LFLonna M. Frans

Lonna M. Frans

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Lonna M. Frans has a total of 37 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Using Age Tracers and Decadal Sampling to Discern Trends in Nitrate, Arsenic, and Uranium in Groundwater Beneath Irrigated Cropland

    by Anthony J. Tesoriero, Karen R. Burow, Lonna M. Frans, Jonathan V. Haynes, Christopher M. Hobza, Bruce D. Lindsey, John E. Solder

    Repeat sampling and age tracers were used to examine trends in nitrate, arsenic, and uranium concentrations in groundwater beneath irrigated cropland. Much higher nitrate concentrations in shallow modern groundwater were observed at both the Columbia Plateau and High Plains sites (median values of 10.2 and 15.4 mg/L as N, respectively) than in groundwater that recharged prior to the onset of intensive irrigation (median values of r = 0.72, p < 0.01), suggesting bicarbonate may mobilize uranium in this system. A positive correlation between arsenic and phosphorus concentrations in modern groundwater (r = 0.55, p < 0.01) suggests that phosphate from fertilizer outcompetes arsenate for sorption sites, mobilizing sorbed arsenic derived from past pesticide use or other sources.


  • Open Access

    Groundwater and surface-water data collection for Mason County, western Washington, 2016–18

    by Alison E. Tecca, Lonna M. Frans

    Groundwater levels and surface water flow measurements were collected from August 2016 to September 2018 to provide the Mason Conservation District and other stakeholders with basic knowledge of existing water resources in Mason County, Washington. Additionally, the data were collected with the intent of contributing to informed decision making about groundwater use, management, and conservation throughout the county and for future inclusion in a groundwater model. Data were collected and compiled for 130 sites—110 wells and 20 miscellaneous surface-water discharge sites. In the spring of 2016, field reconnaissance was conducted to locate suitable locations for baseflow discharge measurements to be used for estimating groundwater contribution to surface flow. In the summer of 2016, a field inventory of wells was conducted to acquire locational data and to assess the suitability of the wells for inclusion in a monthly groundwater-level monitoring network. Groundwater levels were measured bimonthly in the 64 wells over 2 years. Streamflow measurements were conducted two times each summer during two summers for each of the 20 surface water sites.

  • Open Access

    Simulation of groundwater storage changes in the Quincy Basin, Washington

    by Lonna M. Frans, Sue C. Kahle, Alison E. Tecca, Theresa D. Olsen

    The Miocene Columbia River Basalt Group and younger sedimentary deposits of lacustrine, fluvial, eolian, and cataclysmic-flood origins compose the aquifer system of the Quincy Basin in eastern Washington. Irrigation return flow and canal leakage from the Columbia Basin Project have caused groundwater levels to rise substantially in some areas. Water resource managers are considering extraction of additional stored groundwater to supply increasing demand. To help address these concerns, the transient groundwater model of the Quincy Basin documented in this report was developed to quantify the changes in groundwater flow and storage.The model based on the U.S. Geological Survey modular three-dimensional finite-difference numerical code MODFLOW uses a 1-kilometer finite-difference grid and is constrained by logs from 698 wells in the study area. Five model layers represent two sedimentary hydrogeologic units and underlying basalt formations. Head-dependent flux boundaries represent the Columbia River and other streams, lakes and reservoirs, underflow to and (or) from adjacent areas, and discharge to agricultural drains and springs. Specified flux boundaries represent recharge from precipitation and anthropogenic sources, including irrigation return flow and leakage from water-distribution canals and discharge through groundwater withdrawal wells. Transient conditions were simulated from 1920 to 2013 using annual stress periods. The model was calibrated with the parameter-estimation code PEST to a total of 4,064 water levels measured in 710 wells. Increased recharge since predevelopment resulted in an 11.5 million acre-feet increase in storage in the Quincy Groundwater Management Subarea of the Quincy Basin.Four groundwater-management scenarios were formulated with input from project stakeholders and were simulated using the calibrated model to provide representative examples of how the model could be used to evaluate the effect on groundwater levels as a result of potential changes in recharge, groundwater withdrawals, or increased flow in Crab Creek. Decreased recharge and increased groundwater withdrawals both resulted in declines in groundwater levels over 2013 conditions, whereas increasing the flow in Crab Creek resulted in increased groundwater levels over 2013 conditions.


  • Numerical simulation of groundwater flow at Puget Sound Naval Shipyard, Naval Base Kitsap, Bremerton, Washington

    by Joseph L. Jones, Kenneth H. Johnson, Lonna M. Frans

    Information about groundwater-flow paths and locations where groundwater discharges at and near Puget Sound Naval Shipyard is necessary for understanding the potential migration of subsurface contaminants by groundwater at the shipyard. The design of some remediation alternatives would be aided by knowledge of whether groundwater flowing at specific locations beneath the shipyard will eventually discharge directly to Sinclair Inlet of Puget Sound, or if it will discharge to the drainage system of one of the six dry docks located in the shipyard. A 1997 numerical (finite difference) groundwater-flow model of the shipyard and surrounding area was constructed to help evaluate the potential for groundwater discharge to Puget Sound. That steady-state, multilayer numerical model with homogeneous hydraulic characteristics indicated that groundwater flowing beneath nearly all of the shipyard discharges to the dry-dock drainage systems, and only shallow groundwater flowing beneath the western end of the shipyard discharges directly to Sinclair...


  • Numerical simulation of the groundwater-flow system of the Kitsap Peninsula, west-central Washington

    by Lonna M. Frans, Theresa D. Olsen

    A groundwater-flow model was developed to improve understanding of water resources on the Kitsap Peninsula. The Kitsap Peninsula is in the Puget Sound lowland of west-central Washington, is bounded by Puget Sound on the east and by Hood Canal on the west, and covers an area of about 575 square miles. The peninsula encompasses all of Kitsap County, Mason County north of Hood Canal, and part of Pierce County west of Puget Sound. The peninsula is surrounded by saltwater, and the hydrologic setting is similar to that of an island. The study area is underlain by a thick sequence of unconsolidated glacial and interglacial deposits that overlie sedimentary and volcanic bedrock units that crop out in the central part of the study area. Twelve hydrogeologic units consisting of aquifers, confining units, and an underlying bedrock unit form the basis of the groundwater-flow model.Groundwater flow on the Kitsap Peninsula was simulated using the groundwater-flow model, MODFLOW‑NWT. The finite difference model grid comprises 536 rows, 362 columns, and 14 layers. Each model cell has a horizontal dimension of 500 by 500 feet, and the model contains a total of 1,227,772 active cells. Groundwater flow was simulated for transient conditions. Transient conditions were simulated for January 1985–December 2012 using annual stress periods for 1985–2004 and monthly stress periods for 2005–2012. During model calibration, variables were adjusted within probable ranges to minimize differences between measured and simulated groundwater levels and stream baseflows. As calibrated to transient conditions, the model has a standard deviation for heads and flows of 47.04 feet and 2.46 cubic feet per second, respectively.Simulated inflow to the model area for the 2005–2012 period from precipitation and secondary recharge was 585,323 acre-feet per year (acre-ft/yr) (93 percent of total simulated inflow ignoring changes in storage), and simulated inflow from stream and lake leakage was 43,905 acre-ft/yr (7 percent of total simulated inflow). Simulated outflow from the model primarily was through discharge to streams, lakes, springs, seeps, and Puget Sound (594,595 acre-ft/yr; 95 percent of total simulated outflow excluding changes in storage) and through withdrawals from wells (30,761 acre-ft/yr; 5 percent of total simulated outflow excluding changes in storage).Six scenarios were formulated with input from project stakeholders and were simulated using the calibrated model to provide representative examples of how the model could be used to evaluate the effects on water levels and stream baseflows of potential changes in groundwater withdrawals, in consumptive use, and in recharge. These included simulations of a steady-state system, no-pumping and return flows, 15-percent increase in current withdrawals in all wells, 80-percent decrease in outdoor water to simulate effects of conservation efforts, 15-percent decrease in recharge from precipitation to simulate a drought, and particle tracking to determine flow paths.Changes in water-level altitudes and baseflow amounts vary depending on the stress applied to the system in these various scenarios. Reducing recharge by 15 percent between 2005 and 2012 had the largest effect, with water-level altitudes declining throughout the model domain and baseflow amounts decreasing by as much as 18 percent compared to baseline conditions. Changes in pumping volumes had a smaller effect on the model. Removing all pumping and resulting return flows caused increased water-level altitudes in many areas and increased baseflow amounts of between 1 and 3 percent.