Shou-En Zhu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Shou-En Zhu has a total of 48 co-authors. Here are the top co-authors by number of shared publications:
G. C. A. M. Janssen
Micro and Nano Engineering Lab, Department of Precision and Microsystems Engineering, TU Delft, Mekelweg 2, 2628 CD Delft, The Netherlands
4 shared publications- Jong-Hyun Ahn
Yonsei University
3 shared publications Byung Hee Hong
2 shared publicationsG.C.A.M. Janssen
2 shared publicationsT. Taniguchi
National Institute for Materials Science, Namiki 1-1, Tsukuba, Ibaraki 305-0044, Japan
2 shared publicationsChao Zhang
Kavli Institute of Nanoscience, Delft University of Technology 2 , Lorentzweg 1, 2628CJ Delft, The Netherlands
1 shared publication
Latest Publications
- Top Cited PapersOpen Access
- 22 June 2015
- Published by Springer Nature in Nature Nanotechnology
- Vol. 10 (8) , 682-686
Graphene on hexagonal boron nitride as a tunable hyperbolic metamaterial
The amplitude and wavelength of hyperbolic phonon polaritons in hexagonal boron nitride can be tuned using a monolayer graphene gate. Hexagonal boron nitride (h-BN) is a natural hyperbolic material1, in which the dielectric constants are the same in the basal plane (εt ≡ εx = εy) but have opposite signs (εtεz < 0) in the normal plane (εz)1,2,3,4. Owing to this property, finite-thickness slabs of h-BN act as multimode waveguides for the propagation of hyperbolic phonon polaritons1,2,5—collective modes that originate from the coupling between photons and electric dipoles6 in phonons. However, control of these hyperbolic phonon polaritons modes has remained challenging, mostly because their electrodynamic properties are dictated by the crystal lattice of h-BN1,2,7. Here we show, by direct nano-infrared imaging, that these hyperbolic polaritons can be effectively modulated in a van der Waals heterostructure8 composed of monolayer graphene on h-BN. Tunability originates from the hybridization of surface plasmon polaritons in graphene9,10,11,12,13 with hyperbolic phonon polaritons in h-BN1,2, so that the eigenmodes of the graphene/h-BN heterostructure are hyperbolic plasmon–phonon polaritons. The hyperbolic plasmon–phonon polaritons in graphene/h-BN suffer little from ohmic losses, making their propagation length 1.5–2.0 times greater than that of hyperbolic phonon polaritons in h-BN. The hyperbolic plasmon–phonon polaritons possess the combined virtues of surface plasmon polaritons in graphene and hyperbolic phonon polaritons in h-BN. Therefore, graphene/h-BN can be classified as an electromagnetic metamaterial14 as the resulting properties of these devices are not present in its constituent elements alone.
- 22 June 2015
- Published by Springer Nature in Nature Nanotechnology
- Vol. 10 (8) , 682-686
Top Cited PapersOpen AccessGraphene on hexagonal boron nitride as a tunable hyperbolic metamaterial
The amplitude and wavelength of hyperbolic phonon polaritons in hexagonal boron nitride can be tuned using a monolayer graphene gate. Hexagonal boron nitride (h-BN) is a natural hyperbolic material1, in which the dielectric constants are the same in the basal plane (εt ≡ εx = εy) but have opposite signs (εtεz < 0) in the normal plane (εz)1,2,3,4. Owing to this property, finite-thickness slabs of h-BN act as multimode waveguides for the propagation of hyperbolic phonon polaritons1,2,5—collective modes that originate from the coupling between photons and electric dipoles6 in phonons. However, control of these hyperbolic phonon polaritons modes has remained challenging, mostly because their electrodynamic properties are dictated by the crystal lattice of h-BN1,2,7. Here we show, by direct nano-infrared imaging, that these hyperbolic polaritons can be effectively modulated in a van der Waals heterostructure8 composed of monolayer graphene on h-BN. Tunability originates from the hybridization of surface plasmon polaritons in graphene9,10,11,12,13 with hyperbolic phonon polaritons in h-BN1,2, so that the eigenmodes of the graphene/h-BN heterostructure are hyperbolic plasmon–phonon polaritons. The hyperbolic plasmon–phonon polaritons in graphene/h-BN suffer little from ohmic losses, making their propagation length 1.5–2.0 times greater than that of hyperbolic phonon polaritons in h-BN. The hyperbolic plasmon–phonon polaritons possess the combined virtues of surface plasmon polaritons in graphene and hyperbolic phonon polaritons in h-BN. Therefore, graphene/h-BN can be classified as an electromagnetic metamaterial14 as the resulting properties of these devices are not present in its constituent elements alone.
- 30 September 2014
- Published by Oxford University Press (OUP) in Europhysics Letters
- Vol. 108 (1)
Optical transmittance of multilayer graphene
- 30 September 2014
- Published by Oxford University Press (OUP) in Europhysics Letters
- Vol. 108 (1)
Optical transmittance of multilayer graphene
- 13 January 2014
- Published by AIP Publishing in Applied Physics Letters
- Vol. 104 (2) , 023103
Ballistic transport in graphene grown by chemical vapor deposition
In this letter, we report the observation of ballistic transport on micron length scales in graphene synthesised by chemical vapour deposition (CVD). Transport measurements were done on Hall bar geometries in a liquid He cryostat. Using non-local measurements, we show that electrons can be ballistically directed by a magnetic field (transverse magnetic focussing) over length scales of ∼1 μm. Comparison with atomic force microscope measurements suggests a correlation between the absence of wrinkles and the presence of ballistic transport in CVD graphene.
- 13 January 2014
- Published by AIP Publishing in Applied Physics Letters
- Vol. 104 (2) , 023103
Ballistic transport in graphene grown by chemical vapor deposition
In this letter, we report the observation of ballistic transport on micron length scales in graphene synthesised by chemical vapour deposition (CVD). Transport measurements were done on Hall bar geometries in a liquid He cryostat. Using non-local measurements, we show that electrons can be ballistically directed by a magnetic field (transverse magnetic focussing) over length scales of ∼1 μm. Comparison with atomic force microscope measurements suggests a correlation between the absence of wrinkles and the presence of ballistic transport in CVD graphene.
- 1 July 2013
- Published by Elsevier in Optics Communications
- Vol. 300, 17-21
Multilayer graphene for Q-switched mode-locking operation in an erbium-doped fiber laser
- 1 July 2013
- Published by Elsevier in Optics Communications
- Vol. 300, 17-21
Multilayer graphene for Q-switched mode-locking operation in an erbium-doped fiber laser
- 22 April 2013
- Published by AIP Publishing in Applied Physics Letters
- Vol. 102 (16)
Graphene based piezoresistive pressure sensor
We present a pressure sensor based on the piezoresistive effect of graphene. The sensor is a 100 nm thick, 280 μm wide square silicon nitride membrane with graphene meander patterns located on the maximum strain area. The multilayer, polycrystalline graphene was obtained by chemical vapor deposition. Strain in graphene was generated by applying differential pressure across the membrane. Finite element simulation was used to analyze the strain distribution. By performing electromechanical measurements, we obtained a gauge factor of ∼1.6 for graphene and a dynamic range from 0 mbar to 700 mbar for the pressure sensor.
- 22 April 2013
- Published by AIP Publishing in Applied Physics Letters
- Vol. 102 (16)
Graphene based piezoresistive pressure sensor
We present a pressure sensor based on the piezoresistive effect of graphene. The sensor is a 100 nm thick, 280 μm wide square silicon nitride membrane with graphene meander patterns located on the maximum strain area. The multilayer, polycrystalline graphene was obtained by chemical vapor deposition. Strain in graphene was generated by applying differential pressure across the membrane. Finite element simulation was used to analyze the strain distribution. By performing electromechanical measurements, we obtained a gauge factor of ∼1.6 for graphene and a dynamic range from 0 mbar to 700 mbar for the pressure sensor.
- 31 January 2011
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 11 (3) , 977-981
Graphene-Based Bimorph Microactuators
A novel graphene-on-organic film fabrication method that is compatible with a batch microfabrication process was developed and used for electromechanically driven microactuators. A very thin layer of graphene sheets was monolithically integrated and the unique material characteristics of graphene including negative thermal expansion and high electrical conductivity were exploited to produce a bimorph actuation. A large displacement with rapid response was observed while maintaining the low power consumption. This enabled the successful demonstration of transparent graphene-based organic microactuators.
- 31 January 2011
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 11 (3) , 977-981
Graphene-Based Bimorph Microactuators
A novel graphene-on-organic film fabrication method that is compatible with a batch microfabrication process was developed and used for electromechanically driven microactuators. A very thin layer of graphene sheets was monolithically integrated and the unique material characteristics of graphene including negative thermal expansion and high electrical conductivity were exploited to produce a bimorph actuation. A large displacement with rapid response was observed while maintaining the low power consumption. This enabled the successful demonstration of transparent graphene-based organic microactuators.
- 11 September 2010
- Published by Springer Nature in Journal of Materials Science
- Vol. 46 (4) , 1021-1026
Methylthiolate adsorbed on as-rich GaAs (001) surface
- 11 September 2010
- Published by Springer Nature in Journal of Materials Science
- Vol. 46 (4) , 1021-1026
Methylthiolate adsorbed on as-rich GaAs (001) surface
- 4 January 2010
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 10 (2) , 490-493
Wafer-Scale Synthesis and Transfer of Graphene Films
We developed means to produce wafer scale, high-quality graphene films as large as 3 in. wafer size on Ni and Cu films under ambient pressure and transfer them onto arbitrary substrates through instantaneous etching of metal layers. We also demonstrated the applications of the large-area graphene films for the batch fabrication of field-effect transistor (FET) arrays and stretchable strain gauges showing extraordinary performances. Transistors showed the hole and electron mobilities of the device of 1100 ± 70 and 550 ± 50 cm2/(V s) at drain bias of −0.75 V, respectively. The piezo-resistance gauge factor of strain sensor was ∼6.1. These methods represent a significant step toward the realization of graphene devices in wafer scale as well as application in optoelectronics, flexible and stretchable electronics.
- 4 January 2010
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 10 (2) , 490-493
Wafer-Scale Synthesis and Transfer of Graphene Films
We developed means to produce wafer scale, high-quality graphene films as large as 3 in. wafer size on Ni and Cu films under ambient pressure and transfer them onto arbitrary substrates through instantaneous etching of metal layers. We also demonstrated the applications of the large-area graphene films for the batch fabrication of field-effect transistor (FET) arrays and stretchable strain gauges showing extraordinary performances. Transistors showed the hole and electron mobilities of the device of 1100 ± 70 and 550 ± 50 cm2/(V s) at drain bias of −0.75 V, respectively. The piezo-resistance gauge factor of strain sensor was ∼6.1. These methods represent a significant step toward the realization of graphene devices in wafer scale as well as application in optoelectronics, flexible and stretchable electronics.