Yong Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Yong Li has a total of 51 co-authors. Here are the top co-authors by number of shared publications:
Ruzhu Wang
4 shared publications- Qian Chen
Institute of Ocean Engineering, Tsinghua Shenzhen International Graduate School, Tsinghua University, Shenzhen 518071, China
3 shared publications - Ru Zhu Wang
Institute of Refrigeration and Cryogenics, MOE Engineering Research Center of Solar Power and Refrigeration, Shanghai Jiao Tong University, Shanghai 200240, China
3 shared publications B.Y. Zhao
2 shared publicationsDongwen Chen
School of Mechanical Engineering, Shanghai Jiaotong University, 200240 Shanghai, China
2 shared publications- Dongwen Chen
School of Mechanical Engineering, Shanghai Jiao Tong University, Shanghai 200240, China
2 shared publications
Latest Publications
- Open Access
- 6 August 2021
- Published by EDP Sciences
- Vol. 300, 01018
Application of frequency optimization neural network method on power line communication
The quality of broadband power line carrier communication mainly depends on the carrier communication frequency. However, there is a lack of fast and effective optimal carrier frequency selection method. One frequency selection method based on frequency point optimization neural network is proposed by this paper. This method combines transmission line theory and voltage partial reflection theory to build a power line carrier channel mathematical model of the distribution network. The input frequency point sample set is used as the training set of the frequency point optimization neural network to obtain a neural network model that can predict the local optimal frequency point set. Then the actual distribution network is taken as an example for simulation analysis. When inputting any frequency range, the model outputs the corresponding optimal frequency point set. Simulation results show that the algorithm saves a lot of input impedance or channel strength testing time, while the error rate is limited to about 3%.
- 6 August 2021
- Published by EDP Sciences
- Vol. 300, 01018
Open AccessApplication of frequency optimization neural network method on power line communication
The quality of broadband power line carrier communication mainly depends on the carrier communication frequency. However, there is a lack of fast and effective optimal carrier frequency selection method. One frequency selection method based on frequency point optimization neural network is proposed by this paper. This method combines transmission line theory and voltage partial reflection theory to build a power line carrier channel mathematical model of the distribution network. The input frequency point sample set is used as the training set of the frequency point optimization neural network to obtain a neural network model that can predict the local optimal frequency point set. Then the actual distribution network is taken as an example for simulation analysis. When inputting any frequency range, the model outputs the corresponding optimal frequency point set. Simulation results show that the algorithm saves a lot of input impedance or channel strength testing time, while the error rate is limited to about 3%.
- Open Access
- 1 April 2021
- Published by Elsevier in Energy Reports
- Vol. 7, 458-468
Planning of a distributed integrated cooling system in reducing the peak power consumption
- 1 April 2021
- Published by Elsevier in Energy Reports
- Vol. 7, 458-468
Open AccessPlanning of a distributed integrated cooling system in reducing the peak power consumption
- 16 November 2020
- Published by Wiley in International Journal of Energy Research
- Vol. 45 (1) , 894-907
Optimal centralized integrated energy station site approach based on energy transmission loss analysis
- 16 November 2020
- Published by Wiley in International Journal of Energy Research
- Vol. 45 (1) , 894-907
Optimal centralized integrated energy station site approach based on energy transmission loss analysis
- Open Access
- 15 July 2020
- Published by IntechOpen
A Novel Low-Temperature Thermal Desalination Technology Using Direct-Contact Spray Method
Due to the emerging water crisis, the global desalination capacity has been expanding exponentially in the past few decades, leading to substantial amount of primary energy consumption. Therefore, the exploration of energy-efficient desalination processes and alternative energy sources has been the subject of great research interests. The spray-assisted low-temperature desalination (SLTD) system is a novel method for desalination that enables efficient renewable energy utilization. It works on the direct-contact spray evaporation/condensation mechanism and uses only hollow chambers. The merits include enhanced heat and mass transfer, lower initial and operational costs, and reduced scaling and fouling issues. This chapter presents a study on the SLTD system driven by sensible heat sources. The working principle of the system will be introduced first. Then a thermodynamic analysis will be presented to obtain the freshwater productivity under different design and operational conditions. Additionally, the energy utilization level will be quantified to highlight the energy wastage when operating with sensible heat sources. Afterward, the system configuration will be modified to maximize the utilization of sensible heat sources and promote productivity. Finally economic viability of the modified design will be evaluated.
- 15 July 2020
- Published by IntechOpen
Open AccessA Novel Low-Temperature Thermal Desalination Technology Using Direct-Contact Spray Method
Due to the emerging water crisis, the global desalination capacity has been expanding exponentially in the past few decades, leading to substantial amount of primary energy consumption. Therefore, the exploration of energy-efficient desalination processes and alternative energy sources has been the subject of great research interests. The spray-assisted low-temperature desalination (SLTD) system is a novel method for desalination that enables efficient renewable energy utilization. It works on the direct-contact spray evaporation/condensation mechanism and uses only hollow chambers. The merits include enhanced heat and mass transfer, lower initial and operational costs, and reduced scaling and fouling issues. This chapter presents a study on the SLTD system driven by sensible heat sources. The working principle of the system will be introduced first. Then a thermodynamic analysis will be presented to obtain the freshwater productivity under different design and operational conditions. Additionally, the energy utilization level will be quantified to highlight the energy wastage when operating with sensible heat sources. Afterward, the system configuration will be modified to maximize the utilization of sensible heat sources and promote productivity. Finally economic viability of the modified design will be evaluated.
- 9 June 2020
- Published by Springer Nature in Frontiers in Energy
- Vol. 15 (2) , 328-344
Numerical simulation of underground seasonal cold energy storage for a 10 MW solar thermal power plant in north-western China using TRNSYS
- 9 June 2020
- Published by Springer Nature in Frontiers in Energy
- Vol. 15 (2) , 328-344
Numerical simulation of underground seasonal cold energy storage for a 10 MW solar thermal power plant in north-western China using TRNSYS
- 3 February 2020
- Published by Wiley in International Journal of Energy Research
- Vol. 44 (7) , 5093-5116
Patent‐based trend analysis for advanced thermal energy storage technologies and their applications
- 3 February 2020
- Published by Wiley in International Journal of Energy Research
- Vol. 44 (7) , 5093-5116
Patent‐based trend analysis for advanced thermal energy storage technologies and their applications
- 1 February 2020
- Published by Elsevier in Energy Conversion and Management
- Vol. 206
Nodal-pressure-based heating flow model for analyzing heating networks in integrated energy systems
- 1 February 2020
- Published by Elsevier in Energy Conversion and Management
- Vol. 206
Nodal-pressure-based heating flow model for analyzing heating networks in integrated energy systems
- 2 August 2019
- Published by Taylor & Francis in Science and Technology for the Built Environment
- Vol. 25 (7) , 925-934
Performance simulation of underground seasonal solar energy storage in hot summer and cold winter zone in china
To analyze the performance of underground seasonal solar energy storage in hot summer and cold winter zones in China, a three-dimensional model for heat storage was developed. This model has been validated by the data from Tianjin’s experimental system and the relative error stayed below 5% during the process. A simulation was conducted to analyze thermal energy storage from March to October. Underground temperature distribution and the change in heat flux at each boundary were obtained. Three control strategies, that is, Normal, Double, and Interval were studied and compared. The effect of different heat storage start times/months for long-term heat storage was compared and discussed. The results show that the surface heat flux is significantly affected by the ambient temperature, while the bottom and sides of the heat storage area are primarily affected by the temperature of that area. The rise in the internal energy in March by Double-strategy and Interval-strategy are, respectively, 1.52 times and 1.12 times of that by Normal-strategy. For four months of heating storage, the average monthly heat storage efficiency is 80.70%, 81.34%, and 80.83% in Normal, Double, and Interval strategies, respectively. For long-term heat storage, an earlier start time/month lowers the efficiency of the system.
- 2 August 2019
- Published by Taylor & Francis in Science and Technology for the Built Environment
- Vol. 25 (7) , 925-934
Performance simulation of underground seasonal solar energy storage in hot summer and cold winter zone in china
To analyze the performance of underground seasonal solar energy storage in hot summer and cold winter zones in China, a three-dimensional model for heat storage was developed. This model has been validated by the data from Tianjin’s experimental system and the relative error stayed below 5% during the process. A simulation was conducted to analyze thermal energy storage from March to October. Underground temperature distribution and the change in heat flux at each boundary were obtained. Three control strategies, that is, Normal, Double, and Interval were studied and compared. The effect of different heat storage start times/months for long-term heat storage was compared and discussed. The results show that the surface heat flux is significantly affected by the ambient temperature, while the bottom and sides of the heat storage area are primarily affected by the temperature of that area. The rise in the internal energy in March by Double-strategy and Interval-strategy are, respectively, 1.52 times and 1.12 times of that by Normal-strategy. For four months of heating storage, the average monthly heat storage efficiency is 80.70%, 81.34%, and 80.83% in Normal, Double, and Interval strategies, respectively. For long-term heat storage, an earlier start time/month lowers the efficiency of the system.
- 1 October 2018
- Published by Elsevier in Renewable Energy
- Vol. 126, 1113-1125
Performance study of a grid-connected photovoltaic powered central air conditioner in the South China climate
- 1 October 2018
- Published by Elsevier in Renewable Energy
- Vol. 126, 1113-1125
Performance study of a grid-connected photovoltaic powered central air conditioner in the South China climate