Koyadan Koroth Ajith
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Koyadan Koroth Ajith has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
Amitabha Bhattacharya
3 shared publicationsAjay M. Sidpara
Department of Mechanical Engineering Indian Institute of Technology Kharagpur 721302 West Bengal India
1 shared publication- Amitabha Bhattacharya
Department of Electronics and Electrical Communication Engineering, Indian Institute of Technology Kharagpur, Kharagpur, India
1 shared publication Dina A. John
Department of Electrical Engineering Indian Institute of Technology Kharagpur 721302 West Bengal India
1 shared publication- Jinu Paul
Department of Mechanical Engineering, National Institute of Technology Calicut, Calicut, India
1 shared publication Jomy Joseph
Department of Mechanical Engineering Indian Institute of Technology Kharagpur 721302 West Bengal India
1 shared publication
Latest Publications
- 11 April 2019
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 136 (29)
Highly filled multilayer thermoplastic/graphene conducting composite structures with high strength and thermal stability for electromagnetic interference shielding applications
Polyvinyl chloride (PVC)/graphene and poly(methyl methacrylate) (PMMA)/graphene nanocomposites were made by solution casting technique with graphene weight fractions of 1, 5, 10, 15, and 20%. Multilayer structures of the composites were made by hot compression technique to study their electromagnetic interference shielding effectiveness (EMI SE). Tensile strength, hardness, and storage modulus of the nanocomposites were studied in relation with graphene weight fraction. There has been a substantial increase in the electrical conductivity and EMI SE of the composites with 15–20% filler loading. Differential thermal analysis of the composites shows improved thermal stability with an increase in graphene loading. PMMA/graphene composites have better thermal stability, whereas PVC/graphene composites have superior mechanical properties. About 2 mm thick multilayer structures of PMMA/graphene and PVC/graphene composites show a maximum EMI SE of 21 dB and 31 dB, respectively, in the X band at 20 wt % graphene loading. © 2019 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2019, 136, 47792.
- 11 April 2019
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 136 (29)
Highly filled multilayer thermoplastic/graphene conducting composite structures with high strength and thermal stability for electromagnetic interference shielding applications
Polyvinyl chloride (PVC)/graphene and poly(methyl methacrylate) (PMMA)/graphene nanocomposites were made by solution casting technique with graphene weight fractions of 1, 5, 10, 15, and 20%. Multilayer structures of the composites were made by hot compression technique to study their electromagnetic interference shielding effectiveness (EMI SE). Tensile strength, hardness, and storage modulus of the nanocomposites were studied in relation with graphene weight fraction. There has been a substantial increase in the electrical conductivity and EMI SE of the composites with 15–20% filler loading. Differential thermal analysis of the composites shows improved thermal stability with an increase in graphene loading. PMMA/graphene composites have better thermal stability, whereas PVC/graphene composites have superior mechanical properties. About 2 mm thick multilayer structures of PMMA/graphene and PVC/graphene composites show a maximum EMI SE of 21 dB and 31 dB, respectively, in the X band at 20 wt % graphene loading. © 2019 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2019, 136, 47792.
- 15 May 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 66 (8) , 3830-3836
A Novel Compact Superwideband Bowtie Antenna for 420 MHz to 5.5 GHz Operation
Bowtie antennas are ubiquitous in practical ground-penetrating radars. In spite of having a wide impedance bandwidth, boresight gain of these antennas is small and the main beam gets tilted beyond a 4:1 bandwidth. In this paper, a bowtie antenna design is presented, which has a return loss of at least 10 dB from 420 MHz to 5.5 GHz (13:1 bandwidth) and a stable radiation pattern and improved gain throughout the bandwidth. A superwide bandwidth is obtained without any kind of dissipative loading. The peak gain and average gain are 7.96 and 5.89 dBi, respectively. The gain of the antenna is improved using parasitic loops as directors. The size of the antenna is only 0.322λ at 420 MHz.
- 15 May 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 66 (8) , 3830-3836
A Novel Compact Superwideband Bowtie Antenna for 420 MHz to 5.5 GHz Operation
Bowtie antennas are ubiquitous in practical ground-penetrating radars. In spite of having a wide impedance bandwidth, boresight gain of these antennas is small and the main beam gets tilted beyond a 4:1 bandwidth. In this paper, a bowtie antenna design is presented, which has a return loss of at least 10 dB from 420 MHz to 5.5 GHz (13:1 bandwidth) and a stable radiation pattern and improved gain throughout the bandwidth. A superwide bandwidth is obtained without any kind of dissipative loading. The peak gain and average gain are 7.96 and 5.89 dBi, respectively. The gain of the antenna is improved using parasitic loops as directors. The size of the antenna is only 0.322λ at 420 MHz.
- 28 September 2017
- Published by National Institute of Telecommunications in Journal of Telecommunications and Information Technology
- Vol. 3 (2017) , 9-16
Improving the GPR Detectability Using a Novel Loop Bowtie Antenna
The Ground Penetrating Radar (GPR) technique finds immense applications in civil engineering today, as the most suitable approach for non-destructive testing of pavements, highways, concrete structures, and more. The major challenge in carrying out a GPR evaluation is that the properties of the probed medium are usually unknown. The permittivity and conductivity of the medium may vary from those of air to water. The electromagnetic waves also have a frequency dependent attenuation. The ability of GPR to detect signals reflected and scattered by the targets largely depends upon the antenna performance. This paper studies a novel 11:1 wideband loop bowtie antenna with very good radiation properties in the entire operating bandwidth. Synthetic and experimental results are presented for the return loss and gain of the antenna. Furthermore, experimental results are presented for the radiation patterns in the E- and H-plane. We also used the antenna to measure B-scans over two different pipes, a bamboo, and a reinforced concrete structure. All results obtained with the proposed antenna have been compared with results obtained by using a RC loaded antenna. It has been found that the loop bowtie antenna has excellent detection capability and produces less clutter. The loop loading technique can be applied to existing antennas for improved GPR imaging. This will improve the detectability of GPR by improving the target return signal.
- 28 September 2017
- Published by National Institute of Telecommunications in Journal of Telecommunications and Information Technology
- Vol. 3 (2017) , 9-16
Improving the GPR Detectability Using a Novel Loop Bowtie Antenna
The Ground Penetrating Radar (GPR) technique finds immense applications in civil engineering today, as the most suitable approach for non-destructive testing of pavements, highways, concrete structures, and more. The major challenge in carrying out a GPR evaluation is that the properties of the probed medium are usually unknown. The permittivity and conductivity of the medium may vary from those of air to water. The electromagnetic waves also have a frequency dependent attenuation. The ability of GPR to detect signals reflected and scattered by the targets largely depends upon the antenna performance. This paper studies a novel 11:1 wideband loop bowtie antenna with very good radiation properties in the entire operating bandwidth. Synthetic and experimental results are presented for the return loss and gain of the antenna. Furthermore, experimental results are presented for the radiation patterns in the E- and H-plane. We also used the antenna to measure B-scans over two different pipes, a bamboo, and a reinforced concrete structure. All results obtained with the proposed antenna have been compared with results obtained by using a RC loaded antenna. It has been found that the loop bowtie antenna has excellent detection capability and produces less clutter. The loop loading technique can be applied to existing antennas for improved GPR imaging. This will improve the detectability of GPR by improving the target return signal.
- Open Access
- 1 January 2016
- Published by The Electromagnetics Academy in Progress in Electromagnetics Research C
- Vol. 62, 11-22
PRINTED COMPACT LENS ANTENNA FOR UHF BAND APPLICATIONS
A new microwave lens antenna suitable for ultra-high frequency (UHF: 300 MHz-3 GHz) band applications is proposed. An improved bow-tie antenna and a planar metamaterial lens design is presented. 5 dB improvement in boresight gain and a directive radiation pattern is achieved with the lens. The application of the designed antenna is demonstrated in a ground penetrating radar (GPR) experiment. The size of the antenna is very compact compared to other antennas found in the literature used for similar applications.
- 1 January 2016
- Published by The Electromagnetics Academy in Progress in Electromagnetics Research C
- Vol. 62, 11-22
Open AccessPRINTED COMPACT LENS ANTENNA FOR UHF BAND APPLICATIONS
A new microwave lens antenna suitable for ultra-high frequency (UHF: 300 MHz-3 GHz) band applications is proposed. An improved bow-tie antenna and a planar metamaterial lens design is presented. 5 dB improvement in boresight gain and a directive radiation pattern is achieved with the lens. The application of the designed antenna is demonstrated in a ground penetrating radar (GPR) experiment. The size of the antenna is very compact compared to other antennas found in the literature used for similar applications.
- 1 June 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 739-744
Improved ultra-wide bandwidth bow-tie antenna with metamaterial lens for GPR applications
A new resistively loaded bow-tie antenna which can operate from 300 MHz to more than 3 GHz bandwidth is proposed. The proposed antenna employs a metamaterial lens to improve the forward gain and front-to-back ratio. The antenna radiates pulses with minimal late-time ringing and high peak amplitude. A stable radiation pattern obtained from 300 MHz to 2 GHz, makes it suitable for time domain as well as stepped frequency continuous wave (SFCW) GPR applications. The antenna is characterized by measurements of return loss, transmission scattering parameter, radiation pattern, gain, front-to-back ratio, and GPR B-scan with object buried under soil. The measured results are in good agreement with the simulation results.
- 1 June 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 739-744
Improved ultra-wide bandwidth bow-tie antenna with metamaterial lens for GPR applications
A new resistively loaded bow-tie antenna which can operate from 300 MHz to more than 3 GHz bandwidth is proposed. The proposed antenna employs a metamaterial lens to improve the forward gain and front-to-back ratio. The antenna radiates pulses with minimal late-time ringing and high peak amplitude. A stable radiation pattern obtained from 300 MHz to 2 GHz, makes it suitable for time domain as well as stepped frequency continuous wave (SFCW) GPR applications. The antenna is characterized by measurements of return loss, transmission scattering parameter, radiation pattern, gain, front-to-back ratio, and GPR B-scan with object buried under soil. The measured results are in good agreement with the simulation results.