Miguel Ángel Guerra-Cossío
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Miguel Ángel Guerra-Cossío has a total of 19 co-authors. Here are the top co-authors by number of shared publications:
- Mayra Zyzlila Figueroa Torres
Universidad Autónoma de Nuevo León, Facultad de Ingeniería Civil, Av. Universidad S/N, San Nicolás de Los Garza 66455, Mexico
6 shared publications - Javier Rodrigo Gonzalez Lopez
Facultad de Ingeniería Civil, Universidad Autónoma de Nuevo León, San Nicolás de los Garza, Mexico
4 shared publications - Antonio A. Zaldivar-Cadena
Facultad de Ingeniería Civil, Universidad Autónoma de Nuevo León, San Nicolás de los Garza, Mexico
2 shared publications - C.A. Laguna-Torres2 shared publications
J.R. González-López
2 shared publications- Ricardo Valdez Cano
Facultad de Ingeniería Civil, Unidad Torreón, Universidad Autónoma de Coahuila, Torreón, Mexico
2 shared publications
Latest Publications
- 30 September 2026
- Published by Elsevier in Surfaces and Interfaces
- Vol. 99
ZnO/SiO2 and ZnO/CuO nanocomposite surface treatments for multifunctional interfacial protection of cement mortars
- 30 September 2026
- Published by Elsevier in Surfaces and Interfaces
- Vol. 99
ZnO/SiO2 and ZnO/CuO nanocomposite surface treatments for multifunctional interfacial protection of cement mortars
- 22 September 2026
- Published by Elsevier in Construction and Building Materials
- Vol. 543
Effect of calcium sulfoaluminate cement on the reactivity of alkali-activated fly ash and slag hybrid binders
- 22 September 2026
- Published by Elsevier in Construction and Building Materials
- Vol. 543
Effect of calcium sulfoaluminate cement on the reactivity of alkali-activated fly ash and slag hybrid binders
- 6 April 2023
- Published by Springer Nature in Silicon
- Vol. 15 (12) , 5353-5366
Effects on the Mechanical and Thermal Behaviors of an Alternative Mortar when Adding Modified Silica Aerogel with Aminopropyl Triethoxysilane and PEG-PPG-PEG Triblock Copolymer Additives
- 6 April 2023
- Published by Springer Nature in Silicon
- Vol. 15 (12) , 5353-5366
Effects on the Mechanical and Thermal Behaviors of an Alternative Mortar when Adding Modified Silica Aerogel with Aminopropyl Triethoxysilane and PEG-PPG-PEG Triblock Copolymer Additives
- Open Access
- 31 December 2022
- Published by ECORFAN in Revista de Ingeniería Civil
- p. 32-45
Hybrid nanocomposite of vanadium dioxide and carbon nanotubes embedded in a gypsum binder for thermal energy storage
This investigation studied the heat storage capacity of a gypsum blinder with a hybrid nanocomposite (NH) of vanadium dioxide and multiwall carbon nanotubes (VO2/MWCNT). The influence of the NH in the hydration kinetics and hydrated products was determined. The effect of the incorporated amount of NH in the wettability, mass loss by humectation-drying cycles, thermal conductivity, specific heat (Cp) and gypsum thermal performance at 40 °C was determined. Characterization techniques exhibited that the presence of VO2/MWCNT did not modify hydration kinetics and phases development, water drop angle or compressive strength. Nevertheless, gypsum blinders mass loss increased with the presence of the nanocomposite after 6 humectation-drying cycles. According to the thermal properties, it was found that the NH addition increased gypsum blinders thermal conductivity and Cp values. Finally, it was concluded that gypsum with VO2/MWCNT promotes self-thermal regulation properties without affecting its performance. The usage of VO2/MWCNT embedded in a gypsum as a construction material would provide thermal comfort conditions in buildings.
- 31 December 2022
- Published by ECORFAN in Revista de Ingeniería Civil
- p. 32-45
Open AccessHybrid nanocomposite of vanadium dioxide and carbon nanotubes embedded in a gypsum binder for thermal energy storage
This investigation studied the heat storage capacity of a gypsum blinder with a hybrid nanocomposite (NH) of vanadium dioxide and multiwall carbon nanotubes (VO2/MWCNT). The influence of the NH in the hydration kinetics and hydrated products was determined. The effect of the incorporated amount of NH in the wettability, mass loss by humectation-drying cycles, thermal conductivity, specific heat (Cp) and gypsum thermal performance at 40 °C was determined. Characterization techniques exhibited that the presence of VO2/MWCNT did not modify hydration kinetics and phases development, water drop angle or compressive strength. Nevertheless, gypsum blinders mass loss increased with the presence of the nanocomposite after 6 humectation-drying cycles. According to the thermal properties, it was found that the NH addition increased gypsum blinders thermal conductivity and Cp values. Finally, it was concluded that gypsum with VO2/MWCNT promotes self-thermal regulation properties without affecting its performance. The usage of VO2/MWCNT embedded in a gypsum as a construction material would provide thermal comfort conditions in buildings.
- 8 November 2022
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 33 (35) , 26580-26589
Study on thermally stabilized vanadium dioxide nanoparticles solid–solid phase change thermal energy storage material
- 8 November 2022
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 33 (35) , 26580-26589
Study on thermally stabilized vanadium dioxide nanoparticles solid–solid phase change thermal energy storage material
- 22 October 2022
- Published by Springer Nature in Silicon
- Vol. 15 (5) , 2211-2220
Effect of Adding Silica Fume, Calcium Carbonate or Silicon Carbide on the Properties of an Alternative Binder Based on Anhydrite and Blast Furnace Slag
- 22 October 2022
- Published by Springer Nature in Silicon
- Vol. 15 (5) , 2211-2220
Effect of Adding Silica Fume, Calcium Carbonate or Silicon Carbide on the Properties of an Alternative Binder Based on Anhydrite and Blast Furnace Slag
- 1 May 2018
- Published by Emerald Publishing in Advances in Cement Research
- Vol. 31 (8) , 362-369
Anhydrite, blast-furnace slag and silica fume composites: properties and reaction products
Mixtures of a composite binder based on anhydrite synthesised from waste plaster from the ceramics industry complemented with granulated blast-furnace slag (BFS) and silica fume (SF) were studied. Small additions of potassium sulfate, calcium hydroxide and Portland cement clinker were used as chemical activators. The addition of BFS and SF to the systems was found to improve the properties and hinder the dissolution of gypsum in wet environments. The presence of ettringite was visually verified by scanning electron microscopy. The samples did not show considerable expansion or loss of mechanical properties for up to 56 d. The strength obtained by the compounds after 56 d was ∼20 MPa, far exceeding the typical compressive strength of gypsum plaster (about 4 MPa). The main hydrated products were gypsum, ettringite and calcium silicate hydrate type products.
- 1 May 2018
- Published by Emerald Publishing in Advances in Cement Research
- Vol. 31 (8) , 362-369
Anhydrite, blast-furnace slag and silica fume composites: properties and reaction products
Mixtures of a composite binder based on anhydrite synthesised from waste plaster from the ceramics industry complemented with granulated blast-furnace slag (BFS) and silica fume (SF) were studied. Small additions of potassium sulfate, calcium hydroxide and Portland cement clinker were used as chemical activators. The addition of BFS and SF to the systems was found to improve the properties and hinder the dissolution of gypsum in wet environments. The presence of ettringite was visually verified by scanning electron microscopy. The samples did not show considerable expansion or loss of mechanical properties for up to 56 d. The strength obtained by the compounds after 56 d was ∼20 MPa, far exceeding the typical compressive strength of gypsum plaster (about 4 MPa). The main hydrated products were gypsum, ettringite and calcium silicate hydrate type products.