Christof Beyer
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Christof Beyer has a total of 97 co-authors. Here are the top co-authors by number of shared publications:
- Sebastian Bauer
Institute of Geosciences, Kiel University, Kiel, Germany
33 shared publications - Olaf Kolditz
Helmholtz Centre for Environmental Research - UFZ, Leipzig, Germany
10 shared publications Andreas Dahmke
Institute of Geosciences, Kiel University, Kiel, Germany
5 shared publications- Peter Dietrich
Helmholtz Centre for Environmental Research Leipzig Germany
4 shared publications Ralf Köber
Institute of Geosciences, Kiel University, Kiel, Germany
4 shared publications- E. Ballarini
University of Kiel
3 shared publications
Latest Publications
- Open Access
- 15 April 2026
- Published by Springer Nature in Hydrogeology Journal
- Vol. 34 (5) , 1-23
Integrating hydraulic and thermal constraints for ATES well placements: An analytical approach
Aquifer thermal energy storage (ATES) mitigates the seasonal mismatch between summertime heat supply and wintertime heat demand, contributing to decarbonization of the heating and cooling sector. Conventional low-temperature ATES design targets high-transmissivity aquifers to achieve the pumping rates needed to meet energy demand. If geological constraints or competing subsurface uses require storage in lower-transmissivity formations, pumping rates may be restricted to limit hydraulic head changes or reduce the risk of well screen particle clogging. This restriction would increase the number of well doublets and potentially make well field layout a critical design challenge. To address this complexity at an early planning stage, an analytical approach is presented that determines the minimum number and distance of ATES well doublets assuming a checkerboard or a lane layout. The approach combines thermal and hydraulic constraints by determining a minimum well distance derived from the thermal radius and a maximum well distance necessary to limit pumping-induced head changes, explicitly accounting for hydraulic superposition effects in multi-doublet well fields. Applying this approach to a planned low-temperature ATES at Kiel University, Germany, shows that the checkerboard layout achieves the target pumping rate of 200 m 3 /h with nine well doublets, whereas the lane layout requires 11 well doublets. The analysis also indicates that reducing the distance between wells of the same type in low-transmissivity aquifers significantly increases the number of well doublets. The approach provides a practical tool for preliminary ATES design, supporting informed well field configuration under hydraulic constraints.
- 15 April 2026
- Published by Springer Nature in Hydrogeology Journal
- Vol. 34 (5) , 1-23
Open AccessIntegrating hydraulic and thermal constraints for ATES well placements: An analytical approach
Aquifer thermal energy storage (ATES) mitigates the seasonal mismatch between summertime heat supply and wintertime heat demand, contributing to decarbonization of the heating and cooling sector. Conventional low-temperature ATES design targets high-transmissivity aquifers to achieve the pumping rates needed to meet energy demand. If geological constraints or competing subsurface uses require storage in lower-transmissivity formations, pumping rates may be restricted to limit hydraulic head changes or reduce the risk of well screen particle clogging. This restriction would increase the number of well doublets and potentially make well field layout a critical design challenge. To address this complexity at an early planning stage, an analytical approach is presented that determines the minimum number and distance of ATES well doublets assuming a checkerboard or a lane layout. The approach combines thermal and hydraulic constraints by determining a minimum well distance derived from the thermal radius and a maximum well distance necessary to limit pumping-induced head changes, explicitly accounting for hydraulic superposition effects in multi-doublet well fields. Applying this approach to a planned low-temperature ATES at Kiel University, Germany, shows that the checkerboard layout achieves the target pumping rate of 200 m 3 /h with nine well doublets, whereas the lane layout requires 11 well doublets. The analysis also indicates that reducing the distance between wells of the same type in low-transmissivity aquifers significantly increases the number of well doublets. The approach provides a practical tool for preliminary ATES design, supporting informed well field configuration under hydraulic constraints.
- Open Access
- 21 June 2024
- Published by Elsevier in Geothermics
- Vol. 122
Uncertainty assessment of thermal recovery and subsurface temperature changes induced by high-temperature aquifer thermal energy storage (HT-ATES): A case study
- 21 June 2024
- Published by Elsevier in Geothermics
- Vol. 122
Open AccessUncertainty assessment of thermal recovery and subsurface temperature changes induced by high-temperature aquifer thermal energy storage (HT-ATES): A case study
- Open Access
- 16 April 2024
- Published by Elsevier in Applied Thermal Engineering
- Vol. 248
Experimental and numerical investigation of thermal interactions between high-temperature borehole heat exchangers in unsaturated and low permeable soil
- 16 April 2024
- Published by Elsevier in Applied Thermal Engineering
- Vol. 248
Open AccessExperimental and numerical investigation of thermal interactions between high-temperature borehole heat exchangers in unsaturated and low permeable soil
- Open Access
- 14 August 2023
- Published by Elsevier in Applied Thermal Engineering
- Vol. 236, 121345
Experimental and numerical investigation of thermally induced convection along a high-temperature borehole heat exchanger
- 14 August 2023
- Published by Elsevier in Applied Thermal Engineering
- Vol. 236, 121345
Open AccessExperimental and numerical investigation of thermally induced convection along a high-temperature borehole heat exchanger
- 1 December 2019
- Published by Elsevier in Applied Energy
- Vol. 256, 113937
Experimental characterization of a lab-scale cement based thermal energy storage system
- 1 December 2019
- Published by Elsevier in Applied Energy
- Vol. 256, 113937
Experimental characterization of a lab-scale cement based thermal energy storage system
- 1 January 2018
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 43 (1) , 512-529
A unified phase equilibrium model for hydrogen solubility and solution density
- 1 January 2018
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 43 (1) , 512-529
A unified phase equilibrium model for hydrogen solubility and solution density
- Open Access
- 1 September 2017
- Published by Elsevier in Energy Procedia
- Vol. 125, 604-611
Experimental and numerical investigation of a scalable modular geothermal heat storage system
- 1 September 2017
- Published by Elsevier in Energy Procedia
- Vol. 125, 604-611
Open AccessExperimental and numerical investigation of a scalable modular geothermal heat storage system
- Top Cited PapersOpen Access
- 9 March 2017
- Published by Geological Society of London in Petroleum Geoscience
- Vol. 23 (3) , 315-326
Hydrogen storage in a heterogeneous sandstone formation: dimensioning and induced hydraulic effects
Large-scale energy storage in the geological subsurface (e.g. by storing hydrogen gas) may help to mitigate effects of a fluctuating energy production arising from the extensive use of renewable energy sources. The applicability of hydrogen (H 2 ) storage in a porous sandstone formation is investigated by defining a usage scenario and a subsequent numerical simulation of a storage operation at an existing anticlinal structure in the North German Basin. A facies modelling approach is used to obtain 25 heterogeneous and realistic parameter sets. The storage operation consists of the initial filling with nitrogen used as cushion gas, the initial filling with H 2 , and six withdrawal periods with successive refilling and shut-in periods. It is found that, on average, the storage can sustain a continuous power output of 245 MW for 1 week when using five storage wells, while peak performance can be as high as 363 MW, indicating that the storage is mainly limited by the achievable extraction rates. The median of the maximum pressure perturbation caused by this storage is around 3 bars and can be observed at a distance of 5 km from the wells.
- 9 March 2017
- Published by Geological Society of London in Petroleum Geoscience
- Vol. 23 (3) , 315-326
Top Cited PapersOpen AccessHydrogen storage in a heterogeneous sandstone formation: dimensioning and induced hydraulic effects
Large-scale energy storage in the geological subsurface (e.g. by storing hydrogen gas) may help to mitigate effects of a fluctuating energy production arising from the extensive use of renewable energy sources. The applicability of hydrogen (H 2 ) storage in a porous sandstone formation is investigated by defining a usage scenario and a subsequent numerical simulation of a storage operation at an existing anticlinal structure in the North German Basin. A facies modelling approach is used to obtain 25 heterogeneous and realistic parameter sets. The storage operation consists of the initial filling with nitrogen used as cushion gas, the initial filling with H 2 , and six withdrawal periods with successive refilling and shut-in periods. It is found that, on average, the storage can sustain a continuous power output of 245 MW for 1 week when using five storage wells, while peak performance can be as high as 363 MW, indicating that the storage is mainly limited by the achievable extraction rates. The median of the maximum pressure perturbation caused by this storage is around 3 bars and can be observed at a distance of 5 km from the wells.
- 1 January 2017
- Published by Springer Nature
OpenGeoSys Tutorial
- Open Access
- 23 December 2016
- Published by Springer Nature in Environmental Earth Sciences
- Vol. 76 (1) , 1-17
Energy storage in the geological subsurface: dimensioning, risk analysis and spatial planning: the ANGUS+ project
- 23 December 2016
- Published by Springer Nature in Environmental Earth Sciences
- Vol. 76 (1) , 1-17
Open AccessEnergy storage in the geological subsurface: dimensioning, risk analysis and spatial planning: the ANGUS+ project