Junfu Lyu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Junfu Lyu has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Yang Zhang
Tsinghua University
4 shared publications - Hairui Yang
Department of Energy and Power Engineering, Tsinghua University
3 shared publications - Yuxin Wu
Department of Energy and Power Engineering, Tsinghua University, Beijing 100084, China
3 shared publications Hai Zhang
Key Laboratory for Thermal Science and Power Engineering of Ministry of Education, Department of Energy and Power Engineering, Tsinghua University, Beijing100084, China
2 shared publicationsJunping Gu
Qian Xuesen Laboratory of Space Technology, China Academy of Space Technology, Beijing 100094, China
2 shared publications- Qinggong Wang
Energy Conversion Research Center, Qian Xuesen Laboratory of Space Technology, China Academy of Space Technology, Beijing 100094, China
2 shared publications
Latest Publications
- 30 January 2023
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 62 (6) , 3001-3010
Semiempirical Model of the Drag Force Acting on an Obstacle in Downward Dense Particle Flows as per the Flow-Around Behavior
- 30 January 2023
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 62 (6) , 3001-3010
Semiempirical Model of the Drag Force Acting on an Obstacle in Downward Dense Particle Flows as per the Flow-Around Behavior
- 27 September 2022
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 61 (40) , 14927-14939
Double-Eccentric Design for the Vortex Finder of a Cyclone Separator
- 27 September 2022
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 61 (40) , 14927-14939
Double-Eccentric Design for the Vortex Finder of a Cyclone Separator
- 14 September 2021
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 37 (41) , 12098-12111
Manipulation of a Nonconductive Droplet in an Aqueous Fluid with AC Electric Fields: Droplet Dewetting, Oscillation, and Detachment
Electrowetting (EW) is an effective method for droplet manipulation in microfluidics. In traditional EW, a conductive droplet is actuated, which spreads on a solid substrate. Recently, we considered an opposite phenomenon of droplet actuation in EW: inducing nonconductive droplet dewetting and detaching from the substrate. An oil/water system is used in which the oil droplet (nonconductive) is actuated on a flat substrate in surrounding water (conductive) by EW. In this work, alternating current (AC) electric fields are applied to EW, and the transient dynamics of droplet dewetting, oscillation, and detachment with the AC signals are investigated. The droplet is not in contact with electrodes, and it dances freely on the substrate. Experiments are performed in a wide range of voltages and AC frequencies. To demonstrate the droplet dynamics, we divide the full process of droplet manipulation into three distinguishable periods, that is, an initiating period, a steady oscillation period, and a detaching condition. Transient droplet dewetting is considered in the initiating period, and we obtain the distribution of the contact line friction factor. In steady oscillation, the oscillation resonance is verified from the oscillating amplitude of the contact line. Different periodical features are found for the droplet dancing at the resonance frequencies and departure from resonance. The droplet is detached at high voltages, and we provide a map for the detachable and nondetachable zones. The voltage is the dominant factor determining the droplet detachment; however, the AC frequency has notable influences on the critical voltage. The detachment is promoted when the AC frequency is within the region of the oscillation resonance (e.g., 20 < f < 75 Hz). In this region, the detaching process is not monotonic but instead, the droplet rebounds by several times before it is completely detached.
- 14 September 2021
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 37 (41) , 12098-12111
Manipulation of a Nonconductive Droplet in an Aqueous Fluid with AC Electric Fields: Droplet Dewetting, Oscillation, and Detachment
Electrowetting (EW) is an effective method for droplet manipulation in microfluidics. In traditional EW, a conductive droplet is actuated, which spreads on a solid substrate. Recently, we considered an opposite phenomenon of droplet actuation in EW: inducing nonconductive droplet dewetting and detaching from the substrate. An oil/water system is used in which the oil droplet (nonconductive) is actuated on a flat substrate in surrounding water (conductive) by EW. In this work, alternating current (AC) electric fields are applied to EW, and the transient dynamics of droplet dewetting, oscillation, and detachment with the AC signals are investigated. The droplet is not in contact with electrodes, and it dances freely on the substrate. Experiments are performed in a wide range of voltages and AC frequencies. To demonstrate the droplet dynamics, we divide the full process of droplet manipulation into three distinguishable periods, that is, an initiating period, a steady oscillation period, and a detaching condition. Transient droplet dewetting is considered in the initiating period, and we obtain the distribution of the contact line friction factor. In steady oscillation, the oscillation resonance is verified from the oscillating amplitude of the contact line. Different periodical features are found for the droplet dancing at the resonance frequencies and departure from resonance. The droplet is detached at high voltages, and we provide a map for the detachable and nondetachable zones. The voltage is the dominant factor determining the droplet detachment; however, the AC frequency has notable influences on the critical voltage. The detachment is promoted when the AC frequency is within the region of the oscillation resonance (e.g., 20 < f < 75 Hz). In this region, the detaching process is not monotonic but instead, the droplet rebounds by several times before it is completely detached.
- 13 March 2021
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 60 (11) , 4440-4452
Bubble Growth in NaCl Solution: Influence of Superheat Temperature and Solution Concentration
- 13 March 2021
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 60 (11) , 4440-4452
Bubble Growth in NaCl Solution: Influence of Superheat Temperature and Solution Concentration
- 23 June 2020
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 36 (28) , 8152-8164
Actuation of a Nonconductive Droplet in an Aqueous Fluid by Reversed Electrowetting Effect
Manipulation of a conductive droplet by electrowetting has been a popular topic in microfluidics whereby wettability of the droplet on a solid surface is increased by applying a voltage between the conductive droplet and the insulated surface. However, the opposite phenomenon, e.g., decreasing the wettability of a nonconductive droplet and increasing its contact angle (CA) by the reversed electrowetting (REW) effect, has been scarcely reported. Such a process involves not only the transient dynamics of droplet dewetting but also a critical condition for droplet detachment from the adhesive surface. In this work, actuation of a nonconductive droplet in an aqueous surrounding fluid by REW is studied experimentally. Silicone oil is used for the actuated droplet, and filtered water is used as the surrounding fluid. The solid substrate is made of a glass substrate coated with an indium tin oxide (ITO) film and then deposited by a dielectric layer of Parylene C. Potential difference is applied between the substrate and the surrounding fluid, eliminating the disturbance from the top needle on the motion of the droplet. Three different regimes are identified in the full range of operation. An underactuated regime occurs at low applied voltages, in which the CA of the droplet shows a monotonic increase with the increase of voltage (V). The friction coefficient of the contact line decreases with V before the CA saturation (Vs) but shows little change when V > Vs. At high voltages, the contact line of the sessile droplet is contracted excessively by REW. The droplet shows oscillation, and it refers to the overactuated regime. A combined time scale is proposed, and it verifies that the viscous dissipation of the contact line and liquid inertia show comparable contributions in the droplet dynamics. At sufficiently high voltages, the droplet is rejected completely from the surface. A critical equation for the threshold voltage of droplet detachment is built, and its validity is confirmed by experimental results.
- 23 June 2020
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 36 (28) , 8152-8164
Actuation of a Nonconductive Droplet in an Aqueous Fluid by Reversed Electrowetting Effect
Manipulation of a conductive droplet by electrowetting has been a popular topic in microfluidics whereby wettability of the droplet on a solid surface is increased by applying a voltage between the conductive droplet and the insulated surface. However, the opposite phenomenon, e.g., decreasing the wettability of a nonconductive droplet and increasing its contact angle (CA) by the reversed electrowetting (REW) effect, has been scarcely reported. Such a process involves not only the transient dynamics of droplet dewetting but also a critical condition for droplet detachment from the adhesive surface. In this work, actuation of a nonconductive droplet in an aqueous surrounding fluid by REW is studied experimentally. Silicone oil is used for the actuated droplet, and filtered water is used as the surrounding fluid. The solid substrate is made of a glass substrate coated with an indium tin oxide (ITO) film and then deposited by a dielectric layer of Parylene C. Potential difference is applied between the substrate and the surrounding fluid, eliminating the disturbance from the top needle on the motion of the droplet. Three different regimes are identified in the full range of operation. An underactuated regime occurs at low applied voltages, in which the CA of the droplet shows a monotonic increase with the increase of voltage (V). The friction coefficient of the contact line decreases with V before the CA saturation (Vs) but shows little change when V > Vs. At high voltages, the contact line of the sessile droplet is contracted excessively by REW. The droplet shows oscillation, and it refers to the overactuated regime. A combined time scale is proposed, and it verifies that the viscous dissipation of the contact line and liquid inertia show comparable contributions in the droplet dynamics. At sufficiently high voltages, the droplet is rejected completely from the surface. A critical equation for the threshold voltage of droplet detachment is built, and its validity is confirmed by experimental results.
- 5 May 2020
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 34 (6) , 7545-7553
Soot Formation and Distribution in Coal Jet Flames over a Broad Range of Coal Concentration
- 5 May 2020
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 34 (6) , 7545-7553
Soot Formation and Distribution in Coal Jet Flames over a Broad Range of Coal Concentration
- 29 October 2019
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 53 (22) , 13514-13523
Applications of Ultrafine Limestone Sorbents for the Desulfurization Process in CFB Boilers
With the stringent emission regulation taking effect, it is difficult for the conventional desulfurization technology in circulating fluidized bed (CFB) boilers to meet the requirements on ultra-low SO2 emission. Therefore, in this paper, the application of natural ultrafine limestone, with Sauter mean diameter of less than 20 μm, was tested by conducting bench-scale, pilot-scale and commercial-scale experiments to realize the highly efficient desulfurization in CFB furnaces. In the past, such small limestone was considered unsuitable for CFB boilers. However, as demonstrated by bench-scale results, the desulfurization performance was clearly superior to that of coarse limestone, especially at low SO2 concentrations. In a 3 MWth pilot-scale CFB boiler, the ultrafine limestone exhibited the competent desulfurization efficiency to the coarse limestone but clearly less significant catalytic effects on NOx formation. As revealed by field tests in four commercial-scale CFB boilers, when high-efficiency cyclones were applied to CFB boilers, the mass inventory of ultrafine particles was significantly increased and the residence time would be extended accordingly, thus the ultrafine limestone can be used to achieve the high desulfurization efficiency and even the ultra-low SO2 emission with a favorable Ca/S ratio. Furthermore, a technical roadmap was drawn for the cost-effective control of SO2 emission.
- 29 October 2019
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 53 (22) , 13514-13523
Applications of Ultrafine Limestone Sorbents for the Desulfurization Process in CFB Boilers
With the stringent emission regulation taking effect, it is difficult for the conventional desulfurization technology in circulating fluidized bed (CFB) boilers to meet the requirements on ultra-low SO2 emission. Therefore, in this paper, the application of natural ultrafine limestone, with Sauter mean diameter of less than 20 μm, was tested by conducting bench-scale, pilot-scale and commercial-scale experiments to realize the highly efficient desulfurization in CFB furnaces. In the past, such small limestone was considered unsuitable for CFB boilers. However, as demonstrated by bench-scale results, the desulfurization performance was clearly superior to that of coarse limestone, especially at low SO2 concentrations. In a 3 MWth pilot-scale CFB boiler, the ultrafine limestone exhibited the competent desulfurization efficiency to the coarse limestone but clearly less significant catalytic effects on NOx formation. As revealed by field tests in four commercial-scale CFB boilers, when high-efficiency cyclones were applied to CFB boilers, the mass inventory of ultrafine particles was significantly increased and the residence time would be extended accordingly, thus the ultrafine limestone can be used to achieve the high desulfurization efficiency and even the ultra-low SO2 emission with a favorable Ca/S ratio. Furthermore, a technical roadmap was drawn for the cost-effective control of SO2 emission.
- 29 October 2018
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 32 (11) , 11710-11717
Experimental Study of Alkali Salt Adsorption in a Circulating Fluidized Bed Boiler
- 29 October 2018
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 32 (11) , 11710-11717
Experimental Study of Alkali Salt Adsorption in a Circulating Fluidized Bed Boiler