Emily Judd
Research Subjects
Emily Judd has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
Andrew C. Owens
NASA Langley Research Center
2 shared publicationsChristopher A. Jones
NASA Langley Research Center
2 shared publicationsDavid Reeves
NASA Langley Research Center
2 shared publicationsJordan J. Klovstad
NASA Langley Research Center
2 shared publicationsKevin D. Earle
NASA Langley Research Center
2 shared publicationsMatthew Carrier
NASA Langley Research Center
2 shared publications
Latest Publications
- 15 September 2018
- Published by American Institute of Aeronautics and Astronautics (AIAA)
Mega-Drivers to Inform NASA Space Technology Strategic Planning
- 15 September 2018
- Published by American Institute of Aeronautics and Astronautics (AIAA)
Mega-Drivers to Inform NASA Space Technology Strategic Planning
- 11 January 2017
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 139 (6) , 061001
Automated Composite Fabric Layup for Wind Turbine Blades
This work presents an automated fabric layup solution based on a new method to deform fiberglass fabric, referred to as shifting, for the layup of noncrimp fabric (NCF) plies. The shifting method is intended for fabric with tows only in 0 deg (warp) and 90 deg (weft) directions, where the fabric is sequentially constrained and then rotated through a deformation angle to approximate curvature. Shifting is conducted in a two-dimensional (2D) plane, making the process easy to control and automate, but can be applied for fabric placement in three-dimensional (3D) models, either directly or after a ply kitting process and then manually placed. Preliminary tests have been conducted to evaluate the physical plausibility of the shifting method. Layup tests show that shifting can deposit fabric accurately and repeatedly while avoiding out-of-plane deformation.
- 11 January 2017
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 139 (6) , 061001
Automated Composite Fabric Layup for Wind Turbine Blades
This work presents an automated fabric layup solution based on a new method to deform fiberglass fabric, referred to as shifting, for the layup of noncrimp fabric (NCF) plies. The shifting method is intended for fabric with tows only in 0 deg (warp) and 90 deg (weft) directions, where the fabric is sequentially constrained and then rotated through a deformation angle to approximate curvature. Shifting is conducted in a two-dimensional (2D) plane, making the process easy to control and automate, but can be applied for fabric placement in three-dimensional (3D) models, either directly or after a ply kitting process and then manually placed. Preliminary tests have been conducted to evaluate the physical plausibility of the shifting method. Layup tests show that shifting can deposit fabric accurately and repeatedly while avoiding out-of-plane deformation.