Michitaka Yoshino
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Michitaka Yoshino has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Akira Yasuda
Hosei University
3 shared publications - Tohru Nakamura
Research Center for Micro-Nano Technology, Hosei University, Tokyo 184-0003, Japan
3 shared publications - Tomoaki Nishimura
Hosei University
2 shared publications - Toru Toyabe
Faculty of Engineering, Toyo University, Saitama 350-8585, Japan
2 shared publications - Fumimasa Horikiri
Hosei University, Koganei, Tokyo 184-8584, Japan
1 shared publication - Hiroshi Amano
Institute of Materials and Systems for Sustainability, Nagoya University 1 , Nagoya 464-8601
1 shared publication
Latest Publications
- Open Access
- 18 January 2024
- Published by MDPI AG in Micromachines
- Vol. 15 (1) , 147
Breakdown Characteristics of GaN DMISFETs Fabricated via Mg, Si and N Triple Ion Implantation
Mg-ion-implanted layers in a GaN substrate after annealing were investigated. Implanted Mg atoms precipitated along the edges of crystal defects were observed using 3D-APT. The breakdown characteristics of a GaN double-diffused vertical MISFET (DMISFET) fabricated via triple ion implantation are presented. A DMISFET with Si-ion-implanted source regions was formed in Mg-ion-implanted p-base regions, which were isolated from adjacent devices by N-ion-implanted edge termination regions. A threshold voltage of −0.5 V was obtained at a drain voltage of 0.5 V for the fabricated vertical MISFET with an estimated Mg surface concentration of 5 × 1018 cm−3. The maximum drain current and maximum transconductance in a saturation region of Vds = 100 V were 2.8 mA/mm and 0.5 mS/mm at a gate voltage of 15 V, respectively. The breakdown voltage in the off-state was 417 V. The breakdown points were determined by the boundary regions between the N- and Mg-implanted regions. By improving heat annealing methods, ion-implanted GaN DMISFETs can be a promising candidate for future high-voltage and high-power applications.
- 18 January 2024
- Published by MDPI AG in Micromachines
- Vol. 15 (1) , 147
Open AccessBreakdown Characteristics of GaN DMISFETs Fabricated via Mg, Si and N Triple Ion Implantation
Mg-ion-implanted layers in a GaN substrate after annealing were investigated. Implanted Mg atoms precipitated along the edges of crystal defects were observed using 3D-APT. The breakdown characteristics of a GaN double-diffused vertical MISFET (DMISFET) fabricated via triple ion implantation are presented. A DMISFET with Si-ion-implanted source regions was formed in Mg-ion-implanted p-base regions, which were isolated from adjacent devices by N-ion-implanted edge termination regions. A threshold voltage of −0.5 V was obtained at a drain voltage of 0.5 V for the fabricated vertical MISFET with an estimated Mg surface concentration of 5 × 1018 cm−3. The maximum drain current and maximum transconductance in a saturation region of Vds = 100 V were 2.8 mA/mm and 0.5 mS/mm at a gate voltage of 15 V, respectively. The breakdown voltage in the off-state was 417 V. The breakdown points were determined by the boundary regions between the N- and Mg-implanted regions. By improving heat annealing methods, ion-implanted GaN DMISFETs can be a promising candidate for future high-voltage and high-power applications.
- Open Access
Fully Ion Implanted Normally-Off GaN DMOSFETs with ALD-Al2O3 Gate Dielectrics
A normally-off GaN double-implanted vertical MOSFET (DMOSFET) with an atomic layer deposition (ALD)-Al2O3 gate dielectric film on a free-standing GaN substrate fabricated by triple ion implantation is presented. The DMOSFET was formed with Si ion implanted source regions in a Mg ion implanted p-type base with N ion implanted termination regions. A maximum drain current of 115 mA/mm, maximum transconductance of 19 mS/mm at a drain voltage of 15 V, and a threshold voltage of 3.6 V were obtained for the fabricated DMOSFET with a gate length of 0.4 μm with an estimated p-type base Mg surface concentration of 5 × 1018 cm−3. The difference between calculated and measured Vths could be due to the activation ratio of ion-implanted Mg as well as Fermi level pinning and the interface state density. On-resistance of 9.3 mΩ·cm2 estimated from the linear region was also attained. Blocking voltage at off-state was 213 V. The fully ion implanted GaN DMOSFET is a promising candidate for future high-voltage and high-power applications.
Open AccessFully Ion Implanted Normally-Off GaN DMOSFETs with ALD-Al2O3 Gate Dielectrics
A normally-off GaN double-implanted vertical MOSFET (DMOSFET) with an atomic layer deposition (ALD)-Al2O3 gate dielectric film on a free-standing GaN substrate fabricated by triple ion implantation is presented. The DMOSFET was formed with Si ion implanted source regions in a Mg ion implanted p-type base with N ion implanted termination regions. A maximum drain current of 115 mA/mm, maximum transconductance of 19 mS/mm at a drain voltage of 15 V, and a threshold voltage of 3.6 V were obtained for the fabricated DMOSFET with a gate length of 0.4 μm with an estimated p-type base Mg surface concentration of 5 × 1018 cm−3. The difference between calculated and measured Vths could be due to the activation ratio of ion-implanted Mg as well as Fermi level pinning and the interface state density. On-resistance of 9.3 mΩ·cm2 estimated from the linear region was also attained. Blocking voltage at off-state was 213 V. The fully ion implanted GaN DMOSFET is a promising candidate for future high-voltage and high-power applications.
- Open Access
- 31 March 2016
- Published by MDPI AG in Electronics
- Vol. 5 (2) , 15
High-k Dielectric Passivation for GaN Diode with a Field Plate Termination
Vertical structured Gallium nitride (GaN) p-n junction diodes with improved breakdown properties have been demonstrated using high-k dielectric passivation underneath the field plate. Simulation results at a reverse voltage of 1 kV showed that the maximum electric field near the mesa-etched p-n junction edges covered with film of dielectric constant k = 10 was reduced to 2.0 MV/cm from 3.0 MV/cm (SiO2 (k = 3.9)). The diodes were fabricated using the high-k mixed oxide of SiO2 and CeO2 with k = 12.3. I–V characteristics of the diode with a field plate showed a breakdown voltage above 2 kV with an increased avalanche resistance. This means that the electric field reduces at the periphery of the mesa-etched p-n junction and is uniformly formed across the whole p-n junction. It is clear that high-k dielectric film passivation and filed plate termination are essential techniques for GaN power devices.
- 31 March 2016
- Published by MDPI AG in Electronics
- Vol. 5 (2) , 15
Open AccessHigh-k Dielectric Passivation for GaN Diode with a Field Plate Termination
Vertical structured Gallium nitride (GaN) p-n junction diodes with improved breakdown properties have been demonstrated using high-k dielectric passivation underneath the field plate. Simulation results at a reverse voltage of 1 kV showed that the maximum electric field near the mesa-etched p-n junction edges covered with film of dielectric constant k = 10 was reduced to 2.0 MV/cm from 3.0 MV/cm (SiO2 (k = 3.9)). The diodes were fabricated using the high-k mixed oxide of SiO2 and CeO2 with k = 12.3. I–V characteristics of the diode with a field plate showed a breakdown voltage above 2 kV with an increased avalanche resistance. This means that the electric field reduces at the periphery of the mesa-etched p-n junction and is uniformly formed across the whole p-n junction. It is clear that high-k dielectric film passivation and filed plate termination are essential techniques for GaN power devices.
- 11 July 2015
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 85 (2) , 243-251
Delta–sigma DAC with jitter-shaper-reducing jitter noise
- 11 July 2015
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 85 (2) , 243-251
Delta–sigma DAC with jitter-shaper-reducing jitter noise
- Open Access
- 21 February 2013
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 75 (2) , 279-286
Continuous-time delta-sigma modulator using vector filter in feedback path to reduce effect of clock jitter and excess loop delay
- 21 February 2013
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 75 (2) , 279-286
Open AccessContinuous-time delta-sigma modulator using vector filter in feedback path to reduce effect of clock jitter and excess loop delay