Nasim Ramezani
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Nasim Ramezani has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
Mohini Sain
Center for Biocomposite and Biomaterials Processing, Faculty of Forestry, University of Toronto, ON, M5S 3B3, Canada
3 shared publications- Abdullah Mohammed Asiri
College of Medicine, Alfaisal University, Riyadh 11533, Saudi Arabia
1 shared publication - Mohini Sain
Department of Mechanical and Industrial Engineering University of Toronto Toronto Canada
1 shared publication Robert Jeng
Center for Biocomposite and Biomaterials Processing, Faculty of Forestry, University of Toronto, ON, M5S 3B3, Canada
1 shared publication- Shuna Cheng
University of Toronto
1 shared publication - Suhara Panthapulakkal
Center for Biocomposites and Biomaterials Processing (CBBP) Faculty of Forestry University of Toronto 33 Willcocks Street Toronto ON, M5S 3B3 Canada
1 shared publication
Latest Publications
- 1 September 2019
- Published by Elsevier in Renewable Energy
- Vol. 140, 292-303
Non-catalytic green solvent lignin isolation process from wheat straw and the structural analysis
- 1 September 2019
- Published by Elsevier in Renewable Energy
- Vol. 140, 292-303
Non-catalytic green solvent lignin isolation process from wheat straw and the structural analysis
- Open Access
- 23 July 2018
- Published by IOP Publishing in IOP Conference Series: Earth and Environmental Science
- Vol. 167 (1) , 012034
Production of value-added chemicals from wheat straw lignin by bio-refinery process
- 23 July 2018
- Published by IOP Publishing in IOP Conference Series: Earth and Environmental Science
- Vol. 167 (1) , 012034
Open AccessProduction of value-added chemicals from wheat straw lignin by bio-refinery process
- 6 February 2018
- Published by Springer Nature in Journal of Polymers and the Environment
- Vol. 26 (7) , 3109-3116
Thermal and Physiochemical Characterization of Lignin Extracted from Wheat Straw by Organosolv Process
- 6 February 2018
- Published by Springer Nature in Journal of Polymers and the Environment
- Vol. 26 (7) , 3109-3116
Thermal and Physiochemical Characterization of Lignin Extracted from Wheat Straw by Organosolv Process
- 4 August 2014
- Published by BioResources in BioResources
- Vol. 9 (4) , 7653-7665
Aloe Vera Rind Nanofibers: Effect of Isolation Process on the Tensile Properties of Nanofibre Films
The effect of different physico-chemical treatments used in the isolation process of aloe vera (AV) rind nanofibers on the tensile properties of the nanofiber films were studied to understand the root of the low strength values of these films. In the first stage of the investigation, ground AV rind was subjected to different chemical treatments before mechanical defibrillation. In the second stage, cuticle present in the AV rind was removed before subjecting them to chemical treatment. Nanofiber films were prepared using these defibrillated AV rind pulp fibers, and tensile properties were measured to examine the effect of chemical treatments and the raw material characteristics on the nanofibrillation process. The results showed that tensile values were not affected significantly with the chemical treatments; however, the thick cuticle coated on AV rind had a significant effect on the tensile strength and Young’s modulus of the nanofibre films. The maximum tensile strength and Young’s modulus (234.5 MPa and 12.6 GPa) of AV rind nanofibre films without cuticle were very high compared to the nanofibre films with the cuticle (tensile strength of about 110 MPa and Young’s modulus of 10 GPa). The study also found that mild chemical treatments were sufficient to isolate nanofibres from AV rind. The morphological analyses illustrated that the isolated AV rind nanofibers had a diameter size smaller than 20 nm and a high aspect ratio of approximately 1000 to 1500 or larger.
- 4 August 2014
- Published by BioResources in BioResources
- Vol. 9 (4) , 7653-7665
Aloe Vera Rind Nanofibers: Effect of Isolation Process on the Tensile Properties of Nanofibre Films
The effect of different physico-chemical treatments used in the isolation process of aloe vera (AV) rind nanofibers on the tensile properties of the nanofiber films were studied to understand the root of the low strength values of these films. In the first stage of the investigation, ground AV rind was subjected to different chemical treatments before mechanical defibrillation. In the second stage, cuticle present in the AV rind was removed before subjecting them to chemical treatment. Nanofiber films were prepared using these defibrillated AV rind pulp fibers, and tensile properties were measured to examine the effect of chemical treatments and the raw material characteristics on the nanofibrillation process. The results showed that tensile values were not affected significantly with the chemical treatments; however, the thick cuticle coated on AV rind had a significant effect on the tensile strength and Young’s modulus of the nanofibre films. The maximum tensile strength and Young’s modulus (234.5 MPa and 12.6 GPa) of AV rind nanofibre films without cuticle were very high compared to the nanofibre films with the cuticle (tensile strength of about 110 MPa and Young’s modulus of 10 GPa). The study also found that mild chemical treatments were sufficient to isolate nanofibres from AV rind. The morphological analyses illustrated that the isolated AV rind nanofibers had a diameter size smaller than 20 nm and a high aspect ratio of approximately 1000 to 1500 or larger.