Debdut Biswas
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Debdut Biswas has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Tarun Kanti Bhattacharyya
Department of Electronics and Electrical Communication Engineering, Indian Institute of Technology, Kharagpur, India
3 shared publications - Nripendra Narayan Halder
Electrical Engineering Faculty, Technion Israel Institute of Technology, Haifa 32000, Israel
2 shared publications - Pallab Banerji
Indian Institute of Technology Kharagpur
2 shared publications - Souvik Kundu
Department of Electrical & Electronics Engineering, Birla Institute of Technology and Science (BITS) Pilani, Hyderabad, India
2 shared publications Tarun Kanti Bhattacharyya
Department of Electronics and Electrical Communication Engineering Indian Institute of Technology Kharagpur Kharagpur West Bengal 721 302 India
2 shared publicationsB. Nagabhushan
Indian Institute of Technology 2 Materials Science Centre Kharagpur 721 302, India
1 shared publication
Latest Publications
- 5 February 2024
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 118 (3) , 415-423
A phase noise filter for RF oscillators
- 5 February 2024
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 118 (3) , 415-423
A phase noise filter for RF oscillators
- 12 July 2022
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 112 (3) , 537-544
Dual-loop integer PLL for phase noise reduction
- 12 July 2022
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 112 (3) , 537-544
Dual-loop integer PLL for phase noise reduction
- 23 February 2022
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 111 (1) , 153-158
Phase noise reduction by resistor abutment in differential ring VCOs
- 23 February 2022
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 111 (1) , 153-158
Phase noise reduction by resistor abutment in differential ring VCOs
- 19 December 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
LC-VCO with Simple Enhancement to Suppress Flicker Noise Upconversion
In this work, a phase noise reduction mechanism in a cross-coupled LC-VCO is proposed. The tail current source small signal impedance is curtailed by negative feedback with an ideal voltage source as a reference to mimic an LC-VCO without a tail current source. Proofs show that this modification also leads to suppression of flicker noise upconversion from the tail without the dissipation of extra power. Simulations are carried out in 180 nm technology for a VCO operating in 2.4 GHz. Phase noise is reduced by 4 dBc/Hz at 10 kHz and 100 kHz offset frequency by this tail current modification.
- 19 December 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
LC-VCO with Simple Enhancement to Suppress Flicker Noise Upconversion
In this work, a phase noise reduction mechanism in a cross-coupled LC-VCO is proposed. The tail current source small signal impedance is curtailed by negative feedback with an ideal voltage source as a reference to mimic an LC-VCO without a tail current source. Proofs show that this modification also leads to suppression of flicker noise upconversion from the tail without the dissipation of extra power. Simulations are carried out in 180 nm technology for a VCO operating in 2.4 GHz. Phase noise is reduced by 4 dBc/Hz at 10 kHz and 100 kHz offset frequency by this tail current modification.
- 22 November 2021
- Published by Springer Nature in Circuits, Systems, and Signal Processing
- Vol. 41 (5) , 2466-2485
Spur Reduction Circuit for Fractional-N PLLs
- 22 November 2021
- Published by Springer Nature in Circuits, Systems, and Signal Processing
- Vol. 41 (5) , 2466-2485
Spur Reduction Circuit for Fractional-N PLLs
- 4 October 2021
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 109 (3) , 695-704
Moving average filter for spur reduction in subsampling fractional PLLs
- 4 October 2021
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 109 (3) , 695-704
Moving average filter for spur reduction in subsampling fractional PLLs
- Open Access
- 12 November 2019
- Published by Institution of Engineering and Technology (IET) in IET Circuits, Devices & Systems
- Vol. 13 (8) , 1169-1180
Spur reduction architecture for multiphase fractional PLLs
In this study, a multiphase fractional phase‐locked loop (PLL) is presented with methods to reduce spurs. General causes of spurs are non‐idealities of the phase‐frequency detector (PFD) and charge pump (CP) and phase errors between the adjacent phases from the oscillator. In the architecture, the non‐idealities of the PFD and CP are compensated and a phase correction circuit is added after the oscillator phase generator to reduce the phase errors, and hence minimise the spurs. Spurs may still be persistent after these modifications due to process variations and device mismatch. The effect is visible in the perturbations of the loop filter control voltage. The residual spurs are minimised by further filtering the control voltage using a moving average filter and then applying it to the oscillator. The PLL is designed in 180 nm technology and outputs a 400 MHz carrier. The highest fractional spur is decreased from −36 to −66 dBc through phase correction and control voltage filtering.
- 12 November 2019
- Published by Institution of Engineering and Technology (IET) in IET Circuits, Devices & Systems
- Vol. 13 (8) , 1169-1180
Open AccessSpur reduction architecture for multiphase fractional PLLs
In this study, a multiphase fractional phase‐locked loop (PLL) is presented with methods to reduce spurs. General causes of spurs are non‐idealities of the phase‐frequency detector (PFD) and charge pump (CP) and phase errors between the adjacent phases from the oscillator. In the architecture, the non‐idealities of the PFD and CP are compensated and a phase correction circuit is added after the oscillator phase generator to reduce the phase errors, and hence minimise the spurs. Spurs may still be persistent after these modifications due to process variations and device mismatch. The effect is visible in the perturbations of the loop filter control voltage. The residual spurs are minimised by further filtering the control voltage using a moving average filter and then applying it to the oscillator. The PLL is designed in 180 nm technology and outputs a 400 MHz carrier. The highest fractional spur is decreased from −36 to −66 dBc through phase correction and control voltage filtering.
- Open Access
- 1 November 2019
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 55 (23) , 1217-1220
5‐GHz integer‐ N PLL with spur reduction sampler
In this work, a 5‐GHz current‐controlled ring oscillator based integer PLL is implemented with a spur reduction sampler to reduce the reference spurs. The sampler can have taps with each tap sampling the oscillator's control voltage at offsets of the reference phase. The sampler introduces bandstop notches at the frequencies where the spurs appear. The samplers are capable of reducing the spurs from to , a reduction by 50 dB, as evident from simulation results performed in 28 nm technology.
- 1 November 2019
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 55 (23) , 1217-1220
Open Access5‐GHz integer‐ N PLL with spur reduction sampler
In this work, a 5‐GHz current‐controlled ring oscillator based integer PLL is implemented with a spur reduction sampler to reduce the reference spurs. The sampler can have taps with each tap sampling the oscillator's control voltage at offsets of the reference phase. The sampler introduces bandstop notches at the frequencies where the spurs appear. The samplers are capable of reducing the spurs from to , a reduction by 50 dB, as evident from simulation results performed in 28 nm technology.
- 24 June 2019
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 100 (3) , 621-632
Spurs in subsampling fractional PLLs
- 24 June 2019
- Published by Springer Nature in Analog Integrated Circuits and Signal Processing
- Vol. 100 (3) , 621-632
Spurs in subsampling fractional PLLs