PRPaul S. Russo

Paul S. Russo

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Paul S. Russo has a total of 117 co-authors. Here are the top co-authors by number of shared publications:

  • Cornelia Rosu

    School of Chemical & Biomolecular Engineering, Georgia Institute of Technology, 311 Ferst Drive, Atlanta, Georgia 30332-0100, United States

    7 shared publications
  • Rafael Cueto

    Department of Chemistry & Macromolecular Studies Group, Louisiana State University, 232 Choppin Hall, Baton Rouge, Louisiana 70803, United States

    6 shared publications
  • Xujun Zhang

    School of Materials Science & Engineering, Georgia Institute of Technology, Atlanta, Georgia 30332, United States

    6 shared publications
  • Cornelia Rosu

    School of Materials Science and Engineering, Georgia Institute of Technology , Atlanta, Georgia 30332, United States

    4 shared publications
  • Elsa Reichmanis

    Lehigh University

    3 shared publications
  • Yuwu Chen

    Center for Computation and Technology, Louisiana State University, Baton Rouge, Louisiana 70803, United States

    3 shared publications

Latest Publications

  • Open Access

    On the potential of zero-angle depolarized dynamic light scattering for rapid determination of solvent-dispersed cellulose nanocrystals

    by Natalie Glover, Evan B. Moore, Monneh W. Diggs, Ingeborg Schmidt-Krey, Victor Breedveld, Paul S. Russo

    As the use of cellulose nanocrystals has grown, so has the need to characterize their sizes and the degree to which they are dispersed. Quick and reliable assessment of an individual batch would improve quality control, of great interest to producers, vendors, and users. While current techniques such as transmission electron microscopy, scanning probe microscopy, and asymmetric field flow fractionation enjoy high particle resolution, they are expensive and slow. This report concerns the potential of zero-angle depolarized dynamic light scattering as a low-cost, rapid, and straightforward method for cellulose nanocrystal length measurements. The technique proves more effective than traditional dynamic light scattering when it comes to differentiating between two separate cellulose nanocrystal samples in the important case where the difference resides not so much in the particle dimensions as in the state of dispersion. This much is evident from the raw data—i.e., without assumptions. When reasonable assumptions about the shape, hydrodynamics and optical nature of the nanocrystals are applied, zero-angle depolarized dynamic light scattering can reproducibly provide qualitative length distributions for billions of particles simultaneously. Pushing ahead to semiquantitative analysis remains a challenge, and full characterization of length, width and shape distributions still lies in the realm of particle-imaging forms of microscopy.

  • Equipping a Wyatt multiangle, multidetector instrument for real-time particle and polymer sizing by simultaneous multiple-angle dynamic and static light scattering

    by Xujun Zhang, Daniel Hicks, Honglin Liu, Natalie Glover, Zhaoxian Zhang, Arshay J. Grant, Monneh Diggs, Ingeborg Schmidt-Krey, Paul S. Russo

    Well-constructed instruments may continue to perform beyond their manufacturer-supported service lifetime, which is typically limited by computer operating system compatibility or the availability of spare parts. Often, such equipment is condemned to surplus and destroyed. End-of-life plans that retain some of the material and energy used to create scientific instruments are of interest, just as in other manufacturing sectors. This is especially true when an instrument can be given new capabilities beyond those for which it was originally designed, maybe even surpassing newly built models. We report the “upcycling” of a Wyatt multiangle, multidetector instrument designed for static light scattering (SLS). The instrument retains SLS capability but was extended to multiangle, multidetector, multicorrelator dynamic light scattering operation by adding readily available fiber optics, detectors, and a modern, multichannel autocorrelator. Because one of the main catalysts of obsolescence is software compatibility, data processing was implemented with the stable Microsoft Excel platform, including a graphical user interface. Instrument performance is demonstrated with microemulsions, protein and polymer solutions, suspensions of latex particles, and suspensions of cellulose nanocrystals.


  • Open Access

    Classic Ubbelöhde Intrinsic Viscosity Laboratory Exercise Made Simple and Fast

    by Katie Copenhaver, Samuel Pennell, Samyak Jain, Paul S. Russo, Prateek Verma


  • Open Access

    Solubilization of Paclitaxel with Natural Compound Rubusoside toward Improving Oral Bioavailability in a Rodent Model

    by Jian Zhang, Jicheng Shu, Rhett W. Stout, Paul S. Russo, Zhijun Liu

    Paclitaxel, which features low water solubility and permeability, is an efflux pump substrate. The current paclitaxel drugs are given intravenously after resolving the solubility issue. Yet, oral delivery to achieve therapeutic bioavailability is not effective due to low absorption. This study evaluated a natural compound, rubusoside, to improve oral bioavailability in an animal model. Free paclitaxel molecules were processed into nano-micelles formed in water with rubusoside. The particle size of the nano-micelles in water was determined using dynamic light scattering. The oral bioavailability of paclitaxel in nano-micelles was determined against Cremophor/alcohol-solubilized Taxol after oral and intravenous administration to pre-cannulated Sprague Dawley rats. When loaded into the rubusoside-formed nano-micelles, paclitaxel reached a supersaturated concentration of 6 mg/mL, 60,000-fold over its intrinsic saturation of 0.1 µg/mL. The mean particle size was 4.7 ± 0.7 nm in diameter. Compared with Taxol®, maximum blood concentration was increased by 1.5-fold; the time to reach maximum concentration shortened to 0.8 h from 1.7 h; and, relative oral bioavailability increased by 88%. Absolute oral bioavailability was 1.7% and 1.3% for the paclitaxel nano-micelles and Taxol®, respectively. Solubilizing paclitaxel with rubusoside was successful, but oral bioavailability remained low. Further inhibition of the efflux pump and/or first metabolism may allow more oral paclitaxel to enter systemic circulation.


  • Open Access

    Structural Information on Supramolecular Copper(II) β-Diketonate Complexes from Atomic Force Microscopy and Analytical Ultracentrifugation

    by Jonathan S. Casey, Ashley R. Walker, Xianglin Zhai, Jayne C. Garno, Paul S. Russo, Andrew W. Maverick

    Supramolecular Cu(II) complexes were prepared from two trifunctional β-diketone ligands. The ligands (CH3Si(phacH)3 and CH3Si(phprH)3, represented by LH3) contain three aryl-β-diketone moieties joined by an organosilicon group. The complexes have the empirical formula Cu3L2, as expected for combinations of Cu2+ and L3-. Several metal-organic polyhedra (MOPs) [Cu3L2]n are possible (n = 1-10); a dodecahedron (Cu30L20; n = 10; estimated diameter of ca. 5 nm) should be the most stable because its internal bond angles would come closest to ideal values. Atomic force microscopy (AFM), performed on samples deposited from solution onto mica substrates, revealed a distribution of sample heights in the 0.5-3.0 nm range. The most commonly observed heights were 0.5-1.5 nm, corresponding to the smallest possible molecules (Cu3L2, i.e., n = 1). Some molecular cubes (Cu12L8; ca. 2.5 nm) or larger molecules or aggregates may be present as well. Equilibrium analytical ultracentrifugation (AUC) was also used to probe the compounds. A previously reported reference compound, the molecular square Cu4(m-pbhx)4 (M = 2241 g mol-1), behaved well in AUC experiments in four nonpolar organic solvents. AUC data for the new tris(β-diketonate) MOPs [Cu3L2]n in toluene and fluorobenzene did not agree well with the theoretical results for a single solute. The data were fit well by a two-solute model, but these results were not consistent in the two solvents used, and some run-to-run variability was noted even in the same solvent. Also, the calculated molecular weights differed significantly from those expected for [Cu3L2]n ([Cu3(CH3Si(phac)3)2]n, multiples of 1322 g mol-1; or [Cu3(CH3Si(phpr)3)2]n, multiples of 1490 g mol-1).


  • Open Access

    Differential Dynamic Microscopy: Diffusion Measurements Where You Want Them

    by Xujun Zhang, Jinxin Fu, Zhaoxian Zhang, Mateen Jangda, Cornelia Rosu, Graham D. B. Parkinson, Paul S. Russo


  • Solution Characterization of PEGL, a Water-Soluble, Non-Ionic, Helical Polypeptide

    by Wayne Huberty, Rafael Cueto, Donghui Zhang, Paul S. Russo

  • Reshaping sub-millimetre bubbles from spheres to tori

    by Xujun Zhang, Shane Jacobeen, Qiang Zhang, Brian Khau, Peter Yunker, H. Jerry Qi, Saad Bhamla, Paul S. Russo

    Manipulating air pressure above suspensions of sub-millimetre, protein-coated bubbles converts them from rods to lollipops to smooth spheres to tori. The sphere-to toroid transition can be reversed at least 4 times.


  • Molecular Dynamics Simulations of Nanostructures Formed by Hydrophobins and Oil in Seawater

    by Andrés A. Vodopivec, Yuwu Chen, Paul S. Russo, Francisco R. Hung

    Classical molecular dynamics simulations using the Martini coarse-grained force field were performed to study oil nanodroplets surrounded by fungal hydrophobin (HP) proteins in seawater. The class I EAS and the class II HFBII HPs were studied along with two model oils, namely, benzene and n-decane. Both HPs exhibit free energy minima at the oil-seawater interface, which is deeper in benzene compared to the n-decane systems. Larger constraint forces are required to keep both HPs within the n-decane phase compared to inside benzene, with HFBII being more affine to benzene compared to EAS. Smaller surface tensions are observed at benzene-seawater interfaces coated with HPs compared to their n-decane counterparts. In the latter the surface tension remains unchanged upon increases in the concentration of HPs, whereas in benzene systems adding more HPs lead to decreases in surface tension. EAS has a larger tendency to cluster together in the interface compared to HFBII, with both HPs having larger coordination numbers when surrounding benzene droplets compared to when they are around n-decane nanoblobs. The HP-oil nanostructures in seawater examined have radii of gyration ranging between 2 and 12 nm, where the n-decane structures are larger and have more irregular shapes compared to the benzene systems. The n-decane molecules within the nanostructures form a compact spherical core, with the HPs partially covering its surface and clustering together, conferring irregular shapes to the nanostructures. The EAS with n-decane structures are larger and have more irregular shapes compared to their HFBII counterparts. In contrast, in the HP-benzene structures both HPs tend to penetrate the oil part of the droplet. The HFBII-benzene structures having the larger oil/HP ratios examined tend to be more compact and spherical compared to their EAS counterparts; however, some of the HFBII-benzene systems that have smaller oil/HP ratios have a more elongated structure compared to their EAS counterparts. This simulation study provides insights into HP-oil nanostructures that are smaller than the oil droplets and gas bubbles recently studied in experiments and, thus, might be challenging to examine with experimental techniques.