Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Ruben Tapia-Olvera has a total of 96 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Phase Voltage-Based Diagnosis of Inter-Turn Short Circuits in Permanent Magnet Synchronous Motor Stator Windings

    by David Marcos-Andrade, Francisco Beltran-Carbajal, Ivan Rivas-Cambero, Daniel Guillen, Ruben Tapia-Olvera, Irvin Lopez-Garcia

    The problem of fault diagnosis in electrical motors has an important impact on the supervision of dynamic systems, and model-based methods are efficient tools for this purpose. In this regard, this work presents a novel method for detecting inter-turn short circuits (ITSCs) in the stator windings of permanent magnet synchronous motors (PMSMs). The approach is based on algebraic identification to process the motor voltage signals, estimating the offsets, amplitudes, and phases of the fundamental and third-harmonic components. Fault detection is performed in two steps: first, a voltage imbalance index is evaluated to determine the presence of abnormal operating conditions. Subsequently, characteristic patterns in the estimated parameters are analyzed to identify both the fault type and the affected phase(s). The experimental results show that single-phase ITSC faults produce a reduction in the offset of the faulted phase together with an increase in its third-harmonic amplitude, whereas phase-to-phase ITSC faults lead to an increase in the offsets of the affected phases and nearly identical third-harmonic amplitudes between them. In both cases, only minor variations are observed in the estimated phase angles. The effectiveness of the proposed methodology is supported through theoretical analysis and validated experimentally using voltage measurements acquired from a PMSM test bench. The results demonstrate that the proposed technique can accurately identify fault conditions through voltage imbalance and harmonic-pattern analysis, providing a practical and computationally efficient methodology for PMSM stator winding fault diagnosis.

  • Open Access

    Bioinspired optimization on controlled anthropomorphic manipulator robots

    by Daniel Galvan-Perez, Francisco Beltran-Carbajal, Hugo Yañez-Badillo, Ivan Rivas-Cambero, Hossam A. Gabbar, Ruben Tapia-Olvera

    Bioinspired optimization algorithms, derived from biological processes such as bacterial foraging and swarm behavior, have shown increasing potential in addressing high-dimensional, nonlinear, and time-varying problems in engineering. Their integration into robotic control architectures enables the development of adaptive, model-flexible schemes that are robust to uncertainty and real-time constraints. Anthropomorphic manipulator robots, widely used in manufacturing and medical applications, require high-performance motion control under structural uncertainty, dynamic perturbations, and limited sensing. This paper proposes a unified and robust control scheme that integrates three key components: (i) a bacterial foraging optimization algorithm for offline initialization of controller weights, (ii) B-spline artificial neural networks for online adjustment of adaptive control gains, and (iii) a robust motion control law based on integral reconstruction theory, which eliminates the need for velocity measurement or full dynamic models and avoids high-gain compensation. This architecture overcomes several limitations of classical model-based, PID, or adaptive-only approaches by combining learning, compensation, and optimization within a scalable framework. The proposed method is validated through multiple simulation studies involving anthropomorphic manipulators with documented physical parameters and subjected to varying disturbances. Comparative analysis demonstrates superior tracking precision, reduced control effort, and faster convergence dynamics. These results confirm the practical viability of the proposed framework for motion control in dynamically uncertain robotic platforms.


  • Open Access

    Failure mode and effects analysis and sensitivity analysis for a neutral point re-injection multi-pulse voltage source converter

    by A. Valderrabano-Gonzalez, H.R. Robles-Campos, F. Beltran-Carbajal, R. Tapia-Olvera, J.C. Rosas-Caro, O. Aguilar-Mejia

  • Open Access

    Hybrid Empirical and Variational Mode Decomposition of Vibratory Signals

    by Eduardo Esquivel-Cruz, Francisco Beltran-Carbajal, Ivan Rivas-Cambero, José Humberto Arroyo-Núñez, Ruben Tapia-Olvera, Daniel Guillen

    Signal analysis is a fundamental field in engineering and data science, focused on the study of signal representation, transformation, and manipulation. The accurate estimation of harmonic vibration components and their associated parameters in vibrating mechanical systems presents significant challenges in the presence of very similar frequencies and mode mixing. In this context, a hybrid strategy to estimate harmonic vibration modes in weakly damped, multi-degree-of-freedom vibrating mechanical systems by combining Empirical Mode Decomposition and Variational Mode Decomposition is described. In this way, this hybrid approach leverages the detection of mode mixing based on the analysis of intrinsic mode functions through Empirical Mode Decomposition to determine the number of components to be estimated and thus provide greater information for Variational Mode Decomposition. The computational time and dependency on a predefined number of modes are significantly reduced by providing crucial information about the approximate number of vibratory components, enabling a more precise estimation with Variational Mode Decomposition. This hybrid strategy is employed to compute unknown natural frequencies of vibrating systems using output measurement signals. The algorithm for this hybrid strategy is presented, along with a comparison to conventional techniques such as Empirical Mode Decomposition, Variational Mode Decomposition, and the Fast Fourier Transform. Through several case studies involving multi-degree-of-freedom vibrating systems, the superior and satisfactory performance of the hybrid method is demonstrated. Additionally, the advantages of the hybrid approach in terms of computational efficiency and accuracy in signal decomposition are highlighted.


  • Open Access

    Efficient Adaptive Regulation Strategy for Control Position of Induction Motors

    by Ruben Tapia-Olvera, Antonio Valderrabano-Gonzalez, Francisco Beltran-Carbajal

    In this paper, we introduce an efficient adaptive algorithm based on B-spline neural networks for trajectory tracking of angular position for industrial induction motors. This strategy is developed in a two-axis reference frame and the regulation algorithm is based on four main stages: a) flux observer; b) internal control loop; c) determination of required electrical currents and; d) calculation of the three-phase input voltages. The strategy considers an algebraic regulation scheme based on the model. The control parameters are tuning online to attain the best dynamic behavior, besides, the proposed adaptive controller is subject to non-modeled components as an 84-pulse voltage source converter included in this study. These two aspects make the main contribution of this article. The proposed high-performance strategy for trajectory tracking of angular position is demonstrated by simulation results using the parameters of two induction motors of 500 hp and 50 hp, respectively.


  • Fluid use in the scheduled surgical patient.

    by Critical Care & Emergency Medicine, Ernesto Arriaga-Morales, Angélica Contreras-Muñoz, José Eduardo Rovelo Lima, Ricardo Sánchez Zamora, Rubén Isaac Olvera Rodríguez, Patrick James Atherton Avila, Ángel Nájera-Albarrán, Rubén Orlando Pérez-Nieto

    Fluid administration is almost universally accepted as a part of the treatment of any hospitalized patient, but this is based on old perspectives and an incomplete understanding of the intravenous fluid dynamics. A long time ago Shires et al described and defined a “third space” which is a nonfunctional fluid that can be considered a fluid loss and must be replaced; this understanding led to over reanimation1, 2. The surgical scheduled patient is a perfect example, most of those procedures don’t compromise the oral route, don’t imply large fluid loses, and don’t need large intravenous fluids even in complex cases like congenital heart defects

  • Open Access

    Motion-Tracking Control of Mobile Manipulation Robotic Systems Using Artificial Neural Networks for Manufacturing Applications

    by Daniel Galvan-Perez, Francisco Beltran-Carbajal, Ivan Rivas-Cambero, Hugo Yañez-Badillo, Antonio Favela-Contreras, Ruben Tapia-Olvera

    Robotic systems have experienced exponential growth in their utilization for manufacturing applications over recent decades. Control systems responsible for executing desired robot motion planning face increasingly stringent performance requirements. These demands encompass high precision, efficiency, stability, robustness, ease of use, and simplicity of the user interface. Furthermore, diverse modern manufacturing applications primarily employ robotic systems within disturbed operating scenarios. This paper presents a novel neural motion-tracking control scheme for mobile manipulation robotic systems. Dynamic position output error feedback and B–Spline artificial neural networks are integrated in the design process of the introduced adaptive robust control strategy to perform efficient and robust tracking of motion-planning trajectories in robotic systems. Integration of artificial neural networks demonstrates performance improvements in the control scheme while effectively addressing common issues encountered in manufacturing environments. Parametric uncertainty, unmodeled dynamics, and unknown disturbance torque terms represent some adverse influences to be compensated for by the robust control scheme. Several case studies prove the robustness of the adaptive neural control scheme in highly coupled nonlinear six-degree-of-freedom mobile manipulation robotic systems. Case studies provide valuable insights and validate the efficacy of the proposed adaptive multivariable control scheme in manufacturing applications.


  • Open Access

    Neural Network Trajectory Tracking Control on Electromagnetic Suspension Systems

    by Francisco Beltran-Carbajal, Hugo Yañez-Badillo, Ruben Tapia-Olvera, Julio C. Rosas-Caro, Carlos Sotelo, David Sotelo

    A new adaptive-like neural control strategy for motion reference trajectory tracking for a nonlinear electromagnetic suspension dynamic system is introduced. Artificial neural networks, differential flatness and sliding modes are strategically integrated in the presented adaptive neural network control design approach. The robustness and efficiency of the magnetic suspension control system on desired smooth position reference profile tracking can be improved in this fashion. A single levitation control parameter is tuned on-line from a neural adaptive perspective by using information of the reference trajectory tracking error signal only. The sliding mode discontinuous control action is approximated by a neural network-based adaptive continuous control function. Control design is firstly developed from theoretical modelling of the nonlinear physical system. Next, dependency on theoretical modelling of the nonlinear dynamic system is substantially reduced by integrating B-spline neural networks and sliding modes in the electromagnetic levitation control technique. On-line accurate estimation of uncertainty, unmeasured external disturbances and uncertain nonlinearities are conveniently evaded. The effective performance of the robust trajectory tracking levitation control approach is depicted for multiple simulation operating scenarios. The capability of active disturbance suppression is furthermore evidenced. The presented B-spline neural network trajectory tracking control design approach based on sliding modes and differential flatness can be extended to other controllable complex uncertain nonlinear dynamic systems where internal and external disturbances represent a relevant issue. Computer simulations and analytical results demonstrate the effective performance of the new adaptive neural control method.