George Tassis
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
George Tassis has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
Nikolaos Spiliopoulos
2 shared publicationsAlexandros A. Vradis
University of Patras Department of Physics GR 26504 Patras, Greece
1 shared publicationAnastasia Christoulaki
University of Patras Department of Physics GR 26504 Patras, Greece
1 shared publicationAristeidis Papagiannopoulos
1 shared publicationDimitrios L. Anastassopoulos
University of Patras Department of Physics GR 26504 Patras, Greece
1 shared publication- Eleni Koutsopoulou
Hellenic Survey of Geology and Mineral Exploration (HSGME), GR-13677 Athens, Greece
1 shared publication
Latest Publications
- 1 July 2019
- Published by Elsevier in Applied Clay Science
- Vol. 175, 1-9
Surface plasmon resonance study of adhesion kinetics of smectites on the Au/water interface: Clay and organo-clay film formation
- 1 July 2019
- Published by Elsevier in Applied Clay Science
- Vol. 175, 1-9
Surface plasmon resonance study of adhesion kinetics of smectites on the Au/water interface: Clay and organo-clay film formation
- 10 September 2015
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 118 (10) , 103108
Fabrication of an aluminum-porous alumina sensor by in situ monitoring anodization of thin aluminum films
The aim of the present work is to optimize a well-known plasmon-based aluminum/porous anodic alumina sensor. This kind of sensors is produced by partial electrochemical anodization of an aluminum film, while the remaining, non-anodized metallic film is used for supporting the propagation of surface plasmons. The anodized porous alumina is preferable against a flat solid surface as it presents much larger sensing area and thus enhanced detecting efficiency. In this work, a novel method for controlling the remaining aluminum film thickness is reported, based on a simple optical reflectance measurement during the electrochemical anodization of the initial metallic film.
- 10 September 2015
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 118 (10) , 103108
Fabrication of an aluminum-porous alumina sensor by in situ monitoring anodization of thin aluminum films
The aim of the present work is to optimize a well-known plasmon-based aluminum/porous anodic alumina sensor. This kind of sensors is produced by partial electrochemical anodization of an aluminum film, while the remaining, non-anodized metallic film is used for supporting the propagation of surface plasmons. The anodized porous alumina is preferable against a flat solid surface as it presents much larger sensing area and thus enhanced detecting efficiency. In this work, a novel method for controlling the remaining aluminum film thickness is reported, based on a simple optical reflectance measurement during the electrochemical anodization of the initial metallic film.