Stefaan Pomme
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Stefaan Pomme has a total of 398 co-authors. Here are the top co-authors by number of shared publications:
R. Van Ammel
European Commission, Joint Research Centre (JRC), Geel, Belgium
29 shared publicationsJ. Paepen
European Commission, Joint Research Centre (JRC), Geel, Belgium
24 shared publicationsM. Marouli
European Commission, Joint Research Centre (JRC), Geel, Belgium
18 shared publicationsG. Sibbens
European Commission, Joint Research Centre (JRC), Geel, Belgium
17 shared publicationsH. Stroh
European Commission, Joint Research Centre (JRC), Geel, Belgium
17 shared publicationsT. Altzitzoglou
European Commission, Joint Research Centre (JRC), Geel, Belgium
15 shared publications
Latest Publications
- Open Access
- 23 October 2026
- Published by Copernicus GmbH in EGUsphere
- Vol. 2026, 1-44
A practical quantile approach to nonlinear uncertainty propagation in radiometric dating
Radiometric ages are commonly reported with a symmetric uncertainty (±u) obtained by first-order propagation. This is adequate when the age uncertainty is small relative to the characteristic timescale of the chronometer, but becomes unreliable when a measured isotope or activity ratio is transformed through a strongly nonlinear age equation. Equal positive and negative ratio deviations then produce unequal age deviations and asymmetric coverage intervals. Where the measured ratio approaches a physical bound, a finite upper age limit may cease to exist. Monte Carlo propagation can account for these effects, but is unnecessary for monotonic dating equations when the uncertainty budget can be adequately represented by a single equivalent perturbation of the measured ratio with standard deviation σeq. The degree of nonlinearity is then described by a single dimensionless parameter, β = ulin/τ, which compares the linearly propagated age uncertainty with the chronometer timescale (τ = 109–158 ka for 230Th/238U, 8.2 ka for 14C). Symmetric propagation is generally adequate for |β|<0.1. At larger |β|, asymmetric coverage limits follow from solving the dating equation at the measured ratio ±kσeq. Above |β|≈1/k, the ratio quantile near the phsycial bound reaches the limit of the age equation, so no finite upper coverage limit exists and the result must be reported as a lower age limit. The approach is developed for 230Th/238U dating and validated against Monte Carlo simulation. It is then extended to three families of monotonic chronometers: decaying parents, daughter/parent activity ratios approaching secular equilibrium, and accumulating daughter/parent atom ratios. Only the first two families have a dating limit, whereas classical geochronometers such as K–Ar, Rb–Sr, and U–Pb generally do not. Requiring only standard uncertainty budget parameters, the method can be implemented directly in a spreadsheet or data-reduction software.
- 23 October 2026
- Published by Copernicus GmbH in EGUsphere
- Vol. 2026, 1-44
Open AccessA practical quantile approach to nonlinear uncertainty propagation in radiometric dating
Radiometric ages are commonly reported with a symmetric uncertainty (±u) obtained by first-order propagation. This is adequate when the age uncertainty is small relative to the characteristic timescale of the chronometer, but becomes unreliable when a measured isotope or activity ratio is transformed through a strongly nonlinear age equation. Equal positive and negative ratio deviations then produce unequal age deviations and asymmetric coverage intervals. Where the measured ratio approaches a physical bound, a finite upper age limit may cease to exist. Monte Carlo propagation can account for these effects, but is unnecessary for monotonic dating equations when the uncertainty budget can be adequately represented by a single equivalent perturbation of the measured ratio with standard deviation σeq. The degree of nonlinearity is then described by a single dimensionless parameter, β = ulin/τ, which compares the linearly propagated age uncertainty with the chronometer timescale (τ = 109–158 ka for 230Th/238U, 8.2 ka for 14C). Symmetric propagation is generally adequate for |β|<0.1. At larger |β|, asymmetric coverage limits follow from solving the dating equation at the measured ratio ±kσeq. Above |β|≈1/k, the ratio quantile near the phsycial bound reaches the limit of the age equation, so no finite upper coverage limit exists and the result must be reported as a lower age limit. The approach is developed for 230Th/238U dating and validated against Monte Carlo simulation. It is then extended to three families of monotonic chronometers: decaying parents, daughter/parent activity ratios approaching secular equilibrium, and accumulating daughter/parent atom ratios. Only the first two families have a dating limit, whereas classical geochronometers such as K–Ar, Rb–Sr, and U–Pb generally do not. Requiring only standard uncertainty budget parameters, the method can be implemented directly in a spreadsheet or data-reduction software.
- Open Access
- 18 September 2025
- Published by Royal Society of Chemistry (RSC) in Journal of Analytical Atomic Spectrometry
- Vol. 40 (10) , 2937-2944
Non-linearity correction for variable signal analysis in mass spectrometry using discrete ion counters
The response of a discrete ion counter is not perfectly linear due to count loss caused by dead time and pulse pileup. As a result, measurements conducted at a variable input rate require bias correction.
- 18 September 2025
- Published by Royal Society of Chemistry (RSC) in Journal of Analytical Atomic Spectrometry
- Vol. 40 (10) , 2937-2944
Open AccessNon-linearity correction for variable signal analysis in mass spectrometry using discrete ion counters
The response of a discrete ion counter is not perfectly linear due to count loss caused by dead time and pulse pileup. As a result, measurements conducted at a variable input rate require bias correction.
- Open Access
- 10 September 2025
- Published by Elsevier in Applied Radiation and Isotopes
- Vol. 226, 112178
Design of a start-timing detector for the A–TOF facility
- 10 September 2025
- Published by Elsevier in Applied Radiation and Isotopes
- Vol. 226, 112178
Open AccessDesign of a start-timing detector for the A–TOF facility
- Open Access
- 6 August 2025
- Published by Elsevier in Applied Radiation and Isotopes
- Vol. 225, 112084
Dealing with discontinuities in half-life measurements
- 6 August 2025
- Published by Elsevier in Applied Radiation and Isotopes
- Vol. 225, 112084
Open AccessDealing with discontinuities in half-life measurements
- Open Access
- 30 July 2025
- Published by Royal Society of Chemistry (RSC) in Journal of Analytical Atomic Spectrometry
- Vol. 40 (8) , 2073-2082
A throughput model explaining non-linearity in discrete ion counters used in mass spectrometry
A mathematical model is presented to calculate the expected throughput rate in a discrete ion counter with imposed non-extending dead time.
- 30 July 2025
- Published by Royal Society of Chemistry (RSC) in Journal of Analytical Atomic Spectrometry
- Vol. 40 (8) , 2073-2082
Open AccessA throughput model explaining non-linearity in discrete ion counters used in mass spectrometry
A mathematical model is presented to calculate the expected throughput rate in a discrete ion counter with imposed non-extending dead time.
- Open Access
- 4 July 2025
- Published by Elsevier in Applied Radiation and Isotopes
- Vol. 225, 112029
High-resolution alpha-particle spectrometry of 243Am
- 4 July 2025
- Published by Elsevier in Applied Radiation and Isotopes
- Vol. 225, 112029
Open AccessHigh-resolution alpha-particle spectrometry of 243Am
- Open Access
- 8 November 2024
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 1070
A simplified approach to counting statistics with an imperfect pileup rejector
- 8 November 2024
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 1070
Open AccessA simplified approach to counting statistics with an imperfect pileup rejector
- Open Access
- 5 November 2024
- Published by IOP Publishing in Metrologia
- Vol. 61 (6) , 065009
Calibration of an ionisation chamber for parent–progeny decay
For a single radionuclide being measured in an ionisation chamber, a calibration factor can be established that relates the ionisation current to the source activity. The same applies to a decay chain in secular equilibrium, for which the calibration factor comprises the ionisation current produced by the parent and progeny nuclei combined. The calibration of an ionisation chamber for non-equilibrated parent–progeny decay poses a problem because the activity ratio of the parent and progeny nuclei varies with time. This study examines cases in which the half-lives of the parent and only one of the progenies in the decay series are significantly long. Thus, two calibration factors are involved, which combine differently as a function of time. By means of nuclear dating of the material, the parent–progeny activity ratio can be determined, and the respective contributions to the ionisation current can be unambiguously distinguished. Once the ionisation chamber is calibrated, two measurements taken at different times are sufficient to determine the activity and age of the parent–progeny mixture. This study presents equations for calculating the calibration factors and propagating uncertainties, illustrated with a case study focusing on the 227Th/223Ra decay chain used in alpha-immunotherapy.
- 5 November 2024
- Published by IOP Publishing in Metrologia
- Vol. 61 (6) , 065009
Open AccessCalibration of an ionisation chamber for parent–progeny decay
For a single radionuclide being measured in an ionisation chamber, a calibration factor can be established that relates the ionisation current to the source activity. The same applies to a decay chain in secular equilibrium, for which the calibration factor comprises the ionisation current produced by the parent and progeny nuclei combined. The calibration of an ionisation chamber for non-equilibrated parent–progeny decay poses a problem because the activity ratio of the parent and progeny nuclei varies with time. This study examines cases in which the half-lives of the parent and only one of the progenies in the decay series are significantly long. Thus, two calibration factors are involved, which combine differently as a function of time. By means of nuclear dating of the material, the parent–progeny activity ratio can be determined, and the respective contributions to the ionisation current can be unambiguously distinguished. Once the ionisation chamber is calibrated, two measurements taken at different times are sufficient to determine the activity and age of the parent–progeny mixture. This study presents equations for calculating the calibration factors and propagating uncertainties, illustrated with a case study focusing on the 227Th/223Ra decay chain used in alpha-immunotherapy.
- 14 July 2024
- Published by Elsevier in Nuclear Data Sheets
- Vol. 196
Nuclear Data Sheets Symbols and Abbreviations
- 14 July 2024
- Published by Elsevier in Nuclear Data Sheets
- Vol. 196
Nuclear Data Sheets Symbols and Abbreviations
- Open Access
- 27 November 2023
- Published by IOP Publishing in Metrologia
- Vol. 61 (1) , 015001
Ambient humidity, the overlooked influencer of radioactivity measurements
When verifying the validity of the exponential-decay law through 137 precise decay rate measurement series at various nuclear laboratories, minor violations have been observed in the shape of annual cycles in the residuals with different amplitudes and phase shifts. The timing and amplitude of these deviations have been compared with local weather data and it appears that ambient humidity is highly correlated with the observed instabilities in these radioactivity measurements. In fact, when compensating the residuals for a linear relationship with absolute humidity in air, most of the annual cycles are no longer statistically significant. As a result, the validity of the exponential-decay law can now be demonstrated with even higher fidelity.
- 27 November 2023
- Published by IOP Publishing in Metrologia
- Vol. 61 (1) , 015001
Open AccessAmbient humidity, the overlooked influencer of radioactivity measurements
When verifying the validity of the exponential-decay law through 137 precise decay rate measurement series at various nuclear laboratories, minor violations have been observed in the shape of annual cycles in the residuals with different amplitudes and phase shifts. The timing and amplitude of these deviations have been compared with local weather data and it appears that ambient humidity is highly correlated with the observed instabilities in these radioactivity measurements. In fact, when compensating the residuals for a linear relationship with absolute humidity in air, most of the annual cycles are no longer statistically significant. As a result, the validity of the exponential-decay law can now be demonstrated with even higher fidelity.