Rawya Mohammed Ramadan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Rawya Mohammed Ramadan has a total of 54 co-authors. Here are the top co-authors by number of shared publications:
H. Doweidar
Physics Department, Faculty of Science, Mansoura University, Mansoura, Egypt
8 shared publicationsK. El-Egili
6 shared publications- Asmaa Mohamed Abdelghany
Spectroscopy Department, Physics Research Institute, National Research Centre, Giza, Egypt
5 shared publications - Gomaa El Damrawi
Physics Department, Faculty of Science, Mansoura University, Mansoura, Egypt
4 shared publications E. Khalil
3 shared publicationsG. El Damrawi
3 shared publications
Latest Publications
- Open Access
- 30 January 2025
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 36 (3) , 1-14
Effect of mutual modification by BaO and BaF2 on the structure and properties of BaO–BaF2–B2O3 glasses
Oxy-fluoroborate glasses of the composition xBaF2·(45-x)BaO·55B2O3 (0 ≤ x ≤ 45 mol%) have been prepared by the normal melt-quenching technique. X-ray diffraction (XRD) and transmission electron microscopy (TEM) confirm that the glassy matrix contains amorphous and/or crystalline phases depending on BaF2 concentration. Scanning electron microscopy (SEM) shows agglomerates consisting of clusters in micro-scale separated from the amorphous phase. Fourier-transform infrared (FTIR) spectra reveal that BaF2 partially modifies the borate matrix as in the binary BaF2–B2O3 glasses. Values of fraction N 4 of four coordinated boron atoms calculated from FTIR spectra agree with nuclear magneitic resonance (NMR) data. N 4 increases at the expense of non-bridging planar trigonal (BO3) units at low concentrations of BaF2 while at higher concentrations, N 4 increases at the expense of tetrahedral BO4 units. Density seems to be constant while molar volume increases from 27.51 to 30.31 cm−1 with increasing BaF2 content. It is found that the volume of structural units by BaF2 is greater than those related to BaO. T g have a linear decrease from 580 to 485 °C with increasing BaF2 concentration. A structural view is presented for the role of BaF2, obtained based on N 4 data obtained from NMR and FTIR analysis.
- 30 January 2025
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 36 (3) , 1-14
Open AccessEffect of mutual modification by BaO and BaF2 on the structure and properties of BaO–BaF2–B2O3 glasses
Oxy-fluoroborate glasses of the composition xBaF2·(45-x)BaO·55B2O3 (0 ≤ x ≤ 45 mol%) have been prepared by the normal melt-quenching technique. X-ray diffraction (XRD) and transmission electron microscopy (TEM) confirm that the glassy matrix contains amorphous and/or crystalline phases depending on BaF2 concentration. Scanning electron microscopy (SEM) shows agglomerates consisting of clusters in micro-scale separated from the amorphous phase. Fourier-transform infrared (FTIR) spectra reveal that BaF2 partially modifies the borate matrix as in the binary BaF2–B2O3 glasses. Values of fraction N 4 of four coordinated boron atoms calculated from FTIR spectra agree with nuclear magneitic resonance (NMR) data. N 4 increases at the expense of non-bridging planar trigonal (BO3) units at low concentrations of BaF2 while at higher concentrations, N 4 increases at the expense of tetrahedral BO4 units. Density seems to be constant while molar volume increases from 27.51 to 30.31 cm−1 with increasing BaF2 content. It is found that the volume of structural units by BaF2 is greater than those related to BaO. T g have a linear decrease from 580 to 485 °C with increasing BaF2 concentration. A structural view is presented for the role of BaF2, obtained based on N 4 data obtained from NMR and FTIR analysis.
- Open Access
- 11 January 2025
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 57 (1) , 1-20
Optical parameters and shielding attitude of sodium fluoride in calcium-borate glasses
Borate glasses with compositions xCaO-(30-x)NaF-70B2O3 (x = 0–30 mol%, step 5) were synthesized and characterized to investigate the effects of partially substituting NaF with CaO on radiation shielding ability and optical properties. Density, molar volume, packing density, and free volume were measured and calculated. UV–visible spectroscopy was utilized to determine the optical bandgap and other correlated physical parameters. Moreover, different shielding parameters were evaluated using Phy-X simulation software. From data analyses, it was found that increasing CaO content transformed BO3 to BO4 structural units in the borate glass network, keeping the optical bandgap values between 3.76 and 3.55 eV. In addition, the refractive index varied from 2.32 to 2.4, while molar refractivity and Urbach energy were slightly increased with composition. Moreover, the replacement of NaF by CaO enhanced photon interaction cross-sections, reducing the mean free path and half-value layer. The work demonstrated that controlled additions of an intermediate oxide like CaO can tailor the radiation shielding and optical characteristics of borate glasses for potential applications as transparent radiation shielding materials.
- 11 January 2025
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 57 (1) , 1-20
Open AccessOptical parameters and shielding attitude of sodium fluoride in calcium-borate glasses
Borate glasses with compositions xCaO-(30-x)NaF-70B2O3 (x = 0–30 mol%, step 5) were synthesized and characterized to investigate the effects of partially substituting NaF with CaO on radiation shielding ability and optical properties. Density, molar volume, packing density, and free volume were measured and calculated. UV–visible spectroscopy was utilized to determine the optical bandgap and other correlated physical parameters. Moreover, different shielding parameters were evaluated using Phy-X simulation software. From data analyses, it was found that increasing CaO content transformed BO3 to BO4 structural units in the borate glass network, keeping the optical bandgap values between 3.76 and 3.55 eV. In addition, the refractive index varied from 2.32 to 2.4, while molar refractivity and Urbach energy were slightly increased with composition. Moreover, the replacement of NaF by CaO enhanced photon interaction cross-sections, reducing the mean free path and half-value layer. The work demonstrated that controlled additions of an intermediate oxide like CaO can tailor the radiation shielding and optical characteristics of borate glasses for potential applications as transparent radiation shielding materials.
- 20 May 2024
- Published by Elsevier in Optical Materials
- Vol. 152
Structural, optical, and radiation shielding parameters of zinc silicate glasses modified with erbium oxide
- 20 May 2024
- Published by Elsevier in Optical Materials
- Vol. 152
Structural, optical, and radiation shielding parameters of zinc silicate glasses modified with erbium oxide
- 2 January 2024
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 56 (3) , 1-21
Structural, mechanical and electrical characteristics as well radiation attenuation capacities of barium lithium meta-phosphate glasses
- 2 January 2024
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 56 (3) , 1-21
Structural, mechanical and electrical characteristics as well radiation attenuation capacities of barium lithium meta-phosphate glasses
- 2 November 2023
- Published by Elsevier in Journal of Molecular Liquids
- Vol. 392
Novel nanocomposites based on Tetrazine liquid crystals for energy storage application
- 2 November 2023
- Published by Elsevier in Journal of Molecular Liquids
- Vol. 392
Novel nanocomposites based on Tetrazine liquid crystals for energy storage application
- 19 January 2022
- Published by Egyptian Knowledge Bank in Egyptian Journal of Chemistry
- Vol. 65 (9) , 1-10
Synthesis, structural characterization, and antibacterial studies of new borate 13-93B3 bioglasses with low copper dopant
Glasses of nominal composition (6Na2O.12K2O.5MgO.20CaO.4P2O5.(53-x) B2O3. xCuO Wt%) (0 ≤ x ≤ 0.6 wt%) were successfully synthesized via the traditional melt quenching route. The synthesized samples proved to be amorphous without any tendency for crystallization through X-ray diffraction measurements. Structural changes within the glassy matrix and their ability for bone bonding were investigated through employing deconvolution analysis technique (DAT) combined with Fourier transform Infrared (FT-IR) spectral measurement to calculate the percent of tetrahedral boron change versus doping copper ion concentration. It was found that copper additions control the transformation of triangular and tetrahedral coordinated boron that increase with increasing copper content up to 0.4 wt%. UV/Vis. electronic spectral data was used to calculate physical parameters including optical energy gap, refractive index, dielectric permittivity, and other physical parameters. Antimicrobial activity against different pathogenic grams using a cup and disc diffusion method was also correlated to the copper oxide doping level. All previous investigations were used as an optimizing factor for the synthesis of bioactive borate glass suitable for wound healing and wound dressing applications.
- 19 January 2022
- Published by Egyptian Knowledge Bank in Egyptian Journal of Chemistry
- Vol. 65 (9) , 1-10
Synthesis, structural characterization, and antibacterial studies of new borate 13-93B3 bioglasses with low copper dopant
Glasses of nominal composition (6Na2O.12K2O.5MgO.20CaO.4P2O5.(53-x) B2O3. xCuO Wt%) (0 ≤ x ≤ 0.6 wt%) were successfully synthesized via the traditional melt quenching route. The synthesized samples proved to be amorphous without any tendency for crystallization through X-ray diffraction measurements. Structural changes within the glassy matrix and their ability for bone bonding were investigated through employing deconvolution analysis technique (DAT) combined with Fourier transform Infrared (FT-IR) spectral measurement to calculate the percent of tetrahedral boron change versus doping copper ion concentration. It was found that copper additions control the transformation of triangular and tetrahedral coordinated boron that increase with increasing copper content up to 0.4 wt%. UV/Vis. electronic spectral data was used to calculate physical parameters including optical energy gap, refractive index, dielectric permittivity, and other physical parameters. Antimicrobial activity against different pathogenic grams using a cup and disc diffusion method was also correlated to the copper oxide doping level. All previous investigations were used as an optimizing factor for the synthesis of bioactive borate glass suitable for wound healing and wound dressing applications.
- 15 January 2022
- Published by Springer Nature in Silicon
- Vol. 14 (14) , 8733-8743
Structural Characterization of Strontium Silicate Glasses and Glass Ceramics Applied as Glass Ionomer Cements (GICs)
- 15 January 2022
- Published by Springer Nature in Silicon
- Vol. 14 (14) , 8733-8743
Structural Characterization of Strontium Silicate Glasses and Glass Ceramics Applied as Glass Ionomer Cements (GICs)
- 24 February 2021
- Published by Egyptian Knowledge Bank in Egyptian Journal of Chemistry
- Vol. 64 (6) , 3111-3120
A study of the biophysical properties of polystyrene films incorporated with clove oil as bio-based plasticizer.
. Polystyrene based films loaded with different concentrations of clove oil (0, 10, 20, 30 and 40 wt.%) were prepared using solution casting technique. The properties of the novel composites are characterized using dielectric spectroscopy (DS), attenuated total reflection-fourier transform infrared spectroscopy (ATR-FTIR), scanning electron microscope (SEM), X-ray diffraction (XRD),UV absorption spectra, contact angle measurements, mechanical analysis, in addition to test the anti-bacterial effect of the composites against two strains of microorganisms: Escherichia coli(gram-negative bacteria) and Staphylococcus aureus (gram-positive bacteria). According to dielectric study, by increasing the CLO content both The permittivity ', dielectric loss " and the electrical conductivity increases. The contact angle measurements indicate that, the PS-CLO films demonstrate hydrophilic behavior compared to the pure PS. Tensile strength R values decreased by increasing CLO content and elongation at break R values were found to be increased. The increase in R may be due to the softening effect of CLO. The incorporation of the clove oil improved the light transmittance of the films. PS-CLO 40% sample have antibacterial activity against both E. coli and S. aureus.
- 24 February 2021
- Published by Egyptian Knowledge Bank in Egyptian Journal of Chemistry
- Vol. 64 (6) , 3111-3120
A study of the biophysical properties of polystyrene films incorporated with clove oil as bio-based plasticizer.
. Polystyrene based films loaded with different concentrations of clove oil (0, 10, 20, 30 and 40 wt.%) were prepared using solution casting technique. The properties of the novel composites are characterized using dielectric spectroscopy (DS), attenuated total reflection-fourier transform infrared spectroscopy (ATR-FTIR), scanning electron microscope (SEM), X-ray diffraction (XRD),UV absorption spectra, contact angle measurements, mechanical analysis, in addition to test the anti-bacterial effect of the composites against two strains of microorganisms: Escherichia coli(gram-negative bacteria) and Staphylococcus aureus (gram-positive bacteria). According to dielectric study, by increasing the CLO content both The permittivity ', dielectric loss " and the electrical conductivity increases. The contact angle measurements indicate that, the PS-CLO films demonstrate hydrophilic behavior compared to the pure PS. Tensile strength R values decreased by increasing CLO content and elongation at break R values were found to be increased. The increase in R may be due to the softening effect of CLO. The incorporation of the clove oil improved the light transmittance of the films. PS-CLO 40% sample have antibacterial activity against both E. coli and S. aureus.
- 14 May 2020
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 31 (12) , 9065-9075
New approach for synthesis of nano-sized CaCu3Ti4O12 powder by economic and innovative method
- 14 May 2020
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 31 (12) , 9065-9075
New approach for synthesis of nano-sized CaCu3Ti4O12 powder by economic and innovative method