Tianyu Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Tianyu Li has a total of 59 co-authors. Here are the top co-authors by number of shared publications:
- Chunchang Wang
Anhui University
8 shared publications Jiajia Yin
5 shared publicationsJiahuan He
3 shared publicationsJun Wu
School of Materials Science and Engineering, Anhui Polytechnic University, Wuhu, People’s Republic of China
3 shared publicationsPengfei Chen
Laboratory of Dielectric Functional Materials, School of Materials Physics and Engineering, Anhui University, Hefei 230601, China
3 shared publications- Renjun Si
Laboratory of Dielectric Functional Materials, School of Physics & Materials Science, Anhui University, Hefei 230601, China
3 shared publications
Latest Publications
- Open Access
Simultaneous X8R Stability, High Permittivity, and Pulse Discharge Performance Achieved Through Synergistic Peak-Shifting and Relaxor Modification in BaTiO3-Based Ceramics
Simultaneously realizing high room temperature permittivity and X8R temperature stability (−55 °C to 150 °C, ΔC/C25 °C ≤ ±15%) remains a significant obstacle for lead-free BaTiO3-based dielectrics. Herein, a synergistic strategy combining Curie-point shifting and weak relaxor engineering is demonstrated. A single composition, 0.95BaTi0.8Hf0.2O3-0.05Bi(Zn0.5Ti0.5)O3 is prepared via solid-state reaction. The ceramic possesses a pure perovskite structure and a dense and chemically homogeneous microstructure. At 1 kHz and room temperature, it delivers a high dielectric constant exceeding 1000 and a low loss below 0.02, while the capacitance variation remains within ±15% from −100 °C to 313 °C, fully satisfying the X8R specification. Moreover, an ultrafast discharge time of 39 ns, a power density of 315 MW/cm3, and a discharge energy density of 3.3 J/cm3 are achieved at 300 kV/cm. The synergy between Hf-driven peak shifting and minimal relaxor incorporation yields a composition that balances high polarization, thermal stability, and rapid energy release, offering a promising route for high-performance temperature-stable and pulsed-power capacitors.
Open AccessSimultaneous X8R Stability, High Permittivity, and Pulse Discharge Performance Achieved Through Synergistic Peak-Shifting and Relaxor Modification in BaTiO3-Based Ceramics
Simultaneously realizing high room temperature permittivity and X8R temperature stability (−55 °C to 150 °C, ΔC/C25 °C ≤ ±15%) remains a significant obstacle for lead-free BaTiO3-based dielectrics. Herein, a synergistic strategy combining Curie-point shifting and weak relaxor engineering is demonstrated. A single composition, 0.95BaTi0.8Hf0.2O3-0.05Bi(Zn0.5Ti0.5)O3 is prepared via solid-state reaction. The ceramic possesses a pure perovskite structure and a dense and chemically homogeneous microstructure. At 1 kHz and room temperature, it delivers a high dielectric constant exceeding 1000 and a low loss below 0.02, while the capacitance variation remains within ±15% from −100 °C to 313 °C, fully satisfying the X8R specification. Moreover, an ultrafast discharge time of 39 ns, a power density of 315 MW/cm3, and a discharge energy density of 3.3 J/cm3 are achieved at 300 kV/cm. The synergy between Hf-driven peak shifting and minimal relaxor incorporation yields a composition that balances high polarization, thermal stability, and rapid energy release, offering a promising route for high-performance temperature-stable and pulsed-power capacitors.
- 15 April 2026
- Published by Elsevier in Ceramics International
- Vol. 52 (14) , 26663-26670
Enhanced energy-storage properties in Bi0.5Na0.5TiO3-SrTiO3 lead-free ceramics by high-entropy engineering
- 15 April 2026
- Published by Elsevier in Ceramics International
- Vol. 52 (14) , 26663-26670
Enhanced energy-storage properties in Bi0.5Na0.5TiO3-SrTiO3 lead-free ceramics by high-entropy engineering
- 1 October 2025
- Published by Elsevier in Ceramics International
- Vol. 51 (28) , 57800-57806
Superior energy-storage performance in lead-free BaTiO3-based ceramics achieved via compositional engineering for pulsed power capacitors
- 1 October 2025
- Published by Elsevier in Ceramics International
- Vol. 51 (28) , 57800-57806
Superior energy-storage performance in lead-free BaTiO3-based ceramics achieved via compositional engineering for pulsed power capacitors
- 30 June 2025
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 108 (10)
Lead‐free high‐energy‐storage performance ternary Bi 0.5 Na 0.5 TiO 3 ‐BaTiO 3 ‐Nd(Mg 0.5 Hf 0.5 )O 3 relaxor ferroelectric ceramics
Dielectric energy‐storage ceramics capacitors have shown remarkable application potential in pulsed power systems. However, their energy‐storage density remains substantially lower than required for next‐generation power electronics applications, thereby restricting their widespread adoption in electric vehicle drive systems. In this study, the energy‐storage properties were significantly improved through the strategic incorporation of Nd(Mg 0.5 Hf 0.5 )O 3 as a ternary component into the 0.94Bi 0.5 Na 0.5 TiO 3 ‐0.06BaTiO 3 binary lead‐free ceramics system. The prepared (1 – x )(0.94Bi 0.5 Na 0.5 TiO 3 ‐0.06BaTiO 3 )‐ x Nd(Mg 0.5 Hf 0.5 )O 3 ternary lead‐free ceramics were comprehensively evaluated with regard to their structural characteristics, dielectric properties, and energy‐storage capabilities. Systematic characterization revealed that Nd(Mg 0.5 Hf 0.5 )O 3 doping effectively tailored electrical properties by reducing remnant polarization while enhancing breakdown strength, synergistically boosting recoverable energy‐storage density W rec . The optimized 0.85(0.94Bi 0.5 Na 0.5 TiO 3 ‐0.06BaTiO 3 )‐0.15Nd(Mg 0.5 Hf 0.5 )O 3 composition demonstrated superior energy‐storage performance: a high W rec of 6.1 J/cm 3 with moderate efficiency ~ 75.4% at 580 kV/cm, accompanied by exceptional thermal stability (20–100°C) and frequency stability (1–1000 Hz). Notably, superior power density (~352 MW/cm 3 ) and ultrafast discharge time (~45 ns) were simultaneously achieved. These enhancements originate from Nd(Mg 0.5 Hf 0.5 )O 3 ‐induced refined grain morphology, widened bandgap, and improved electrical homogeneity. This work establishes an effective strategy for developing BNT‐based ceramics, offering a sustainable solution for next‐generation pulsed power capacitor applications.
- 30 June 2025
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 108 (10)
Lead‐free high‐energy‐storage performance ternary Bi 0.5 Na 0.5 TiO 3 ‐BaTiO 3 ‐Nd(Mg 0.5 Hf 0.5 )O 3 relaxor ferroelectric ceramics
Dielectric energy‐storage ceramics capacitors have shown remarkable application potential in pulsed power systems. However, their energy‐storage density remains substantially lower than required for next‐generation power electronics applications, thereby restricting their widespread adoption in electric vehicle drive systems. In this study, the energy‐storage properties were significantly improved through the strategic incorporation of Nd(Mg 0.5 Hf 0.5 )O 3 as a ternary component into the 0.94Bi 0.5 Na 0.5 TiO 3 ‐0.06BaTiO 3 binary lead‐free ceramics system. The prepared (1 – x )(0.94Bi 0.5 Na 0.5 TiO 3 ‐0.06BaTiO 3 )‐ x Nd(Mg 0.5 Hf 0.5 )O 3 ternary lead‐free ceramics were comprehensively evaluated with regard to their structural characteristics, dielectric properties, and energy‐storage capabilities. Systematic characterization revealed that Nd(Mg 0.5 Hf 0.5 )O 3 doping effectively tailored electrical properties by reducing remnant polarization while enhancing breakdown strength, synergistically boosting recoverable energy‐storage density W rec . The optimized 0.85(0.94Bi 0.5 Na 0.5 TiO 3 ‐0.06BaTiO 3 )‐0.15Nd(Mg 0.5 Hf 0.5 )O 3 composition demonstrated superior energy‐storage performance: a high W rec of 6.1 J/cm 3 with moderate efficiency ~ 75.4% at 580 kV/cm, accompanied by exceptional thermal stability (20–100°C) and frequency stability (1–1000 Hz). Notably, superior power density (~352 MW/cm 3 ) and ultrafast discharge time (~45 ns) were simultaneously achieved. These enhancements originate from Nd(Mg 0.5 Hf 0.5 )O 3 ‐induced refined grain morphology, widened bandgap, and improved electrical homogeneity. This work establishes an effective strategy for developing BNT‐based ceramics, offering a sustainable solution for next‐generation pulsed power capacitor applications.
- 15 April 2025
- Published by Elsevier in Ceramics International
- Vol. 51 (19) , 29792-29799
Enhancing dielectric stability in lead-free (Na0.25Ca0.25Sr0.25Bi0.25)TiO3 ceramics via Zr doping: Microstructural and electrical property modulation
- 15 April 2025
- Published by Elsevier in Ceramics International
- Vol. 51 (19) , 29792-29799
Enhancing dielectric stability in lead-free (Na0.25Ca0.25Sr0.25Bi0.25)TiO3 ceramics via Zr doping: Microstructural and electrical property modulation
- 9 February 2024
- Published by World Scientific Pub Co Pte Ltd in Modern Physics Letters B
- Vol. 38 (24)
Evidence for Vogel Fulcher behavior of the 50K-relaxation in (Tm+Ta) co-doped TiO2 ceramics
There is still no consensus about the relaxation behavior of the so-called 50[ ]K-relaxation in acceptor and donor co-doped TiO2 system. Herein, the relaxation behavior of the 50[ ]K-relaxation was investigated in (Tm[ ][ ][ ]Ta) co-doped rutile TiO2 ceramics. Dielectric properties of the sample were studied in the temperature range of 2–300[ ]K under 100 frequencies in the range of 102–106[ ]Hz. The sample shows a pronounced 50[ ]K-relaxation. Various relaxation behaviors of Arrhenius, Mott’s variable range hopping, and Vogel Fulcher laws were tried to describe the relaxation. The result indisputably evidences that the 50[ ]K-relaxation follows the Vogel Fulcher law. This work provides a heuristic hint to understand the fundamental physics underlying the colossal permittivity behavior in the acceptor and donor co-doped TiO2 ceramics system.
- 9 February 2024
- Published by World Scientific Pub Co Pte Ltd in Modern Physics Letters B
- Vol. 38 (24)
Evidence for Vogel Fulcher behavior of the 50K-relaxation in (Tm+Ta) co-doped TiO2 ceramics
There is still no consensus about the relaxation behavior of the so-called 50[ ]K-relaxation in acceptor and donor co-doped TiO2 system. Herein, the relaxation behavior of the 50[ ]K-relaxation was investigated in (Tm[ ][ ][ ]Ta) co-doped rutile TiO2 ceramics. Dielectric properties of the sample were studied in the temperature range of 2–300[ ]K under 100 frequencies in the range of 102–106[ ]Hz. The sample shows a pronounced 50[ ]K-relaxation. Various relaxation behaviors of Arrhenius, Mott’s variable range hopping, and Vogel Fulcher laws were tried to describe the relaxation. The result indisputably evidences that the 50[ ]K-relaxation follows the Vogel Fulcher law. This work provides a heuristic hint to understand the fundamental physics underlying the colossal permittivity behavior in the acceptor and donor co-doped TiO2 ceramics system.
- 25 April 2023
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 34 (12) , 1-9
Achieving high energy storage density under low electric field in modified bismuth sodium titanate ceramics
- 25 April 2023
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 34 (12) , 1-9
Achieving high energy storage density under low electric field in modified bismuth sodium titanate ceramics
- 20 November 2022
- Published by Springer Nature in Journal of Materials Science
- Vol. 57 (45) , 21000-21008
Design of high energy-storage properties in eco-friendly AgNbO3-based ceramics via two-step sintering method and tuning phase boundary
- 20 November 2022
- Published by Springer Nature in Journal of Materials Science
- Vol. 57 (45) , 21000-21008
Design of high energy-storage properties in eco-friendly AgNbO3-based ceramics via two-step sintering method and tuning phase boundary