Andrey Shchukarev
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Andrey Shchukarev has a total of 498 co-authors. Here are the top co-authors by number of shared publications:
- Krisztian Kordas
Microelectronics Research Unit, Faculty of Information Technology and Electrical Engineering, University of Oulu, P.O. Box 4500, FIN-90014 Oulu, Finland
20 shared publications Jyri-Pekka Mikkola
17 shared publications- Madeleine Ramstedt
Department of Chemistry, Umeå University, Umeå, Sweden
12 shared publications Staffan Sjöberg
9 shared publications- Per Persson
Centre for Environmental and Climate Science, Lund University, Lund, Sweden
8 shared publications - Tapio Salmi
Åbo Akademi University Henrikinkatu 2
8 shared publications
Latest Publications
- Open Access
- 30 May 2025
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 43 (4)
What more can be done with XPS? Highly informative but underused approaches to XPS data collection and analysis
Because of the importance of surfaces and interfaces in many scientific and technological areas, the use of x-ray photoelectron spectroscopy (XPS) has been growing exponentially. Although XPS is being used to obtain useful information about the surface composition of samples, much more information about materials and their properties can be extracted from XPS data than commonly obtained. This paper describes some of the areas where alternative analysis methods or experimental design can obtain information about the near-surface region of a sample, often information not available in other ways. Experienced XPS analysts are familiar with many of these methods, but they may not be known to new or casual XPS users, and sometimes, they have not been used because of an inappropriately assumed complexity. The information available includes optical, electronic, and electrical properties; nanostructure; expanded chemical information; and enhanced analysis of biological materials and solid/liquid interfaces. Many of these analyses can be conducted on standard laboratory XPS systems, with either no or relatively minor system alterations. Topics discussed include (1) considerations beyond the “traditional” uniform surface layer composition calculation, (2) using the Auger parameter to determine a sample property, (3) use of the D parameter to identify sp2 and sp3 carbon information, (4) information from the XPS valence band, (5) using cryocooling to expand range of samples that can be analyzed and minimize damage, and (6) using electrical potential effects on XPS signals to extract chemically resolved electrical measurements including band alignment and electrical property information.
- 30 May 2025
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 43 (4)
Open AccessWhat more can be done with XPS? Highly informative but underused approaches to XPS data collection and analysis
Because of the importance of surfaces and interfaces in many scientific and technological areas, the use of x-ray photoelectron spectroscopy (XPS) has been growing exponentially. Although XPS is being used to obtain useful information about the surface composition of samples, much more information about materials and their properties can be extracted from XPS data than commonly obtained. This paper describes some of the areas where alternative analysis methods or experimental design can obtain information about the near-surface region of a sample, often information not available in other ways. Experienced XPS analysts are familiar with many of these methods, but they may not be known to new or casual XPS users, and sometimes, they have not been used because of an inappropriately assumed complexity. The information available includes optical, electronic, and electrical properties; nanostructure; expanded chemical information; and enhanced analysis of biological materials and solid/liquid interfaces. Many of these analyses can be conducted on standard laboratory XPS systems, with either no or relatively minor system alterations. Topics discussed include (1) considerations beyond the “traditional” uniform surface layer composition calculation, (2) using the Auger parameter to determine a sample property, (3) use of the D parameter to identify sp2 and sp3 carbon information, (4) information from the XPS valence band, (5) using cryocooling to expand range of samples that can be analyzed and minimize damage, and (6) using electrical potential effects on XPS signals to extract chemically resolved electrical measurements including band alignment and electrical property information.
- Open Access
- 1 December 2024
- Published by American Vacuum Society in Surface Science Spectra
- Vol. 31 (2)
XPS spectra from five monosaccharides
X-ray photoelectron spectroscopy was used to analyze commercially available powders of five monosaccharides: glucose, glucosamine, galactosamine, glucuronic acid, and N-acetyl galactosamine. These powders were pressed onto a sample holder and analyzed as received from the manufacturer. Survey spectra and high-resolution spectra of O 1s and C 1s of all monosaccharides are reported, including N 1s for N-acetyl galactosamine, glucosamine, and galactosamine and Cl 2p for glucosamine and galactosamine. Furthermore, the presented data are compared with theoretical values, and differences are discussed.
- 1 December 2024
- Published by American Vacuum Society in Surface Science Spectra
- Vol. 31 (2)
Open AccessXPS spectra from five monosaccharides
X-ray photoelectron spectroscopy was used to analyze commercially available powders of five monosaccharides: glucose, glucosamine, galactosamine, glucuronic acid, and N-acetyl galactosamine. These powders were pressed onto a sample holder and analyzed as received from the manufacturer. Survey spectra and high-resolution spectra of O 1s and C 1s of all monosaccharides are reported, including N 1s for N-acetyl galactosamine, glucosamine, and galactosamine and Cl 2p for glucosamine and galactosamine. Furthermore, the presented data are compared with theoretical values, and differences are discussed.
- Open Access
- 6 December 2023
- Published by Elsevier in Geochimica et Cosmochimica Acta
- Vol. 365, 136-157
Manganese cycling and transport in boreal estuaries impacted by acidic Mn-rich drainage
- 6 December 2023
- Published by Elsevier in Geochimica et Cosmochimica Acta
- Vol. 365, 136-157
Open AccessManganese cycling and transport in boreal estuaries impacted by acidic Mn-rich drainage
- 21 September 2023
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry A
- Vol. 127 (39) , 8220-8227
Cryo-XPS for Surface Characterization of Nanomedicines
Nanoparticles used for medical applications commonly possess coatings or surface functionalities intended to provide specific behavior in vivo, for example, the use of PEG to provide stealth properties. Direct, quantitative measurement of the surface chemistry and composition of such systems in a hydrated environment has thus far not been demonstrated, yet such measurements are of great importance for the development of nanomedicine systems. Here we demonstrate the first use of cryo-XPS for the measurement of two PEG-functionalized nanomedicines: a polymeric drug delivery system and a lipid nanoparticle mRNA carrier. The observed differences between cryo-XPS and standard XPS measurements indicate the potential of cryo-XPS for providing quantitative measurements of such nanoparticle systems in hydrated conditions.
- 21 September 2023
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry A
- Vol. 127 (39) , 8220-8227
Cryo-XPS for Surface Characterization of Nanomedicines
Nanoparticles used for medical applications commonly possess coatings or surface functionalities intended to provide specific behavior in vivo, for example, the use of PEG to provide stealth properties. Direct, quantitative measurement of the surface chemistry and composition of such systems in a hydrated environment has thus far not been demonstrated, yet such measurements are of great importance for the development of nanomedicine systems. Here we demonstrate the first use of cryo-XPS for the measurement of two PEG-functionalized nanomedicines: a polymeric drug delivery system and a lipid nanoparticle mRNA carrier. The observed differences between cryo-XPS and standard XPS measurements indicate the potential of cryo-XPS for providing quantitative measurements of such nanoparticle systems in hydrated conditions.
- Open Access
- 16 May 2023
- Published by American Vacuum Society in Surface Science Spectra
- Vol. 30 (1)
XPS spectra from nucleobases, DNA, and RNA
X-ray photoelectron spectroscopy was used to analyze commercially available powders of thymine, uracil, cytosine, guanine, adenine, as well as DNA isolated from salmon testes and RNA from torula yeast. The powders were pressed onto a sample holder and analyzed as received from the manufacturer. Survey spectra and high-resolution spectra of O 1s, N 1s, C 1s of all nucleobases are reported, including a small Na 1s contamination in cytosine. Spectra of DNA and RNA are also included for comparison. Furthermore, the presented data are compared with previously published results, as well as theoretical values, and differences are discussed.
- 16 May 2023
- Published by American Vacuum Society in Surface Science Spectra
- Vol. 30 (1)
Open AccessXPS spectra from nucleobases, DNA, and RNA
X-ray photoelectron spectroscopy was used to analyze commercially available powders of thymine, uracil, cytosine, guanine, adenine, as well as DNA isolated from salmon testes and RNA from torula yeast. The powders were pressed onto a sample holder and analyzed as received from the manufacturer. Survey spectra and high-resolution spectra of O 1s, N 1s, C 1s of all nucleobases are reported, including a small Na 1s contamination in cytosine. Spectra of DNA and RNA are also included for comparison. Furthermore, the presented data are compared with previously published results, as well as theoretical values, and differences are discussed.
- Open Access
- 23 March 2022
- Published by American Vacuum Society in Surface Science Spectra
- Vol. 29 (1) , 014010
Cryo-XPS spectra from bacterial reference strain Pseudomonas fluorescens DSM50090
Cryogenic x-ray photoelectron spectroscopy was used to analyze the cell envelope of intact and hydrated Gram-negative bacteria of the species Pseudomonas fluorescens. We used a reference strain, DSM50090, from the German microbial culture collection, which we previously have suggested would function well as a reference strain for future XPS analyses of Gram-negative bacteria. Bacteria were grown on nutrient agar plates at room temperature, collected with a cultivation loop, and washed using phosphate buffered saline. An aliquot of the cell pellet was fast-frozen on the sample holder in the sample introduction chamber to a temperature of 103 K and kept frozen throughout the measurement. Survey spectra and high-resolution spectra of Na 1s, O 1s, N 1s, C 1s, Cl 2p, S 2p, and P 2p are reported. The spectra obtained from the analyzed cells represent a combined signal from O, N, C, and S atoms in proteins, lipids, and polysaccharides at the cell surface. Furthermore, signal from P, Na, K, and Cl atoms was present both originating from processes in the cell envelope and remnants from the wash buffer.
- 23 March 2022
- Published by American Vacuum Society in Surface Science Spectra
- Vol. 29 (1) , 014010
Open AccessCryo-XPS spectra from bacterial reference strain Pseudomonas fluorescens DSM50090
Cryogenic x-ray photoelectron spectroscopy was used to analyze the cell envelope of intact and hydrated Gram-negative bacteria of the species Pseudomonas fluorescens. We used a reference strain, DSM50090, from the German microbial culture collection, which we previously have suggested would function well as a reference strain for future XPS analyses of Gram-negative bacteria. Bacteria were grown on nutrient agar plates at room temperature, collected with a cultivation loop, and washed using phosphate buffered saline. An aliquot of the cell pellet was fast-frozen on the sample holder in the sample introduction chamber to a temperature of 103 K and kept frozen throughout the measurement. Survey spectra and high-resolution spectra of Na 1s, O 1s, N 1s, C 1s, Cl 2p, S 2p, and P 2p are reported. The spectra obtained from the analyzed cells represent a combined signal from O, N, C, and S atoms in proteins, lipids, and polysaccharides at the cell surface. Furthermore, signal from P, Na, K, and Cl atoms was present both originating from processes in the cell envelope and remnants from the wash buffer.