SPStephen Pansino

Stephen Pansino

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Stephen Pansino has a total of 11 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Modeling fracture growth for EGS in foreland sedimentary basins

    by Stephen Pansino, Manuel A. Florez, Rafael Torres

  • Open Access

    Magma Flow Patterns in Dikes: Observations From Analogue Experiments

    by Stephen Pansino, Adel Emadzadeh, Benoit Taisne

    We conducted analogue experiments to examine flux‐driven and buoyancy‐driven magma ascent, which included a series of isothermal experiments and thermal, solidification‐prone experiments. We measured the internal flow using 2D particle image velocimetry, which indicates that buoyancy has a strong control on the flow pattern of isothermal dikes. Dikes that are not buoyant (likely driven by source pressure) take on a circulating pattern, while buoyant dikes assume an ascending flow pattern. Solidification modifies the flow field so that flow is confined to the dike's upper head region. The lower tail becomes mostly solidified, with a narrow conduit connecting the source to the head. We interpret that this conduit acts as a high velocity point source to the head, promoting a circulating flow pattern, even as the dike becomes buoyant. We then perform particle tracking velocimetry on several particles to illustrate the complexity of their paths. In a circulating flow pattern, particles rise to the top of the dike, descend near the lateral edge, and then are drawn back into the upward flow. In an ascending pattern, particles ascend slightly faster than the propagation velocity, and therefore are pushed to the side as they approach the upper tip. In erupting dikes, particles simply flow to the vent. In the context of crystal growth in magmatic dikes, these results suggest that crystal growth patterns (e.g., normal or oscillatory zoning) can reflect the magma flow pattern, and potentially the driving forces.


  • Open Access

    Modeling Dike Propagation in Both Vertical Length and Horizontal Breadth

    by Stephen Pansino, Adel Emadzadeh, Benoit Taisne

    We present analog experiments on dike propagation, followed by a numerical model of horizontal and vertical growth, which is partially analytical and partially based on empirical observations. Experimental results show that the growth rates are similar until buoyancy becomes significant and, afterward, vertical growth dominates. The numerical model is defined for different conditions in a homogeneous medium: (a) constant flux, fracture‐limited propagation; (b) constant flux, viscous‐limited propagation; and (c) variable flux dependent on the driving pressure and dike dimensions. These conditions distinguish between cases when the influx depends on the deeper source of magma (e.g., a conduit, independent of the dike geometry) and when it depends on the dike, so the influx can change as it grows. In all cases, the ratio of vertical to horizontal propagation is proportional to the ratio of buoyancy pressure to source pressure, in which buoyancy drives vertical propagation. We test the numerical model on dikes observed at Piton de la Fournaise, in which the dimensions were estimated using geodetic and seismic data. The results show that the final dimensions can be reproduced using magma‐crust density differences of 50–300 kg/m3, viscosities of 30–300 Pa·s, influxes of 50–750 m3/s and shear moduli of ∼10 GPa. The modeled magma and host rock parameters agree with previous studies of the volcano, while the flux is higher than what is typically observed during eruption. This implies a variable injection condition, in which the flux peaks during propagation and diminishes by the onset of eruption.


  • Analog experiments in volcanology: towards multimethod, upscaled, and integrated models

    by Sam Poppe, Johan T. Gilchrist, Eric Christophe Pascal Breard, Alison Graettinger, Stephen Pansino


  • Open Access

    Modeling dike propagation in both vertical length and horizontal breadth

    by Stephen Pansino, Adel Emadzadeh, Benoit Taisne

    We present analogue experiments on dike propagation in gelatin, on which we base a numerical model of horizontal and vertical growth. Experimental results show that vertical growth dominates when buoyancy becomes significant and, beforehand, the growth rates are similar. In both experimental and numerical models, influx at the base of the dike drives vertical and horizontal propagation, as well as inflating in the thickness dimension, and the proportion of vertical to horizontal growth depends on buoyancy. The model is defined for different conditions in a homogeneous medium: influx-controlled dikes dominated by fracture pressure; those dominated by viscous pressure drop; and pressure-controlled dikes. In all cases, the ratio of vertical to horizontal propagation is proportional to the ratio of buoyancy pressure to source pressure, in which buoyancy drives vertical propagation. We test the numerical model on nine dikes observed at Piton de la Fournaise from 2000 to 2003. The results show that the final dimensions and average propagation velocity can be accurately reproduced using magma-crust density differences of 50 to 300 kg/m^3, viscosities of 30 to 300 Pa*s, influxes of 50 to 750 m^3/s and shear moduli of ~10 GPa, depending on the event, with variation associated to the observed propagation velocities. The modeled magma and host rock parameters agree with previous studies, while the flux is higher than what is typically observed during eruption.

  • Open Access

    Shear Wave Measurements of a Gelatin’s Young’s Modulus

    by Stephen Pansino, Benoit Taisne

    Gelatin is a commonly used material for analog experiments in geophysics, investigating fluid-filled fracture propagation (e.g., magmatic dikes), as well as fault slip. Quantification of its physical properties, such as the Young’s modulus, is important for scaling experimental results to nature. Traditional methods to do so are either time consuming or destructive and cannot be performed in situ. We present an optical measurement technique, using shear waves. Polarizing filters enable visualization of the deviatoric stresses in a block of gelatin, so shear wave propagation can be observed. We demonstrate how the wave velocity can be measured and related to the Young’s modulus, show how the results are comparable to another methodology and discuss processing techniques that maximize the measurement precision. This methodology is useful for experimentalist, as it is simple to implement into a laboratory setting, can make precise, time-efficient estimates of the material strength and additionally is non-destructive and can be performed in situ.


  • Open Access

    Dike Channelization and Solidification: Time Scale Controls on the Geometry and Placement of Magma Migration Pathways

    by S. Pansino, A. Emadzadeh, B. Taisne

    We investigate the conditions under which magma prefers to migrate through the crust via a dike or a conduit geometry. We performed a series of analogue experiments, repeatedly injecting warm, liquid gelatin, into a cold, solid gelatin medium and allowing the structure to evolve with time. We varied the liquid flux and the time interval between discrete injections of gelatin. The time interval controls the geometry of the migration, in that long intervals allow the intrusions to solidify, favoring the propagation of new dikes. Short time intervals allow the magma to channelize into a conduit. These times are characterized by the Fourier number (Fo), a ratio of time and thermal diffusion to dike thickness, so that long times scales have Fo > 102 and short time scales have Fo < 100. Between these time scales, a transitional behavior exists, in which new dikes nest inside of previous dikes. The flux controls the distance a dike can propagate before solidifying, in that high fluxes favor continual propagation, whereas low fluxes favor dike arrest due to solidification. For vertically propagating dikes, this indicates whether or not a dike can erupt. A transitional behavior exist, in which dikes may erupt at the surface in an unstable, on‐and‐off fashion. We supplemented the experimental findings with a 2‐D numerical model of thermal conduction to characterize the temperature gradient in the crust as a function of intrusion recurrence frequency. For very infrequent intrusions (Fo > 104 to 105) all thermal energy is lost, while more frequent intrusions allow heat to build up nearby.


  • Open Access

    How Magmatic Storage Regions Attract and Repel Propagating Dikes

    by Stephen Pansino, Benoit Taisne

    We investigate the effect of magmatic reservoir pressure on the propagation of dikes that approach from below, using analogue experiments. We injected oil into gelatin and observed how dike propagation responded to the stress field around a pressurized, spherical reservoir, filled with water. The reservoir was modeled using two different setups: one simply using an inflatable rubber balloon and the other by constructing a liquid‐filled cavity. We find that the dike's response is dependent on the sign of the reservoir pressure (i.e., inflated/overpressurized and deflated/underpressurized) as well as on the dike's initial orientation (i.e., if its strike is radially, circumferentially, or obliquely oriented to the reservoir). Dikes that are initially strike radial respond, respectively, by propagating toward or away from overpressurized or underpressurized reservoirs, taking advantage of the reservoir's hoop stresses. Otherwise‐oriented dikes respond by changing orientation, twisting and curling into a form dictated by the principal stresses in the medium. For overpressurized reservoirs, they are coaxed to propagate radially to, and therefore approach, the reservoir. For underpressurized reservoirs, they generally reorient to propagate tangentially, which causes them to avoid the reservoir. The magnitude of reservoir pressure controls at which distance dikes can be affected, and, at natural scales, we estimate that this occurs within a radius of a few tens of kilometers. This diminishes with time, due to viscous stress relaxation of the crust, which will occur on a timescale of hundreds of years.