RSRobert Sokolovskij

Robert Sokolovskij

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Robert Sokolovskij has a total of 117 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A Novel AlGaN/GaN SBD Thermal Sensor With Ultralow Power, Excellent Linearity, and High Sensitivity

    by Yuhan Sun, Kangyao Wen, Fangzhou Du, Chenkai Deng, Wenmao Li, Jiaqi He, Qiaoyu Hu, Yang Jiang, Robert Sokolovskij, Qing Wang, et al.

    A novel AlGaN/GaN Schottky barrier diode (SBD) thermal sensor featuring a recessed anode and a thin Al0.25Ga0.75N barrier layer is fabricated, which is demonstrated to have ultralow power, excellent linearity and high sensitivity for thermal sensing. The AlGaN layer thickness is employed to trade off the tunneling current proportion against the two dimensional electron gas (2DEG) density for the thermionic emission (TE) dominated electron transportation with better linearity and high sensitivity of thermal sensing at ultralow power. A sensitivity of 1.39 mV/K with a linearity of 0.995 operating at 0.082 - 0.324 V for a constant current of 10-7 A is revealed. The proposed SBD sensor shows the great potential application for on-chip, low power, and high performance thermal sensing in monolithic AlGaN/GaN heterostructure based power ICs.


  • Open Access

    Investigation of High-Sensitivity pH Sensor Based on Au-Gated AlGaN/GaN Heterostructure

    by Minjie Ye, Jianwen Sun, Teng Zhan, Robert Sokolovskij, Yulong Zhang, Jiangtao Wei, Shaomin Chen, Zewen Liu

    A high-sensitivity pH sensor based on an AlGaN/GaN high-electron mobility transistor (HEMT) with a 10 nm thick Au-gated sensing membrane was investigated. The Au nanolayer as a sensing membrane was deposited by electron-beam evaporation and patterned onto the GaN cap layer, which provides more surface-active sites and a more robust adsorption capacity for hydrogen ions (H+) and hydroxide ions (OH−) and thus the sensitivity of the sensor can be significantly enhanced. A quasi-reference electrode was used to minimize the sensing system for the measurement of the microliter solution. The measurement and analysis results demonstrate that the fabricated sensor exhibits a high potential sensitivity of 58.59 mV/pH, which is very close to the Nernstian limit. The current sensitivity is as high as 372.37 μA/pH in the pH range from 4.0 to 9.18, under a 3.5 V drain-source voltage and a 0 V reference-source voltage. Comparison experiments show that the current sensitivity of the Au-gated sensor can reach 3.9 times that of the SiO2-gated sensor. Dynamic titration experiments reveal the pH sensor’s ability to promptly respond to immediate pH variations. These findings indicate that this pH sensor can meet most application requirements for advanced medical and chemical analysis.


  • Open Access

    Investigation of Nitrogen-Based Plasma Passivation on GaN RF HEMTs Using Various Precursors

    by Qiaoyu Hu, Wei-Chih Cheng, Xiguang Chen, Chenkai Deng, Lina Liao, Wenmao Li, Yang Jiang, Jiaqi He, Yi Zhang, Chuying Tang, et al.

    This study investigates the DC and RF performance of RF GaN High Electron Mobility Transistors (HEMTs) subjected to surface pretreatments by N2 and N2O plasma. The filling of nitrogen vacancies or the passivation effect introduced by the thin GaON layer result in enhanced DC characteristics and RF performance for devices treated with nitrogen-based plasma. Compared to the untreated device, the device treated with N2 plasma exhibited a significant improvement in performance i.e. the saturated current increased by approximately 16%, the characteristic frequency (fT) had an increase of 27.6 GHz, the maximum oscillating frequency (fmax) increased by 60.4 GHz. Furthermore, the breakdown voltage had a 10.7% increase, and the dynamic/static on-resistance ratio decreased from 1.34 to 1.18. These results highlight the potential of nitrogen-based plasma treatments in improving the performance of RF GaN HEMTs.

  • A comprehensive review of gallium nitride (GaN)-based gas sensors and their dynamic responses

    by Yang Jiang, Wenmao Li, Fangzhou Du, Robert Sokolovskij, Yi Zhang, Shuhui Shi, Weiguo Huang, Qing Wang, Hongyu Yu, Zhongrui Wang

    This paper provides a comprehensive review of recent progress in GaN-based gas sensors with a focus on their dynamic-related responses, mechanisms and applications, which are important for sensing performance, efficiency, and signal processing.


  • Application of a gateless AlGaN/GaN HEMT sensor for diesel soot particulate detection

    by Robert Sokolovskij, Hongze Zheng, Wenmao Li, Guangnan Zhou, Qing Wang, Guoqi Zhang, Hongyu Yu


  • Open Access

    Room temperature ppt-level NO2 gas sensor based on SnO x /SnS nanostructures with rich oxygen vacancies

    by Hongyu Tang, Chenshan Gao, Huiru Yang, Leandro Sacco, Robert Sokolovskij, Hongze Zheng, Huaiyu Ye, Sten Vollebregt, Hongyu Yu, Xuejun Fan, et al.

    In this paper, tin oxidation (SnO x )/tin-sulfide (SnS) heterostructures are synthesized by the post-oxidation of liquid-phase exfoliated SnS nanosheets in air. We comparatively analyzed the NO2 gas response of samples with different oxidation levels to study the gas sensing mechanisms. The results show that the samples oxidized at 325 °C are the most sensitive to NO2 gas molecules, followed by the samples oxidated at 350 °C, 400 °C and 450 °C. The repeatabilities of 350 °C samples are better than that of 325 °C, and there is almost no shift in the baseline. Thus this work systematically analyzed the gas sensing performance of SnO x /SnS-based sensor oxidized at 350 °C. It exhibits a high response of 171% towards 1 ppb NO2, a wide detecting range (from 1 ppb to 1 ppm), and an ultra-low theoretical detection limit of 5 ppt, and excellent repeatability at room temperature. The sensor also shows superior gas selectivity to NO2 in comparison to several other gas molecules, such as NO, H2, SO2, CO, NH3, and H2O. After x-ray diffraction, x-ray photoelectron spectroscopy, scanning electron microscopy, transmission electron microscope, and electron paramagnetic resonance characterizations combining first principle analysis, it is found that the outstanding NO2 sensing behavior may be attributed to three factors: the Schottky contact between electrodes and SnO x /SnS; active charge transfer in the surface and the interface layer of SnO x /SnS heterostructures; and numerous oxygen vacancies generated during the post-oxidation process, which provides more adsorption sites and superior bandgap modulation. Such a heterostructure-based room-temperature sensor can be fabricated in miniaturized size with low cost, making it possible for large-scale applications.


  • Enhanced Sensitivity Pt/AlGaN/GaN Heterostructure NO₂ Sensor Using a Two-Step Gate Recess Technique

    by Jianwen Sun, Teng Zhan, Robert Sokolovskij, Zewen Liu, Pasqualina M. Sarro, Guoqi Zhang

    Based on our proposed precision two-step gate recess technique, a suspended gate-recessed Pt/AlGaN/GaN heterostructure gas sensor integrated with a micro-heater is fabricated and characterized. The controllable two-step gate recess etching method, which includes O 2 plasma oxidation of nitride and wet etching, improves gas sensing performance. The sensitivity and current change of the AlGaN/GaN heterostructure to 1-200 ppm NO 2 /air are increased up to about 20 and 12 times compared to conventional gate device, respectively. The response time is also reduced to only about 25 % of value for conventional device. The sensor has a suspended circular membrane structure and an integrated micro-hotplate for adjusting the optimum working temperature. The sensitivity (response time) increases from 0.75 % (1250 s) to 3.5 % (75 s) toward 40 ppm NO 2 /air when temperature increase from 60°C to 300°C. The repeatability and cross-sensitivity of the sensor are also demonstrated. These results support the practicability of a high accuracy and fast response gas sensor based on the suspended gate recessed AlGaN/GaN heterostructure with an integrated micro-heater.


  • The Impact of Gate Recess on the H₂ Detection Properties of Pt-AlGaN/GaN HEMT Sensors

    by Robert Sokolovskij, Jian Zhang, Hongze Zheng, Wenmao Li, Yang Jiang, Gaiying Yang, Hongyu Yu, Pasqualina M. Sarro, Guoqi Zhang

    The present work reports on the hydrogen gas detection properties of Pt-AlGaN/GaN high electron mobility transistor (HEMT) sensors with recessed gate structure. Devices with gate recess depths from 5 to 15 nm were fabricated using a precision cyclic etching method, examined with AFM, STEM and EDS, and tested towards H2 response at high temperature. With increasing recess depth, the threshold voltage (VTH) shifted from -1.57 to 1.49 V. A shallow recess (5 nm) resulted in a 1.03 mA increase in signal variation (ΔIDS), while a deep recess (15 nm) resulted in the highest sensing response (S) of 145.8% towards 300 ppm H2 as compared to reference sensors without gate recess. Transient measurements demonstrated reversible H2 response for all tested devices. The response and recovery time towards 250 ppm gradually decreased from 7.3 to 2.5 min and from 29.2 to 8.85 min going from 0 nm to 15 nm recess depth. The power consumption of the sensors reduced with increasing recess depth from 146.6 to 2.95 mW.


  • Gate Leakage Suppression and Breakdown Voltage Enhancement in p-GaN HEMTs Using Metal/Graphene Gates

    by Guangnan Zhou, Zeyu Wan, Gaiying Yang, Yang Jiang, Robert Sokolovskij, Hongyu Yu, Guangrui Xia

    In this article, single-layer intrinsic and fluorinated graphene were investigated as gate insertion layers in normally-OFF p-gallium nitride (GaN) gate high electron mobility transistors (HEMTs), which wraps around the bottom of the gate forming Ti/graphene/p-GaN at the bottom and Ti/graphene/SiNx on the two sides. Compared to the Au/Ti/p-GaN HEMTs without graphene, the insertion of graphene can increase the ION/IOFF ratios by a factor of 50, increase the VTH by 0.30 V and reduce the OFF-state gate leakage by 50 times. Additionally, this novel gate structure has better thermal stability. After thermal annealing at 350 °C, gate breakdown voltage (BV) holds at 12.1 V. This is considered to be a result of the 0.24 eV increase in Schottky barrier height and the better quality of the Ti/graphene/p-GaN and Ti/graphene/SiNx interfaces. This approach is very effective in improving the ION/IOFF ratio and gate BV of normally-OFF GaN HEMTs.


  • Suspended AlGaN/GaN HEMT NO2 Gas Sensor Integrated With Micro-heater

    by Jianwen Sun, Robert Sokolovskij, Elina Iervolino, Zewen Liu, Pasqualina M. Sarro, Guoqi Zhang