ZGZhe Guan

Zhe Guan

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Zhe Guan has a total of 19 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Retraction
    Open Access

    RETRACTION: Design of an Optimized GMV Controller based on Data-Driven Approach

    by Liying Shi, Zhe Guan, Toru Yamamoto

    This paper presents a data-driven scheme that can obtain the optimized Generalized Minimum Variance (GMV) control parameters by applying the Nelder–Mead (NM) method based on Proportional–Integral Derivative (PID) controller for linear system. An adjustable λ is included in the GMV-PID controller. In the existing GMV-PID controller, the PID parameters are calculated by simply changing λ manually. Therefore, it is hard to get desirable control performance. The NM method is introduced to improve the control performance. The application of NM method can optimize the calculation of λ. However, the objective function in NM method needs the output calculation. In other words, the model information is inevitably to obtain output. To achieve model-free design scheme, the estimation of closed-loop response method is introduced in database-driven approach. Using obtained closed-loop data can predict the output and then substitute it into the objective function without any model information of the process. The effectiveness is verified by experiment.

  • Topography-Dependent Q-Compensated Least-Squares Reverse Time Migration of Prismatic Waves

    by Yingming Qu, Zhenchun Li, Zhe Guan, Chang Liu, Junzhi Sun

    Prismatic waves carry steeply dipping structural information that primaries cannot contain. Therefore, prismatic waves are separately used in some migration methods to improve the illumination and imaging effect on steeply dipping structures. Least-squares reverse time migration of prismatic waves (LSRTM-P) can produce high-resolution images with improved steeply dipping structures. However, viscoelasticity exists widely on the Earth, which poses great difficulty for imaging. The effect of attenuation on prismatic waves is difficult to be compensated when conducting LSRTM-P because prismatic waves have three propagation paths. To overcome this problem, a $Q$ -compensated LSRTM ( $Q$ -LSRTM)-P method is proposed by deriving $Q$ -compensated forward-propagated operators and backward-propagated adjoint operators of prismatic waves, which compensates for $Q$ attenuation along all the three propagation paths of prismatic waves. The proposed $Q$ -LSRTM-P is conducted to update the image after applying the conventional $Q$ -LSRTM. Besides, the proposed method can be adapted to the irregular surface media. Numerical examples on two synthetic and a field datasets verify that our method can produce better imaging results with clearer steeply dipping structures, higher signal-to-noise ratio (SNR), higher resolution, and more balanced amplitude than noncompensated LSRTM-P and conventional $Q$ -LSRTM.


  • Open Access

    Design of a Nonlinear Generalized Predictive Controller based on Database-Driven Approach

    by Zhe Guan, Toru Yamamoto

    This paper presents a Generalized Predictive Control (GPC) design scheme based on database-driven approach for nonlinear systems. In industrial systems, lots of controlled plants with unknown time-delay and strong nonlinearity, are difficult to be handled in terms of control performance. The databased-driven approach has been attracted attention to tackle non-linearity issue without system information. On the other hand, GPC is considered in cases where the time-delay is unknown. The proposed scheme is validated through a numerical simulation.

  • Open Access

    Erratum: [Learning the blending spikes using sparse dictionaries]

    by Yangkang Chen, Shaohuan Zu, Wei Chen, Mi Zhang, Zhe Guan

    This is an erratum to ‘Learning the blending spikes using sparse dictionaries’. In the original version of this article, due to our carelessness, Shaohuan Zu's affiliation was erroneously marked as ‘School of Earth Sciences, Zhejiang University, Hangzhou, Zhejiang Province 310027, China’. The correct affiliation of Shaohuan Zu is State Key Laboratory of Petroleum Resources and Prospecting, China University of Petroleum, Fuxue Road 18th Beijing 102200, China. The author apologies for the error.

  • Automatic high-resolution microseismic event detection via supervised machine learning

    by Shan Qu, Zhe Guan, Eric Verschuur, Yangkang Chen

    SUMMARY: Microseismic methods are crucial for real-time monitoring of the hydraulic fracturing dynamic status during the development of unconventional reservoirs. However, unlike the active-source seismic events, the microseismic events usually have low signal-to-noise ratio (SNR), which makes its data processing challenging. To overcome the noise issue of the weak microseismic events, we propose a new workflow for high-resolution microseismic event detection. For the preprocessing, fix-sized segmentation with a length of 2*wavelength is used to divide the data into segments. Later on, 191 features have been extracted and used as the input data to train the support vector machine (SVM) model. These features include 63 1-D time/spectral-domain features, and 128 2-D texture features, which indicate the continuity, smoothness, and irregularity of the events/noise. The proposed feature extraction maximally exploits the limited information of each segment. Afterward, we use a combination of univariate feature selection and random-forest-based recursive feature elimination for feature selection to avoid overfitting. This feature selection strategy not only finds the best features, but also decides the optimal number of features that are needed for the best accuracy. Regarding the training process, SVM with a Gaussian kernel is used. In addition, a cross-validation (CV) process is implemented for automatic parameter setting. In the end, a group of synthetic and field microseismic data with different levels of complexity show that the proposed workflow is much more robust than the state-of-the-art short-term-average over long-term-average ratio (STA/LTA) method and also performs better than the convolutional-neural-networks (CNN), for this case where the amount of training data sets is limited. A demo for the synthetic example is available: https://github.com/shanqu91/ML_event_detection_microseismic.


  • Viscoacoustic reverse time migration of joint primaries and different-order multiples

    by Yingming Qu, Jinli Li, Zhe Guan, Zhenchun Li

    Compared to primary arrivals, multiples have longer propagation paths and smaller reflection angles, leading to a wider illumination area in the horizontal direction and higher resolution in the vertical direction. Hence, it is better to make full use of the multiples rather than suppressing them. However, seismic attenuation exists widely in the subsurface medium, especially directly below the deep sea bottom. Therefore, to compensate for the attenuation effect during multiple imaging, we have developed a viscoacoustic reverse time migration (RTM) method of different-order multiples. Following the multiple propagation paths, we compensate for the attenuation during source wavefield forward propagation and receiver backward propagation, and we introduce a regularization operator to automatically eliminate the exponential high-frequency noise during the attenuation compensation process. Taking advantage of the full wavefield information, we jointly use the different-order multiples and primaries when implementing viscoacoustic RTM. In numerical examples, we validate the viscoacoustic RTM of different-order multiples in a three-layer attenuation model and an attenuating Sigsbee2B model. Our results suggest that our method can image the models using different-order multiples separately, which suppresses crosstalk artifacts, balances energy, raises resolution, and improves subsalt images dramatically.


  • Fluid-solid coupled elastic full waveform inversion in the curvilinear coordinates for OBC data

    by Yingming Qu, Zhe Guan, Jinli Li, Zhenchun Li

    Marine seismic exploration with the ocean bottom cable (OBC) technology is able to record the compressional (P-) wave and shear (S-) wave information simultaneously. Elastic full waveform inversion...


  • Open Access

    Using Fast Marching Eikonal Solver to Compute 3‐D Pds Traveltime for Deep Receiver‐Function Imaging

    by Zhe Guan, Fenglin Niu

    In common‐conversion‐point stacking of receiver functions, most current studies compute 3‐D relative Pds traveltime corrections by integrating traveltime anomalies along 1‐D raypaths. This ray tracing approach is generally time‐consuming and less accurate when prominent velocity anomalies exist and effects of 3‐D raypaths become significant. In this study we introduce a new scheme that utilizes a fast‐marching method eikonal solver to improve both the efficiency and accuracy of 3‐D Pds traveltime computation. We first employ a 1‐D raytracing method and the iasp91 model to calibrate the accuracy of the new scheme and optimize the parameters of the numerical solver. We then apply the new scheme to compute a massive number of Pds traveltimes using two sets of 3‐D synthetic models, one set with a high‐velocity slab and another set with a low‐velocity plume, and compare these 3‐D traveltimes with those computed with the raypath integrating approach. We find 2.7% and 11.8% raypaths in the two slab models and 7.8% and 12.0% raypaths in the two plume models show a 3‐D traveltime difference of ≥0.5 s. We apply the proposed scheme to a subset of transportable array receiver functions that sample the transition zone beneath the Yellowstone hotspot and find that a common‐conversion‐point stack using 3‐D Pds traveltimes computed by the eikonal solver method has the best focused P660s. Finally, we illustrate that computational times can be reduced by 1 to 2 orders of magnitude with the new scheme to compute 3‐D Pds traveltimes of 20,000–200,000 receiver functions.


  • Attenuation compensation in anisotropic least-squares reverse time migration

    by Yingming Qu, Jianping Huang, Zhenchun Li, Zhe Guan, Jinli Li

    Anisotropic and attenuating properties of subsurface media cause amplitude loss and waveform distortion in seismic wave propagation, resulting in negative influence on seismic imaging. To correct the anisotropy effect and compensate amplitude attenuation, a compensated-amplitude vertical transverse isotropic (VTI) least-squares reverse time migration (LSRTM) method is adopted. In this method, the attenuation term of an attenuated acoustic wave equation is extended to a VTI quasi-differential wave equation, which takes care of effects from anisotropy and attenuation. The finite-difference method is used to solve the equation, in which attenuation terms are solved in the wavenumber domain, and other terms are solved in the space or wavenumber domain. Stable regularization operators are derived and introduced to the equations to eliminate severe numerical noise in high-frequency components during backward propagation. Meanwhile, a demigration operator, migration operator, and gradient formula for attenuated VTI media are derived to implement the amplitude-compensated VTI LSRTM. Test of a homogeneous model proves the accuracy of the attenuated VTI quasi-differential equations and the effectiveness of the regularization operators. A numerical example for a modified Marmousi model verifies the accuracy and superiority to the amplitude-compensated VTI LSRTM. Our results show that the sensitivity to anisotropic parameters is much higher than that to the Q parameters.