Mohammad Hadi Katooli
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Mohammad Hadi Katooli has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Ahmad Hajinezhad
Engineering and Sustainable Resources, College of Interdisciplinary Science and Technologies University of Tehran Tehran Iran
3 shared publications - Reza Askari Moghadam
Sorbonne Université, CNRS, INSERM, Laboratoire d'Imagerie Biomédicale, LIB, F-75006, Paris, France
3 shared publications - Mehdi Mehrpooya
School of Energy Engineering and Sustainable Resources, College of Interdisciplinary Science and Technology, University of Tehran, Tehran, Iran
2 shared publications - Alireza Aslani
Department of Renewable Energies and Environment University of Tehran Tehran Iran
1 shared publication - Asieh Bakhtiar
Department of Technology Management Faculty of Management, Shaid Beheshti University, Iran
1 shared publication Fatemeh Razi Astaraee
Department of Renewable Energy and Environment Faculty of New Sciences and Technologies, University of Tehran, Iran
1 shared publication
Latest Publications
- 6 April 2022
- Published by Hindawi Limited in International Journal of Energy Research
- Vol. 46 (8) , 10894-10906
Design optimization of a heat‐to‐cool Stirling cycle using artificial neural network
- 6 April 2022
- Published by Hindawi Limited in International Journal of Energy Research
- Vol. 46 (8) , 10894-10906
Design optimization of a heat‐to‐cool Stirling cycle using artificial neural network
- 20 March 2020
- Published by Springer Nature in SN Applied Sciences
- Vol. 2 (4) , 1-7
Investigation on effective operating variables in gamma-type Stirling engine performance: a simulation approach
- 20 March 2020
- Published by Springer Nature in SN Applied Sciences
- Vol. 2 (4) , 1-7
Investigation on effective operating variables in gamma-type Stirling engine performance: a simulation approach
- 1 March 2019
- Published by Elsevier in Energy Conversion and Management
- Vol. 184, 83-90
Simulation and experimental evaluation of Stirling refrigerator for converting electrical/mechanical energy to cold energy
- 1 March 2019
- Published by Elsevier in Energy Conversion and Management
- Vol. 184, 83-90
Simulation and experimental evaluation of Stirling refrigerator for converting electrical/mechanical energy to cold energy
- 19 January 2019
- Published by Taylor & Francis in Biofuels
- Vol. 12 (7) , 789-795
Multi-criteria analysis of microalgae production in Iran
With deployment of renewable energy utilization, biofuels have an important role in government policies. Microalgae is an important and promising biofuel source that has high potential for production in some areas such as Iran. Studies show that Iran’s climate is suitable for cultivation of microalgae. The aim of the current work is to first identify the most important criteria for production of microalgae. Then, the best areas for cultivation of microalgae are ranked based on the identified criteria and expert opinions using the analytic hierarchy process method. The main criteria identified are land, climate, water and nutrients, and the existing infrastructure needed to cultivate algae. The main contributors for selecting the best areas for algae production are climate, and water and natural resources. The overall results show that the Caspian Sea and Persian Gulf are the best candidates for algae production. A comparison is also carried out between the present study and the previous study by the authors to explain more about the role of criteria in the site selection.
- 19 January 2019
- Published by Taylor & Francis in Biofuels
- Vol. 12 (7) , 789-795
Multi-criteria analysis of microalgae production in Iran
With deployment of renewable energy utilization, biofuels have an important role in government policies. Microalgae is an important and promising biofuel source that has high potential for production in some areas such as Iran. Studies show that Iran’s climate is suitable for cultivation of microalgae. The aim of the current work is to first identify the most important criteria for production of microalgae. Then, the best areas for cultivation of microalgae are ranked based on the identified criteria and expert opinions using the analytic hierarchy process method. The main criteria identified are land, climate, water and nutrients, and the existing infrastructure needed to cultivate algae. The main contributors for selecting the best areas for algae production are climate, and water and natural resources. The overall results show that the Caspian Sea and Persian Gulf are the best candidates for algae production. A comparison is also carried out between the present study and the previous study by the authors to explain more about the role of criteria in the site selection.
- 2 November 2018
- Published by Elsevier in Sustainable Chemistry and Pharmacy
- Vol. 10, 112-117
Study on nutritional values of a novel plant in Iran-Nowruzak- and its application in producing biofuels
- 2 November 2018
- Published by Elsevier in Sustainable Chemistry and Pharmacy
- Vol. 10, 112-117
Study on nutritional values of a novel plant in Iran-Nowruzak- and its application in producing biofuels
- 1 November 2018
- Published by Elsevier in Progress in Energy and Combustion Science
- Vol. 69, 1-27
Thermodynamic analysis of integrated LNG regasification process configurations
- 1 November 2018
- Published by Elsevier in Progress in Energy and Combustion Science
- Vol. 69, 1-27
Thermodynamic analysis of integrated LNG regasification process configurations
- 29 January 2018
- Published by Taylor & Francis in International Journal of Ambient Energy
- Vol. 40 (7) , 783-789
Thermodynamical analysis of dry cooling tower and solar chimney power plant combination
Solar chimney power plant is one of the rather new technologies that can produce power from solar energy. Its high stack is one of the important parts of the system in which the differential density of air among its top and bottom sections causes air-flow. Dry cooling towers are used in industries for cooling condensing water by utilising this concept and generating air-flow. The structural and conceptual similarity between these two systems cause the feasibility of their combination and usage of waste energy in industries. In this article, a simple and useful analytical thermodynamic model is improved in order to estimate the thermodynamic flow properties for combining both systems. Results show that the stack height and diameter are effective parameters in recovery of power. Moreover, the results show that the collector area does not remarkably affect the system performance.
- 29 January 2018
- Published by Taylor & Francis in International Journal of Ambient Energy
- Vol. 40 (7) , 783-789
Thermodynamical analysis of dry cooling tower and solar chimney power plant combination
Solar chimney power plant is one of the rather new technologies that can produce power from solar energy. Its high stack is one of the important parts of the system in which the differential density of air among its top and bottom sections causes air-flow. Dry cooling towers are used in industries for cooling condensing water by utilising this concept and generating air-flow. The structural and conceptual similarity between these two systems cause the feasibility of their combination and usage of waste energy in industries. In this article, a simple and useful analytical thermodynamic model is improved in order to estimate the thermodynamic flow properties for combining both systems. Results show that the stack height and diameter are effective parameters in recovery of power. Moreover, the results show that the collector area does not remarkably affect the system performance.
- 28 June 2015
- Published by ASME International
The Application of a Microgrid Considering Wind Generation
Conventional power networks have experienced a gradual evolution from a centralized nature to distributed and localized structures. The upgrading of power system toward a smart grid is being developed to improve reliability and facilitate the integration of different types of renewable energies and improve load management. Due to different uncertainties linked to electricity supply in renewable MGs, probabilistic energy management techniques are going to be necessary to analyze the system. In this study, the short-term operation planning of a typical microgrid (MG) with diverse units for achieving the maximum profit, considering technical and economical constraints, for the next 24 hours, using gravitational search algorithm (GSA) with SPSS software is presented and the effect of wind generation in the planning is investigated. The MG consists of a diverse variety of power system components such as wind turbine, microturbine, photovoltaic, fuel cell, Hydrogen storage tank, reformer, a boiler, and electrical and thermal loads. Moreover, MG is connected to an electrical grid for exchange of power. The MG is managed and controlled through a central controller. The system costs include the operational cost, thermal recovery, power trade with the local grid, and hydrogen production costs. The system costs include the operational cost, thermal recovery, power trade with the local grid, and hydrogen production costs. Total obtained profit from the MG, considering with US electricity and natural gas prices is $5.312902×103.
- 28 June 2015
- Published by ASME International
The Application of a Microgrid Considering Wind Generation
Conventional power networks have experienced a gradual evolution from a centralized nature to distributed and localized structures. The upgrading of power system toward a smart grid is being developed to improve reliability and facilitate the integration of different types of renewable energies and improve load management. Due to different uncertainties linked to electricity supply in renewable MGs, probabilistic energy management techniques are going to be necessary to analyze the system. In this study, the short-term operation planning of a typical microgrid (MG) with diverse units for achieving the maximum profit, considering technical and economical constraints, for the next 24 hours, using gravitational search algorithm (GSA) with SPSS software is presented and the effect of wind generation in the planning is investigated. The MG consists of a diverse variety of power system components such as wind turbine, microturbine, photovoltaic, fuel cell, Hydrogen storage tank, reformer, a boiler, and electrical and thermal loads. Moreover, MG is connected to an electrical grid for exchange of power. The MG is managed and controlled through a central controller. The system costs include the operational cost, thermal recovery, power trade with the local grid, and hydrogen production costs. The system costs include the operational cost, thermal recovery, power trade with the local grid, and hydrogen production costs. Total obtained profit from the MG, considering with US electricity and natural gas prices is $5.312902×103.