LMLukasz Marciniak

Lukasz Marciniak

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Lukasz Marciniak has a total of 42 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    D-D fusion neutron emission and plasma compression in a small-sized plasma focus operating with D 2 and D 2 +Ar gas mixtures

    by Lukasz Marciniak, Karel Rezac, Jan Novotny, Pavel Kubes, Jozef Kravarik, Daniel Klír, Jakub Cikhardt, Balzima Cikhardtova, Mohamad Akel

    Research was conducted to determine the influence of adding a small amount of argon on plasmafocus electrical discharges in deuterium. The influence of the initial deuterium pressure on discharges was also verified. A 3-kJ Mather-type plasma focus device was used together with the following diagnostic systems: magnetic and electric probes, vacuum ultraviolet and soft x-ray pinhole camera, schlieren laser imaging, PIN photodetectors, silver activation counter, and scintillation probes. A total of 470 discharges were performed and examined for two constant initial deuterium pressures: 280 Pa and 340 Pa. The 280 Pa was the optimum pressure for discharges in pure deuterium. Discharges in D 2 +Ar mixtures were performed with the following Ar fractions for 340 Pa of D 2 (in relation to the total mass of the mixture): 0.9%, 2.8%, and 10.4%. And discharges for 280 Pa with: 1.1%, 3.4%, 9.6%, and 17.5%. Most experiments were conducted with pumping of the experimental chamber prior to discharge, and a smaller number without. A maximum increase in total D-D fusion neutron emission yield ( Y n ) of 22% was achieved for discharges in 98.9%D 2 +1.1%Ar compared to discharges in pure D 2 . Experiments with predischarge pumping proved to be significantly more beneficial in terms of Y n . Three spontaneously occurring modes of plasma pinch compression were identified, for well-compressed discharges: stable, partially-stable, and unstable. And another three, for discharges not so well-compressed. They differed significantly in terms of compression dynamics, electrical waveforms and fusion neutron emission. Discharges in stable mode were characterised by lower radial compression velocities, slower evolution, greater pinch stability and low Y n . In contrast, discharges in unstable mode were characterised by faster radial compression of plasma, strong presence of filamentarylike structures, low stability, the presence of hot spots and the highest Y n . The reasons for the changes in Y n turned out to be changes in discharge statistics.

  • Open Access

    Erratum: “Evolution of filament-like compact structures in small 3 kJ dense plasma focus discharges” [Phys. Plasmas 31, 082707 (2024)]

    by P. Kubes, L. Marciniak, M. J. Sadowski, M. Paduch, B. Cikhardtova, J. Cikhardt, J. Kravarik, J. Malir, V. Munzar, J. Novotny, et al.

  • Open Access

    Evolution of filament-like compact structures in small 3 kJ dense plasma focus discharges

    by P. Kubes, L. Marciniak, M. J. Sadowski, M. Paduch, B. Cikhardtova, J. Cikhardt, J. Kravarik, J. Malir, V. Munzar, J. Novotný, et al.

    This paper presents the filamentary structure of the pinched column in a smaller plasma focus device filled with deuterium. The deflections were observed using schlieren and differential interferometry techniques. The observed filaments have a transverse diameter of 40–200 μm, which could be interpreted based on the electric current hypothesis as local concentrations of electric current. The evolution of filaments was compared with global structures recorded by extra ultraviolet frames. These results provide a basis for considering the possibility of a filamentary composition of the poloidal current in compact structures. The model of filaments with a helical shape of electrical current may be able to explain the central narrow and dense cord in the axis of the column, the different lifetimes of the structures, and the submillimeter sources of fast electrons and ions.


  • Open Access

    Total neutron emission from deuteron fusion and plasma pinch compression in a medium-sized plasma focus operating with D2 and D2 + Ne gas mixtures—Experimental results

    by L. Marciniak, A. Kulinska, M. Scholz, M. Akel, S. Lee, S. H. Saw

    Newly obtained results on hot and dense deuterium and deuterium-neon plasma compression in a z-pinch electrical discharge configuration are presented. The investigated plasma was generated and compressed using 269 high-current discharges in a medium-sized (dense) plasma focus device. The experimental chamber of the device was filled with deuterium and deuterium-neon gas mixtures under constant total mass/density conditions. Magnetic and electric probes, beryllium neutron activation counter, and high-speed four-frame vacuum ultraviolet/soft x-ray pinhole camera were used to study the plasma dynamics and radiation emission. The results obtained experimentally for the first time confirmed clearly a decrease in the minimum radius of plasma columns with an increase in initial neon fraction. Simultaneously, a decrease in the total neutron emission from deuteron fusion was found. The observed plasma/discharge evolution revealed that the classical description of plasma-focus discharges can be approximately correct up to the moment of maximum compression. Including, existence of quasi-equilibrium plasma compression is probable. It is also possible that the homogeneity of plasma columns during the slow compression phase and maximum compression moment increases with the increase in initial neon fraction. The effect of higher stabilization (repeatability) of discharges was confirmed, for higher initial neon fractions. The dependency of the total neutron emission yield on the parameters describing the full discharge dynamics and the maximum discharge voltage was confirmed. The existence of this type of dependency, for a minimum pinch radius is also possible. In contrast, there was little dependency to the total discharge current parameters measured in the collector area.


  • Open Access

    Filamentary-like structures of plasma in a small 3-kJ dense plasma-focus discharge in pure deuterium

    by P. Kubes, L. Marciniak, M. J. Sadowski, B. Cikhardtova, J. Cikhardt, D. Klir, J. Kravarik, J. Malir, V. Munzar, J. Novotný, et al.

    Filament-like structures were observed during discharges in a small 3-kJ plasma focus device operated with pure deuterium. These structures were recorded by means of two different laser diagnostic techniques: a schlieren system and a differential laser interferometry. They present the novel fine-scale (submillimeter) plasma structures recorded during the radial implosion, at the pinch stagnation, at the development of instabilities, and during a decay of the dense plasma column, when hard x-rays and fusion-produced neutrons were generated. The temporal uncertainty of these observations was about 2 ns, and the spatial one amounted to 40 μm. The filamentation seems be a natural and spontaneous process which occurs in high-current, hot, and dense plasmas produced in plasma focus devices. The observed filaments have usually longitudinal and/or azimuthal orientations. Their higher plasma density and appearance in regions of the measured and assumed current flows can be interpreted as the formation of plasma-current filaments with concentrated magnetic energy. These filamentary effects should be studied due to their possible role during the evolution of instabilities and the formation of small sources emitting fast electrons and ions.


  • Numerical experiments on the total D–D fusion neutron yield versus deuterium pressure for different energy plasma focus devices using the Lee model code

    by S Wahbe, Y Abou-Ali, M Akel, S Lee, L Marciniak

    Numerical experiments using the Lee model code were carried out to compute the total D–D fusion neutron yield versus initial deuterium pressure for nine different plasma focus devices [PF50, AACS, PF400J, PF2.2, UNU-ICTP, PFZ200, PF24, PF78, Poseidon]. The computed data were compared with the published experimental results. In addition, the maximum discharge current, the pinch current and the pinch ion number density, as a function of initial deuterium pressure, were discussed, as well as their effect on the neutron yield. The optimum pressures that correspond to the maximum neutron yield Y n were obtained for all considered devices, with reference to the specific plasma focus properties. The scaling laws for the D–D fusion neutron production, in terms of storage energies E 0 and pinch current I pinch, were derived. The scaling of Y n with I pinch and E 0 over the whole range of investigated energies up to 300 kJ has been obtained as follows: Y n ∼ I pinch 5 ,   Y n ∼ E 0 1.95 . These laws are important in the planning and design of a plasma focus as a potentially powerful pulse neutron source.


  • Investigation of the Measured and Computed Neutron Yield From the PF-24 Device Operated With D2-$x$ %Ar Admixture

    by M. Akel, L. Marciniak, S. Ismael, D. Gannom, A. Kulinska, S. Lee, M. Scholz, H.-J. Kunze, S. H. Saw

    Many experiments have been carried out on the (16.8 kJ, 17 kV) dense plasma focus PF-24 device operated with pure deuterium and deuterium-argon admixture. The main purpose of the work was to investigate the influence of the doping argon on the average total neutron yields experimentally and numerically. The 103 discharges (34 for D₂, 69 for D₂-x%Ar, where x = 3, 5, 10, 15, 22, 25, 30, 45, 60) were performed in four experimental sessions under constant total initial optimum pressure of about 2.2 torr. The total current and its time derivative traces, as well as the total neutron yield values, were recorded, and the electro-kinetic plasma parameters were estimated for each shot. The Lee model has also been adapted for gas mixture plasma focus modeling, and then the enhanced code was used for simulation of each of the PF-24 discharge with D₂ and D₂-x%Ar. The fitting parameters for each shot are found and discussed. The measured and computed values of the neutron yield and the electro-kinetic plasma parameters are in good agreement. The obtained results showed that there is no neutron yield enhancement with argon seeding. The scaling law of the neutron yield Yn against argon fraction has been deduced. Additionally, our results illustrate that the PF-24 plasma focus device has an optimized configuration for the DD fusion neutron emission.


  • Measurements and Simulations of Neutron Emission Versus Deuterium Filling Pressure in Plasma Focus Device PF-24

    by Ł. Marciniak, M. Akel, A. Kulińska, M. Scholz, S. Lee, H.-J. Kunze, S. H. Saw


  • EXPERIMENTAL AND MONTE CARLO INVESTIGATIONS OF BCF-12 SMALL‑AREA PLASTIC SCINTILLATION DETECTORS FOR NEUTRON PINHOLE CAMERA

    by J Bielecki, K Drozdowicz, D Dworak, A Igielski, W Janik, A Kulińska, Ł Marciniak, M Scholz, M Turzański, U Wiącek, et al.

    Plastic organic scintillators such as the blue-emitting BCF-12 are versatile and inexpensive tools. Recently, BCF-12 scintillators have been foreseen for investigation of the spatial distribution of neutrons emitted from dense magnetized plasma. For this purpose, small-area (5 mm × 5 mm) detectors based on BCF-12 scintillation rods and Hamamatsu photomultiplier tubes were designed and constructed at the Institute of Nuclear Physics. They will be located inside the neutron pinhole camera of the PF-24 plasma focus device. Two different geometrical layouts and approaches to the construction of the scintillation element were tested. The aim of this work was to determine the efficiency of the detectors. For this purpose, the experimental investigations using a neutron generator and a Pu–Be source were combined with Monte Carlo computations using the Geant4 code.