Gustavo A. Ortigoza-Villalba
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Gustavo A. Ortigoza-Villalba has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Andrea Lanzini
Department of Energy, Politecnico di Torino, Turin, Italy
6 shared publications - Massimo Santarelli
Department of Energy (DENERG), Politecnico di Torino, Corso Duca degli Abruzzi 24, 10129 Torino, Italy
5 shared publications - Pierluigi Leone
Department of Energy, Politecnico di Torino, Corso Duca degli Abruzzi 24, 10129 Torino, Italy
5 shared publications - Fabio Alessandro Deorsola
Department of Applied Science and Technology (DISAT), Politecnico di Torino, Corso Duca degli Abruzzi 24, 10129 Torino, Italy
4 shared publications F. Smeacetto
3 shared publicationsB. DeBenedetti
2 shared publications
Latest Publications
- 1 July 2014
- Published by Elsevier in Applied Energy
- Vol. 125, 254-263
Performance of a Solid Oxide Fuel Cell short-stack with biogas feeding
- 1 July 2014
- Published by Elsevier in Applied Energy
- Vol. 125, 254-263
Performance of a Solid Oxide Fuel Cell short-stack with biogas feeding
- 1 April 2013
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 38 (11) , 4740-4747
Coupling and thermal integration of a solid oxide fuel cell with a magnesium hydride tank
- 1 April 2013
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 38 (11) , 4740-4747
Coupling and thermal integration of a solid oxide fuel cell with a magnesium hydride tank
- 1 January 2013
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 38 (1) , 588-596
Performance of a glass-ceramic sealant in a SOFC short stack
- 1 January 2013
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 38 (1) , 588-596
Performance of a glass-ceramic sealant in a SOFC short stack
- 1 May 2012
- Published by Elsevier in Chemical Engineering Journal
- Vol. 191, 349-355
Operation of a solid oxide fuel cell under direct internal reforming of liquid fuels
- 1 May 2012
- Published by Elsevier in Chemical Engineering Journal
- Vol. 191, 349-355
Operation of a solid oxide fuel cell under direct internal reforming of liquid fuels
- 1 April 2012
- Published by Elsevier in Journal of Power Sources
- Vol. 204, 100-105
Analysis of the thermal field of a seal-less planar solid oxide fuel cell
- 1 April 2012
- Published by Elsevier in Journal of Power Sources
- Vol. 204, 100-105
Analysis of the thermal field of a seal-less planar solid oxide fuel cell
- 1 July 2011
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 36 (13) , 7897-7901
Development of nanostructured Mg2Ni alloys for hydrogen storage applications
- 1 July 2011
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 36 (13) , 7897-7901
Development of nanostructured Mg2Ni alloys for hydrogen storage applications
- 22 February 2011
- Published by ASME International in Journal of Fuel Cell Science and Technology
- Vol. 8 (3) , 031009
Experimental Evaluation of Planar SOFC Single Unit Cell With Crofer22APU Plate Assembly
This paper describes an experimental analysis of a planar solid oxide fuel cell (SOFC) single unit cell with Crofer22APU plate assembly. The work reports the electrical behavior of such a system by outlining the time-evolution of contact resistances between the air electrode and the stainless steel plate. Moreover, the stability and effectiveness of a glass-ceramic sealant used to join Crofer22APU interconnector to an anode supported cell is also discussed. The time-evolution of the open circuit voltage was investigated with respect to the eventual sealant degradation or chromium poisoning issues by the metallic interconnector; a rapid voltage degradation at open circuit voltage was measured after 150 h. Chromium poisoning was found to degrade the fuel cell performance, whereas the sealant was chemically and physically stable, as shown by a post-mortem analysis on the cell components.
- 22 February 2011
- Published by ASME International in Journal of Fuel Cell Science and Technology
- Vol. 8 (3) , 031009
Experimental Evaluation of Planar SOFC Single Unit Cell With Crofer22APU Plate Assembly
This paper describes an experimental analysis of a planar solid oxide fuel cell (SOFC) single unit cell with Crofer22APU plate assembly. The work reports the electrical behavior of such a system by outlining the time-evolution of contact resistances between the air electrode and the stainless steel plate. Moreover, the stability and effectiveness of a glass-ceramic sealant used to join Crofer22APU interconnector to an anode supported cell is also discussed. The time-evolution of the open circuit voltage was investigated with respect to the eventual sealant degradation or chromium poisoning issues by the metallic interconnector; a rapid voltage degradation at open circuit voltage was measured after 150 h. Chromium poisoning was found to degrade the fuel cell performance, whereas the sealant was chemically and physically stable, as shown by a post-mortem analysis on the cell components.
- 13 April 2010
- Published by Trans Tech Publications, Ltd. in Defect and Diffusion Forum
- Vol. 297-301, 745-756
Hydrogen Absorption/Desorption in Nanostructured Fe- and Ti-Doped Mg2Ni Alloys
Nanostructured Mg2Ni, Fe-doped and Ti-doped Mg2Ni alloys for hydrogen storage applications have been produced by means of Mechanically Activated Self-propagating High temperature Synthesis (MASHS). Different molar compositions of Fe and Ti (0.1; 0.3 and 0.5) have been studied in order to determine their influence in the hydrogen sorption properties. Different Mg-Ni based alloys have been tested in order to study their hydrogen sorption behavior. The hydrogenation was carried out in a Pressflow Gas Controller. Subsequently, the dehydrogenation process was conducted by means of a Differential Scanning Calorimetry (DSC) equipped with an H2 detector of the purged gas. The MASHS method has been demonstrated to be effective for the obtainment of nanostructured pure and doped Mg2Ni intermetallics. In addition, the materials produced showed hydrogen storage capacities superior to 4wt%, especially in the case of Fe-doped Mg2Ni and a slight reduction of desorption temperature was reached with Ti-doped Mg2Ni. Finally, the activation energy of the dehydrogenation process was evaluated and Ti-doped sample exhibited the lower activation energy value. Obtained results are promising for technological applications of Mg-based alloys.
- 13 April 2010
- Published by Trans Tech Publications, Ltd. in Defect and Diffusion Forum
- Vol. 297-301, 745-756
Hydrogen Absorption/Desorption in Nanostructured Fe- and Ti-Doped Mg2Ni Alloys
Nanostructured Mg2Ni, Fe-doped and Ti-doped Mg2Ni alloys for hydrogen storage applications have been produced by means of Mechanically Activated Self-propagating High temperature Synthesis (MASHS). Different molar compositions of Fe and Ti (0.1; 0.3 and 0.5) have been studied in order to determine their influence in the hydrogen sorption properties. Different Mg-Ni based alloys have been tested in order to study their hydrogen sorption behavior. The hydrogenation was carried out in a Pressflow Gas Controller. Subsequently, the dehydrogenation process was conducted by means of a Differential Scanning Calorimetry (DSC) equipped with an H2 detector of the purged gas. The MASHS method has been demonstrated to be effective for the obtainment of nanostructured pure and doped Mg2Ni intermetallics. In addition, the materials produced showed hydrogen storage capacities superior to 4wt%, especially in the case of Fe-doped Mg2Ni and a slight reduction of desorption temperature was reached with Ti-doped Mg2Ni. Finally, the activation energy of the dehydrogenation process was evaluated and Ti-doped sample exhibited the lower activation energy value. Obtained results are promising for technological applications of Mg-based alloys.
- 1 March 2010
- Published by Elsevier in International Journal of Refractory Metals and Hard Materials
- Vol. 28 (2) , 254-259
Densification of ultrafine WC–12Co cermets by Pressure Assisted Fast Electric Sintering
- 1 March 2010
- Published by Elsevier in International Journal of Refractory Metals and Hard Materials
- Vol. 28 (2) , 254-259
Densification of ultrafine WC–12Co cermets by Pressure Assisted Fast Electric Sintering
- 1 October 2008
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 466 (1-2) , 205-207
Synthesis of Mg2Ni nanostructured by MASHS technique
- 1 October 2008
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 466 (1-2) , 205-207
Synthesis of Mg2Ni nanostructured by MASHS technique