Anna Penkova
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Anna Penkova has a total of 62 co-authors. Here are the top co-authors by number of shared publications:
- Jose Antonio Odriozola
Inorganic Chemistry Department and Materials Sciences Institute, University of Seville-CSIC, Sevilla, 41092, Spain
17 shared publications - Miguel Angel Centeno
Instituto de Ciencia de Materiales de Sevilla, Centro Mixto CSIC-Universidad de Sevilla, Avda. Américo Vespucio 49, 41092 Seville, Spain
14 shared publications - Francisca Romero Sarria
Department of Inorganic Chemistry and Institute of Materials Science, Joint Center University of Seville-CSIC, Av. Américo Vespucio, 41092 Seville, Spain
8 shared publications - Svetlana Ivanova
Departamento de Química Inorgánica e Instituto de Ciencia de Materiales de Sevilla, Centro Mixto CSIC-Universidad de Sevilla, 41092 Sevilla, Spain
6 shared publications K. Hadjiivanov
Bulgarian Academy of Sciences
5 shared publicationsKonstantin Hadjiivanov
Bulgarian Academy of Sciences
5 shared publications
Latest Publications
- Open Access
- 17 October 2026
- Published by Elsevier in Sustainable Chemistry for Climate Action
- Vol. 9
Catalysts design for biofuel production through a CLEVER-FUEL approach: Impact of support selection on hydrogen-free HDO
- 17 October 2026
- Published by Elsevier in Sustainable Chemistry for Climate Action
- Vol. 9
Open AccessCatalysts design for biofuel production through a CLEVER-FUEL approach: Impact of support selection on hydrogen-free HDO
- Open Access
- 9 October 2024
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 38 (21) , 21204-21218
Effect of Na/Ca Adsorbents on NiRu-DFM Performance for Integrated CO2 Capture and Hydrogenation
- 9 October 2024
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 38 (21) , 21204-21218
Open AccessEffect of Na/Ca Adsorbents on NiRu-DFM Performance for Integrated CO2 Capture and Hydrogenation
- Open Access
- 25 September 2024
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 14 (19) , 14947-14957
Reactive Surface Explored by NAP-XPS: Why Ionic Conductors Are Promoters for Water Gas Shift Reaction
- 25 September 2024
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 14 (19) , 14947-14957
Open AccessReactive Surface Explored by NAP-XPS: Why Ionic Conductors Are Promoters for Water Gas Shift Reaction
- Open Access
- 23 May 2023
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 11 (25) , 13209-13216
Unravelling the CO2 capture and conversion mechanism of a NiRu–Na2O switchable dual-function material in various CO2 utilisation reactions
The mechanism of a NiRuNa/CeAl dual function material in successive cycles of CO2 capture and conversion was investigated. Carbonyls and carbonates were formed during CO2 capture, and a spillover mechanism occurred to form the desired products.
- 23 May 2023
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 11 (25) , 13209-13216
Open AccessUnravelling the CO2 capture and conversion mechanism of a NiRu–Na2O switchable dual-function material in various CO2 utilisation reactions
The mechanism of a NiRuNa/CeAl dual function material in successive cycles of CO2 capture and conversion was investigated. Carbonyls and carbonates were formed during CO2 capture, and a spillover mechanism occurred to form the desired products.
- 29 June 2022
- Published by Elsevier in Applied Materials Today
- Vol. 29
CO2 methanation on Ni/YMn1-xAlxO3 perovskite catalysts
- 29 June 2022
- Published by Elsevier in Applied Materials Today
- Vol. 29
CO2 methanation on Ni/YMn1-xAlxO3 perovskite catalysts
- 12 November 2019
- Published by Wiley in ChemCatChem
- Vol. 12 (4) , 1177-1183
Effect of Gold Particles Size over Au/C Catalyst Selectivity in HMF Oxidation Reaction
A series of gold nanoparticles in the 4–40 nm range were prepared, immobilized on activated carbon and further tested, at low base concentration, in the catalytic oxidation of 5‐hydroxymethyl furfural (HMF) to 2,5‐furandicarboxylic acid (FDCA). Gold particles size variation has no influence on HMF conversion but significantly affects product selectivity and carbon balance. This behavior is ascribed to the thermodynamically favorable oxygen reduction reaction on Au(100) faces. As the gold particle size decreases the Au(100)/Au(111) exposure ratio, estimated by using the van Hardeveld‐Hartog model, increases as well as the FDCA selectivity. The smaller the gold particle size the smaller the 5‐hydroxymethyl‐2‐furancarboxylic acid (HMFCA) to FDCA ratio pointing to the gold size dependent behavior of the oxidation of the alcohol function of the HMF molecule.
- 12 November 2019
- Published by Wiley in ChemCatChem
- Vol. 12 (4) , 1177-1183
Effect of Gold Particles Size over Au/C Catalyst Selectivity in HMF Oxidation Reaction
A series of gold nanoparticles in the 4–40 nm range were prepared, immobilized on activated carbon and further tested, at low base concentration, in the catalytic oxidation of 5‐hydroxymethyl furfural (HMF) to 2,5‐furandicarboxylic acid (FDCA). Gold particles size variation has no influence on HMF conversion but significantly affects product selectivity and carbon balance. This behavior is ascribed to the thermodynamically favorable oxygen reduction reaction on Au(100) faces. As the gold particle size decreases the Au(100)/Au(111) exposure ratio, estimated by using the van Hardeveld‐Hartog model, increases as well as the FDCA selectivity. The smaller the gold particle size the smaller the 5‐hydroxymethyl‐2‐furancarboxylic acid (HMFCA) to FDCA ratio pointing to the gold size dependent behavior of the oxidation of the alcohol function of the HMF molecule.
- Open Access
- 2 April 2019
- Published by MDPI AG in Nanomaterials
- Vol. 9 (4) , 517
Powder and Nanotubes Titania Modified by Dye Sensitization as Photocatalysts for the Organic Pollutants Elimination
In this study, titanium dioxide powder obtained by the sol-gel method and TiO2 nanotubes, were prepared. In order to increase the TiO2 photoactivity, the powders and nanotubes obtained were modified by dye sensitization treatment during the oxide synthesis. The sensitizers applied were Quinizarin (Q) and Zinc protoporphyrin (P). The materials synthesized were extensively characterized and it was found that the dye sensitization treatment leads to modify the optical and surface properties of Titania. It was also found that the effectiveness of the dye-sensitized catalysts in the phenol and methyl orange (MO) photodegradation strongly depends on the dye sensitizer employed. Thus, the highest degradation rate for MO was obtained over the conventional Q-TiO2 photocatalyst. In the case of the nanotubes series, the most effective photocatalyst in the MO degradation was based on TiO2-nanotubes sensitized with the dye protoporfirin (ZnP). Selected catalysts were also tested in the phenol and MO photodegradation under visible light and it was observed that these samples are also active under this radiation.
- 2 April 2019
- Published by MDPI AG in Nanomaterials
- Vol. 9 (4) , 517
Open AccessPowder and Nanotubes Titania Modified by Dye Sensitization as Photocatalysts for the Organic Pollutants Elimination
In this study, titanium dioxide powder obtained by the sol-gel method and TiO2 nanotubes, were prepared. In order to increase the TiO2 photoactivity, the powders and nanotubes obtained were modified by dye sensitization treatment during the oxide synthesis. The sensitizers applied were Quinizarin (Q) and Zinc protoporphyrin (P). The materials synthesized were extensively characterized and it was found that the dye sensitization treatment leads to modify the optical and surface properties of Titania. It was also found that the effectiveness of the dye-sensitized catalysts in the phenol and methyl orange (MO) photodegradation strongly depends on the dye sensitizer employed. Thus, the highest degradation rate for MO was obtained over the conventional Q-TiO2 photocatalyst. In the case of the nanotubes series, the most effective photocatalyst in the MO degradation was based on TiO2-nanotubes sensitized with the dye protoporfirin (ZnP). Selected catalysts were also tested in the phenol and MO photodegradation under visible light and it was observed that these samples are also active under this radiation.
- 22 October 2018
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 8 (12) , 11154-11164
Understanding the Role of the Acid Sites in 5-Hydroxymethylfurfural Oxidation to 2,5-Furandicarboxylic Acid Reaction over Gold Catalysts: Surface Investigation on CexZr1–xO2 Compounds
- 22 October 2018
- Published by American Chemical Society (ACS) in ACS Catalysis
- Vol. 8 (12) , 11154-11164
Understanding the Role of the Acid Sites in 5-Hydroxymethylfurfural Oxidation to 2,5-Furandicarboxylic Acid Reaction over Gold Catalysts: Surface Investigation on CexZr1–xO2 Compounds
- Open Access
- 1 May 2018
- Published by Elsevier in Applied Catalysis A: General
- Vol. 558, 91-98
Multicomponent Au/Cu-ZnO-Al2O3 catalysts: Robust materials for clean hydrogen production
- 1 May 2018
- Published by Elsevier in Applied Catalysis A: General
- Vol. 558, 91-98
Open AccessMulticomponent Au/Cu-ZnO-Al2O3 catalysts: Robust materials for clean hydrogen production
- Open Access
- 1 March 2018
- Published by Elsevier in Catalysis Today
- Vol. 301, 72-77
Gold catalyst recycling study in base-free glucose oxidation reaction
- 1 March 2018
- Published by Elsevier in Catalysis Today
- Vol. 301, 72-77
Open AccessGold catalyst recycling study in base-free glucose oxidation reaction