Andrea Cristofaro
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Andrea Cristofaro has a total of 40 co-authors. Here are the top co-authors by number of shared publications:
Tor Arne Johansen
Center for Autonomous Marine Operations and Systems, Department of Engineering Cybernetics Norwegian University of Science and Technology Trondheim Norway
12 shared publications- Silvia Pettinari
Scuola di Scienze e Tecnologie, Università di Camerino, via Madonna delle Carceri, 62032 (MC), Italy
10 shared publications Maria Letizia Corradini
7 shared publications- Giuseppe Orlando
Dipartimento di Ingegneria dell'Informazione Università Politecnica delle Marche Ancona Italy
6 shared publications Fabio Giannoni
University of Camerino
5 shared publications- Lucia Pallottino
Università di Pisa
5 shared publications
Latest Publications
- Open Access
- 11 October 2025
- Published by Elsevier in Aerospace Science and Technology
- Vol. 168
Optimization-based task allocation for Earth observation in multi-satellite systems
- 11 October 2025
- Published by Elsevier in Aerospace Science and Technology
- Vol. 168
Open AccessOptimization-based task allocation for Earth observation in multi-satellite systems
- 1 March 2019
- Published by Elsevier in European Journal of Control
- Vol. 46, 23-35
A switched and scheduled design for model recovery anti-windup of linear plants
- 1 March 2019
- Published by Elsevier in European Journal of Control
- Vol. 46, 23-35
A switched and scheduled design for model recovery anti-windup of linear plants
- Open Access
- 28 October 2018
- Published by Wiley in International Journal of Robust and Nonlinear Control
- Vol. 29 (16) , 5456-5480
Robust fault and icing diagnosis in unmanned aerial vehicles using LPV interval observers
Summary: This paper proposes a linear parameter varying (LPV) interval unknown input observer for the robust fault diagnosis of actuator faults and ice accretion in unmanned aerial vehicles (UAVs) described by an uncertain model. The proposed interval observer evaluates the set of values for the state, which are compatible with the nominal fault‐free and icing‐free operation and can be designed in such a way that some information about the nature of the unknown inputs affecting the system can be obtained, thus allowing the diagnosis to be performed. The proposed strategy has several advantages. First, the LPV paradigm allows taking into account operating point variations. Second, the noise rejection properties are enhanced by the presence of the integral term. Third, the interval estimation property guarantees the absence of false alarms. Linear matrix inequality–based conditions for the analysis/design of these observers are provided in order to guarantee the interval estimation of the state and the boundedness of the estimation. The developed theory is supported by simulation results, obtained with the uncertain model of a Zagi Flying Wing UAV, which illustrate the strong appeal of the methodology for identifying correctly unexpected changes in the system dynamics due to actuator faults or icing.
- 28 October 2018
- Published by Wiley in International Journal of Robust and Nonlinear Control
- Vol. 29 (16) , 5456-5480
Open AccessRobust fault and icing diagnosis in unmanned aerial vehicles using LPV interval observers
Summary: This paper proposes a linear parameter varying (LPV) interval unknown input observer for the robust fault diagnosis of actuator faults and ice accretion in unmanned aerial vehicles (UAVs) described by an uncertain model. The proposed interval observer evaluates the set of values for the state, which are compatible with the nominal fault‐free and icing‐free operation and can be designed in such a way that some information about the nature of the unknown inputs affecting the system can be obtained, thus allowing the diagnosis to be performed. The proposed strategy has several advantages. First, the LPV paradigm allows taking into account operating point variations. Second, the noise rejection properties are enhanced by the presence of the integral term. Third, the interval estimation property guarantees the absence of false alarms. Linear matrix inequality–based conditions for the analysis/design of these observers are provided in order to guarantee the interval estimation of the state and the boundedness of the estimation. The developed theory is supported by simulation results, obtained with the uncertain model of a Zagi Flying Wing UAV, which illustrate the strong appeal of the methodology for identifying correctly unexpected changes in the system dynamics due to actuator faults or icing.
- 8 March 2018
- Published by Wiley in Optimal Control Applications and Methods
- Vol. 39 (4) , 1451-1466
Optimality principles and decomposition of tracking controllers for weakly dual redundant systems
Summary: In this paper, the problem of optimizing the output regulation of a weakly dual redundant plant is addressed. When the system is underactuated, only a subset of the outputs can be arbitrarily controlled and the remaining ones are constrained. With a specific focus on the asymptotic output tracking problem for single‐input systems, we investigate the connection between the overall optimal input and the individually optimal controllers, which leads to the perfect tracking of each output reference. Such relationship is analyzed both for open‐loop and closed‐loop controllers for different cost functions and types of references, and the optimality principles are established, provided that suitable structural conditions are met by the plant matrices.
- 8 March 2018
- Published by Wiley in Optimal Control Applications and Methods
- Vol. 39 (4) , 1451-1466
Optimality principles and decomposition of tracking controllers for weakly dual redundant systems
Summary: In this paper, the problem of optimizing the output regulation of a weakly dual redundant plant is addressed. When the system is underactuated, only a subset of the outputs can be arbitrarily controlled and the remaining ones are constrained. With a specific focus on the asymptotic output tracking problem for single‐input systems, we investigate the connection between the overall optimal input and the individually optimal controllers, which leads to the perfect tracking of each output reference. Such relationship is analyzed both for open‐loop and closed‐loop controllers for different cost functions and types of references, and the optimality principles are established, provided that suitable structural conditions are met by the plant matrices.
- 24 August 2017
- Published by Wiley in Asian Journal of Control
- Vol. 20 (2) , 621-634
Fault‐Tolerant Control Allocation for Overactuated Nonlinear Systems
This paper addresses the problem of fault‐tolerant control allocation for input affine nonlinear systems. The proposed scheme is divided in three main tasks: fault detection and estimation using a nonlinear observer, fault isolation through a bank of unknown input observers with a resetting policy to reduce the effects of nonlinearities and control reconfiguration based on reduced order allocation. Analytical results regarding the isolability and reconfigurability of actuator faults are derived and a simulation example is used to illustrate the the proposed fault tolerant control methodology.
- 24 August 2017
- Published by Wiley in Asian Journal of Control
- Vol. 20 (2) , 621-634
Fault‐Tolerant Control Allocation for Overactuated Nonlinear Systems
This paper addresses the problem of fault‐tolerant control allocation for input affine nonlinear systems. The proposed scheme is divided in three main tasks: fault detection and estimation using a nonlinear observer, fault isolation through a bank of unknown input observers with a resetting policy to reduce the effects of nonlinearities and control reconfiguration based on reduced order allocation. Analytical results regarding the isolability and reconfigurability of actuator faults are derived and a simulation example is used to illustrate the the proposed fault tolerant control methodology.
- Open Access
- 3 August 2017
- Published by Wiley in International Journal of Robust and Nonlinear Control
- Vol. 28 (2) , 611-624
Fault tolerant control of uncertain dynamical systems using interval virtual actuators
Summary: In this paper, a model reference fault tolerant control strategy based on a reconfiguration of the reference model, with the addition of a virtual actuator block, is presented for uncertain systems affected by disturbances and sensor noise. In particular, this paper (1) extends the reference model approach to the use of interval state observers, by considering an error feedback controller, which uses the estimated bounds for the error between the real state and the reference state, and (2) extends the virtual actuator approach to the use of interval observers, which means that the virtual actuator is added to the control loop to preserve the nonnegativity of the interval estimation errors and the boundedness of the involved signals, in spite of the fault occurrence. In both cases, the conditions to assure the desired operation of the control loop are provided in terms of linear matrix inequalities. An illustrative example is used to show the main characteristics of the proposed approach.
- 3 August 2017
- Published by Wiley in International Journal of Robust and Nonlinear Control
- Vol. 28 (2) , 611-624
Open AccessFault tolerant control of uncertain dynamical systems using interval virtual actuators
Summary: In this paper, a model reference fault tolerant control strategy based on a reconfiguration of the reference model, with the addition of a virtual actuator block, is presented for uncertain systems affected by disturbances and sensor noise. In particular, this paper (1) extends the reference model approach to the use of interval state observers, by considering an error feedback controller, which uses the estimated bounds for the error between the real state and the reference state, and (2) extends the virtual actuator approach to the use of interval observers, which means that the virtual actuator is added to the control loop to preserve the nonnegativity of the interval estimation errors and the boundedness of the involved signals, in spite of the fault occurrence. In both cases, the conditions to assure the desired operation of the control loop are provided in terms of linear matrix inequalities. An illustrative example is used to show the main characteristics of the proposed approach.
- 24 May 2017
- Published by Wiley in International Journal of Adaptive Control and Signal Processing
- Vol. 31 (11) , 1584-1607
Icing detection and identification for unmanned aerial vehicles using adaptive nested multiple models
Summary: A multiple‐model approach for icing diagnosis and identification in small unmanned aerial vehicles is proposed. The accretion of ice layers on wings and control surfaces modifies the shape of the aircraft and, consequently, alters the performance and controllability of the vehicle. Pitot tubes might be blocked due to icing, providing errors in the airspeed measurements. In this paper, we propose a nested multiple‐model adaptive estimation framework to detect and estimate icing using standard sensors only, ie, a pitot tube and an inertial measurement unit. The architecture of the estimation scheme is based on 2 different time scales, ie, one for the accretion of ice on aircraft surfaces and one for the accretion of ice on sensors, and consists of 2 nested adaptive observers, namely, outer and inner loops, respectively. The case study of a typical small unmanned aerial vehicle supports and validates the proposed theoretical results.
- 24 May 2017
- Published by Wiley in International Journal of Adaptive Control and Signal Processing
- Vol. 31 (11) , 1584-1607
Icing detection and identification for unmanned aerial vehicles using adaptive nested multiple models
Summary: A multiple‐model approach for icing diagnosis and identification in small unmanned aerial vehicles is proposed. The accretion of ice layers on wings and control surfaces modifies the shape of the aircraft and, consequently, alters the performance and controllability of the vehicle. Pitot tubes might be blocked due to icing, providing errors in the airspeed measurements. In this paper, we propose a nested multiple‐model adaptive estimation framework to detect and estimate icing using standard sensors only, ie, a pitot tube and an inertial measurement unit. The architecture of the estimation scheme is based on 2 different time scales, ie, one for the accretion of ice on aircraft surfaces and one for the accretion of ice on sensors, and consists of 2 nested adaptive observers, namely, outer and inner loops, respectively. The case study of a typical small unmanned aerial vehicle supports and validates the proposed theoretical results.
- 11 April 2017
- Published by Springer Nature in Journal of Optimization Theory and Applications
- Vol. 173 (3) , 967-993
On the Minimum-Time Control Problem for Differential Drive Robots with Bearing Constraints
- 11 April 2017
- Published by Springer Nature in Journal of Optimization Theory and Applications
- Vol. 173 (3) , 967-993
On the Minimum-Time Control Problem for Differential Drive Robots with Bearing Constraints
- 1 November 2016
- Published by Elsevier in Journal of the Franklin Institute
- Vol. 353 (17) , 4652-4666
Uncertain parameter estimation for a class of nonlinear systems using a polynomial representation of outputs
- 1 November 2016
- Published by Elsevier in Journal of the Franklin Institute
- Vol. 353 (17) , 4652-4666
Uncertain parameter estimation for a class of nonlinear systems using a polynomial representation of outputs
- 1 September 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 690-697
Detection of icing and actuators faults in the longitudinal dynamics of small UAVs using an LPV proportional integral unknown input observer
This paper proposes a linear parameter varying proportional integral unknown input observer (PI-UIO) for the diagnosis of actuator faults and icing in unmanned aerial vehicles. It is shown that in presence of sensor noise, the proposed PI-UIO has the advantage of being affected by the noise, but not by its derivative. Another contribution of the paper is the introduction of an icing to wind/noise ratio, which allows performing an optimal tuning of some PI-UIO design parameters. Results obtained with a Zagi Flying Wing simulator are used to validate the effectiveness of the proposed approach.
- 1 September 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 690-697
Detection of icing and actuators faults in the longitudinal dynamics of small UAVs using an LPV proportional integral unknown input observer
This paper proposes a linear parameter varying proportional integral unknown input observer (PI-UIO) for the diagnosis of actuator faults and icing in unmanned aerial vehicles. It is shown that in presence of sensor noise, the proposed PI-UIO has the advantage of being affected by the noise, but not by its derivative. Another contribution of the paper is the introduction of an icing to wind/noise ratio, which allows performing an optimal tuning of some PI-UIO design parameters. Results obtained with a Zagi Flying Wing simulator are used to validate the effectiveness of the proposed approach.