Amit Prashant
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Amit Prashant has a total of 37 co-authors. Here are the top co-authors by number of shared publications:
Debayan Bhattacharya
Assistant Professor, Dept. of Civil Engineering, Indian Institute of Technology Delhi, New Delhi 110016, India; formerly, Senior Research Fellow, Dept. of Civil Engineering, Indian Institute of Technology Gandhinagar, Gandhinagar, Gujarat 382355, India
4 shared publications- Prabhakar Vishwakarma
Department of Civil Engineering, Indian Institute of Technology Gandhinagar, Gandhinagar, India
4 shared publications Prajakta R. Jadhav
Former Ph.D. Student, Indian Institute of Technology Gandhinagar, Gandhinagar 382355, India
4 shared publications- Anurag Gupta
Department of Mechanical Engineering, Indian Institute of Technology Kanpur, Kanpur, India
3 shared publications - Mousumi Mukherjee
Indian Institute of Technology Mandi
3 shared publications - Mohan Krishna Kolli
Indian Institute of Technology Gandhinagar, Palaj, India
2 shared publications
Latest Publications
- 8 October 2025
- Published by Springer Nature in Pure and Applied Geophysics
- Vol. 182 (11) , 4633-4655
On the Applicability of Teaching–Learning-Based Optimization to Estimate the ${{\varvec{V}}}_{{\varvec{s}}}$ Profile in Active MASW Test- 8 October 2025
- Published by Springer Nature in Pure and Applied Geophysics
- Vol. 182 (11) , 4633-4655
On the Applicability of Teaching–Learning-Based Optimization to Estimate the ${{\varvec{V}}}_{{\varvec{s}}}$ Profile in Active MASW Test- 30 May 2025
- Published by Springer Nature in Acta Geophysica
- Vol. 73 (5) , 4165-4181
Buried object detection using cross-correlation and wavelet coherence analysis of MASW datasets
- 30 May 2025
- Published by Springer Nature in Acta Geophysica
- Vol. 73 (5) , 4165-4181
Buried object detection using cross-correlation and wavelet coherence analysis of MASW datasets
- 13 June 2024
- Published by Springer Nature in Acta Geophysica
- Vol. 73 (1) , 359-378
Analysis of shear wave velocity estimation using MASW on sloping grounds
- 13 June 2024
- Published by Springer Nature in Acta Geophysica
- Vol. 73 (1) , 359-378
Analysis of shear wave velocity estimation using MASW on sloping grounds
- 9 June 2024
- Published by Springer Nature in Geotechnical and Geological Engineering
- Vol. 42 (7) , 5519-5538
Hard Sandwiched Soil Layer Detection Using Higher Mode in Active MASW Test
- 9 June 2024
- Published by Springer Nature in Geotechnical and Geological Engineering
- Vol. 42 (7) , 5519-5538
Hard Sandwiched Soil Layer Detection Using Higher Mode in Active MASW Test
- 21 March 2024
- Published by Springer Nature in Acta Geotechnica
- Vol. 19 (8) , 5733-5755
Influence of toe condition on mechanical response of rigid-faced GRS walls
- 21 March 2024
- Published by Springer Nature in Acta Geotechnica
- Vol. 19 (8) , 5733-5755
Influence of toe condition on mechanical response of rigid-faced GRS walls
- 26 November 2023
- Published by Taylor & Francis in International Journal of Geotechnical Engineering
- Vol. 17 (7-10) , 778-797
Deformation behaviour of rigid faced GRS walls in numerical simulation with bonded and frictional soil-reinforcement interfaces
- 26 November 2023
- Published by Taylor & Francis in International Journal of Geotechnical Engineering
- Vol. 17 (7-10) , 778-797
Deformation behaviour of rigid faced GRS walls in numerical simulation with bonded and frictional soil-reinforcement interfaces
- 1 November 2022
- Published by American Society of Civil Engineers (ASCE) in Journal of Bridge Engineering
- Vol. 27 (11) , 04022110
Scaling Factors Quantifying Seismic Load Uncertainty with Soil Nonlinearity Effect in Displacement-Based Design of Bridge Abutments
The displacement-based design methods for bridge abutments, essentially cantilever retaining walls, require an input of expected ground motion on-site. For major projects, these motions are obtained based on site-specific response studies. In other projects, it is merely a guess based on the PGA values prescribed in the design codes. Further, the seismic displacements in retaining walls are usually estimated using simplified rigid–plastic analytical models. These models do not account for the effect of soil nonlinearity, alteration of input signal due to soil–structure interaction, amplification effects, or material damping. The currently followed seismic load factor of 1 on the prescribed PGA does not account for the induced uncertainties for the reasons given here, which can often be unconservative and lead to failure. This study statistically quantifies the effect of these uncertainties and proposes scaling factors on the design PGA of the input motion to estimate more reliable seismic displacements accounting for the assumptions in the simplified rigid–plastic model. The nonlinear finite-element analysis of retaining wall in OpenSees has been compared with the analytical double-wedge model considering a realistic V-shaped mechanism in backfill. It includes analysis for 83 different cases of earthquake motions scaled to four different PGAs. Finally, the scaling factors are proposed to estimate residual as well as peak sliding and in-plane rotational displacements of cantilever retaining walls with and without shear key.
- 1 November 2022
- Published by American Society of Civil Engineers (ASCE) in Journal of Bridge Engineering
- Vol. 27 (11) , 04022110
Scaling Factors Quantifying Seismic Load Uncertainty with Soil Nonlinearity Effect in Displacement-Based Design of Bridge Abutments
The displacement-based design methods for bridge abutments, essentially cantilever retaining walls, require an input of expected ground motion on-site. For major projects, these motions are obtained based on site-specific response studies. In other projects, it is merely a guess based on the PGA values prescribed in the design codes. Further, the seismic displacements in retaining walls are usually estimated using simplified rigid–plastic analytical models. These models do not account for the effect of soil nonlinearity, alteration of input signal due to soil–structure interaction, amplification effects, or material damping. The currently followed seismic load factor of 1 on the prescribed PGA does not account for the induced uncertainties for the reasons given here, which can often be unconservative and lead to failure. This study statistically quantifies the effect of these uncertainties and proposes scaling factors on the design PGA of the input motion to estimate more reliable seismic displacements accounting for the assumptions in the simplified rigid–plastic model. The nonlinear finite-element analysis of retaining wall in OpenSees has been compared with the analytical double-wedge model considering a realistic V-shaped mechanism in backfill. It includes analysis for 83 different cases of earthquake motions scaled to four different PGAs. Finally, the scaling factors are proposed to estimate residual as well as peak sliding and in-plane rotational displacements of cantilever retaining walls with and without shear key.
- 20 October 2022
- Published by Taylor & Francis in Journal of Earthquake Engineering
- Vol. 27 (12) , 3341-3361
Charts for Permanent Displacement-Based Seismic Design of Cantilever Retaining Walls
This study proposes seismic design charts to predict the permanent displacements in cantilever retaining walls. These charts are developed considering the realistic v-shaped mechanism in the backfill. It captures the aleatory uncertainty of earthquake motions by incorporating numerical analysis results for 152 earthquake ground motions. Conventionally, the charts developed for slopes and gravity walls have been adopted by practitioners for cantilever retaining walls assuming an imaginary vertical plane through the wall heel and considering the soil above as a part of the wall itself. Using these conventional charts of slopes with a single wedge assumption may lead to misleading predictions, which is one of the motivations behind developing charts specifically for the cantilever retaining walls. It also provides an estimation for the resulting subsidence in the backfill that may induce distress in the overlying structures. Unlike conventional charts, 5% − 20% probability of exceedance curves besides upper-bound curves have been developed accounting for earthquake motion variability. Non-dimensional equations have been proposed to estimate the minimum heel-length of the wall with and without shear key for the design values of PGA and PGV.
- 20 October 2022
- Published by Taylor & Francis in Journal of Earthquake Engineering
- Vol. 27 (12) , 3341-3361
Charts for Permanent Displacement-Based Seismic Design of Cantilever Retaining Walls
This study proposes seismic design charts to predict the permanent displacements in cantilever retaining walls. These charts are developed considering the realistic v-shaped mechanism in the backfill. It captures the aleatory uncertainty of earthquake motions by incorporating numerical analysis results for 152 earthquake ground motions. Conventionally, the charts developed for slopes and gravity walls have been adopted by practitioners for cantilever retaining walls assuming an imaginary vertical plane through the wall heel and considering the soil above as a part of the wall itself. Using these conventional charts of slopes with a single wedge assumption may lead to misleading predictions, which is one of the motivations behind developing charts specifically for the cantilever retaining walls. It also provides an estimation for the resulting subsidence in the backfill that may induce distress in the overlying structures. Unlike conventional charts, 5% − 20% probability of exceedance curves besides upper-bound curves have been developed accounting for earthquake motion variability. Non-dimensional equations have been proposed to estimate the minimum heel-length of the wall with and without shear key for the design values of PGA and PGV.