Manoj Pudukudy
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Manoj Pudukudy has a total of 85 co-authors. Here are the top co-authors by number of shared publications:
- Zahira Yaakob
Department of Chemical and Process Engineering, Faculty of Engineering and Built Environment, Universiti Kebangsaan Malaysia, 43600 UKM Bangi, Selangor, Malaysia
33 shared publications - Qingming Jia
Faculty of Chemical Engineering, Kunming University of Science and Technology, Kunming 650500, China
11 shared publications - Mohd Sobri Takriff
Chemical and Water Desalination Engineering Program, Department of Mechanical & Nuclear Engineering, College of Engineering, University of Sharjah, Sharjah 26666, United Arab Emirates
7 shared publications - Binitha Njarakkattuvalappil Narayanan
Department of Chemistry, University of Calicut, Calicut University (PO), Malappuram, India
6 shared publications - Ramesh Rajendran
Department of Physics, Periyar University, Salem-636011, Tamil Nadu, India
5 shared publications Qingming Jia
4 shared publications
Latest Publications
- 4 October 2026
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 37 (28) , 2147
Influence of annealing temperature on the physicochemical and optical properties of the Aloe vera gel-assisted solid-state combustion derived ZnO nanostructures for the photocatalytic mineralization of tetracycline under UV light irradiation
- 4 October 2026
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 37 (28) , 2147
Influence of annealing temperature on the physicochemical and optical properties of the Aloe vera gel-assisted solid-state combustion derived ZnO nanostructures for the photocatalytic mineralization of tetracycline under UV light irradiation
- 7 August 2026
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 37 (22) , 1762
Influence of annealing temperature on the structural, textural, and optical properties of polygonal-shaped spinel Co3O4 nanoparticles for the photocatalytic mineralization of methyl orange under visible light irradiation
- 7 August 2026
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 37 (22) , 1762
Influence of annealing temperature on the structural, textural, and optical properties of polygonal-shaped spinel Co3O4 nanoparticles for the photocatalytic mineralization of methyl orange under visible light irradiation
- Open Access
- 23 June 2026
- Published by Springer Nature in Journal of Materials Science: Materials in Engineering
- Vol. 21 (1)
A novel seawater-mediated low-temperature hydrothermal synthesis of {001} faceted BiOCl nanoflakes with high photocatalytic activity under UV-light irradiation
A novel cost-effective facile green method is reported for the direct low-temperature hydrothermal synthesis of flake-like BiOCl nanocrystals with highly exposed {001} facets using seawater as a natural, sustainable and green precursor/precipitant and solvent for the first time. No additional structure-directing agents and special synthetic conditions were used in the aforementioned synthesis. The structural, textural and optical properties of the material was analyzed by various characterization methods. The in-situ prepared material exhibited high phase purity and crystallinity. The scanning and transmission electron microscopic analysis confirmed the nanoflake-like morphology with lamellar structure. The optical analysis revealed its light absorption in the UV region with a band gap energy of 3.25 eV whereas the existence of surface defects and oxygen vacancies was confirmed by photoluminescent study. The BiOCl was effectively applied for the photocatalytic degradation of methylene blue dye pollutant, followed by its mineralization. The BiOCl nanoflakes exhibited 99.3% degradation and 33% mineralization efficiency under UV light irradiation within 110 min. The enhanced photocatalytic activity could be attributed to the presence of nanocrystallite size, specific surface-area, mesoporosity, oxygen vacancies and flake-like morphology with highly exposed {001} facets that will enhance the separation and transfer of photogenerated charge carriers. The oxygen vacancies act like electron-trappers and it further reduces the dissolved oxygen to superoxide anion radicals. The sample was effectively recycled for four consecutive degradation runs indicating its high photostability. This work offers valuable insights into the utilization of seawater as a precipitant or no-cost chloride precursor and solvent for material synthesis for effective wastewater purification.
- 23 June 2026
- Published by Springer Nature in Journal of Materials Science: Materials in Engineering
- Vol. 21 (1)
Open AccessA novel seawater-mediated low-temperature hydrothermal synthesis of {001} faceted BiOCl nanoflakes with high photocatalytic activity under UV-light irradiation
A novel cost-effective facile green method is reported for the direct low-temperature hydrothermal synthesis of flake-like BiOCl nanocrystals with highly exposed {001} facets using seawater as a natural, sustainable and green precursor/precipitant and solvent for the first time. No additional structure-directing agents and special synthetic conditions were used in the aforementioned synthesis. The structural, textural and optical properties of the material was analyzed by various characterization methods. The in-situ prepared material exhibited high phase purity and crystallinity. The scanning and transmission electron microscopic analysis confirmed the nanoflake-like morphology with lamellar structure. The optical analysis revealed its light absorption in the UV region with a band gap energy of 3.25 eV whereas the existence of surface defects and oxygen vacancies was confirmed by photoluminescent study. The BiOCl was effectively applied for the photocatalytic degradation of methylene blue dye pollutant, followed by its mineralization. The BiOCl nanoflakes exhibited 99.3% degradation and 33% mineralization efficiency under UV light irradiation within 110 min. The enhanced photocatalytic activity could be attributed to the presence of nanocrystallite size, specific surface-area, mesoporosity, oxygen vacancies and flake-like morphology with highly exposed {001} facets that will enhance the separation and transfer of photogenerated charge carriers. The oxygen vacancies act like electron-trappers and it further reduces the dissolved oxygen to superoxide anion radicals. The sample was effectively recycled for four consecutive degradation runs indicating its high photostability. This work offers valuable insights into the utilization of seawater as a precipitant or no-cost chloride precursor and solvent for material synthesis for effective wastewater purification.
- Open Access
Promoting Effects of Copper and Iron on Ni/MSN Catalysts for Methane Decomposition
Copper and iron-based bimetallic nickel catalysts supported on Mesostructured Silica Nanoparticles (MSNs) with compositions of 50% Ni–5% Cu/MSN and 50% Ni–5% Fe/MSN were prepared using an impregnation method, and they were compared with a monometallic 50% Ni–MSN catalyst for their activity and stability in methane decomposition reaction. The influence of promoters, such as Cu and Fe, at different reaction temperatures (700 °C, 800 °C and 900 °C) was investigated. The results revealed that the Cu and Fe-promoted catalysts significantly increased the hydrogen yield in methane decomposition compared with the unpromoted catalyst. This could be attributed to the formation of Ni–Cu and Ni–Fe bimetallic alloys in the catalysts, respectively, and this favored the stability of the catalysts. With increasing reaction temperature, the hydrogen yield also increased. However, the hydrogen yield and the lifetime of the nickel catalyst were enhanced upon the addition of iron compared to copper at all the reaction temperatures. The analysis conducted over the spent catalysts validated the formation of multi-walled carbon nanotubes with a bamboo-like internal channel over the catalysts along with a high crystallinity and graphitization degree of the carbon produced.
Open AccessPromoting Effects of Copper and Iron on Ni/MSN Catalysts for Methane Decomposition
Copper and iron-based bimetallic nickel catalysts supported on Mesostructured Silica Nanoparticles (MSNs) with compositions of 50% Ni–5% Cu/MSN and 50% Ni–5% Fe/MSN were prepared using an impregnation method, and they were compared with a monometallic 50% Ni–MSN catalyst for their activity and stability in methane decomposition reaction. The influence of promoters, such as Cu and Fe, at different reaction temperatures (700 °C, 800 °C and 900 °C) was investigated. The results revealed that the Cu and Fe-promoted catalysts significantly increased the hydrogen yield in methane decomposition compared with the unpromoted catalyst. This could be attributed to the formation of Ni–Cu and Ni–Fe bimetallic alloys in the catalysts, respectively, and this favored the stability of the catalysts. With increasing reaction temperature, the hydrogen yield also increased. However, the hydrogen yield and the lifetime of the nickel catalyst were enhanced upon the addition of iron compared to copper at all the reaction temperatures. The analysis conducted over the spent catalysts validated the formation of multi-walled carbon nanotubes with a bamboo-like internal channel over the catalysts along with a high crystallinity and graphitization degree of the carbon produced.
- 1 May 2020
- Published by Elsevier in Carbohydrate Polymers
- Vol. 236, 116079
A facile method for in situ fabrication of silica/cellulose aerogels and their application in CO2 capture
- 1 May 2020
- Published by Elsevier in Carbohydrate Polymers
- Vol. 236, 116079
A facile method for in situ fabrication of silica/cellulose aerogels and their application in CO2 capture