Yunus Cengeloglu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yunus Cengeloglu has a total of 47 co-authors. Here are the top co-authors by number of shared publications:
Mustafa Ersoz
18 shared publicationsAli Tor
16 shared publicationsGulsin Arslan
11 shared publications- Esengul Kir
Department of Chemistry, Faculty of Engineering and Natural Sciences, Suleyman Demirel University, Isparta, Turkiye
8 shared publications - Ali Tor
Department of Environmental Engineering, Necmettin Erbakan University, Konya, Turkey
4 shared publications - Ilker Akin
Necmettin Erbakan Universitesi
4 shared publications
Latest Publications
- 25 April 2016
- Published by Walter de Gruyter GmbH in Zeitschrift für Physikalische Chemie
- Vol. 230 (11) , 1607-1616
Electrocapillary Curves for the Polarisable Liquid–Liquid Interface in Presence of the Peptide Melittin
The adsorption of the anti-microbial peptide melittin at the polarisable water/1,2-DCE (W–DCE) interface is expected to manifest itself by changes in the interfacial tension. These interfacial tension changes during the peptide adsorption at the interface were measured by a custom-built quasi-elastic light scattering (QELS) setup. Electrocapillary curves obtained for melittin at physiological pH evidences the strong affinity of this peptide for the W–DCE interface. In other words, it is evident that at negative potentials the peptide are readily adsorbed and that at more positive potentials desorption of adsorbed peptide from the interface proceeds leading to an increase of interfacial tension.
- 25 April 2016
- Published by Walter de Gruyter GmbH in Zeitschrift für Physikalische Chemie
- Vol. 230 (11) , 1607-1616
Electrocapillary Curves for the Polarisable Liquid–Liquid Interface in Presence of the Peptide Melittin
The adsorption of the anti-microbial peptide melittin at the polarisable water/1,2-DCE (W–DCE) interface is expected to manifest itself by changes in the interfacial tension. These interfacial tension changes during the peptide adsorption at the interface were measured by a custom-built quasi-elastic light scattering (QELS) setup. Electrocapillary curves obtained for melittin at physiological pH evidences the strong affinity of this peptide for the W–DCE interface. In other words, it is evident that at negative potentials the peptide are readily adsorbed and that at more positive potentials desorption of adsorbed peptide from the interface proceeds leading to an increase of interfacial tension.
- 6 May 2015
- Published by Springer Nature in Polymer Bulletin
- Vol. 72 (9) , 2127-2142
Facile synthesis of boronic acid-functionalized nanocarriers for glucose-triggered caffeic acid release
- 6 May 2015
- Published by Springer Nature in Polymer Bulletin
- Vol. 72 (9) , 2127-2142
Facile synthesis of boronic acid-functionalized nanocarriers for glucose-triggered caffeic acid release
- 1 April 2015
- Published by Elsevier in Journal of Luminescence
- Vol. 160, 9-15
Biocompatible multi-walled carbon nanotube–CdTe quantum dot–polymer hybrids for medical applications
- 1 April 2015
- Published by Elsevier in Journal of Luminescence
- Vol. 160, 9-15
Biocompatible multi-walled carbon nanotube–CdTe quantum dot–polymer hybrids for medical applications
- 1 September 2014
- Published by Elsevier in Journal of Luminescence
- Vol. 153, 177-181
A comparative study on fluorescence quenching of CdTe nanocrystals with a serial of polycyclic aromatic hydrocarbons
- 1 September 2014
- Published by Elsevier in Journal of Luminescence
- Vol. 153, 177-181
A comparative study on fluorescence quenching of CdTe nanocrystals with a serial of polycyclic aromatic hydrocarbons
- 10 March 2014
- Published by Wiley in Journal of Biomedical Materials Research Part A
- Vol. 103 (1) , 243-251
Biocompatible thermoresponsive PEGMA nanoparticles crosslinked with cleavable disulfide-based crosslinker for dual drug release
Smart materials have been attracting much attention because of their stimuli responsive nature. We have synthesized biocompatible thermoresponsive crosslinked poly(ethylene glycol) methyl ether methacrylate (PEGMA)-co-vinyl pyrrolidone nanoparticles (PEGMA NPs) using disulfide-based crosslinker by surfactant-free emulsion polymerization method. Particle characterization studies were carried out by dynamic light scattering, and scanning electron microscopy. Polymerization kinetics, effect of crosslinker and initiator concentrations on both average hydrodynamic diameter and polydispersity index were investigated. Hydrodynamic diameters of thermoresponsive PEGMA NPs were decreased from 210 nm to 90 nm upon heating over the lowest critical solution temperature (LCST). Disulfide crosslinked PEGMA NPs were demonstrated as a dual delivery system. Rhodamine B, a model of small-sized drug molecule, and poly(ethylene glycol) (PEG)-alizarin yellow, a model of large drug molecule, were loaded into PEGMA NPs where LCST of these NPs was tuned to 37°C, the body temperature. The rhodamine B was released from PEGMA NPs upon heating to 39°C. Then, PEG-alizarin content was released by subsequent degradation of nanoparticles using dithiothreitol (DTT), which reduces disulfide bonds to thiols. Furthermore, cytotoxicity studies of PEGMA NPs were carried out in 3T3 cells, which resulted in no toxic effect on the cells. © 2014 Wiley Periodicals, Inc. J Biomed Mater Res Part A: 103A: 243–251, 2015.
- 10 March 2014
- Published by Wiley in Journal of Biomedical Materials Research Part A
- Vol. 103 (1) , 243-251
Biocompatible thermoresponsive PEGMA nanoparticles crosslinked with cleavable disulfide-based crosslinker for dual drug release
Smart materials have been attracting much attention because of their stimuli responsive nature. We have synthesized biocompatible thermoresponsive crosslinked poly(ethylene glycol) methyl ether methacrylate (PEGMA)-co-vinyl pyrrolidone nanoparticles (PEGMA NPs) using disulfide-based crosslinker by surfactant-free emulsion polymerization method. Particle characterization studies were carried out by dynamic light scattering, and scanning electron microscopy. Polymerization kinetics, effect of crosslinker and initiator concentrations on both average hydrodynamic diameter and polydispersity index were investigated. Hydrodynamic diameters of thermoresponsive PEGMA NPs were decreased from 210 nm to 90 nm upon heating over the lowest critical solution temperature (LCST). Disulfide crosslinked PEGMA NPs were demonstrated as a dual delivery system. Rhodamine B, a model of small-sized drug molecule, and poly(ethylene glycol) (PEG)-alizarin yellow, a model of large drug molecule, were loaded into PEGMA NPs where LCST of these NPs was tuned to 37°C, the body temperature. The rhodamine B was released from PEGMA NPs upon heating to 39°C. Then, PEG-alizarin content was released by subsequent degradation of nanoparticles using dithiothreitol (DTT), which reduces disulfide bonds to thiols. Furthermore, cytotoxicity studies of PEGMA NPs were carried out in 3T3 cells, which resulted in no toxic effect on the cells. © 2014 Wiley Periodicals, Inc. J Biomed Mater Res Part A: 103A: 243–251, 2015.
- 1 October 2012
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 235-236, 62-68
Arsenic(V) removal from underground water by magnetic nanoparticles synthesized from waste red mud
- 1 October 2012
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 235-236, 62-68
Arsenic(V) removal from underground water by magnetic nanoparticles synthesized from waste red mud
- 1 February 2012
- Published by Elsevier in Electrochimica Acta
- Vol. 62, 290-295
Voltammetric and visual evidence of adsorption reactions at the liquid–liquid interfaces supported on a metallic electrode
- 1 February 2012
- Published by Elsevier in Electrochimica Acta
- Vol. 62, 290-295
Voltammetric and visual evidence of adsorption reactions at the liquid–liquid interfaces supported on a metallic electrode
- 1 October 2011
- Published by Elsevier in Desalination
- Vol. 281, 88-92
Removal of arsenate [As(V)] and arsenite [As(III)] from water by SWHR and BW-30 reverse osmosis
- 1 October 2011
- Published by Elsevier in Desalination
- Vol. 281, 88-92
Removal of arsenate [As(V)] and arsenite [As(III)] from water by SWHR and BW-30 reverse osmosis
- 30 July 2010
- Published by Elsevier in Separation and Purification Technology
- Vol. 74 (1) , 14-20
Removal of Cr(III) and Cr(VI) through the plasma modified and unmodified ion-exchange membranes
- 30 July 2010
- Published by Elsevier in Separation and Purification Technology
- Vol. 74 (1) , 14-20
Removal of Cr(III) and Cr(VI) through the plasma modified and unmodified ion-exchange membranes
- 29 July 2010
- Published by Wiley in CLEAN – Soil, Air, Water
- Vol. 38 (7) , 639-648
Synthesis of Calix[4]arene‐grafted Magnetite Nanoparticles and Evaluation of Their Arsenate as Well as Dichromate Removal Efficiency
In this study, 5,17‐bis‐[(4‐benzylpiperidine)methyl]‐25,26,27,28‐tetrahydroxy‐calix[4]arene (3) has been prepared by the treatment of calix[4]arene with a secondary amine (4‐benzylpiperidine) and formaldehyde by means of Mannich reaction. The prepared Mannich base (3) has been grafted onto [3‐(2,3‐epoxypropoxy)‐propyl]‐trimethoxysilane‐modified Fe3O4 magnetite nanoparticles (EPPTMS‐MN) in order to obtain 5,17‐bis‐[(4‐benzylpiperidine)methyl]‐25,26,27,28‐tetrahydroxy calix[4]arene‐grafted EPPTMS‐MN (BP‐calix[4]arene‐grafted Fe3O4). All new compounds were characterized by a combination of FTIR and 1H‐NMR analyses. The morphology of the magnetic nanoparticles was examined by transmission electron microscopy. Moreover, the studies regarding the removal of arsenate and dichromate ions from the aqueous solutions were also carried out by using 5,17‐bis‐[(4‐benzylpiperidine)methyl]‐25,26,27,28‐tetrahydroxy‐calix[4]arene in liquid–liquid extraction and BP‐calix[4]arene‐grafted Fe3O4 (4) in solid–liquid extraction experiments. The extraction results indicated that 3 is protonated at proton‐switchable binding sites in acidic conditions. Hence, facilitating binding of arsenate and dichromate is resulted from both electrostatic interactions and hydrogen bonding. To understand the selectivity of 3, the retention of dichromate anions in the presence of Cl−, NO, and SO anions at pH 1.5 was also examined.
- 29 July 2010
- Published by Wiley in CLEAN – Soil, Air, Water
- Vol. 38 (7) , 639-648
Synthesis of Calix[4]arene‐grafted Magnetite Nanoparticles and Evaluation of Their Arsenate as Well as Dichromate Removal Efficiency
In this study, 5,17‐bis‐[(4‐benzylpiperidine)methyl]‐25,26,27,28‐tetrahydroxy‐calix[4]arene (3) has been prepared by the treatment of calix[4]arene with a secondary amine (4‐benzylpiperidine) and formaldehyde by means of Mannich reaction. The prepared Mannich base (3) has been grafted onto [3‐(2,3‐epoxypropoxy)‐propyl]‐trimethoxysilane‐modified Fe3O4 magnetite nanoparticles (EPPTMS‐MN) in order to obtain 5,17‐bis‐[(4‐benzylpiperidine)methyl]‐25,26,27,28‐tetrahydroxy calix[4]arene‐grafted EPPTMS‐MN (BP‐calix[4]arene‐grafted Fe3O4). All new compounds were characterized by a combination of FTIR and 1H‐NMR analyses. The morphology of the magnetic nanoparticles was examined by transmission electron microscopy. Moreover, the studies regarding the removal of arsenate and dichromate ions from the aqueous solutions were also carried out by using 5,17‐bis‐[(4‐benzylpiperidine)methyl]‐25,26,27,28‐tetrahydroxy‐calix[4]arene in liquid–liquid extraction and BP‐calix[4]arene‐grafted Fe3O4 (4) in solid–liquid extraction experiments. The extraction results indicated that 3 is protonated at proton‐switchable binding sites in acidic conditions. Hence, facilitating binding of arsenate and dichromate is resulted from both electrostatic interactions and hydrogen bonding. To understand the selectivity of 3, the retention of dichromate anions in the presence of Cl−, NO, and SO anions at pH 1.5 was also examined.