Dong-Hwan Choi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Dong-Hwan Choi has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Myung-Ho Bae
Korea Research Institute of Standards and Science
4 shared publications - Jinhee Kim
Chonbuk Natl Univ, Dept Phys, Jeonju 54896, South Korea
3 shared publications Bum-Kyu Kim
Korea Research Institute of Standards and Science, Daejeon, Korea (the Republic of)
2 shared publications- Kenji Watanabe
National Institute for Materials Science
2 shared publications Takashi Taniguchi
National Institute for Materials Science, Tsukuba, Japan
2 shared publicationsByung-Sung Yu
Jeonbuk National University, Jeonju, Jeollabuk-do, Korea (the Republic of)
1 shared publication
Latest Publications
- Open Access
Tunneling Spectroscopy for Electronic Bands in Multi-Walled Carbon Nanotubes with Van Der Waals Gap
Various intriguing quantum transport measurements for carbon nanotubes (CNTs) based on their unique electronic band structures have been performed adopting a field-effect transistor (FET), where the contact resistance represents the interaction between the one-dimensional and three-dimensional systems. Recently, van der Waals (vdW) gap tunneling spectroscopy for single-walled CNTs with indium–metal contacts was performed adopting an FET device, providing the direct assignment of the subband location in terms of the current–voltage characteristic. Here, we extend the vdW gap tunneling spectroscopy to multi-walled CNTs, which provides transport spectroscopy in a tunneling regime of ~1 eV, directly reflecting the electronic density of states. This new quantum transport regime may allow the development of novel quantum devices by selective electron (or hole) injection to specific subbands.
Open AccessTunneling Spectroscopy for Electronic Bands in Multi-Walled Carbon Nanotubes with Van Der Waals Gap
Various intriguing quantum transport measurements for carbon nanotubes (CNTs) based on their unique electronic band structures have been performed adopting a field-effect transistor (FET), where the contact resistance represents the interaction between the one-dimensional and three-dimensional systems. Recently, van der Waals (vdW) gap tunneling spectroscopy for single-walled CNTs with indium–metal contacts was performed adopting an FET device, providing the direct assignment of the subband location in terms of the current–voltage characteristic. Here, we extend the vdW gap tunneling spectroscopy to multi-walled CNTs, which provides transport spectroscopy in a tunneling regime of ~1 eV, directly reflecting the electronic density of states. This new quantum transport regime may allow the development of novel quantum devices by selective electron (or hole) injection to specific subbands.
- 19 February 2021
- Published by IOP Publishing in Nanotechnology
- Vol. 32 (19) , 195207
Gate-tunable quantum dot formation between localized-resonant states in a few-layer MoS 2
We demonstrate a gate-tunable quantum dot (QD) located between two potential barriers defined in a few-layer MoS 2 . Although both local gates used to tune the potential barriers have disorder-induced QDs, we observe diagonal current stripes in current resonant islands formed by the alignment of the Fermi levels of the electrodes and the energy levels of the disorder-induced QDs, as evidence of the gate-tunable QD. We demonstrate that the charging energy of the designed QD can be tuned in the range of 2–6 meV by changing the local-gate voltages in ∼1 V.
- 19 February 2021
- Published by IOP Publishing in Nanotechnology
- Vol. 32 (19) , 195207
Gate-tunable quantum dot formation between localized-resonant states in a few-layer MoS 2
We demonstrate a gate-tunable quantum dot (QD) located between two potential barriers defined in a few-layer MoS 2 . Although both local gates used to tune the potential barriers have disorder-induced QDs, we observe diagonal current stripes in current resonant islands formed by the alignment of the Fermi levels of the electrodes and the energy levels of the disorder-induced QDs, as evidence of the gate-tunable QD. We demonstrate that the charging energy of the designed QD can be tuned in the range of 2–6 meV by changing the local-gate voltages in ∼1 V.
- Open Access
- 8 January 2021
- Published by Springer Nature in npj 2D Materials and Applications
- Vol. 5 (1) , 1-10
Origins of genuine Ohmic van der Waals contact between indium and MoS2
The achievement of ultraclean Ohmic van der Waals (vdW) contacts at metal/transition-metal dichalcogenide (TMDC) interfaces would represent a critical step for the development of high-performance electronic and optoelectronic devices based on two-dimensional (2D) semiconductors. Herein, we report the fabrication of ultraclean vdW contacts between indium (In) and molybdenum disulfide (MoS2) and the clarification of the atomistic origins of its Ohmic-like transport properties. Atomically clean In/MoS2 vdW contacts are achieved by evaporating In with a relatively low thermal energy and subsequently cooling the substrate holder down to ~100 K by liquid nitrogen. We reveal that the high-quality In/MoS2 vdW contacts are characterized by a small interfacial charge transfer and the Ohmic-like transport based on the field-emission mechanism over a wide temperature range from 2.4 to 300 K. Accordingly, the contact resistance reaches ~600 Ω μm and ~1000 Ω μm at cryogenic temperatures for the few-layer and monolayer MoS2 cases, respectively. Density functional calculations show that the formation of large in-gap states due to the hybridization between In and MoS2 conduction band edge states is the microscopic origins of the Ohmic charge injection. We suggest that seeking a mechanism to generate strong density of in-gap states while maintaining the pristine contact geometry with marginal interfacial charge transfer could be a general strategy to simultaneously avoid Fermi-level pinning and minimize contact resistance for 2D vdW materials.
- 8 January 2021
- Published by Springer Nature in npj 2D Materials and Applications
- Vol. 5 (1) , 1-10
Open AccessOrigins of genuine Ohmic van der Waals contact between indium and MoS2
The achievement of ultraclean Ohmic van der Waals (vdW) contacts at metal/transition-metal dichalcogenide (TMDC) interfaces would represent a critical step for the development of high-performance electronic and optoelectronic devices based on two-dimensional (2D) semiconductors. Herein, we report the fabrication of ultraclean vdW contacts between indium (In) and molybdenum disulfide (MoS2) and the clarification of the atomistic origins of its Ohmic-like transport properties. Atomically clean In/MoS2 vdW contacts are achieved by evaporating In with a relatively low thermal energy and subsequently cooling the substrate holder down to ~100 K by liquid nitrogen. We reveal that the high-quality In/MoS2 vdW contacts are characterized by a small interfacial charge transfer and the Ohmic-like transport based on the field-emission mechanism over a wide temperature range from 2.4 to 300 K. Accordingly, the contact resistance reaches ~600 Ω μm and ~1000 Ω μm at cryogenic temperatures for the few-layer and monolayer MoS2 cases, respectively. Density functional calculations show that the formation of large in-gap states due to the hybridization between In and MoS2 conduction band edge states is the microscopic origins of the Ohmic charge injection. We suggest that seeking a mechanism to generate strong density of in-gap states while maintaining the pristine contact geometry with marginal interfacial charge transfer could be a general strategy to simultaneously avoid Fermi-level pinning and minimize contact resistance for 2D vdW materials.