Rupam Goswami
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Rupam Goswami has a total of 70 co-authors. Here are the top co-authors by number of shared publications:
Deepjyoti Deb
Department of ECE, SRM Institute of Science and Technology-Vadapalani Campus, Chennai, Tamil Nadu, India
9 shared publications- Brinda Bhowmick
National Institute of Technology
8 shared publications - Nayan M. Kakoty
Tezpur University
8 shared publications - Ramana Vinjamuri
Department of Computer Science and Electrical Engineering, University of Maryland Baltimore County, Baltimore, MD 21250, USA
8 shared publications - Rajesh Saha
NIT Silchar
7 shared publications Hirakjyoti Choudhury
Department of Electronics, North Lakhimpur University, Lakhimpur, Assam, India
5 shared publications
Latest Publications
- 1 October 2026
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 41 (10) , 105005
Source/drain junction engineering through investigation of interface trap sensitivity with lateral straggle in n–p–n SOI double gate TFETs
This article analyses the effects of lateral straggling and interface trap on the characteristics of SOI TFETs with an n – p – n configuration in double gate structures using TCAD simulation. The study considers the effects of lateral straggle ( σ = 3 nm − 7 nm ) in both source and drain regions, along with the impact of acceptor-like and donor-like interface traps having Gaussian distribution. Key analog and RF performance metrics, such as transconductance efficiency ( g M / I D ), total gate capacitance ( C gg ), gate-to-source capacitance ( C gs ), and gate-to-drain capacitance ( C gd ), cut-off frequency ( f T ), and intrinsic delay ( τ ) under analytical doping profiles are reported. The findings indicate that source-side straggle substantially impairs device performance by widening the tunneling barrier, resulting in diminished g M / I D and increased C gs , especially at greater σ values. On the other hand, drain-side straggle mostly raises C gd because of stronger coupling, especially in the ambipolar region. The acceptor-like traps lower the performance of the device due to their effect on lowering the carrier density and tunneling rate, while donor-like traps enhance the local electric field intensity, thus increasing the drain current. Based on sensitivity analysis, traps play a critical role within the subthreshold regime. Overall, the work offers insights into the effects of lateral straggle of dopants and interface traps through DC and RF analysis.
- 1 October 2026
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 41 (10) , 105005
Source/drain junction engineering through investigation of interface trap sensitivity with lateral straggle in n–p–n SOI double gate TFETs
This article analyses the effects of lateral straggling and interface trap on the characteristics of SOI TFETs with an n – p – n configuration in double gate structures using TCAD simulation. The study considers the effects of lateral straggle ( σ = 3 nm − 7 nm ) in both source and drain regions, along with the impact of acceptor-like and donor-like interface traps having Gaussian distribution. Key analog and RF performance metrics, such as transconductance efficiency ( g M / I D ), total gate capacitance ( C gg ), gate-to-source capacitance ( C gs ), and gate-to-drain capacitance ( C gd ), cut-off frequency ( f T ), and intrinsic delay ( τ ) under analytical doping profiles are reported. The findings indicate that source-side straggle substantially impairs device performance by widening the tunneling barrier, resulting in diminished g M / I D and increased C gs , especially at greater σ values. On the other hand, drain-side straggle mostly raises C gd because of stronger coupling, especially in the ambipolar region. The acceptor-like traps lower the performance of the device due to their effect on lowering the carrier density and tunneling rate, while donor-like traps enhance the local electric field intensity, thus increasing the drain current. Based on sensitivity analysis, traps play a critical role within the subthreshold regime. Overall, the work offers insights into the effects of lateral straggle of dopants and interface traps through DC and RF analysis.
- Open Access
- 14 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 14, 11149-11162
Interface Segmentation Approach (InSeAp) on TCAD for Statistical Analysis of Interface Trap Spatial Variations in TFETs
This work proposes a methodology to conduct statistical analyses of variation in spatial location and concentration of gate oxide/ semiconductor interface traps taking the example of a p-i-n silicon-on-insulator (SOI) tunnelling field-effect transistor (TFET). The methodology involves simulation of a total of 800 instances of devices leading to evaluation of variability in key electrical metrics, such as ON and OFF current, maximum band-to-band tunneling (BTBT) rate, maximum electron velocity, and threshold voltage. The approach uses an interface segmentation approach (InSeAp) on TCAD tool using which the trap placement at the oxide/ semiconductor is localized to ${2}{nm}$ segments. Such segments are then assessed based on their placement: 1) within the high BTBT region and 2) outside the high BTBT region. The methodology is validated using parametric and non-parametric statistical tests (two-sided paired t-test, Wilcoxon signed-rank test, two-sided binomial test) along with coefficient of variation (CoV).
- 14 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 14, 11149-11162
Open AccessInterface Segmentation Approach (InSeAp) on TCAD for Statistical Analysis of Interface Trap Spatial Variations in TFETs
This work proposes a methodology to conduct statistical analyses of variation in spatial location and concentration of gate oxide/ semiconductor interface traps taking the example of a p-i-n silicon-on-insulator (SOI) tunnelling field-effect transistor (TFET). The methodology involves simulation of a total of 800 instances of devices leading to evaluation of variability in key electrical metrics, such as ON and OFF current, maximum band-to-band tunneling (BTBT) rate, maximum electron velocity, and threshold voltage. The approach uses an interface segmentation approach (InSeAp) on TCAD tool using which the trap placement at the oxide/ semiconductor is localized to ${2}{nm}$ segments. Such segments are then assessed based on their placement: 1) within the high BTBT region and 2) outside the high BTBT region. The methodology is validated using parametric and non-parametric statistical tests (two-sided paired t-test, Wilcoxon signed-rank test, two-sided binomial test) along with coefficient of variation (CoV).
- Open Access
- 9 October 2025
- Published by Frontiers Media SA in Frontiers in Electronics
- Vol. 6, 1686130
Beyond ideal models: non-idealities in TCAD simulations of dielectric-modulated FETs for label-free biosensing
Dielectric modulation in field-effect transistors (FETs) for label-free biosensing have been extensively explored to date, mostly due to the availability of semiconductor device technology computer-aided design (TCAD) tools. Of these works, many reports have revolved around TCAD simulations and focused on ideal or slightly deviated-from-ideal conditions, rather than on the inclusion of non-idealities to create actual biosensing test scenarios. This perspective presents a status of label-free dielectric-modulated biosensing in FETs. It highlights the five most important but rarely used or missing non-idealities in semiconductor TCAD tools, viz., multispecies representation, biomolecular kinematics, cavity profile, hybridization, and transient response. To better align TCAD frameworks with experimental studies, this article recommends adopting method-specific TCAD-integrated modeling (MSTIM) approaches.
- 9 October 2025
- Published by Frontiers Media SA in Frontiers in Electronics
- Vol. 6, 1686130
Open AccessBeyond ideal models: non-idealities in TCAD simulations of dielectric-modulated FETs for label-free biosensing
Dielectric modulation in field-effect transistors (FETs) for label-free biosensing have been extensively explored to date, mostly due to the availability of semiconductor device technology computer-aided design (TCAD) tools. Of these works, many reports have revolved around TCAD simulations and focused on ideal or slightly deviated-from-ideal conditions, rather than on the inclusion of non-idealities to create actual biosensing test scenarios. This perspective presents a status of label-free dielectric-modulated biosensing in FETs. It highlights the five most important but rarely used or missing non-idealities in semiconductor TCAD tools, viz., multispecies representation, biomolecular kinematics, cavity profile, hybridization, and transient response. To better align TCAD frameworks with experimental studies, this article recommends adopting method-specific TCAD-integrated modeling (MSTIM) approaches.
- 1 August 2025
- Published by IOP Publishing in Physica Scripta
- Vol. 100 (8) , 085981
Scaling-induced noise behavior in n-p-n SOI double-gate tunnel FETs in presence of interface traps
This article examines the noise behavior in n-p-n Silicon-on-Insulator (SOI) Double-Gate Tunnel Field Effect Transistors (DG TFETs) influenced by interface traps. The research integrates interface trap models, low and high-frequency noise mechanisms, and examines spectral density fluctuations caused by factors such as doping concentration, gate work function, scaling the device and gate engineered versions of the proposed architecture. Two frequencies, 1 MHz and 1 GHz, and two interface trap types (acceptor-like and donor-like) have been considered for the analyses. It is observed that any scaling related to the gate structure, particularly the length in the lateral as well as the vertical direction affects the noise response. The results conclude that in some cases, the carrier density is responsible for the trend in noise response, whereas in others, the current density. This article also proposes an analog figure of merit involving noise parameters, and a metric to represent actual noise-derived transconductance.
- 1 August 2025
- Published by IOP Publishing in Physica Scripta
- Vol. 100 (8) , 085981
Scaling-induced noise behavior in n-p-n SOI double-gate tunnel FETs in presence of interface traps
This article examines the noise behavior in n-p-n Silicon-on-Insulator (SOI) Double-Gate Tunnel Field Effect Transistors (DG TFETs) influenced by interface traps. The research integrates interface trap models, low and high-frequency noise mechanisms, and examines spectral density fluctuations caused by factors such as doping concentration, gate work function, scaling the device and gate engineered versions of the proposed architecture. Two frequencies, 1 MHz and 1 GHz, and two interface trap types (acceptor-like and donor-like) have been considered for the analyses. It is observed that any scaling related to the gate structure, particularly the length in the lateral as well as the vertical direction affects the noise response. The results conclude that in some cases, the carrier density is responsible for the trend in noise response, whereas in others, the current density. This article also proposes an analog figure of merit involving noise parameters, and a metric to represent actual noise-derived transconductance.
- 21 May 2025
- Published by Springer Nature in Transactions on Electrical and Electronic Materials
- Vol. 26 (6) , 814-821
Work Function Engineering on Electrical Parameters for Step Tunneling Path TFET
- 21 May 2025
- Published by Springer Nature in Transactions on Electrical and Electronic Materials
- Vol. 26 (6) , 814-821
Work Function Engineering on Electrical Parameters for Step Tunneling Path TFET
- 31 March 2025
- Published by IOP Publishing in Physica Scripta
- Vol. 100 (4) , 045966
A SPICE model calibration framework for egg albumin memristors
Memristors which emulate synaptic behaviour are key components in neuromorphic computing; yet, incorporating biological materials into their design presents challenges. Despite progress, a full understanding of bio-memristor electrical characteristics remains unexplored, prompting further analysis through SPICE modelling. This article proposes a calibrated SPICE-level framework for fabricated egg albumin memristors, with its parameters tuned to match experimental data, enabling replication of the device’s current–voltage behaviour. This work provides experimental insights, guidelines for calibration, and examines how variation in the SPICE model parameters influence device characteristics.
- 31 March 2025
- Published by IOP Publishing in Physica Scripta
- Vol. 100 (4) , 045966
A SPICE model calibration framework for egg albumin memristors
Memristors which emulate synaptic behaviour are key components in neuromorphic computing; yet, incorporating biological materials into their design presents challenges. Despite progress, a full understanding of bio-memristor electrical characteristics remains unexplored, prompting further analysis through SPICE modelling. This article proposes a calibrated SPICE-level framework for fabricated egg albumin memristors, with its parameters tuned to match experimental data, enabling replication of the device’s current–voltage behaviour. This work provides experimental insights, guidelines for calibration, and examines how variation in the SPICE model parameters influence device characteristics.
- 21 February 2025
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 36 (6) , 1-15
Statistical variability of physically localized interface traps in SOI n-p-n DG TFETs
- 21 February 2025
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 36 (6) , 1-15
Statistical variability of physically localized interface traps in SOI n-p-n DG TFETs
- 13 December 2024
- Published by Springer Nature
- p. 57-83
Kinematics and Dynamics
- 13 December 2024
- Published by Springer Nature
- p. 19-33
Sensors, Actuators, and Circuits in Robotics