiation. The films were irradiated at fluences of 1 × 10 16 , 3 × 10 16 , and 1 × 10 17 ions/cm 2 . Rutherford backscattering spectrometry was employed to evaluate W sputtering yields and compositional stability. The WC–WO 3 nanocomposite exhibited significantly reduced W erosion compared to pure WC films, attributed to the higher W binding energy and the existence of heterointerfaces within the nanocomposite matrix. SRIM simulations corroborated the experimental sputtering trends. Furthermore, preferential sputtering of lower- Z elements (C and O) was observed in both material systems. Glancing incidence X-ray diffraction analysis revealed post-irradiation grain growth in WC–WO 3 films, while scanning electron microscopy results show morphological changes, indicating dynamic microstructural evolution rather than amorphization under irradiation. These results highlight the potential of WC–WO 3 nanocomposites as erosion-resistant and structurally resilient candidates for future plasma-facing applications in fusion reactors.


  • Structural and morphological modifications in tungsten carbide thin films under low-energy Kr 2+ and He + ion irradiations

    by Shristi Bist, Ratnesh K Pandey, Sejal Shah, D K Avasthi

    Tungsten carbide (WC) thin films, known for their exceptional thermal stability and mechanical strength, were systematically investigated for their response to ion irradiation using 200 keV Kr 2+ and 100 keV He + ions. The study aims to elucidate structural and surface modifications relevant to advanced applications in extreme radiation environments. Films deposited via DC magnetron sputtering were characterized before and after irradiation using glancing incidence x-ray diffraction (GIXRD), atomic force microscopy (AFM), and scanning electron microscopy (SEM). Kr 2+ irradiation, dominated by nuclear energy loss, led to pronounced grain refinement, lattice distortion, and surface nanostructuring, while He + irradiation caused only minimal changes due to lower nuclear energy loss value. Radiation-induced damage was further quantified through TRIM simulations and correlated with experimental parameters such as FWHM broadening and grain size evolution. The results demonstrate the strong fluence- and ion-mass-dependent behaviour of WC, highlighting its resilience against light ion exposure and providing critical insights into its potential use as a plasma-facing material in nuclear reactor.


  • Open Access

    Influence of Nitrogen Ion Implantation on the Structural, Morphological and Optical Properties of Al‐Doped ZnO [AZO] Thin Films for High‐Performance Optoelectronic Applications

    by Richa Sharma, Fouran Singh, Jag Mohan Singh Rana, Tanuj Kumar, Ratnesh K. Pandey, Aniruddha Mondal, Pankaj Chamoli, Rajeev Gupta

    The work reports the near‐surface doping of N ions, and post implantation effects on the structural, morphological, optical, and electrical properties of Al‐doped ZnO [AZO] thin film deposited by the Radion Frequency (RF) magnetron sputtering method, investigated at room temperature. The Grazing Incidence X‐ray diffraction (GIXRD) studies revealed the structural modifications caused by the implanted ions. The field emission scanning electron microscopy (FE‐SEM) micrographs showed the morphological modifications in the AZO thin film due to implantation. The crystallinity of the thin film structure was preserved even after high ion implantation of 1 × 10 16 ions/cm 2 . Optical analysis revealed a noticeable decrease in average transmittance in the wavelength range of 350 to 500 nm. An increase in electrical resistivity value was witnessed as a post‐implantation effect.The Fourier Transform Infra Red (FTIR) spectroscopy was employed to study the ion implantation on the vibrational properties. The study shows that the ion implantation method can effectively be used to dope N ions into AZO thin films to tailor their various properties. Nitrogen‐doped AZO thin films, with reduced transmittance in the 350–500 nm range and mid‐gap states, exhibit enhanced ultraviolet (UV) sensitivity, making them ideal for optoelectronic applications.


  • Open Access

    Exploring the Role of Metal Oxide Heterostructures for Next-Generation Gas Sensors: A Focus on NH3, H2S and NO2 gases

    by Santosh Kumar, Akula Umamaheswara Rao, Amit Kumar Chawla, Shikha Awasthi, Ratnesh K Pandey


  • Exploring the role of substrate temperature in tailoring the gas sensing performance of sputter-deposited WO3 films

    by Santosh Kumar, Akula Umamaheswara Rao, Amit Kumar Chawla, Ratnesh K Pandey

    Due to the increasing demand for gas sensors, particularly in the oil and gas industry for accurate detection and safe operation, the present study is centered on the synthesis process of WO3 thin-films, as WO3 is a promising material for sensitive gas detection. Using pulsed DC magnetron sputtering, WO3 films were coated on silicon (100) and ITO-coated glass substrates at different substrate temperatures varying from room temperature to 800 °C in 200 °C intervals. The XRD pattern revealed that increasing the substrate temperature beyond 400 °C led to a phase transformation from monoclinic to hexagonal WO3. The surface morphological studies using FESEM showed a transition from a fine granular structure at room temperature to larger grains at higher temperatures, reflecting enhanced grain growth. Gas sensing measurements were conducted at 200 °C in a static test chamber, demonstrating that the sensitivity is strongly depending on the substrate temperature and corresponding microstructure. Gas sensing performance was evaluated for gases like hydrogen (H2), methane (CH4), and carbon monoxide (CO). The films coated at 800 °C showed the highest sensitivity to CH4, with a rapid response time of 20 s and a recovery time of 25 s. Notably, the thin film sensor demonstrated excellent repeatable sensitivity to 25 ppm of CH4. These findings emphasize the critical role of substrate temperature in tailoring the phase composition and grain structure of WO3 thin films for CH4 sensing applications.


  • Nanostructuring, fractal characterization and wettability of ion irradiated Au thin films and their thickness effect

    by Shivani Chaudhary, Vinay K. Srivastava, Mukesh Kumar, Raj Kumar, Sunil Ojha, R.P. Yadav, Sourav Bhakta, Ratnesh K. Pandey, Ravi S. Singh, Udai B. Singh


  • SERS detection of Rhodamine-6G on Au/V2O5/Au under ion irradiation

    by Priya Jasrotia, Raj Kumar, Indra Sulania, Ratnesh K Pandey, Rajeev Gupta, Ajay Singh Verma, Ashish Kumar, Tanuj Kumar