Laurent Debailleux
Laurent Debailleux has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
Daphné Grosselin Calvignac
Polytechnic Faculty of Mons
1 shared publication- Geoffrey Hismans
University of Mons
1 shared publication - José Luis Baró Zarzo
Universitat Politècnica de València
1 shared publication - Natacha Duroisin
Université de Mons
1 shared publication
Latest Publications
- Open Access
- 9 November 2022
- Published by Universitat Politecnica de Valencia
Integration of rural architectural heritage: The case of the alquerías in northern Valencia
Integration of rural architectural heritage: The case of the alquerías in northern Valencia
- 9 November 2022
- Published by Universitat Politecnica de Valencia
Open AccessIntegration of rural architectural heritage: The case of the alquerías in northern Valencia
Integration of rural architectural heritage: The case of the alquerías in northern Valencia
- Open Access
- 31 December 2020
- Published by Silesian University of Technology in Geochronometria
- Vol. 47 (1) , 54-62
Schmidt hammer exposure dating for brick masonry
This research investigates the validity of the Schmidt hammer exposure dating (SHED) technique as a complementary means to date monuments according to the evaluation of the brick decay from masonry exposed to climatic conditions. The degree of surface weathering, I5 (%) is calculated as an indicator of the ageing effect and compared to the absolute age of the churches constructed between 1600 and 1795. This paper discusses the results obtained with such a method and the use of the technique within the framework of historical research. Tests were done on exterior church walls built between the 17th and 19th centuries. All the churches were located within the limited geographical area of Hainaut, in the south of Belgium. Results indicate that SHED provides encouraging results for buildings constructed between 1790 and 1895, with a linear correlation (R2>0.8) between surface weathering of brick façades and their ages. However, the weathering indices show high variability of values for the period 1750−1790, which may confirm that the variable qualities of bricks were in use during this period of time because of the different production techniques. As such, the results highlight the probable influence of the entire manufacturing and construction process and technical improvements in traditional brick-making.
- 31 December 2020
- Published by Silesian University of Technology in Geochronometria
- Vol. 47 (1) , 54-62
Open AccessSchmidt hammer exposure dating for brick masonry
This research investigates the validity of the Schmidt hammer exposure dating (SHED) technique as a complementary means to date monuments according to the evaluation of the brick decay from masonry exposed to climatic conditions. The degree of surface weathering, I5 (%) is calculated as an indicator of the ageing effect and compared to the absolute age of the churches constructed between 1600 and 1795. This paper discusses the results obtained with such a method and the use of the technique within the framework of historical research. Tests were done on exterior church walls built between the 17th and 19th centuries. All the churches were located within the limited geographical area of Hainaut, in the south of Belgium. Results indicate that SHED provides encouraging results for buildings constructed between 1790 and 1895, with a linear correlation (R2>0.8) between surface weathering of brick façades and their ages. However, the weathering indices show high variability of values for the period 1750−1790, which may confirm that the variable qualities of bricks were in use during this period of time because of the different production techniques. As such, the results highlight the probable influence of the entire manufacturing and construction process and technical improvements in traditional brick-making.
- 13 February 2018
- Published by Taylor & Francis in International Journal of Architectural Heritage
- Vol. 13 (2) , 288-297
Schmidt hammer rebound hardness tests for the characterization of ancient fired clay bricks
This article presents results of non-destructive Schmidt hammer tests performed on ancient fired clay bricks sampled from historical masonry. These tests were carried out in order to evaluate, and compare, the different degrees of degradation, depending on the bricks’ specific exposures and locations within a wall. The results indicate that this technique is sensitive enough to distinguish sample locations and measure weathering differences, even for different surfaces of a particular sample. For each case study, referenced surfaces were tested for bricks from a facade or interior wall. Each surface was tested with a Schmidt hammer type LB at ten different points of measurement, and these measurements were repeated ten times. For each impact at a particular point, a mean rebound value was calculated to provide an index of the degree of brick-surface microweathering.
- 13 February 2018
- Published by Taylor & Francis in International Journal of Architectural Heritage
- Vol. 13 (2) , 288-297
Schmidt hammer rebound hardness tests for the characterization of ancient fired clay bricks
This article presents results of non-destructive Schmidt hammer tests performed on ancient fired clay bricks sampled from historical masonry. These tests were carried out in order to evaluate, and compare, the different degrees of degradation, depending on the bricks’ specific exposures and locations within a wall. The results indicate that this technique is sensitive enough to distinguish sample locations and measure weathering differences, even for different surfaces of a particular sample. For each case study, referenced surfaces were tested for bricks from a facade or interior wall. Each surface was tested with a Schmidt hammer type LB at ten different points of measurement, and these measurements were repeated ten times. For each impact at a particular point, a mean rebound value was calculated to provide an index of the degree of brick-surface microweathering.
- 7 March 2014
- Published by Taylor & Francis in International Journal of Architectural Heritage
- Vol. 9 (5) , 529-541
Indexing System for Recognizing Traditional Timber-Framed Structures
Wood has been used from the earliest times worldwide as a structural material, and, in rural areas in particular, many timber buildings are still standing. However, this rich heritage is rarely fully protected and significant alterations to buildings made by successive owners often diminish the building’s authenticity. In addition, if, for example, cottage gables are examined, it is surprising to note the variety of member alignments that frequently differ from one region to another. Hence, in a survey, it is often difficult to identify a specific typology or to arrive at any conclusions regarding the original structure. An innovative indexing system for traditional wooden framed structures is hereby proposed that facilitates the identification of similarities and that will be of use to architects, archaeologists and historians in their building classifications. This semi-automatic approach is based on the calculation of statistical descriptors between pairs of pictures. The fractal dimension, the Hausdorff distance and the geometrical ratio are evaluated and then combined as a single original parameter, facilitating comparison of various structures, notwithstanding any modifications which may have been made.
- 7 March 2014
- Published by Taylor & Francis in International Journal of Architectural Heritage
- Vol. 9 (5) , 529-541
Indexing System for Recognizing Traditional Timber-Framed Structures
Wood has been used from the earliest times worldwide as a structural material, and, in rural areas in particular, many timber buildings are still standing. However, this rich heritage is rarely fully protected and significant alterations to buildings made by successive owners often diminish the building’s authenticity. In addition, if, for example, cottage gables are examined, it is surprising to note the variety of member alignments that frequently differ from one region to another. Hence, in a survey, it is often difficult to identify a specific typology or to arrive at any conclusions regarding the original structure. An innovative indexing system for traditional wooden framed structures is hereby proposed that facilitates the identification of similarities and that will be of use to architects, archaeologists and historians in their building classifications. This semi-automatic approach is based on the calculation of statistical descriptors between pairs of pictures. The fractal dimension, the Hausdorff distance and the geometrical ratio are evaluated and then combined as a single original parameter, facilitating comparison of various structures, notwithstanding any modifications which may have been made.