Stanislav Sykora
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Stanislav Sykora has a total of 78 co-authors. Here are the top co-authors by number of shared publications:
B. Schneider
Institute of Macromolecular Chemistry, Czechoslovak Academy of Sciences, Prague, Czechoslovakia
4 shared publicationsD. Doskočilová
4 shared publicationsD. Lím
Institute of Macromolecular Chemistry, Czechoslovak Academy of Sciences, Prague, Czechoslovakia
3 shared publicationsE. Brosio
Istituto di Chimica-Fisica, Università degli Studi di Roma , P. le Adlo Moro 5, 00185 Rome
3 shared publicationsF. Conti
Istituto di Chimica-Fisica, Università degli Studi di Roma , P. le Adlo Moro 5, 00185 Rome
3 shared publicationsJ. Štokr
3 shared publications
Latest Publications
- 3 March 2020
- Published by Wiley in NMR in Biomedicine
- Vol. 34 (5) , e4285
Application of low‐rank approximation using truncated singular value decomposition for noise reduction in hyperpolarized 13C NMR spectroscopy
Dissolution dynamic nuclear polarization allows in vivo studies of metabolic flux using 13C‐hyperpolarized tracers by enhancing signal intensity by up to four orders of magnitude. The T1 for in vivo applications is typically in the range of 10–50 s for the different 13C‐enriched metabolic substrates; the exponential loss of polarization due to various relaxation mechanisms leads to a strong reduction of the signal‐to‐noise ratio (SNR). A common solution to the problem of low SNR is the accumulation/averaging of consecutive spectra. However, some limitations related to long delays between consecutive scans occur: in particular, following biochemical kinetics and estimate apparent enzymatic constants becomes time critical when measurement scans are repeated with the typical delay of about 3 T1. Here we propose a method to dramatically reduce the noise, and therefore also the acquisition times, by computing, via truncated singular value decomposition, a low‐rank approximation to the individual complex time‐domain signals. Moreover, this approach has the additional advantage that the phase correction can be applied to the spectra already denoised, thus greatly reducing phase correction errors. We have tested the method on (1) simulated data; (2) performing dissolution of hyperpolarized 1‐13C‐pyruvate in standard conditions and (3) in vivo data sets, using a porcine model injected with hyperpolarized Na‐1‐13C‐acetate. It was shown that the presented method reduces the noise level in all the experimental data sets, allowing the retrieval of signals from highly noisy data without any prior phase correction pre‐processing. The effects of the proposed approach on the quantification of metabolic kinetics parameters have to be shown by full quantification studies.
- 3 March 2020
- Published by Wiley in NMR in Biomedicine
- Vol. 34 (5) , e4285
Application of low‐rank approximation using truncated singular value decomposition for noise reduction in hyperpolarized 13C NMR spectroscopy
Dissolution dynamic nuclear polarization allows in vivo studies of metabolic flux using 13C‐hyperpolarized tracers by enhancing signal intensity by up to four orders of magnitude. The T1 for in vivo applications is typically in the range of 10–50 s for the different 13C‐enriched metabolic substrates; the exponential loss of polarization due to various relaxation mechanisms leads to a strong reduction of the signal‐to‐noise ratio (SNR). A common solution to the problem of low SNR is the accumulation/averaging of consecutive spectra. However, some limitations related to long delays between consecutive scans occur: in particular, following biochemical kinetics and estimate apparent enzymatic constants becomes time critical when measurement scans are repeated with the typical delay of about 3 T1. Here we propose a method to dramatically reduce the noise, and therefore also the acquisition times, by computing, via truncated singular value decomposition, a low‐rank approximation to the individual complex time‐domain signals. Moreover, this approach has the additional advantage that the phase correction can be applied to the spectra already denoised, thus greatly reducing phase correction errors. We have tested the method on (1) simulated data; (2) performing dissolution of hyperpolarized 1‐13C‐pyruvate in standard conditions and (3) in vivo data sets, using a porcine model injected with hyperpolarized Na‐1‐13C‐acetate. It was shown that the presented method reduces the noise level in all the experimental data sets, allowing the retrieval of signals from highly noisy data without any prior phase correction pre‐processing. The effects of the proposed approach on the quantification of metabolic kinetics parameters have to be shown by full quantification studies.
- 14 March 2016
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 88 (7) , 3836-3843
Improving the Performance of High-Precision qNMR Measurements by a Double Integration Procedure in Practical Cases
Quantitative 1H NMR (qNMR) is a widely applied technique for compound concentration and purity determinations. The NMR spectrum will display signals from all species in the sample, and this is generally a strength of the method. The key spectral determination is the full and accurate determination of one or more signal areas. Accurate peak integration can be an issue when unrelated peaks resonate in an important integral region. We describe a “hybrid” approach to signal integration that provides an accurate estimation of signal area, removing the component(s) that may arise from unrelated peaks. This is achieved by using the most accurate integration method for the region, and removing unwanted contributions. The key to this performing well, and in almost all cases, is the use of areas from deconvolved peaks. We describe this process and show that it can be very successfully applied to cases where the highest precision is required, and for more common cases of NMR-based quantitation.
- 14 March 2016
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 88 (7) , 3836-3843
Improving the Performance of High-Precision qNMR Measurements by a Double Integration Procedure in Practical Cases
Quantitative 1H NMR (qNMR) is a widely applied technique for compound concentration and purity determinations. The NMR spectrum will display signals from all species in the sample, and this is generally a strength of the method. The key spectral determination is the full and accurate determination of one or more signal areas. Accurate peak integration can be an issue when unrelated peaks resonate in an important integral region. We describe a “hybrid” approach to signal integration that provides an accurate estimation of signal area, removing the component(s) that may arise from unrelated peaks. This is achieved by using the most accurate integration method for the region, and removing unwanted contributions. The key to this performing well, and in almost all cases, is the use of areas from deconvolved peaks. We describe this process and show that it can be very successfully applied to cases where the highest precision is required, and for more common cases of NMR-based quantitation.
- 19 December 2014
- Published by Wiley
- p. 445-492
An Integrated Approach to Structure Verification Using Automated Procedures
- 19 December 2014
- Published by Wiley
- p. 445-492
An Integrated Approach to Structure Verification Using Automated Procedures
- Open Access
- 7 January 2014
- Published by Springer Nature in Nature Communications
- Vol. 5 (1) , 1-8
Multinuclear nanoliter one-dimensional and two-dimensional NMR spectroscopy with a single non-resonant microcoil
Nuclear magnetic resonance (NMR) spectroscopy is a powerful analytical technique, but its low sensitivity and highly sophisticated, costly, equipment severely constrain more widespread applications. Here we show that a non-resonant planar transceiver microcoil integrated in a microfluidic chip (detection volume 25 nl) can detect different nuclides in the full broad-band range of Larmor frequencies (at 9.4 T from 61 to 400 MHz). Routine one-dimensional (1D) and two-dimensional (2D), homo- and heteronuclear experiments can be carried out using the broad-band coil set-up. Noteworthy, heteronuclear 2D experiments can be performed in a straightforward manner on virtually any combination of nuclides (from classical 1H–13C to more exotic combinations like 19F–31P) both in coupled and decoupled mode. Importantly, the concept of a non-resonant system provides magnetic field-independent NMR probes; moreover, the small-volume alleviates problems related to field inhomogeneity, making the broad-band coil an attractive option for, for example, portable and table-top NMR systems.
- 7 January 2014
- Published by Springer Nature in Nature Communications
- Vol. 5 (1) , 1-8
Open AccessMultinuclear nanoliter one-dimensional and two-dimensional NMR spectroscopy with a single non-resonant microcoil
Nuclear magnetic resonance (NMR) spectroscopy is a powerful analytical technique, but its low sensitivity and highly sophisticated, costly, equipment severely constrain more widespread applications. Here we show that a non-resonant planar transceiver microcoil integrated in a microfluidic chip (detection volume 25 nl) can detect different nuclides in the full broad-band range of Larmor frequencies (at 9.4 T from 61 to 400 MHz). Routine one-dimensional (1D) and two-dimensional (2D), homo- and heteronuclear experiments can be carried out using the broad-band coil set-up. Noteworthy, heteronuclear 2D experiments can be performed in a straightforward manner on virtually any combination of nuclides (from classical 1H–13C to more exotic combinations like 19F–31P) both in coupled and decoupled mode. Importantly, the concept of a non-resonant system provides magnetic field-independent NMR probes; moreover, the small-volume alleviates problems related to field inhomogeneity, making the broad-band coil an attractive option for, for example, portable and table-top NMR systems.
- 23 August 2013
- Published by Wiley in Magnetic Resonance in Chemistry
- Vol. 51 (10) , 649-654
Automatic assignment of 1 H-NMR spectra of small molecules
A novel data-evaluation procedure for the automatic atom to peak or multiplet assignment of 1H-NMR spectra of small molecules has been developed using a fast and robust expert system. The applicability and reliability of the method are demonstrated by comparison of a manually assigned database of 1H-NMR spectra with the assignments produced by the automatic procedure. The results of this analysis show an excellent success ratio, indicating that this new algorithm can have a major impact as a time saving tool for the organic chemist. A new graphical feature used to illustrate both the stability and quality of the elementary assignments is also introduced. Copyright © 2013 John Wiley & Sons, Ltd.
- 23 August 2013
- Published by Wiley in Magnetic Resonance in Chemistry
- Vol. 51 (10) , 649-654
Automatic assignment of 1 H-NMR spectra of small molecules
A novel data-evaluation procedure for the automatic atom to peak or multiplet assignment of 1H-NMR spectra of small molecules has been developed using a fast and robust expert system. The applicability and reliability of the method are demonstrated by comparison of a manually assigned database of 1H-NMR spectra with the assignments produced by the automatic procedure. The results of this analysis show an excellent success ratio, indicating that this new algorithm can have a major impact as a time saving tool for the organic chemist. A new graphical feature used to illustrate both the stability and quality of the elementary assignments is also introduced. Copyright © 2013 John Wiley & Sons, Ltd.
- 15 May 2013
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 85 (12) , 5778-5786
Optimization and Automation of Quantitative NMR Data Extraction
NMR is routinely used to quantitate chemical species. The necessary experimental procedures to acquire quantitative data are well-known, but relatively little attention has been applied to data processing and analysis. We describe here a robust expert system that can be used to automatically choose the best signals in a sample for overall concentration determination and determine analyte concentration using all accepted methods. The algorithm is based on the complete deconvolution of the spectrum which makes it tolerant of cases where signals are very close to one another and includes robust methods for the automatic classification of NMR resonances and molecule-to-spectrum multiplets assignments. With the functionality in place and optimized, it is then a relatively simple matter to apply the same workflow to data in a fully automatic way. The procedure is desirable for both its inherent performance and applicability to NMR data acquired for very large sample sets.
- 15 May 2013
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 85 (12) , 5778-5786
Optimization and Automation of Quantitative NMR Data Extraction
NMR is routinely used to quantitate chemical species. The necessary experimental procedures to acquire quantitative data are well-known, but relatively little attention has been applied to data processing and analysis. We describe here a robust expert system that can be used to automatically choose the best signals in a sample for overall concentration determination and determine analyte concentration using all accepted methods. The algorithm is based on the complete deconvolution of the spectrum which makes it tolerant of cases where signals are very close to one another and includes robust methods for the automatic classification of NMR resonances and molecule-to-spectrum multiplets assignments. With the functionality in place and optimized, it is then a relatively simple matter to apply the same workflow to data in a fully automatic way. The procedure is desirable for both its inherent performance and applicability to NMR data acquired for very large sample sets.
- 31 October 2010
- Published by Elsevier in Journal of Magnetic Resonance
- Vol. 206 (2) , 219-226
PERFIDI filters to suppress and/or quantify relaxation time components in multi-component systems: An example for fat–water systems
- 31 October 2010
- Published by Elsevier in Journal of Magnetic Resonance
- Vol. 206 (2) , 219-226
PERFIDI filters to suppress and/or quantify relaxation time components in multi-component systems: An example for fat–water systems
- 4 July 2007
RSS (Really Simple Syndication) for Dummies
- 31 May 2007
- Published by Elsevier in Magnetic Resonance Imaging
- Vol. 25 (4) , 529-532
PERFIDI: parametrically enabled relaxation filters with double and multiple inversion
- 31 May 2007
- Published by Elsevier in Magnetic Resonance Imaging
- Vol. 25 (4) , 529-532
PERFIDI: parametrically enabled relaxation filters with double and multiple inversion
- 31 May 2007
- Published by Elsevier in Magnetic Resonance Imaging
- Vol. 25 (4) , 555
Reference convolution of low-resolution FIDs in the presence of poor magnetic field homogeneity
- 31 May 2007
- Published by Elsevier in Magnetic Resonance Imaging
- Vol. 25 (4) , 555
Reference convolution of low-resolution FIDs in the presence of poor magnetic field homogeneity