Mark Andrew Ashworth
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Mark Andrew Ashworth has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
Jussi Hokka
ESA, ESTEC, The Netherlands
2 shared publicationsTerho Kutilainen
Oy Poltronic Ab, Finland
2 shared publicationsAnthony S. David
Division of Psychiatry, UCL Institute of Mental Health, Maple House, 149 Tottenham Court Road, Maple House, London W1T 7NF, UK
1 shared publication- Barrie D. Dunn
University of Portsmouth
1 shared publication Geoffrey D. Wilcox
Loughborough University
1 shared publication- Geoffrey D. Wilcox
Department of Materials, Loughborough University, Loughborough, UK
1 shared publication
Latest Publications
- 7 September 2021
- Published by Cambridge University Press (CUP) in Psychological Medicine
- Vol. 53 (7) , 3232-3233
PRINCE Secondary: transdiagnostic cognitive behaviour therapy for persistent physical symptoms
- 7 September 2021
- Published by Cambridge University Press (CUP) in Psychological Medicine
- Vol. 53 (7) , 3232-3233
PRINCE Secondary: transdiagnostic cognitive behaviour therapy for persistent physical symptoms
- Open Access
- 23 August 2019
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 48 (11) , 7573-7584
Atomic Layer Deposition (ALD) to Mitigate Tin Whisker Growth and Corrosion Issues on Printed Circuit Board Assemblies
- 23 August 2019
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 48 (11) , 7573-7584
Open AccessAtomic Layer Deposition (ALD) to Mitigate Tin Whisker Growth and Corrosion Issues on Printed Circuit Board Assemblies
- Open Access
- 7 November 2016
- Published by Emerald Publishing in Circuit World
- Vol. 42 (4) , 183-196
An investigation of tin whisker growth over a 32-year period
Purpose: This paper aims to present the results of a 32-year-old laboratory study of whisker growth from tin electrodeposits that was originally undertaken to gain an increased understanding of the phenomenon of tin whisker growth. Design/methodology/approach: Whisker growth was evaluated using electroplated C-rings (both stressed and un-stressed) that were stored throughout in a desiccator at room temperature. Analysis has recently been undertaken to evaluate whisker growth and intermetallic growth after 32 years of storage. Scanning electron microscopy analysis has been performed to investigate whisker length and, using polished cross-sections, the morphology, thickness and type of intermetallic formation. Findings: Normal tin-plated deposits on brass and steel with a copper barrier layer nucleated whiskers within five months, and in each case, these grew to lengths between 1 and 4.5 mm. For normal tin electroplated onto brass, a one- or two-month nucleation period was needed before whiskers developed. They reached a maximum length of about 1.5 mm after six months, and little or no further growth occurred during the subsequent 32 years. Very few whiskers grew on the tin-plated steel samples and no intermetallic formation was observed. None of the fused tin plating samples nucleated whiskers during the 32-year period. Practical implications: Knowledge about vintage whiskers is important to take steps to increase the resiliency of space missions. Similarly, such knowledge is important to engineers engaged in products reaching their nominal end-of-life, but where, for reasons of economy, these products cannot be replaced. Originality/value: This study represents a unique insight into whisker growth and intermetallic formation over an extremely long time period.
- 7 November 2016
- Published by Emerald Publishing in Circuit World
- Vol. 42 (4) , 183-196
Open AccessAn investigation of tin whisker growth over a 32-year period
Purpose: This paper aims to present the results of a 32-year-old laboratory study of whisker growth from tin electrodeposits that was originally undertaken to gain an increased understanding of the phenomenon of tin whisker growth. Design/methodology/approach: Whisker growth was evaluated using electroplated C-rings (both stressed and un-stressed) that were stored throughout in a desiccator at room temperature. Analysis has recently been undertaken to evaluate whisker growth and intermetallic growth after 32 years of storage. Scanning electron microscopy analysis has been performed to investigate whisker length and, using polished cross-sections, the morphology, thickness and type of intermetallic formation. Findings: Normal tin-plated deposits on brass and steel with a copper barrier layer nucleated whiskers within five months, and in each case, these grew to lengths between 1 and 4.5 mm. For normal tin electroplated onto brass, a one- or two-month nucleation period was needed before whiskers developed. They reached a maximum length of about 1.5 mm after six months, and little or no further growth occurred during the subsequent 32 years. Very few whiskers grew on the tin-plated steel samples and no intermetallic formation was observed. None of the fused tin plating samples nucleated whiskers during the 32-year period. Practical implications: Knowledge about vintage whiskers is important to take steps to increase the resiliency of space missions. Similarly, such knowledge is important to engineers engaged in products reaching their nominal end-of-life, but where, for reasons of economy, these products cannot be replaced. Originality/value: This study represents a unique insight into whisker growth and intermetallic formation over an extremely long time period.