Craig Allen Taatjes

Biofuels are an appealing alternative to augment conventional fossil fuels, given that traditional fossil fuels are finite in nature despite being the highest-consumed energy source. Furans have been studied as potential biofuels due to their renewability, high energy density, and ability to both blend with existing fossil fuels and serve as a stand-alone fuel. Although promising, more research efforts on the combustion of furan-based biofuels are needed. In this study, the oxidation of 2,3-dimethylfuran (2,3-DMF) initiated by O(³P) was investigated using vacuum-ultraviolet synchrotron radiation from the Advanced Light Source at the Lawrence Berkeley National Laboratory. The reaction was studied at 550 K and 7 Torr. Major reaction products include 3-methyl-3-buten-2-one, 4,5-dimethyl-3(2H)-furanone, and 3-methyl-4-oxo-2(Z)-pentenal, with 3-methyl-3-buten-2-one being the most abundant.

Methyl-ethyl-substituted Criegee intermediate (MECI) is a four-carbon carbonyl oxide that is formed in the ozonolysis of some asymmetric alkenes. MECI is structurally similar to the isoprene-derived methyl vinyl ketone oxide (MVK-oxide) but lacks resonance stabilization, making it a promising candidate to help us unravel the effects of size, structure, and resonance stabilization that influence the reactivity of atmospherically important, highly functionalized Criegee intermediates. We present experimental and theoretical results from the first bimolecular study of MECI in its reaction with SO₂, a reaction that shows significant sensitivity to the Criegee intermediate structure. Using multiplexed photoionization mass spectrometry, we obtain a rate coefficient of (1.3 ± 0.3) × 10^-10 cm³ s^-1 (95% confidence limits, 298 K, 10 Torr) and demonstrate the formation of SO₃ under our experimental conditions. Through high-level theory, we explore the effect of Criegee intermediate structure on the minimum energy pathways for their reactions with SO₂ and obtain modified Arrhenius fits to our predictions for the reaction of both syn and anti conformers of MECI with SO₂ (k_syn = 4.42 × 10¹¹ T^-7.80exp(-1401/T) cm³ s^-1 and k_anti = 1.26 × 10¹¹ T^-7.55exp(-1397/T) cm³ s^-1). Our experimental and theoretical rate coefficients (which are in reasonable agreement at 298 K) show that the reaction of MECI with SO₂ is significantly faster than MVK-oxide + SO₂, demonstrating the substantial effect of resonance stabilization on Criegee intermediate reactivity.

Alkene ozonolysis generates short-lived Criegee intermediates that are a significant source of hydroxyl (OH) radicals. This study demonstrates that roaming of the separating OH radicals can yield alternate hydroxycarbonyl products, thereby reducing the OH yield. Specifically, hydroxybutanone has been detected as a stable product arising from roaming in the unimolecular decay of the methyl-ethyl-substituted Criegee intermediate (MECI) under thermal flow cell conditions. The dynamical features of this novel multistage dissociation plus a roaming unimolecular decay process have also been examined with ab initio kinetics calculations. Experimentally, hydroxybutanone isomers are distinguished from the isomeric MECI by their higher ionization threshold and distinctive photoionization spectra. Moreover, the exponential rise of the hydroxybutanone kinetic time profile matches that for the unimolecular decay of MECI. A weaker methyl vinyl ketone (MVK) photoionization signal is also attributed to OH roaming. Complementary multireference electronic structure calculations have been utilized to map the unimolecular decay pathways for MECI, starting with 1,4 H atom transfer from a methyl or methylene group to the terminal oxygen, followed by roaming of the separating OH and butanonyl radicals in the long-range region of the potential. Roaming via reorientation and the addition of OH to the vinyl group of butanonyl is shown to yield hydroxybutanone, and subsequent C-O elongation and H-transfer can lead to MVK. A comprehensive theoretical kinetic analysis has been conducted to evaluate rate constants and branching yields (ca. 10-11%) for thermal unimolecular decay of MECI to conventional and roaming products under laboratory and atmospheric conditions, consistent with the estimated experimental yield (ca. 7%).

The mechanism for hydrocarbon ring growth in sooting environments is still the subject of considerable debate. The reaction of phenyl radical (C₆H₅) with propargyl radical (H₂CCCH) provides an important prototype for radical-radical ring-growth pathways. We studied this reaction experimentally over the temperature range of 300-1000 K and pressure range of 4-10 Torr using time-resolved multiplexed photoionization mass spectrometry. We detect both the C₉H₈ and C₉H₇ + H product channels and report experimental isomer-resolved product branching fractions for the C₉H₈ product. We compare these experiments to theoretical kinetics predictions from a recently published study augmented by new calculations. These ab initio transition state theory-based master equation calculations employ high-quality potential energy surfaces, conventional transition state theory for the tight transition states, and direct CASPT2-based variable reaction coordinate transition state theory (VRC-TST) for the barrierless channels. At 300 K only the direct adducts from radical-radical addition are observed, with good agreement between experimental and theoretical branching fractions, supporting the VRC-TST calculations of the barrierless entrance channel. As the temperature is increased to 1000 K we observe two additional isomers, including indene, a two-ring polycyclic aromatic hydrocarbon, and a small amount of bimolecular products C₉H₇ + H. Our calculated branching fractions for the phenyl + propargyl reaction predict significantly less indene than observed experimentally. We present further calculations and experimental evidence that the most likely cause of this discrepancy is the contribution of H atom reactions, both H + indenyl (C₉H₇) recombination to indene and H-assisted isomerization that converts less stable C₉H₈ isomers into indene. Especially at low pressures typical of laboratory investigations, H-atom-assisted isomerization needs to be considered. Regardless, the experimental observation of indene demonstrates that the title reaction leads, either directly or indirectly, to the formation of the second ring in polycyclic aromatic hydrocarbons.

Dimethyl ether (DME) oxidation is a model chemical system with a small number of prototypical reaction intermediates that also has practical importance for low-carbon transportation. Although it has been studied experimentally and theoretically, ambiguity remains in the relative importance of competing DME oxidation pathways in the low-temperature autoignition regime. To focus on the primary reactions in DME autoignition, we measured the time-resolved concentration of five intermediates, CH₃OCH₂OO (ROO), OOCH₂OCH₂OOH (OOQOOH), HOOCH₂OCHO (hydroperoxymethyl formate, HPMF), CH₂O, and CH₃OCHO (methyl formate, MF), from photolytically initiated experiments. We performed these studies at P = 10 bar and T = 450-575 K, using a high-pressure photolysis reactor coupled to a time-of-flight mass spectrometer with tunable vacuum-ultraviolet synchrotron ionization at the Advanced Light Source. Our measurements reveal that the timescale of ROO decay and product formation is much shorter than predicted by current DME combustion models. The models also strongly underpredict the observed yields of CH₂O and MF and do not capture the temperature dependence of OOQOOH and HPMF yields. Adding the ROO + OH → RO + HO₂ reaction to the chemical mechanism (with a rate coefficient approximated from similar reactions) improves the prediction of MF. Increasing the rate coefficients of ROO ↔ QOOH and QOOH + O₂ ↔ OOQOOH reactions brings the model predictions closer to experimental observations for OOQOOH and HPMF, while increasing the rate coefficient for the QOOH → 2CH₂O + OH reaction is needed to improve the predictions of formaldehyde. To aid future quantification of DME oxidation intermediates by photoionization mass spectrometry, we report experimentally determined ionization cross-sections for ROO, OOQOOH, and HPMF.

A crucial chain‐branching step in autoignition is the decomposition of ketohydroperoxides (KHP) to form an oxy radical and OH. Other pathways compete with chain‐branching, such as “Korcek” dissociation of γ‐KHP to a carbonyl and an acid. Here we characterize the formation of a γ‐KHP and its decomposition to formic acid+acetone products from observations of n‐butane oxidation in two complementary experiments. In jet‐stirred reactor measurements, KHP is observed above 590 K. The KHP concentration decreases with increasing temperature, whereas formic acid and acetone products increase. Observation of characteristic isotopologs acetone‐d₃ and formic acid‐d₀ in the oxidation of CH₃CD₂CD₂CH₃ is consistent with a Korcek mechanism. In laser‐initiated oxidation experiments of n‐butane, formic acid and acetone are produced on the timescale of KHP removal. Modelling the time‐resolved production of formic acid provides an estimated upper limit of 2 s⁻¹ for the rate coefficient of KHP decomposition to formic acid+acetone.