Michal Václavů
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Michal Václavů has a total of 95 co-authors. Here are the top co-authors by number of shared publications:
- Vladimír Matolín
Charles University
22 shared publications - Iva Matolínová
Faculty of Mathematics and Physics Department of Surface and Plasma Science Charles University Prague Czech Republic
14 shared publications - Ivan Khalakhan
Department of Surface and Plasma Science, Faculty of Mathematics and Physics, Charles University, V Holesovickach 2, 180 00 Prague 8, Czech Republic
13 shared publications - Mykhailo Vorokhta
Department of Surface and Plasma Science, Faculty of Mathematics and Physics, Charles University, V Holesovickach 2, 180 00 Prague 8, Czech Republic
12 shared publications - Roman Fiala
Charles University
11 shared publications - Tomáš Skála
Charles University, Faculty of Mathematics and Physics, Department of Surface and Plasma Science, V Holešovičkách 2, Prague 18000, Czech Republic
8 shared publications
Latest Publications
- 1 July 2019
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 44 (35) , 19344-19356
Optimization of ionomer-free ultra-low loading Pt catalyst for anode/cathode of PEMFC via magnetron sputtering
- 1 July 2019
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 44 (35) , 19344-19356
Optimization of ionomer-free ultra-low loading Pt catalyst for anode/cathode of PEMFC via magnetron sputtering
- 7 February 2018
- Published by Wiley in Fuel Cells
- Vol. 18 (1) , 51-56
Efficient Pt‐C MEA for PEMFC with Low Platinum Content Prepared by Magnetron Sputtering
The presented research is focused on improvement of platinum utilization in Pt‐C composite catalysts for proton exchange membrane fuel cell (PEMFC) applications. A series of 25 nm thick nanostructured Pt‐C thin films were deposited on carbon paper gas diffusion layer substrates (GDL; Sigracet 29 BC) by a single‐step magnetron sputtering method.Total Pt loading in the thin films varied in the range 6.7–9.7 µg cm−2 as determined by X‐ray photoelectron spectroscopy (XPS). These catalysts were examined for their activity in hydrogen oxidation reaction (HOR) and oxygen reduction reaction (ORR), continuously operating for periods exceeding 24 hours. The dependence of cell output power on Pt concentration and on the working pressure in the cell was examined.Membrane electrode assembly (MEA) with both magnetron sputtered electrodes and a total (anode + cathode) Pt loading 16.7 µg cm−2 was also examined during an extended 250‐hour durability test. A stable power density 0.73 W cm−2 was achieved with cell pressure of 300 kPa. Apart from reasonably small power fluctuations no long‐term efficiency loss has been detected.
- 7 February 2018
- Published by Wiley in Fuel Cells
- Vol. 18 (1) , 51-56
Efficient Pt‐C MEA for PEMFC with Low Platinum Content Prepared by Magnetron Sputtering
The presented research is focused on improvement of platinum utilization in Pt‐C composite catalysts for proton exchange membrane fuel cell (PEMFC) applications. A series of 25 nm thick nanostructured Pt‐C thin films were deposited on carbon paper gas diffusion layer substrates (GDL; Sigracet 29 BC) by a single‐step magnetron sputtering method.Total Pt loading in the thin films varied in the range 6.7–9.7 µg cm−2 as determined by X‐ray photoelectron spectroscopy (XPS). These catalysts were examined for their activity in hydrogen oxidation reaction (HOR) and oxygen reduction reaction (ORR), continuously operating for periods exceeding 24 hours. The dependence of cell output power on Pt concentration and on the working pressure in the cell was examined.Membrane electrode assembly (MEA) with both magnetron sputtered electrodes and a total (anode + cathode) Pt loading 16.7 µg cm−2 was also examined during an extended 250‐hour durability test. A stable power density 0.73 W cm−2 was achieved with cell pressure of 300 kPa. Apart from reasonably small power fluctuations no long‐term efficiency loss has been detected.
- 1 August 2017
- Published by Elsevier in Electrochimica Acta
- Vol. 245, 760-769
In situ probing of magnetron sputtered Pt-Ni alloy fuel cell catalysts during accelerated durability test using EC-AFM
- 1 August 2017
- Published by Elsevier in Electrochimica Acta
- Vol. 245, 760-769
In situ probing of magnetron sputtered Pt-Ni alloy fuel cell catalysts during accelerated durability test using EC-AFM
- 7 December 2016
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 128 (2) , 779-785
The effect of different atmospheres on structural changes of titanate nanotubes during heating
- 7 December 2016
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 128 (2) , 779-785
The effect of different atmospheres on structural changes of titanate nanotubes during heating
- 1 November 2016
- Published by Elsevier in Applied Catalysis B: Environment and Energy
- Vol. 197, 262-270
High efficiency of Pt2+- CeO2 novel thin film catalyst as anode for proton exchange membrane fuel cells
- 1 November 2016
- Published by Elsevier in Applied Catalysis B: Environment and Energy
- Vol. 197, 262-270
High efficiency of Pt2+- CeO2 novel thin film catalyst as anode for proton exchange membrane fuel cells
- 3 October 2016
- Published by Springer Nature in Journal of Solid State Electrochemistry
- Vol. 21 (3) , 657-664
Influence of chemical equilibrium in introduced oxygen vacancies on resistive switching in epitaxial Pt-CeO2 system
- 3 October 2016
- Published by Springer Nature in Journal of Solid State Electrochemistry
- Vol. 21 (3) , 657-664
Influence of chemical equilibrium in introduced oxygen vacancies on resistive switching in epitaxial Pt-CeO2 system
- 1 September 2016
- Published by Elsevier in Electrochimica Acta
- Vol. 211, 52-58
In-situ electrochemical atomic force microscopy study of aging of magnetron sputtered Pt-Co nanoalloy thin films during accelerated degradation test
- 1 September 2016
- Published by Elsevier in Electrochimica Acta
- Vol. 211, 52-58
In-situ electrochemical atomic force microscopy study of aging of magnetron sputtered Pt-Co nanoalloy thin films during accelerated degradation test
- 15 June 2016
- Published by Wiley in Fuel Cells
- Vol. 16 (5) , 652-655
Candle Soot as Efficient Support for Proton Exchange Membrane Fuel Cell Catalyst
Candle soot deposited from the candle flame was used as a catalyst support for an anode catalyst in a proton exchange membrane fuel cell. The results showed that Pt/soot hybrids prepared by magnetron sputtering of 5 nm platinum films on candle soot exhibit very high mass activity in the fuel cell, which is more than one order of magnitude higher than that for commercial catalyst. The elementary preparation, high surface‐to‐volume ratio, good conductivity and hydrophobicity make candle soot a promising type of the support for PEMFCs catalyst.
- 15 June 2016
- Published by Wiley in Fuel Cells
- Vol. 16 (5) , 652-655
Candle Soot as Efficient Support for Proton Exchange Membrane Fuel Cell Catalyst
Candle soot deposited from the candle flame was used as a catalyst support for an anode catalyst in a proton exchange membrane fuel cell. The results showed that Pt/soot hybrids prepared by magnetron sputtering of 5 nm platinum films on candle soot exhibit very high mass activity in the fuel cell, which is more than one order of magnitude higher than that for commercial catalyst. The elementary preparation, high surface‐to‐volume ratio, good conductivity and hydrophobicity make candle soot a promising type of the support for PEMFCs catalyst.
- 1 March 2016
- Published by Elsevier in Applied Surface Science
- Vol. 365, 245-251
Surface composition of magnetron sputtered Pt-Co thin film catalyst for proton exchange membrane fuel cells
- 1 March 2016
- Published by Elsevier in Applied Surface Science
- Vol. 365, 245-251
Surface composition of magnetron sputtered Pt-Co thin film catalyst for proton exchange membrane fuel cells